Cokriging for evaluating agricultural pollution

Agricultural irrigation is a major non-point source polluter. Evaluating the extent of this type of non-point source pollution requires sampling and analysis of drainage waters. To reduce costs, sampling efficiency is important. Cokriging can be used as a tool for interpolating between sampling times or locations. In this experiment, subsurface drainage data from irrigated lands near Twin Falls, Idaho were used. Total Dissolved Solids and NO3-N were selected as variables. The objective was to determine if 50 and 65 percent of the measured data could be removed (creating two new data sets) and accurately estimated via cokriging using a variogram model based on the remaining data. Cokriging models were developed using statistical information obtained from variograms of the remaining data. Once accurate models were developed for both the 50 and 65 percent removal cases, estimations were made for the missing data values. One-way analysis of variance and t-tests were used to test whether the means and variances of the estimated values were significantly different from those of the measured values. At the 65 percent removal level, there were significant differences in the means and variances of the estimated and measured values for NO3-N. One way analysis of variance and similarity of variance tests were used to test whether differences between the error values of the modeled and removed data were significant. By using the unedited full set of measured data for variogram modeling none of the tests produced rejections

Yield conditions for deformation of amorphous polymer glasses

Shear yielding of glassy polymers is usually described in terms of the pressure-dependent Tresca or von Mises yield criteria. We test these criteria against molecular dynamics simulations of deformation in amorphous polymer glasses under triaxial loading conditions that are difficult to realize in experiments. Difficulties and ambiguities in extending several standard definitions of the yield point to triaxial loads are described. Two definitions, the maximum and offset octahedral stresses, are then used to evaluate the yield stress for a wide range of model parameters. In all cases, the onset of shear is consistent with the pressure-modified von Mises criterion, and the pressure coefficient is nearly independent of many parameters. Under triaxial tensile loading, the mode of failure changes to cavitation.Comment: 9 pages, 8 figures, revte

InP monolithically integrated label swapper device for spectral amplitude coded optical packet networks

In this paper a label swapping device, for spectral amplitude coded optical packet networks, fully integrated using InP technology is presented. Compared to previous demonstrations using discrete component assembly, the device footprint is reduced by a factor of 105 and the operation speed is increased by a factor of 103. This is, to the best of our knowledge, the first demonstration of a totally integrated label swapping device

InP monolithically integrated label swapper device for spectral amplitude coded optical packet networks

In this paper a label swapping device, for spectral amplitude coded optical packet networks, fully integrated using InP technology is presented. Compared to previous demonstrations using discrete component assembly, the device footprint is reduced by a factor of 105 and the operation speed is increased by a factor of 103. This is, to the best of our knowledge, the first demonstration of a totally integrated label swapping device

Interwell coupling effect in Si/SiGe quantum wells grown by ultra high vacuum chemical vapor deposition

Si/Si0.66Ge0.34coupled quantum well (CQW) structures with different barrier thickness of 40, 4 and 2 nm were grown on Si substrates using an ultra high vacuum chemical vapor deposition (UHV-CVD) system. The samples were characterized using high resolution x-ray diffraction (HRXRD), cross-sectional transmission electron microscopy (XTEM) and photoluminescence (PL) spectroscopy. Blue shift in PL peak energy due to interwell coupling was observed in the CQWs following increase in the Si barrier thickness. The Si/SiGe heterostructure growth process and theoretical band structure model was validated by comparing the energy of the no-phonon peak calculated by the 6 + 2-bandk·pmethod with experimental PL data. Close agreement between theoretical calculations and experimental data was obtained

Anisotropy studies around the galactic centre at EeV energies with the Auger Observatory

Data from the Pierre Auger Observatory are analyzed to search for anisotropies near the direction of the Galactic Centre at EeV energies. The exposure of the surface array in this part of the sky is already significantly larger than that of the fore-runner experiments. Our results do not support previous findings of localized excesses in the AGASA and SUGAR data. We set an upper bound on a point-like flux of cosmic rays arriving from the Galactic Centre which excludes several scenarios predicting sources of EeV neutrons from Sagittarius $A$. Also the events detected simultaneously by the surface and fluorescence detectors (the `hybrid' data set), which have better pointing accuracy but are less numerous than those of the surface array alone, do not show any significant localized excess from this direction.Comment: Matches published versio

Measurement of the Bottom-Strange Meson Mixing Phase in the Full CDF Data Set

We report a measurement of the bottom-strange meson mixing phase \beta_s using the time evolution of B0_s -> J/\psi (->\mu+\mu-) \phi (-> K+ K-) decays in which the quark-flavor content of the bottom-strange meson is identified at production. This measurement uses the full data set of proton-antiproton collisions at sqrt(s)= 1.96 TeV collected by the Collider Detector experiment at the Fermilab Tevatron, corresponding to 9.6 fb-1 of integrated luminosity. We report confidence regions in the two-dimensional space of \beta_s and the B0_s decay-width difference \Delta\Gamma_s, and measure \beta_s in [-\pi/2, -1.51] U [-0.06, 0.30] U [1.26, \pi/2] at the 68% confidence level, in agreement with the standard model expectation. Assuming the standard model value of \beta_s, we also determine \Delta\Gamma_s = 0.068 +- 0.026 (stat) +- 0.009 (syst) ps-1 and the mean B0_s lifetime, \tau_s = 1.528 +- 0.019 (stat) +- 0.009 (syst) ps, which are consistent and competitive with determinations by other experiments.Comment: 8 pages, 2 figures, Phys. Rev. Lett 109, 171802 (2012