Testing microtubular SOFCs in unmanned air vehicles (UAVs)

Unmanned Air Vehicles (UAVs) powered by microtubular SOFCs (mSOFCs) are described for comparison with polymer fuel cells (PEFCs). Using propane as fuel, 7mm diameter mSOFCs have been tested in a 2m wingspan aircraft with a total weight of 6kg. The start-up time was 12 minutes to deliver 250W in a fuel cell/battery hybrid drive system. Tubes were YSZ cermet anode supported, with 10 µm YSZ electrolyte, 6µm SDC interlayer coated with 50µm LSCF cathode. Silver wires were used as interconnects. Pure propane fuel gas was mixed with air in a CPOX reactor using catalytic fuel processing mesh. A polymeric fuel inlet manifold gave cold sealing at the tube inlet ends which projected out of the hot box. Cathode air was provided in counterflow, preheated over an anode off-gas catalyst. The fuel utilization was 55%, output power of 250W. The fuel cell was incorporated in a hybrid electrical system with lithium polymer battery and inserted in a Skywalker X8 UAV with 500g of propane in an aluminum tank

Micro solid oxide fuel cell thermal dynamics::Incorporation of experimental measurements and model-based estimations for a multidimensional thermal analysis

Transient behaviour of solid oxide fuel cells during various stages of operation, such as warmup, startup, load fluctuations, and shutdown, must be understood and predicted in order to design an efficient controller and prevent degradation/failure of the cell. The difficulty of measuring and monitoring solid oxide fuel cell thermal features necessitates an evaluation of the solid oxide fuel cell thermal dynamics using a hybrid tool that integrates both experimental and numerical methods. In this study, a hybrid measurement tool consisting of a quasi-two-dimensional microscale model and a test rig was used to investigate the solid oxide fuel cell thermal dynamics. Through the hybrid experiment-model approach, steady-state temperature differences across Positive-Electrolyte-Negative and along fuel flow direction were captured. Additionally, the speed of temperature difference change was estimated in two dimensions, which is crucial when estimating transient thermal stresses. Several thermal measures were used to evaluate the thermal dynamics of solid oxide fuel cells. The impact of the operating voltage regime on solid oxide fuel cell thermal dynamics was studied using the varying operating voltage (Voltage Interrupted Measurement) characterisation approach. The outcomes revealed that optimising the performance of solid oxide fuel cells requires a trade-off between thermal management and fuel utilisation due to the exponential effect of fuel utilisation on steady-state temperature differences. The effects of fuel humidity and oxygen content of the oxidant flow on solid oxide fuel cell thermal dynamics were also examined. The results shed light on the new aspects of fuel cell thermal dynamics that are key in designing future smart controllers

The bio-nano-interface in predicting nanoparticle fate and behaviour in living organisms: towards grouping and categorising nanomaterials and ensuring nanosafety by design

In biological media, nanoparticles acquire a coating of biomolecules (proteins, lipids, polysaccharides) from their surroundings, which reduces their surface energy and confers a biological identity to the particles. This adsorbed layer is the interface between the nanomaterial and living systems and therefore plays a significant role in determining the fate and behaviour of the nanoparticles. This review summarises the state of the art in terms of understanding the bio-nano interface and provides direction for potential future research and recommendations for future priorities and strategies to support the safe implementation of nanotechnologies. The central premise is that nanomaterials must be studied as biological entities under the appropriate exposure conditions and that this should be implemented in study design and reporting for nanosafety assessment. The implications of the bio-nano interface for nanomaterials fate and behaviour are described in light of four interlinked perspectives: the Coating concept; the Translocation concept; the Signalling concept, and the Kinetics concept. A key conclusion is that nanoparticles cannot be viewed as non-interacting species, but rather must be thought of, and studied as, biological entities, where their interaction with the environment is mediated by the proteins and other biomolecules that adsorb to them, and the key parameter to characterise then becomes the nature, composition and evolution of the bio-nano interfac

Convocation

Program listing performers and works performe

Search for dark matter produced in association with bottom or top quarks in √s = 13 TeV pp collisions with the ATLAS detector

A search for weakly interacting massive particle dark matter produced in association with bottom or top quarks is presented. Final states containing third-generation quarks and miss- ing transverse momentum are considered. The analysis uses 36.1 fb−1 of proton–proton collision data recorded by the ATLAS experiment at √s = 13 TeV in 2015 and 2016. No significant excess of events above the estimated backgrounds is observed. The results are in- terpreted in the framework of simplified models of spin-0 dark-matter mediators. For colour- neutral spin-0 mediators produced in association with top quarks and decaying into a pair of dark-matter particles, mediator masses below 50 GeV are excluded assuming a dark-matter candidate mass of 1 GeV and unitary couplings. For scalar and pseudoscalar mediators produced in association with bottom quarks, the search sets limits on the production cross- section of 300 times the predicted rate for mediators with masses between 10 and 50 GeV and assuming a dark-matter mass of 1 GeV and unitary coupling. Constraints on colour- charged scalar simplified models are also presented. Assuming a dark-matter particle mass of 35 GeV, mediator particles with mass below 1.1 TeV are excluded for couplings yielding a dark-matter relic density consistent with measurements

Mortality and pulmonary complications in patients undergoing surgery with perioperative SARS-CoV-2 infection: an international cohort study

Background: The impact of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) on postoperative recovery needs to be understood to inform clinical decision making during and after the COVID-19 pandemic. This study reports 30-day mortality and pulmonary complication rates in patients with perioperative SARS-CoV-2 infection. Methods: This international, multicentre, cohort study at 235 hospitals in 24 countries included all patients undergoing surgery who had SARS-CoV-2 infection confirmed within 7 days before or 30 days after surgery. The primary outcome measure was 30-day postoperative mortality and was assessed in all enrolled patients. The main secondary outcome measure was pulmonary complications, defined as pneumonia, acute respiratory distress syndrome, or unexpected postoperative ventilation. Findings: This analysis includes 1128 patients who had surgery between Jan 1 and March 31, 2020, of whom 835 (74·0%) had emergency surgery and 280 (24·8%) had elective surgery. SARS-CoV-2 infection was confirmed preoperatively in 294 (26·1%) patients. 30-day mortality was 23·8% (268 of 1128). Pulmonary complications occurred in 577 (51·2%) of 1128 patients; 30-day mortality in these patients was 38·0% (219 of 577), accounting for 81·7% (219 of 268) of all deaths. In adjusted analyses, 30-day mortality was associated with male sex (odds ratio 1·75 [95% CI 1·28–2·40], p\textless0·0001), age 70 years or older versus younger than 70 years (2·30 [1·65–3·22], p\textless0·0001), American Society of Anesthesiologists grades 3–5 versus grades 1–2 (2·35 [1·57–3·53], p\textless0·0001), malignant versus benign or obstetric diagnosis (1·55 [1·01–2·39], p=0·046), emergency versus elective surgery (1·67 [1·06–2·63], p=0·026), and major versus minor surgery (1·52 [1·01–2·31], p=0·047). Interpretation: Postoperative pulmonary complications occur in half of patients with perioperative SARS-CoV-2 infection and are associated with high mortality. Thresholds for surgery during the COVID-19 pandemic should be higher than during normal practice, particularly in men aged 70 years and older. Consideration should be given for postponing non-urgent procedures and promoting non-operative treatment to delay or avoid the need for surgery. Funding: National Institute for Health Research (NIHR), Association of Coloproctology of Great Britain and Ireland, Bowel and Cancer Research, Bowel Disease Research Foundation, Association of Upper Gastrointestinal Surgeons, British Association of Surgical Oncology, British Gynaecological Cancer Society, European Society of Coloproctology, NIHR Academy, Sarcoma UK, Vascular Society for Great Britain and Ireland, and Yorkshire Cancer Research