24 research outputs found

    Observation of Top Quark Production in Proton-Nucleus Collisions

    Get PDF
    Peer reviewe

    Measurement of the WZ production cross section in pp collisions at root s=7 and 8 TeV and search for anomalous triple gauge couplings at root s=8 TeV

    Get PDF
    Peer reviewe

    Long-range and short-range dihadron angular correlations in central PbPb collisions at √sNN=2.76 TeV

    Get PDF
    This is the pre-print version of the Published Article, which can be accessed from the link below.First measurements of dihadron correlations for charged particles are presented for central PbPb collisions at a nucleon-nucleon center-of-mass energy of 2.76TeV over a broad range in relative pseudorapidity ( ) and the full range of relative azimuthal angle ( ). The data were collected with the CMS detector, at the LHC. A broadening of the away-side ( ) azimuthal correlation is observed at all , as compared to the measurements in pp collisions. Furthermore, long-range dihadron correlations in are observed for particles with similar values. This phenomenon, also known as the \ridge", persists up to at least j j = 4. For particles with transverse momenta (pT) of 2-4 GeV/c, the ridge is found to be most prominent when these particles are correlated with particles of pT = 2-6 GeV/c, and to be much reduced when paired with particles of pT = 10-12 GeV/c

    Suppression and azimuthal anisotropy of prompt and nonprompt J/psi production in PbPb collisions at root S-NN=2.76 TeV

    Get PDF
    The nuclear modification factor RAA and the azimuthal anisotropy coefficient v2 of prompt and nonprompt (i.e. those from decays of b hadrons) J/ψ mesons, measured from PbPb and pp collisions at sNN−−−√=2.76 TeV at the LHC, are reported. The results are presented in several event centrality intervals and several kinematic regions, for transverse momenta pT>6.5 GeV/c and rapidity |y|<2.4 , extending down to pT=3 GeV/c in the 1.6<|y|<2.4 range. The v2 of prompt J/ψ is found to be nonzero, but with no strong dependence on centrality, rapidity, or pT over the full kinematic range studied. The measured v2 of nonprompt J/ψ is consistent with zero. The RAA of prompt J/ψ exhibits a suppression that increases from peripheral to central collisions but does not vary strongly as a function of either y or pT in the fiducial range. The nonprompt J/ψ RAA shows a suppression which becomes stronger as rapidity or pT increases. The v2 and RAA of open and hidden charm, and of open charm and beauty, are compared

    The GridPP DIRAC project - DIRAC for non-LHC communities

    Get PDF
    The GridPP consortium in the UK is currently testing a multi-VO DIRAC service aimed at non-LHC VOs. These VOs (Virtual Organisations) are typically small and generally do not have a dedicated computing support post. The majority of these represent particle physics experiments (e.g. NA62 and COMET), although the scope of the DIRAC service is not limited to this field. A few VOs have designed bespoke tools around the EMI-WMS & LFC, while others have so far eschewed distributed resources as they perceive the overhead for accessing them to be too high. The aim of the GridPP DIRAC project is to provide an easily adaptable toolkit for such VOs in order to lower the threshold for access to distributed resources such as Grid and cloud computing. As well as hosting a centrally run DIRAC service, we will also publish our changes and additions to the upstream DIRAC codebase under an open-source license. We report on the current status of this project and show increasing adoption of DIRAC within the non-LHC communities

    Compound effect of EHD and surface roughness in pool boiling and CHF with R-123

    Get PDF
    This article is a post-print version of the fianl published article which may be accessed at the link below.Saturated pool boiling of R-123 at 1 bar, including the critical heat flux (CHF), was enhanced by modifying the surface characteristics and applying a high intensity electrostatic field, the latter termed electrohydrodynamic (and abbreviated EHD) enhancement. The heat flux was varied from very low values in the natural convection regime up to CHF. Experiments were performed with increasing and decreasing heat flux to study boiling hysteresis without and with EHD. Boiling occurred on the sand blasted surface of a cylindrical copper block with embedded electrical heating elements, with standardized surface parameter Pa = 3.5 Îźm. The electric field was generated by a potential of 5 kV to 25 kV, applied through a 40 mm diameter circular electrode of ss-304 wire mesh, aperture size 5.1 mm, located at distances of 5 - 60 mm from the surface, with most of the data obtained for 20 mm. The data for the rough surface were compared with earlier data for a smooth surface and indicated a significant increase in the heat transfer rates. EHD produced a further increase in the heat transfer rates, particularly at low heat flux values and near the CHF. Boiling hysteresis was reduced progressively by EHD and eliminated at high field strength.This work was supported by Government of Pakistan under a scholarship programme

    The Case On Assessment Of Spilled Oil With Mixed Free Product In Seoul

    Get PDF
    The purpose of this study is to assess sources of contamination by analyzing the free product and oil compounds in groundwater near the Subway Station, located adjacent to the Yongsan Garrison in Seoul, Republic of Korea. All of the samples collected twice were groundwater and free product in a monitoring well. Analysis items are TPH fingerprinting, pristine/phytane ratio, alkylbenzene pattern, PAH&alkyl PAH, antioxidant, icing inhibitor, PIANO, element(C, N, H), and sulfur. Using ratio of pristine/phytane, we were able to distinguished fuel type between kerosene and JP-8 samples, which was impossible by GC/FID pattern. Alkyl benzene pattern was very effective in distinguishing between JP-8 and kerosene. It is very important that 2,4-dimethyl-6-tert-butyl phenol, an antioxidant used only for JP-8, was detected in free product samples. The concentration of sulfur in kerosene fuel is much lower than that of JP-8, and the total contents of sulfur in environmental samples can be used to differentiate the fuel type of spilled oil between kerosene and JP-8. In conclusion, according to the result of a variety of analytical methods to find the source of spilled fuel, it had been found that the fuel type detected in the tunnel of subway station and monitoring wells outside of Yongsan Garrison and the monitoring wells inside of Yongsan Garrison are the same
    corecore