163 research outputs found
Effects of acidic cottage cheese whey on chemical and physical properties of a sodic soil
Sodic soil reclamation requires replacing exchangeable Na+ with Ca2+
and leaching the excess Na+ from the soil. Cottage cheese whey has an electrical
conductivity (EC) of 6-10 dS m-1, pH values of 4.2 or less, low sodium adsorption
ratios (SAR), and contains 40-50 g kg-1 of readily decomposable organic matter.
These whey characteristics should all be beneficial in reclaiming sodic soils. This
study was conducted to determine the effects of cottage cheese whey on the chemical
and physical properties of a sodic soil (SAR = 16.3, EC = 3.8, and pH 8.3).
Cottage cheese whey was applied to 300-mm-deep sodic soil columns at 0-, 20-, 40-,
and 80-mm rates followed by 80, 60, 40, and 0 mm of distilled water, respectively.
The columns were then incubated at 10°C for 21 days, and then leached until 96 mm
(0.60 pore volumes) of leachate was collected. All whey applications lowered the soil
pH, SAR, and exchangeable sodium percentage (ESP) in both the upper and lower
150-mm-depth increments. Aggregate stability in the surface 150-mm-depth increment
increased from 11 % in the water-leached soil to 22% in the 80-mm whey-treated
soil. The results of this study suggest that cottage cheese whey can be used as
an effective sodic soil amendment
Cheese whey effects on surface soil hydraulic properties
Whey, the liquid byproduct of cheese production, can improve the physical condition of sodic soils
or those susceptible to erosion by increasing their aggregate stability. The effects of whey on soil hydraulic properties,
however, are not known. In this experiment, we used tension infiltrometers to determine whey effects on
infiltration rates of water (at suctions s 30 mm of water) and unsaturated hydraulic conductivities of Ap horizons
of a Portneuf silt loam (coarse-silts mixed, mesic Durixerollic Calciorthid) after a winter wheat crop. In the
summer of 1993 near Kimberly, ID, USA, liquid whey was flood-applied at either 0, 200, 400, or 800 t/ha to plots
planted to wheat the previous September. At suctions of 60 and 150 mm, infiltration rates decreased linearly by
about 0.7 µtm/s with each additional 100 t/ha of whey applied. As whey applications increased, hydraulic conductivities
at 60 mm suction increased slightly but as applications exceeded 400 t/ha decreased significantly. We
concluded that summer whey applications up to 400 t/ha would not adversely affect surface hydraulic properties
Recommended from our members
Determination of unconverted HDPE in coal/plastics co-liquefaction stream samples
In several coal/plastics liquefaction runs performed by Hydrocarbon Technologies, Inc. (HTI), a substantial amount of incompletely converted high-density polyethylene (HDPE) was present in ash-free recycle resid streams when either the ROSE-SR unit was used in Run POC-2, or the pressure filter unit was used in Runs CMSL-8 and CMSL-9. This indicates that the HDPE is less reactive than coal at the liquefaction conditions used. In these ash-free streams, there is no solid organic or inorganic material arising from the coal, and the incompletely converted HDPE can be recovered by extraction and filtration with tetrahydrofuran (THF) at room temperature. The HDPE (or HDPE-like material, which could also consist of heavy waxes) is THF insoluble. However, in ashy streams, there are both inorganic ({open_quotes}ash{close_quotes}) and organic (unconverted coal) components present from liquefaction of the coal, that interfere with an easy and clean separation of the HDPE from the coal/plastics liquefaction stream sample. Therefore, CONSOL developed an analytical procedure for HDPE in the ashy stream samples based on extraction of HDPE from the sample using hot (150{degrees}C) decalin (decahydronaphthalene), in which the HDPE is soluble. The decalin extraction is both preceded and succeeded by extractions and washes with THF at room temperature, to remove the coal-derived components from the sample
Cottage cheese (acid) whey effects on sodic soil aggregate stability
Whey applications reduce a sodic soil's exchangeable sodium percentage (ESP) and
sodium adsorption ratio (SAR) and increase its infiltration rate. Whey's effects on
aggregate stability (AS), however, have been less well documented. A greenhouse
study was conducted to determine: ( 1 ) AS response to whey additions, (2) the profile
depth to which surface-applied whey affected AS, and (3) the relationship between AS
and SAR for an illitic soil. Greenhouse lysimeters packed with a Freedom silt loam
(Xerollic Calciorthid) received either 0, 25, 50, or 100 mm of whey (equivalent to 0,
253, 505, and 1010 Mg ha-1 of liquid whey). After drying, the surface 150 mm was
removed, mixed, and replaced. Barley (Hordeum vulgare L. `Ludd') was then planted
and grown to maturity by irrigating weekly. After harvest, AS was measured by wet
sieving. A companion field study was conducted to determine the effects of whey
applications and flood irrigations on AS. In Declo silt loam (Xerollic Calciorthid), 2
x 2 m basins received 0, 25, 50, or 100 mm of whey, followed by 100, 75, 50, or 0 mm
of water, respectively. One week later, each basin was cultivated (to z = 100 mm) and
smoothed. After four 150-mm irrigations, AS was measured on the 0- to 10-, 10- to 50-,
and 50- to 150-mm depth increments. Greenhouse results indicated that AS increased
significantly with whey additions, though only in the tilled 0- to 150-mm depth increment.
Over two ranges, AS increased linearly with SAR decreases resulting from whey
applications. In the upper 50 mm of soil in the field basins, AS also increased linearly
from 33 to 75% with whey additions up to 50 mm. Cottage cheese whey improved the
AS of sodic soil horizons into which it was incorporated
Whey utilization in furrow irrigation: Effects on aggregate stability and erosion
Improving soil structure often reduces furrow erosion and maintains adequate infiltration. Cottage
cheese whey, the liquid byproduct from cottage cheese manufacture, was utilized to stabilize soil aggregates
and reduce sediment losses from furrow irrigation. We applied either 2.4 or 1.9 L of whey per meter
of furrow (3.15 or 2.49 L m?-2, respectively) by gravity flow without incorporation to two fields of Portneuf
silt loam (Durinodic Xeric Haplocalcid) near Kimberly, ID. Furrows were irrigated with water beginning
four days later. We measured sediment losses with furrow flumes during each irrigation and
measured aggregate stability by wet sieving about 10 days after the last irrigation. Overall, whey significantly
increased aggregate stability 25% at the 0–15 mm depth and 14% at 15–30 mm, compared to controls.
On average, whey reduced sediment losses by 75% from furrows sloped at 2.4%. Whey increased the
aggregate stability of structurally degraded calcareous soil in irrigation furrows
Measurement of the Bottom-Strange Meson Mixing Phase in the Full CDF Data Set
We report a measurement of the bottom-strange meson mixing phase \beta_s
using the time evolution of B0_s -> J/\psi (->\mu+\mu-) \phi (-> K+ K-) decays
in which the quark-flavor content of the bottom-strange meson is identified at
production. This measurement uses the full data set of proton-antiproton
collisions at sqrt(s)= 1.96 TeV collected by the Collider Detector experiment
at the Fermilab Tevatron, corresponding to 9.6 fb-1 of integrated luminosity.
We report confidence regions in the two-dimensional space of \beta_s and the
B0_s decay-width difference \Delta\Gamma_s, and measure \beta_s in [-\pi/2,
-1.51] U [-0.06, 0.30] U [1.26, \pi/2] at the 68% confidence level, in
agreement with the standard model expectation. Assuming the standard model
value of \beta_s, we also determine \Delta\Gamma_s = 0.068 +- 0.026 (stat) +-
0.009 (syst) ps-1 and the mean B0_s lifetime, \tau_s = 1.528 +- 0.019 (stat) +-
0.009 (syst) ps, which are consistent and competitive with determinations by
other experiments.Comment: 8 pages, 2 figures, Phys. Rev. Lett 109, 171802 (2012
Modelos matemáticos para estimar as exigências de lisina digestÃvel para aves de corte ISA Label
Materials and Devices of the Public: An Introduction
This introduction provides an overview of material- or device-centered approaches to the study of public participation, and articulates the theoretical contributions of the four articles that make up this special section. Set against the background of post-Foucaldian perspectives on the material dimensions of citizenship and engagement - perspectives that treat matter as a tacit, constituting force in the organization of collectives and are predominantly concerned with the fabrication of political subjects - we outline an approach that considers material engagement as a distinct mode of performing the public. The question, then, is how objects, devices, settings and materials acquire explicit political capacities, and how they serve to enact material participation as a specific public form. We discuss the connections between social studies of material participation and political theory, and define the contours of an empiricist approach to material publics, one that takes as its central cue that the values and criteria particular to these publics emerge as part of the process of their organization. Finally, we discuss four themes that connect the articles in this special section, namely their focus on 1) mundane technologies, 2) experimental devices and settings for material participation; 3) the dynamic of effort and comfort, and 4) the modes of containment and proliferation that characterize material publics
Evaluation and management of patients with chronic thromboembolic pulmonary hypertension: consensus statement from the ISHLT
ISHLT members have recognized the importance of a consensus statement on the evaluation and management of patients with chronic thromboembolic pulmonary hypertension. The creation of this document required multiple steps, including the engagement of the ISHLT councils, approval by the Standards and Guidelines Committee, identification and selection of experts in the field, and the development of 6 working groups. Each working group provided a separate section based on an extensive literature search. These sections were then coalesced into a single document that was circulated to all members of the working groups. Key points were summarized at the end of each section. Due to the limited number of comparative trials in this field, the document was written as a literature review with expert opinion rather than based on level of evidence. (C) 2021 International Society for Heart and Lung Transplantation. All rights reserved.Thrombosis and Hemostasi
Universal DNA methylation age across mammalian tissues
DATA AVAILABILITY STATEMENT : The individual-level data from the Mammalian Methylation Consortium can be accessed from several online locations. All data from the Mammalian Methylation Consortium are posted on Gene Expression Omnibus (complete dataset, GSE223748). Subsets of the datasets can also be downloaded from accession numbers GSE174758, GSE184211, GSE184213, GSE184215, GSE184216, GSE184218, GSE184220, GSE184221, GSE184224, GSE190660, GSE190661, GSE190662, GSE190663, GSE190664, GSE174544, GSE190665, GSE174767, GSE184222, GSE184223, GSE174777, GSE174778, GSE173330, GSE164127, GSE147002, GSE147003, GSE147004, GSE223943 and GSE223944. Additional details can be found in Supplementary Note 2. The mammalian data can also be downloaded from the Clock Foundation webpage: https://clockfoundation.org/MammalianMethylationConsortium. The mammalian methylation array is available through the non-profit Epigenetic Clock Development Foundation (https://clockfoundation.org/). The manifest file of the mammalian array and genome annotations of CpG sites can be found on Zenodo (10.5281/zenodo.7574747). All other data supporting the findings of this study are available from the corresponding author upon reasonable request.
The chip manifest files, genome annotations of CpG sites and the software code for universal pan-mammalian clocks can be found on GitHub95 at https://github.com/shorvath/MammalianMethylationConsortium/tree/v2.0.0. The individual R code for the universal pan-mammalian clocks, EWAS analysis and functional enrichment studies can be also found in the Supplementary Code.SUPPLEMENTARY MATERIAL 1 : Supplementary Tables 1–3 and Notes 1–6.SUPPLEMENTARY MATERIAL 2 : Reporting SummarySUPPLEMENTARY MATERIAL 3 : Supplementary Data 1–14.SUPPLEMENTARY MATERIAL 4 : Supplementary Code.Aging, often considered a result of random cellular damage, can be accurately estimated using DNA methylation profiles, the foundation of pan-tissue epigenetic clocks. Here, we demonstrate the development of universal pan-mammalian clocks, using 11,754 methylation arrays from our Mammalian Methylation Consortium, which encompass 59 tissue types across 185 mammalian species. These predictive models estimate mammalian tissue age with high accuracy (r > 0.96). Age deviations correlate with human mortality risk, mouse somatotropic axis mutations and caloric restriction. We identified specific cytosines with methylation levels that change with age across numerous species. These sites, highly enriched in polycomb repressive complex 2-binding locations, are near genes implicated in mammalian development, cancer, obesity and longevity. Our findings offer new evidence suggesting that aging is evolutionarily conserved and intertwined with developmental processes across all mammals.https://www.nature.com/nataginghj2024Zoology and EntomologySDG-15:Life on lan
- …