Exploiting the WH/ZH symmetry in the search for New Physics

We suggest to isolate the loop-induced gluon-initiated component ($gg\to ZH$) for associated $ZH$ production by using the similarity of the Drell-Yan-like component for $ZH$ production to the $WH$ process. We argue that the cross-section ratio of the latter two processes can be predicted with high theoretical accuracy. Comparing it to the experimental $ZH/WH$ cross-section ratio should allow to probe for New Physics in the $gg\to ZH$ component at the HL-LHC. We consider typical BSM scenarios in order to exemplify the effect they would have on the proposed observable.Comment: 22 pages, 10 figures. v2: Minor changes; matches published versio

Fatigue behavior and cyclic damage of peek short fiber reinforced composites

Fatigue strength and failure mechanisms of short fiber reinforced (SFR) PEEK have been investigated in the past by several research groups. However some relevant aspects of the fatigue behavior of these materials, like cyclic creep and fatigue damage accumulation and modeling, have not been studied yet, in particular in presence of both fillers and short fibers as reinforcement. In the present research these aspects were considered by carrying out uni-axial fatigue tests in load control (cycle ratio R = 0) on neat PEEK and PEEK based composites reinforced either with short carbon fibers only or with addition of fillers (graphite and PTFE). For each material stress-life curves were obtained and compared. Fatigue fracture surfaces were analyzed to identify failure mechanisms in presence of different reinforcement types. The evolution of cyclic creep strain was also monitored as a function of the number of cycles, thus allowing investigation on the correlation between cyclic creep parameters and fatigue life. The evolution of cyclic damage with loading cycles was then compared by defining a damage parameter related to the specimen stiffness reduction observed during the tests. Progressive cyclic damage evolution of short fiber reinforced PEEK composites presented significantly different patterns depending on applied stress level and on the presence of different reinforcement typologies. In order to reproduce the different fatigue damage kinetics and stages of progressive damage accumulation observed experimentally, a cyclic damage model was finally developed and implemented into a finite element code by which a satisfactory agreement between numerical prediction and experimental data at different stress levels for each examined material

Measurement of the cross-section and charge asymmetry of WW bosons produced in proton-proton collisions at s=8\sqrt{s}=8 TeV with the ATLAS detector

This paper presents measurements of the $W^+ \rightarrow \mu^+\nu$ and $W^- \rightarrow \mu^-\nu$ cross-sections and the associated charge asymmetry as a function of the absolute pseudorapidity of the decay muon. The data were collected in proton--proton collisions at a centre-of-mass energy of 8 TeV with the ATLAS experiment at the LHC and correspond to a total integrated luminosity of 20.2~\mbox{fb^{-1}}. The precision of the cross-section measurements varies between 0.8% to 1.5% as a function of the pseudorapidity, excluding the 1.9% uncertainty on the integrated luminosity. The charge asymmetry is measured with an uncertainty between 0.002 and 0.003. The results are compared with predictions based on next-to-next-to-leading-order calculations with various parton distribution functions and have the sensitivity to discriminate between them.Comment: 38 pages in total, author list starting page 22, 5 figures, 4 tables, submitted to EPJC. All figures including auxiliary figures are available at https://atlas.web.cern.ch/Atlas/GROUPS/PHYSICS/PAPERS/STDM-2017-13

Search for chargino-neutralino production with mass splittings near the electroweak scale in three-lepton final states in √s=13 TeV pp collisions with the ATLAS detector

A search for supersymmetry through the pair production of electroweakinos with mass splittings near the electroweak scale and decaying via on-shell W and Z bosons is presented for a three-lepton final state. The analyzed proton-proton collision data taken at a center-of-mass energy of √s=13  TeV were collected between 2015 and 2018 by the ATLAS experiment at the Large Hadron Collider, corresponding to an integrated luminosity of 139  fb−1. A search, emulating the recursive jigsaw reconstruction technique with easily reproducible laboratory-frame variables, is performed. The two excesses observed in the 2015–2016 data recursive jigsaw analysis in the low-mass three-lepton phase space are reproduced. Results with the full data set are in agreement with the Standard Model expectations. They are interpreted to set exclusion limits at the 95% confidence level on simplified models of chargino-neutralino pair production for masses up to 345 GeV

Search for new phenomena in final states with an energetic jet and large missing transverse momentum in pp collisions at √ s = 8 TeV with the ATLAS detector

Results of a search for new phenomena in final states with an energetic jet and large missing transverse momentum are reported. The search uses 20.3 fb−1 of √ s = 8 TeV data collected in 2012 with the ATLAS detector at the LHC. Events are required to have at least one jet with pT > 120 GeV and no leptons. Nine signal regions are considered with increasing missing transverse momentum requirements between Emiss T > 150 GeV and Emiss T > 700 GeV. Good agreement is observed between the number of events in data and Standard Model expectations. The results are translated into exclusion limits on models with either large extra spatial dimensions, pair production of weakly interacting dark matter candidates, or production of very light gravitinos in a gauge-mediated supersymmetric model. In addition, limits on the production of an invisibly decaying Higgs-like boson leading to similar topologies in the final state are presente

Les Houches 2015: Physics at TeV Colliders Standard Model Working Group Report

This Report summarizes the proceedings of the 2015 Les Houches workshop on Physics at TeV Colliders. Session 1 dealt with (I) new developments relevant for high precision Standard Model calculations, (II) the new PDF4LHC parton distributions, (III) issues in the theoretical description of the production of Standard Model Higgs bosons and how to relate experimental measurements, (IV) a host of phenomenological studies essential for comparing LHC data from Run I with theoretical predictions and projections for future measurements in Run II, and (V) new developments in Monte Carlo event generators.Comment: Proceedings of the Standard Model Working Group of the 2015 Les Houches Workshop, Physics at TeV Colliders, Les Houches 1-19 June 2015. 227 page

Advances with long non-coding rnas in alzheimer’s disease as peripheral biomarker

One of the most compelling needs in the study of Alzheimer’s disease (AD) is the characterization of cognitive decline peripheral biomarkers. In this context, the theme of altered RNA processing has emerged as a contributing factor to AD. In particular, the significant role of long non-coding RNAs (lncRNAs) associated to AD is opening new perspectives in AD research. This class of RNAs may offer numerous starting points for new investigations about pathogenic mechanisms and, in particular, about peripheral biomarkers. Indeed, altered lncRNA signatures are emerging as potential diagnostic biomarkers. In this review, we have collected and fully explored all the presented data about lncRNAs and AD in the peripheral system to offer an overview about this class of non-coding RNAs and their possible role in AD

Development and Comparison of Model-Based and Data-Driven Approaches for the Prediction of the Mechanical Properties of Lattice Structures

Lattice structures have great potential for several application fields ranging from medical and tissue engineering to aeronautical one. Their development is further speeded up by the continuing advances in additive manufacturing technologies that allow to overcome issues typical of standard processes and to propose tailored designs. However, the design of lattice structures is still challenging since their properties are considerably affected by numerous factors. The present paper aims to propose, discuss, and compare various modeling approaches to describe, understand, and predict the correlations between the mechanical properties and the void volume fraction of different types of lattice structures fabricated by fused deposition modeling 3D printing. Particularly, four approaches are proposed: (i) a simplified analytical model; (ii) a semi-empirical model combining analytical equations with experimental correction factors; (iii) an artificial neural network trained on experimental data; (iv) numerical simulations by finite element analyses. The comparison among the various approaches, and with experimental data, allows to identify the performances, advantages, and disadvantages of each approach, thus giving important guidelines for choosing the right design methodology based on the needs and available data

Correlated long-range mixed-harmonic fluctuations measured in pp, p+Pb and low-multiplicity Pb+Pb collisions with the ATLAS detector

For abstract see published article

Muon reconstruction performance of the ATLAS detector in proton–proton collision data at √s = 13 TeV

This article documents the performance of the ATLAS muon identification and reconstruction using the LHC dataset recorded at √s = 13 TeV in 2015. Using a large sample of J/ψ→μμ and Z→μμ decays from 3.2 fb−1 of pp collision data, measurements of the reconstruction efficiency, as well as of the momentum scale and resolution, are presented and compared to Monte Carlo simulations. The reconstruction efficiency is measured to be close to 99% over most of the covered phase space (|η| 2.2, the pT resolution for muons from Z→μμ decays is 2.9 % while the precision of the momentum scale for low-pT muons from J/ψ→μμ decays is about 0.2%