Structure-property relationships in glass-reinforced polyamide, part 1: The effects of fiber content

We present the results of an extensive study of the performance of injection-molded glass-fiber reinforced polyamide 66 with glass content between 0 and 40% and based on two chopped glass products both sized with polyamide compatible sizing. Mechanical properties generally improved with increasing glass content, modulus linearly, strength with a maximum at 40-50% glass content, and impact showing an initial decrease from the resin value with a minimum at 4% glass content before increasing at higher glass contents. Residual fiber length decreased linearly with increasing glass content. Interfacial strength was found to be in the range of 30-36 MPa, and no significant differences in dry as molded performance was found between the 123D and 173X sizings. Conditioning these composites in either boiling water or water/glycol mixtures leads to a dramatic drop in both tensile modulus and tensile strength. This is most likely due to the high level of matrix plasticization. After conditioning, the 173X sized glass delivered a significantly higher level of tensile elongation at all fiber contents. Excellent agreement was obtained between the experimental data and the theoretical predictions of the rule of mixtures model for modulus and the Kelly-Tyson model for strength over the range of fiber concentrations studied

Structure-property relationships in glass reinforced polyamide, part 2: The effects of average fiber diameter and diameter distribution

We present the results of an extensive study of the influence of average fibre diameter and the width of the diameter distribution on the performance of injection moulded glass-fibre reinforced polyamide 66. In the average fibre diameter range from 9-18m dry-as-moulded (DaM) composite unnotched impact and tensile strength decreased significantly. The composite notched impact performance and tensile modulus showed little dependence on fibre diameter. The influence of broadening the fibre diameter distribution by blending glass fibre samples of different average diameter was found to be particularly negative on the level of composite unnotched impact when compared at equal number average diameter. After hydrolysis treatment the composite tensile strength and modulus exhibited a large drop compared to the DaM results. In contrast, the unnotched impact results became insensitive to fibre diameter after hydrolysis. The average level of unnotched impact after hydrolysis was sufficiently high to show an increase over DaM when the fibre diameter was above 14m. Residual fibre length correlated significantly with fibre diameter with a lower average length for thinner fibres. The interfacial shear strength was found to be in the range of 26-34 MPa for DaM composites. There was a highly significant inverse correlation between the DaM interfacial strength and the average fibre diameter. It is shown that results from both tensile and unnotched impact measurements can be brought back to single trend lines by using a Z average value for the average fibre diameter which is more heavily weighted to the thicker fibres in the distribution

Cassiopeia A, Cygnus A, Taurus A, and Virgo A at ultra-low radio frequencies

Context. The four persistent radio sources in the northern sky with the highest flux density at metre wavelengths are Cassiopeia A, Cygnus A, Taurus A, and Virgo A; collectively they are called the A-team. Their flux densities at ultra-low frequencies (< 100 MHz) can reach several thousands of janskys, and they often contaminate observations of the low-frequency sky by interfering with image processing. Furthermore, these sources are foreground objects for all-sky observations hampering the study of faint signals, such as the cosmological 21 cm line from the epoch of reionisation. Aims. We aim to produce robust models for the surface brightness emission as a function of frequency for the A-team sources at ultra-low frequencies. These models are needed for the calibration and imaging of wide-area surveys of the sky with low-frequency interferometers. This requires obtaining images at an angular resolution better than 15\u2033 with a high dynamic range and good image fidelity. Methods. We observed the A-team with the Low Frequency Array (LOFAR) at frequencies between 30 MHz and 77 MHz using the Low Band Antenna system. We reduced the datasets and obtained an image for each A-team source. Results. The paper presents the best models to date for the sources Cassiopeia A, Cygnus A, Taurus A, and Virgo A between 30 MHz and 77 MHz. We were able to obtain the aimed resolution and dynamic range in all cases. Owing to its compactness and complexity, observations with the long baselines of the International LOFAR Telescope will be required to improve the source model for Cygnus A further

LOFAR 144-MHz follow-up observations of GW170817

This article has been accepted for publication in Monthly Notices of the Royal Astronomical Society, Volume 494, Issue 4, June 2020, Pages 5110–5117, ©: 2020 The Author(s). Published by Oxford University Press on behalf of the Royal Astronomical Society. All rights reserved.We present low-radio-frequency follow-up observations of AT 2017gfo, the electromagnetic counterpart of GW170817, which was the first binary neutron star merger to be detected by Advanced LIGO-Virgo. These data, with a central frequency of 144 MHz, were obtained with LOFAR, the Low-Frequency Array. The maximum elevation of the target is just 13.7 degrees when observed with LOFAR, making our observations particularly challenging to calibrate and significantly limiting the achievable sensitivity. On time-scales of 130-138 and 371-374 days after the merger event, we obtain 3$\sigma$ upper limits for the afterglow component of 6.6 and 19.5 mJy beam$^{-1}$, respectively. Using our best upper limit and previously published, contemporaneous higher-frequency radio data, we place a limit on any potential steepening of the radio spectrum between 610 and 144 MHz: the two-point spectral index $\alpha^{610}_{144} \gtrsim -2.5$. We also show that LOFAR can detect the afterglows of future binary neutron star merger events occurring at more favourable elevations.Peer reviewe

Multi-messenger observations of a binary neutron star merger

On 2017 August 17 a binary neutron star coalescence candidate (later designated GW170817) with merger time 12:41:04 UTC was observed through gravitational waves by the Advanced LIGO and Advanced Virgo detectors. The Fermi Gamma-ray Burst Monitor independently detected a gamma-ray burst (GRB 170817A) with a time delay of ~1.7 s with respect to the merger time. From the gravitational-wave signal, the source was initially localized to a sky region of 31 deg2 at a luminosity distance of 40+8-8 Mpc and with component masses consistent with neutron stars. The component masses were later measured to be in the range 0.86 to 2.26 Mo. An extensive observing campaign was launched across the electromagnetic spectrum leading to the discovery of a bright optical transient (SSS17a, now with the IAU identification of AT 2017gfo) in NGC 4993 (at ~40 Mpc) less than 11 hours after the merger by the One- Meter, Two Hemisphere (1M2H) team using the 1 m Swope Telescope. The optical transient was independently detected by multiple teams within an hour. Subsequent observations targeted the object and its environment. Early ultraviolet observations revealed a blue transient that faded within 48 hours. Optical and infrared observations showed a redward evolution over ~10 days. Following early non-detections, X-ray and radio emission were discovered at the transient’s position ~9 and ~16 days, respectively, after the merger. Both the X-ray and radio emission likely arise from a physical process that is distinct from the one that generates the UV/optical/near-infrared emission. No ultra-high-energy gamma-rays and no neutrino candidates consistent with the source were found in follow-up searches. These observations support the hypothesis that GW170817 was produced by the merger of two neutron stars in NGC4993 followed by a short gamma-ray burst (GRB 170817A) and a kilonova/macronova powered by the radioactive decay of r-process nuclei synthesized in the ejecta

LOFAR 144-MHz follow-up observations of GW170817

ABSTRACT We present low-radio-frequency follow-up observations of AT 2017gfo, the electromagnetic counterpart of GW170817, which was the first binary neutron star merger to be detected by Advanced LIGO–Virgo. These data, with a central frequency of 144 MHz, were obtained with LOFAR, the Low-Frequency Array. The maximum elevation of the target is just 13${_{.}^{\circ}}$7 when observed with LOFAR, making our observations particularly challenging to calibrate and significantly limiting the achievable sensitivity. On time-scales of 130–138 and 371–374 d after the merger event, we obtain 3σ upper limits for the afterglow component of 6.6 and 19.5 mJy beam−1, respectively. Using our best upper limit and previously published, contemporaneous higher frequency radio data, we place a limit on any potential steepening of the radio spectrum between 610 and 144 MHz: the two-point spectral index $\alpha ^{610}_{144} \gtrsim$ −2.5. We also show that LOFAR can detect the afterglows of future binary neutron star merger events occurring at more favourable elevations.</jats:p