Heat transfer in steady-periodic flows over heated microwires

Effects of Reynolds number (Re), nondimensional drive frequency (Srp) and amplitude of yoscillations in the flow on the heat transfer coefficient and its frequency response characteristics for oscillatory flows over a micro wire are presented here. Time-averaged Nusselt numbers (Nu) at the stagnation point and averaged over the cylinder are calculated for Re = 10, 30 and 50, .001 < Srp < 1., and oscillation amplitudes, Vp, of 0.1 and 0.2 (for Re = 50). We used a formulation that allows decomposition of the flow into mean and periodic components, and used finite-element simulations to solve for the mean flow over the cylinder. Periodic component of the flow contributes to an artificial body force in the Navier-Stokes equation. According to our simulations, time-averaged Nusselt numbers are not strongly affected by oscillations. Largest increase in the time-averaged average Nu is only 3% larger than its unforced value. Nusselt oscillations have multiple modes and we used Fourier Transform to identify each mode and calculate its corresponding amplitude. The mode for which the frequency is twice as much as the driving frequency is the dominant mode for Srp up to 0.1 for all Reynolds numbers studied here. For larger drive frequencies, the second mode dies off; for Re = 30 and 50 amplitude of the first mode at the drive frequency takes over. For large drive frequencies (Srp~1) all modes tend to diminish

Relationship between Coronal Alignment and Posterior Tibial Slope in the Lower Extremity

Abstract Purpose: To restore the normal axial alignment of the lower extremity is important in reconstructive knee surgery. The aim of this study was to evaluate lower-limb alignment and posterior tibial slope. Methods: Thirty-two male and 32 female outpatients aged 22 to 46 were recruited. A full weight-bearing anteroposterior radiograph of the entire lower limb was obtained for each subject. The axial alignment was measured based on the centers of the femoral head, knee, and ankle. The tibiofemoral (TF), tibial joint (TJ), and posterior tibial slope (TS) angles were determined. Results: The mean TF angle was more varus in women (177.8˚) than men (179.2˚), and the mean TJ angle was more medially inclined in women than men. Women had a greater TJ angle than men (93.3˚ vs. 91.6˚). The mean posterior TS was greater in men than women (16.0˚ vs. 12.5˚, p &lt; 0.05), while the mean TS angle was greater in women (14.8˚) than men (12.3˚). Conclusion: Knee alignment and geometry vary among populations. In our study, the TF angle was varus among all participants. The knee joint was more medially inclined in women than men. And also the posterior TS was greater in women than men

Search for dark matter produced in association with bottom or top quarks in √s = 13 TeV pp collisions with the ATLAS detector

A search for weakly interacting massive particle dark matter produced in association with bottom or top quarks is presented. Final states containing third-generation quarks and miss- ing transverse momentum are considered. The analysis uses 36.1 fb−1 of proton–proton collision data recorded by the ATLAS experiment at √s = 13 TeV in 2015 and 2016. No significant excess of events above the estimated backgrounds is observed. The results are in- terpreted in the framework of simplified models of spin-0 dark-matter mediators. For colour- neutral spin-0 mediators produced in association with top quarks and decaying into a pair of dark-matter particles, mediator masses below 50 GeV are excluded assuming a dark-matter candidate mass of 1 GeV and unitary couplings. For scalar and pseudoscalar mediators produced in association with bottom quarks, the search sets limits on the production cross- section of 300 times the predicted rate for mediators with masses between 10 and 50 GeV and assuming a dark-matter mass of 1 GeV and unitary coupling. Constraints on colour- charged scalar simplified models are also presented. Assuming a dark-matter particle mass of 35 GeV, mediator particles with mass below 1.1 TeV are excluded for couplings yielding a dark-matter relic density consistent with measurements

Reducing the environmental impact of surgery on a global scale: systematic review and co-prioritization with healthcare workers in 132 countries

Abstract Background Healthcare cannot achieve net-zero carbon without addressing operating theatres. The aim of this study was to prioritize feasible interventions to reduce the environmental impact of operating theatres. Methods This study adopted a four-phase Delphi consensus co-prioritization methodology. In phase 1, a systematic review of published interventions and global consultation of perioperative healthcare professionals were used to longlist interventions. In phase 2, iterative thematic analysis consolidated comparable interventions into a shortlist. In phase 3, the shortlist was co-prioritized based on patient and clinician views on acceptability, feasibility, and safety. In phase 4, ranked lists of interventions were presented by their relevance to high-income countries and low–middle-income countries. Results In phase 1, 43 interventions were identified, which had low uptake in practice according to 3042 professionals globally. In phase 2, a shortlist of 15 intervention domains was generated. In phase 3, interventions were deemed acceptable for more than 90 per cent of patients except for reducing general anaesthesia (84 per cent) and re-sterilization of ‘single-use’ consumables (86 per cent). In phase 4, the top three shortlisted interventions for high-income countries were: introducing recycling; reducing use of anaesthetic gases; and appropriate clinical waste processing. In phase 4, the top three shortlisted interventions for low–middle-income countries were: introducing reusable surgical devices; reducing use of consumables; and reducing the use of general anaesthesia. Conclusion This is a step toward environmentally sustainable operating environments with actionable interventions applicable to both high– and low–middle–income countries