High pressure pre-treatments promote higher rate and degree of enzymatic hydrolysis of cellulose

The effect of high pressure (HP) pre-treatments on the subsequent enzymatic hydrolysis of cellulose from bleached kraft Eucalyptus globulus pulp by cellulase from Tricoderma viride was evaluated. Pressure pre-treatments of 300 and 400 MPa during 5–45 min, lead to both an increased rate and degree of hydrolysis, reaching values ranging from 1.5- to 1.9-fold, quantified by the formation of reducing sugars. Both the pressure and time under pressure influenced the enzymatic hydrosability of the cellulosic pulps, with the former being more important. The results indicate that the pressure pre-treatments promoted an increased accessibility of cellulose towards cellulase in the cell wall. The results obtained open promising possibilities, to contribute to overcome conventional limitations of enzymatic cellulose hydrolysis for the production of fermentable glucose, for the production of second generation bioethanol and chemicals by enhancement of both rate and yield of hydrolysis. The results are also of interest for the preparation of “pressure engineered” celullose with incremented tailored hydrolysis patterns

Influence of Surface Chemistry on Ibuprofen Adsorption and Confinement in Mesoporous Silicon Microparticles

The effect of adsorption and confinement on ibuprofen was studied by immersion loading the molecules into porous silicon (PSi) microparticles. The PSi micro particles were modified into thermally oxidized PSi (TOPSi) and thermally hydrocarbonized PSi (THCPSi) to evaluate the effects of the loading solvent and the surface chemistry on the obtainable drug payloads. The payloads, location, and the molecular state of the adsorbed drug were evaluated using thermal analysis. The results showed that after the adsorption of similar to 800 mg/cm(3) (w(drug)/v(pores)) of drug into the mesopores, depending on the solvent used in the immersion, the drug began to rapidly recrystallize on the external surface of the particles. Moderate concentrations, however, enabled payloads of 800-850 mg/cm(3) without excessive surface crystallization, and thus, there was no need for rinsing the samples to remove the externally crystallized portion. The results showed that the confined ibuprofen forms nanocrystals inside of the mesopores after approximately 200 mg/cm(3) payloads were obtained, accounting for half of the adsorbed drug amount. The presence of both crystalline and noncrystalline phases was further characterized using variable temperature solid-state nuclear magnetic resonance (NMR) measurements. The interactions between the drug molecules and the pore walls of TOPSi and THCPSi were observed using Fourier transform infrared and H-1 NMR spectroscopies, and the hydrogen bonding between the silanol groups of TOPSi and the adsorbed ibuprofen was confirmed, but having only limited effect on the overall state of the confined drug. In vitro drug permeation studies in Caco-2 and Caco-2/HT29 cocultures showed that the adsorption onto hydrophilic or hydrophobic PSi microparticles had no significant effects on the ibuprofen permeation, whether the drug was partially nanocrystalline or completely in a liquidlike state

Causes and Treatment Outcomes of Stevens-Johnson Syndrome and Toxic Epidermal Necrolysis in 82 Adult Patients

original article korean j intern med 2012;27:203-21

Jet energy measurement with the ATLAS detector in proton-proton collisions at root s=7 TeV

The jet energy scale and its systematic uncertainty are determined for jets measured with the ATLAS detector at the LHC in proton-proton collision data at a centre-of-mass energy of √s = 7TeV corresponding to an integrated luminosity of 38 pb-1. Jets are reconstructed with the anti-kt algorithm with distance parameters R=0. 4 or R=0. 6. Jet energy and angle corrections are determined from Monte Carlo simulations to calibrate jets with transverse momenta pT≥20 GeV and pseudorapidities {pipe}η{pipe}<4. 5. The jet energy systematic uncertainty is estimated using the single isolated hadron response measured in situ and in test-beams, exploiting the transverse momentum balance between central and forward jets in events with dijet topologies and studying systematic variations in Monte Carlo simulations. The jet energy uncertainty is less than 2. 5 % in the central calorimeter region ({pipe}η{pipe}<0. 8) for jets with 60≤pT<800 GeV, and is maximally 14 % for pT<30 GeV in the most forward region 3. 2≤{pipe}η{pipe}<4. 5. The jet energy is validated for jet transverse momenta up to 1 TeV to the level of a few percent using several in situ techniques by comparing a well-known reference such as the recoiling photon pT, the sum of the transverse momenta of tracks associated to the jet, or a system of low-pT jets recoiling against a high-pT jet. More sophisticated jet calibration schemes are presented based on calorimeter cell energy density weighting or hadronic properties of jets, aiming for an improved jet energy resolution and a reduced flavour dependence of the jet response. The systematic uncertainty of the jet energy determined from a combination of in situ techniques is consistent with the one derived from single hadron response measurements over a wide kinematic range. The nominal corrections and uncertainties are derived for isolated jets in an inclusive sample of high-pT jets. Special cases such as event topologies with close-by jets, or selections of samples with an enhanced content of jets originating from light quarks, heavy quarks or gluons are also discussed and the corresponding uncertainties are determined. © 2013 CERN for the benefit of the ATLAS collaboration

Measurement of the inclusive and dijet cross-sections of b-jets in pp collisions at sqrt(s) = 7 TeV with the ATLAS detector

The inclusive and dijet production cross-sections have been measured for jets containing b-hadrons (b-jets) in proton-proton collisions at a centre-of-mass energy of sqrt(s) = 7 TeV, using the ATLAS detector at the LHC. The measurements use data corresponding to an integrated luminosity of 34 pb^-1. The b-jets are identified using either a lifetime-based method, where secondary decay vertices of b-hadrons in jets are reconstructed using information from the tracking detectors, or a muon-based method where the presence of a muon is used to identify semileptonic decays of b-hadrons inside jets. The inclusive b-jet cross-section is measured as a function of transverse momentum in the range 20 < pT < 400 GeV and rapidity in the range |y| < 2.1. The bbbar-dijet cross-section is measured as a function of the dijet invariant mass in the range 110 < m_jj < 760 GeV, the azimuthal angle difference between the two jets and the angular variable chi in two dijet mass regions. The results are compared with next-to-leading-order QCD predictions. Good agreement is observed between the measured cross-sections and the predictions obtained using POWHEG + Pythia. MC@NLO + Herwig shows good agreement with the measured bbbar-dijet cross-section. However, it does not reproduce the measured inclusive cross-section well, particularly for central b-jets with large transverse momenta.Comment: 10 pages plus author list (21 pages total), 8 figures, 1 table, final version published in European Physical Journal

Measurement of the cross-section of high transverse momentum vector bosons reconstructed as single jets and studies of jet substructure in pp collisions at √s = 7 TeV with the ATLAS detector

This paper presents a measurement of the cross-section for high transverse momentum W and Z bosons produced in pp collisions and decaying to all-hadronic final states. The data used in the analysis were recorded by the ATLAS detector at the CERN Large Hadron Collider at a centre-of-mass energy of √s = 7 TeV;{\rm Te}{\rm V}$and correspond to an integrated luminosity of$4.6\;{\rm f}{{{\rm b}}^{-1}}$. The measurement is performed by reconstructing the boosted W or Z bosons in single jets. The reconstructed jet mass is used to identify the W and Z bosons, and a jet substructure method based on energy cluster information in the jet centre-of-mass frame is used to suppress the large multi-jet background. The cross-section for events with a hadronically decaying W or Z boson, with transverse momentum${{p}_{{\rm T}}}\gt 320\;{\rm Ge}{\rm V}$and pseudorapidity$|\eta |\lt 1.9$, is measured to be${{\sigma }_{W+Z}}=8.5\pm 1.7$ pb and is compared to next-to-leading-order calculations. The selected events are further used to study jet grooming techniques

Observation of associated near-side and away-side long-range correlations in √sNN=5.02 TeV proton-lead collisions with the ATLAS detector

Two-particle correlations in relative azimuthal angle (Δϕ) and pseudorapidity (Δη) are measured in √sNN=5.02  TeV p+Pb collisions using the ATLAS detector at the LHC. The measurements are performed using approximately 1  μb-1 of data as a function of transverse momentum (pT) and the transverse energy (ΣETPb) summed over 3.1<η<4.9 in the direction of the Pb beam. The correlation function, constructed from charged particles, exhibits a long-range (2<|Δη|<5) “near-side” (Δϕ∼0) correlation that grows rapidly with increasing ΣETPb. A long-range “away-side” (Δϕ∼π) correlation, obtained by subtracting the expected contributions from recoiling dijets and other sources estimated using events with small ΣETPb, is found to match the near-side correlation in magnitude, shape (in Δη and Δϕ) and ΣETPb dependence. The resultant Δϕ correlation is approximately symmetric about π/2, and is consistent with a dominant cos⁡2Δϕ modulation for all ΣETPb ranges and particle pT

Search for new phenomena in final states with an energetic jet and large missing transverse momentum in pp collisions at √ s = 8 TeV with the ATLAS detector

Results of a search for new phenomena in final states with an energetic jet and large missing transverse momentum are reported. The search uses 20.3 fb−1 of √ s = 8 TeV data collected in 2012 with the ATLAS detector at the LHC. Events are required to have at least one jet with pT > 120 GeV and no leptons. Nine signal regions are considered with increasing missing transverse momentum requirements between Emiss T > 150 GeV and Emiss T > 700 GeV. Good agreement is observed between the number of events in data and Standard Model expectations. The results are translated into exclusion limits on models with either large extra spatial dimensions, pair production of weakly interacting dark matter candidates, or production of very light gravitinos in a gauge-mediated supersymmetric model. In addition, limits on the production of an invisibly decaying Higgs-like boson leading to similar topologies in the final state are presente