Biodegradable fixation for craniomaxillofacial surgery: a 10-year experience involving 761 operations and 745 patients

Patient acceptance, safety, and efficacy of poly-L/DL-lactic acid (PLLDL) bone plates and screws in craniomaxillofacial surgery are reported in this article. Included in the sample are 745 patients who underwent 761 separate operations, including more than 1400 surgical procedures (orthognathic surgery (685), bone graft reconstruction (37), trauma (191) and transcranial surgery (20)). The success (no breakage or inflammation requiring additional operating room treatment) was 94%. Failure occurred because of breakage (14) or exuberant inflammation (31). All breakage occurred at mandibular sites and the majority of inflammatory failure occurred in the maxilla or orbit (29), with only two in the mandible. Failures were evenly distributed between the two major vendors. PLLDL 70/30 bone plates and screws may be used successfully in a variety of craniomaxillofacial surgical applications. The advantages include the gradual transference of physiological forces to the healing bone, the reduced need for a second operation to remove the material and its potential to serve as a vehicle to deliver bone-healing proteins to fracture/osteotomy sites. Bone healing was noted at all sites, even where exuberant inflammation required a second surgical intervention

Long-term stability of adolescent versus adult surgery for treatment of mandibular deficiency

In mandibular deficient patients, mandibular growth is not expected after the adolescent growth spurt, so mandibular advancement surgery is often carried out at 13 years. To test if the long-term stability for younger patients is similar to that for adult patients, the authors compared cephalometric changes from 1 year postsurgery (when changes due to the surgery should be completed) to 5 year follow up. 32 patients who had early mandibular advancement with or without simultaneous maxillary surgery (aged up to 16 for girls and 18 for boys), and 52 patients with similar surgery at older ages were studied. Beyond 1 year postsurgery, the younger patients showed significantly greater change in the horizontal and vertical position of points B and pogonion, the horizontal (but not vertical) position of gonion, and mandibular plane angle. 50% of younger patients had 2–4 mm backward movement of Pg and another 25% had >4 mm. 15% of older patients had 2–4 mm change and none had >4 mm. Long-term changes in younger patients who had 2-jaw surgery were greater than for mandibular advancement only. Changes in younger groups were greater than for adult groups. Satisfaction with treatment and perception of problems were similar for both groups

Facial altered sensation and sensory impairment after orthognathic surgery

The aim of this study was to determine whether impairment of sensory function after trigeminal nerve injury differs in severity among patients who report qualitatively different altered sensations. Data were obtained from 184 patients. Before and at 1, 3 and 6 months after orthognathic surgery, patients were grouped as having no altered sensation, negative sensations only (hypoesthetic), mixed sensations (negative + active), or active sensations only (paresthetic or dysesthetic). Bias-free estimates of contact detection and two-point discrimination were obtained to assess, via ANOVA, whether patients in the four groups exhibited different levels of sensory impairment. Impairment in contact detection and two-point discrimination was found to differ significantly among the groups at 6 months but not at 1 month. At 6 months, patients who reported negative sensations only exhibited the greatest impairment, on average, in contact detection; in contrast, patients who reported mixed sensations exhibited the greatest impairment in two-point discrimination. The least residual impairment at 6 months was observed in patients who reported no altered sensation. It is recommended that clinical judgments regarding nerve injury-associated sensory dysfunction not be based on threshold testing results without consideration of patients’ subjective reports of altered sensation

Postoperative nausea and vomiting following orthognathic surgery

The purpose of this study was to assess the incidence and risk factors associated with postoperative nausea (PON) and vomiting (POV) after orthognathic surgery. A review of the clinical records of consecutively enrolled subjects (2008–2012) at a single academic institution was conducted between 9/2013 and 3/2014. Data on the occurrence of PON and POV and potential patient-related, intraoperative, and postoperative explanatory factors were extracted from the medical records. Logistic models were used for the presence/absence of postoperative nausea and vomiting separately. Data from 204 subjects were analyzed: 63% were female, 72% Caucasian, and the median age was 19 years. Thirty-three percent had a mandibular osteotomy alone, 27% a maxillary osteotomy alone, and 40% had bimaxillary osteotomies. Sixty-seven percent experienced PON and 27% experienced POV. The most important risk factors for PON in this series were female gender, increased intravenous fluids, and the use of nitrous oxide, and for POV were race, additional procedures, and morphine administration. The incidence of PON and POV following orthognathic surgery in the current cohort of patients, after the introduction of the updated 2007 consensus guidelines for the management of postoperative nausea and vomiting, has not decreased substantially from that reported in 2003–2004

Are bioresorbable polylactate devices comparable to titanium devices for stabilizing Le Fort I advancement?

AbstractThe purpose of this study was to evaluate whether skeletal and dental outcomes following Le Fort I surgery differed when stabilization was performed with polylactate bioresorbable devices or titanium devices. Fifty-seven patients with preoperative records and at least 1 year postoperative records were identified and grouped according to the stabilization method. All cephalometric X-rays were traced and digitized by a single operator. Analysis of covariance was used to compare the postsurgical change between the two stabilization methods. Twenty-seven patients received bioresorbable devices (group R), while 30 received titanium devices (group M). There were no statistically significant differences between the two groups with respect to gender, race/ethnicity, age, or dental and skeletal movements during surgery. Subtle postsurgical differences were noted, but were not statistically significant. Stabilization of Le Fort I advancement with polylactate bioresorbable and titanium devices produced similar clinical outcomes at 1 year following surgery

Measurement of the correlation between flow harmonics of different order in lead-lead collisions at √sNN = 2.76 TeV with the ATLAS detector

Correlations between the elliptic or triangular flow coefficients vm (m=2 or 3) and other flow harmonics vn (n=2 to 5) are measured using √sNN=2.76 TeV Pb+Pb collision data collected in 2010 by the ATLAS experiment at the LHC, corresponding to an integrated luminosity of 7 μb−1. The vm−vn correlations are measured in midrapidity as a function of centrality, and, for events within the same centrality interval, as a function of event ellipticity or triangularity defined in a forward rapidity region. For events within the same centrality interval, v3 is found to be anticorrelated with v2 and this anticorrelation is consistent with similar anticorrelations between the corresponding eccentricities, ε2 and ε3. However, it is observed that v4 increases strongly with v2, and v5 increases strongly with both v2 and v3. The trend and strength of the vm−vn correlations for n=4 and 5 are found to disagree with εm−εn correlations predicted by initial-geometry models. Instead, these correlations are found to be consistent with the combined effects of a linear contribution to vn and a nonlinear term that is a function of v22 or of v2v3, as predicted by hydrodynamic models. A simple two-component fit is used to separate these two contributions. The extracted linear and nonlinear contributions to v4 and v5 are found to be consistent with previously measured event-plane correlations

Search for vectorlike B quarks in events with one isolated lepton, missing transverse momentum, and jets at √s = 8 TeV with the ATLAS detector

A search has been performed for pair production of heavy vectorlike down-type (B) quarks. The analysis explores the lepton-plus-jets final state, characterized by events with one isolated charged lepton (electron or muon), significant missing transverse momentum, and multiple jets. One or more jets are required to be tagged as arising from b quarks, and at least one pair of jets must be tagged as arising from the hadronic decay of an electroweak boson. The analysis uses the full data sample of pp collisions recorded in 2012 by the ATLAS detector at the LHC, operating at a center-of-mass energy of 8 TeV, corresponding to an integrated luminosity of 20.3 fb −1 . No significant excess of events is observed above the expected background. Limits are set on vectorlike B production, as a function of the B branching ratios, assuming the allowable decay modes are B → Wt/Zb/Hb. In the chiral limit with a branching ratio of 100% for the decay B → Wt, the observed (expected) 95% C.L. lower limit on the vectorlike B mass is 810 GeV (760 GeV). In the case where the vectorlike B quark has branching ratio values corresponding to those of an SU(2) singlet state, the observed (expected) 95% C.L. lower limit on the vectorlike B mass is 640 GeV (505 GeV). The same analysis, when used to investigate pair production of a colored, charge 5/3 exotic fermion T 5/3 , with subsequent decay T 5/3 → Wt, sets an observed (expected) 95% C.L. lower limit on the T 5/3 mass of 840 GeV (780 GeV)

Fiducial and differential cross sections of Higgs boson production measured in the four-lepton decay channel in pp collisions at √s = 8 TeV with the ATLAS detector

Measurements of fiducial and differential cross sections of Higgs boson production in the H→ZZ∗ → 4ℓ decay channel are presented. The cross sections are determined within a fiducial phase space and corrected for detection efficiency and resolution effects. They are based on 20.3 fb−¹ of pp collision data, produced at √s = 8 TeV centre-of-mass energy at the LHC and recorded by the ATLAS detector. The differential measurements are performed in bins of transverse momentum and rapidity of the four-lepton system, the invariant mass of the subleading lepton pair and the decay angle of the leading lepton pair with respect to the beam line in the four-lepton rest frame, as well as the number of jets and the transverse momentum of the leading jet. The measured cross sections are compared to selected theoretical calculations of the Standard Model expectations. No significant deviation from any of the tested predictions is found

Search for strong gravity in multijet final states produced in pp collisions at √s=13 TeV using the ATLAS detector at the LHC

A search is conducted for new physics in multijet final states using 3.6 inverse femtobarns of data from proton-proton collisions at √s = 13TeV taken at the CERN Large Hadron Collider with the ATLAS detector. Events are selected containing at least three jets with scalar sum of jet transverse momenta (HT) greater than 1TeV. No excess is seen at large HT and limits are presented on new physics: models which produce final states containing at least three jets and having cross sections larger than 1.6 fb with HT > 5.8 TeV are excluded. Limits are also given in terms of new physics models of strong gravity that hypothesize additional space-time dimensions

The performance of the jet trigger for the ATLAS detector during 2011 data taking

The performance of the jet trigger for the ATLAS detector at the LHC during the 2011 data taking period is described. During 2011 the LHC provided proton–proton collisions with a centre-of-mass energy of 7 TeV and heavy ion collisions with a 2.76 TeV per nucleon–nucleon collision energy. The ATLAS trigger is a three level system designed to reduce the rate of events from the 40 MHz nominal maximum bunch crossing rate to the approximate 400 Hz which can be written to offline storage. The ATLAS jet trigger is the primary means for the online selection of events containing jets. Events are accepted by the trigger if they contain one or more jets above some transverse energy threshold. During 2011 data taking the jet trigger was fully efficient for jets with transverse energy above 25 GeV for triggers seeded randomly at Level 1. For triggers which require a jet to be identified at each of the three trigger levels, full efficiency is reached for offline jets with transverse energy above 60 GeV. Jets reconstructed in the final trigger level and corresponding to offline jets with transverse energy greater than 60 GeV, are reconstructed with a resolution in transverse energy with respect to offline jets, of better than 4 % in the central region and better than 2.5 % in the forward direction