Combination of searches for Higgs boson pairs in pp collisions at \sqrts = 13 TeV with the ATLAS detector

This letter presents a combination of searches for Higgs boson pair production using up to 36.1 fb(-1) of proton-proton collision data at a centre-of-mass energy root s = 13 TeV recorded with the ATLAS detector at the LHC. The combination is performed using six analyses searching for Higgs boson pairs decaying into the b (b) over barb (b) over bar, b (b) over barW(+)W(-), b (b) over bar tau(+)tau(-), W+W-W+W-, b (b) over bar gamma gamma and W+W-gamma gamma final states. Results are presented for non-resonant and resonant Higgs boson pair production modes. No statistically significant excess in data above the Standard Model predictions is found. The combined observed (expected) limit at 95% confidence level on the non-resonant Higgs boson pair production cross-section is 6.9 (10) times the predicted Standard Model cross-section. Limits are also set on the ratio (kappa(lambda)) of the Higgs boson self-coupling to its Standard Model value. This ratio is constrained at 95% confidence level in observation (expectation) to -5.0 &lt; kappa(lambda) &lt; 12.0 (-5.8 &lt; kappa(lambda) &lt; 12.0). In addition, limits are set on the production of narrow scalar resonances and spin-2 Kaluza-Klein Randall-Sundrum gravitons. Exclusion regions are also provided in the parameter space of the habemus Minimal Supersymmetric Standard Model and the Electroweak Singlet Model. For complete list of authors see http://dx.doi.org/10.1016/j.physletb.2019.135103</p

Searches for lepton-flavour-violating decays of the Higgs boson in s=13\sqrt{s}=13 TeV pp\mathit{pp} collisions with the ATLAS detector

This Letter presents direct searches for lepton flavour violation in Higgs boson decays, H → eτ and H → μτ , performed with the ATLAS detector at the LHC. The searches are based on a data sample of proton–proton collisions at a centre-of-mass energy √s = 13 TeV, corresponding to an integrated luminosity of 36.1 fb−1. No significant excess is observed above the expected background from Standard Model processes. The observed (median expected) 95% confidence-level upper limits on the leptonflavour-violating branching ratios are 0.47% (0.34+0.13−0.10%) and 0.28% (0.37+0.14−0.10%) for H → eτ and H → μτ , respectively.publishedVersio

Search for flavour-changing neutral currents in processes with one top quark and a photon using 81 fb⁻¹ of pp collisions at \sqrts = 13 TeV with the ATLAS experiment

A search for flavour-changing neutral current (FCNC) events via the coupling of a top quark, a photon, and an up or charm quark is presented using 81 fb−1 of proton–proton collision data taken at a centre-of-mass energy of 13 TeV with the ATLAS detector at the LHC. Events with a photon, an electron or muon, a b-tagged jet, and missing transverse momentum are selected. A neural network based on kinematic variables differentiates between events from signal and background processes. The data are consistent with the background-only hypothesis, and limits are set on the strength of the tqγ coupling in an effective field theory. These are also interpreted as 95% CL upper limits on the cross section for FCNC tγ production via a left-handed (right-handed) tuγ coupling of 36 fb (78 fb) and on the branching ratio for t→γu of 2.8×10−5 (6.1×10−5). In addition, they are interpreted as 95% CL upper limits on the cross section for FCNC tγ production via a left-handed (right-handed) tcγ coupling of 40 fb (33 fb) and on the branching ratio for t→γc of 22×10−5 (18×10−5). © 2019 The Author(s

Evidence for the production of three massive vector bosons with the ATLAS detector

A search for the production of three massive vector bosons in proton-proton collisions is performed using data at $\sqrt{s} = 13$ TeV recorded with the ATLAS detector at the Large Hadron Collider in the years 2015-2017, corresponding to an integrated luminosity of $79.8$ fb$^{-1}$. Events with two same-sign leptons $\ell$ (electrons or muons) and at least two reconstructed jets are selected to search for $WWW \to \ell \nu \ell \nu qq$. Events with three leptons without any same-flavour opposite-sign lepton pairs are used to search for $WWW \to \ell \nu \ell\nu \ell \nu$, while events with three leptons and at least one same-flavour opposite-sign lepton pair and one or more reconstructed jets are used to search for $WWZ \to \ell \nu qq \ell \ell$. Finally, events with four leptons are analysed to search for $WWZ \to \ell \nu \ell \nu \ell \ell$ and $WZZ \to qq \ell \ell \ell \ell$. Evidence for the joint production of three massive vector bosons is observed with a significance of 4.1 standard deviations, where the expectation is 3.1 standard deviations.Comment: 38 pages in total, author list starting page 22, 6 figures, 5 tables, matching published paper in Phys. Lett. B. All figures including auxiliary figures are available at http://atlas.web.cern.ch/Atlas/GROUPS/PHYSICS/PAPERS/STDM-2017-2

Measurement of the top-quark mass using a leptonic invariant mass in pp collisions at s√ = 13 TeV with the ATLAS detector

A measurement of the top-quark mass (mt) in the tt¯ → lepton + jets channel is presented, with an experimental technique which exploits semileptonic decays of b-hadrons produced in the top-quark decay chain. The distribution of the invariant mass mℓμ of the lepton, ℓ (with ℓ = e, μ), from the W-boson decay and the muon, μ, originating from the b-hadron decay is reconstructed, and a binned-template profile likelihood fit is performed to extract mt. The measurement is based on data corresponding to an integrated luminosity of 36.1 fb−1 of s√ = 13 TeV pp collisions provided by the Large Hadron Collider and recorded by the ATLAS detector. The measured value of the top-quark mass is mt = 174.41 ± 0.39 (stat.) ± 0.66 (syst.) ± 0.25 (recoil) GeV, where the third uncertainty arises from changing the PYTHIA8 parton shower gluon-recoil scheme, used in top-quark decays, to a recently developed setup

A century of trends in adult human height

Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.5-22.7) and 16.5 cm (13.3-19.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8-144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries

Rising rural body-mass index is the main driver of the global obesity epidemic in adults

Body-mass index (BMI) has increased steadily in most countries in parallel with a rise in the proportion of the population who live in cities 1,2 . This has led to a widely reported view that urbanization is one of the most important drivers of the global rise in obesity 3�6 . Here we use 2,009 population-based studies, with measurements of height and weight in more than 112 million adults, to report national, regional and global trends in mean BMI segregated by place of residence (a rural or urban area) from 1985 to 2017. We show that, contrary to the dominant paradigm, more than 55 of the global rise in mean BMI from 1985 to 2017�and more than 80 in some low- and middle-income regions�was due to increases in BMI in rural areas. This large contribution stems from the fact that, with the exception of women in sub-Saharan Africa, BMI is increasing at the same rate or faster in rural areas than in cities in low- and middle-income regions. These trends have in turn resulted in a closing�and in some countries reversal�of the gap in BMI between urban and rural areas in low- and middle-income countries, especially for women. In high-income and industrialized countries, we noted a persistently higher rural BMI, especially for women. There is an urgent need for an integrated approach to rural nutrition that enhances financial and physical access to healthy foods, to avoid replacing the rural undernutrition disadvantage in poor countries with a more general malnutrition disadvantage that entails excessive consumption of low-quality calories. © 2019, The Author(s)

THE UNIVERSITY OF IOWA APPARATUS FOR PRODUCTION OF STABILIZED ATOMIC HYDROGEN

Nous avons réalisé le plan détaillé et la plus grande partie de la construction d'un appareillage de basse température destiné à la production d'hydrogène atomique stabilisé selon une méthode antérieurement proposée et décrite dans J. Physique 39 (1978) C6-108. Nous décrivons brièvement l'appareillage qui comprend une source d'hydrogène atomique, un réfrigérateur à dilution pouvant donner des températures inférieures à 0,1 K, un aimant supraconducteur de 11 T et un dewar avec accès par le fond pour l'introduction de d'hydrogène atomique.We have completed the detailed design and most of the construction of a low temperature apparatus for preparation of stabilized atomic hydrogen, based on a proposed production method described previously (J. Physique 39 (1978) C6-108). We will briefly describe the apparatus which includes a microwave source of atomic hydrogen, a dilution refrigerator capable of temperatures below 0.1 K, a 11 T superconducting magnet, and a dewar with access from the bottom for introduction of the atomic hydrogen

THEORETICAL ISSUES CONCERNING THE STABILITY OF ELECTRON SPIN-POLARIZED HYDROGEN

Des atomes d'hydrogène dont le spin de l'électron est polarisé dans un fort champ magnétique ("hydrogène polarisé", symbolisé par H+) devraient rester un fluide quantique gazeux métastable jusqu'au zéro absolu. Cependant il existe de nombreux processus susceptibles de détruire cette métastabilité. A forte densité (≥ 1021/cm3) Berlinsky et al ont suggéré qu'un mécanisme de destruction par onde de spin cohérente empêche la stabilité. A plus faible densité (suffisante toutefois pour donner lieu à la condensation de Bose) des mécanismes de recombinaison en phase gazeuse et en surface devraient jouer un rôle primordial. Une question cruciale concerne la limite d'explosion pour H+, c'est-à-dire à partir de quelle densité un seul retournement de spin électronique déclenchera une recombinaison massive, avec échauffement et destruction du récipient (peut-être un bon "détecteur" pour des processus hautement interdits) ? La seconde question cruciale est la suivante : quels événements déclencheront de telles explosions si l'on suppose qu'on est au-dessous du seuil ? Nous allons présenter le point où nous en sommes actuellement dans la compréhension de ces deux problèmes cruciaux (en donnant des calculs de collision à deux corps d'une grande précision) et nous en montrerons les conséquences pour la conception des appareillages expérimentaux (par exemple effets des inhomogénéités de champ, enduits d'hélium sur les surfaces, élimination des impuretés de deuterium, etc.).Hydrogen atoms with their electron spin polarized in a strong magnetic field ("spinaligned hydrogen" ; symbolized H+) should remain a metastable gaseous quantum fluid even at absolute zero. However, there are many possible ways of destroying this metastability. At high density ≥ 1021/cm3) Berlinsky et al. have suggested that a coherent spin-wave destruction mechanism prevents stability. At lower densities (high enough for Bose-Einstein condensation, however), gas phase and surface recombination mechanisms should be of primary concern. One critical question is essentially the explosion limit for H+., i.e. at what density will a single electronic spin flip event trigger massive recombination, heating and destruction of the sample (perhaps a good "detector" for highly forbidden processes) ? The second critical question is what events will trigger such explosions assuming one is above the limit ? We shall present our current understanding of these two critical questions (including high accuracy two-body collision calculations) and their implications in experimental design (e.g. field inhomogeneity effects, helium coating of surfaces, removal of deuterium impurities, etc.)

Multi-disciplinary analysis of light shelves application within a student dormitory refurbishment

The achievement of sustainable cities and communities is closely linked to an accurate design of the buildings. In this context, the transparent elements of the building envelope have a crucial role since, on one hand, they are a bottleneck in regards to heat and mass transfers and sound propagation, while, on the other hand, they must allow daylight penetration. Thus, they are responsible for occupants’ thermal and visual comfort and their health. Considering passive solutions for windows, the light shelves can improve natural light penetration, reducing the lights’ electricity demand and controlling windows’ related thermal aspects. The scientific literature is characterized by several studies that analyze this topic, which, however, focus only on the daylight field and sometimes the energy saving for lights. Moreover, they often refer to fixed sky type for the simulations. The aim of the present study is to analyze the application of the light shelves with a multi-disciplinary approach, by means of dynamic simulations, in the EnergyPlus engine, for a whole year. A new methodological approach is presented in order to investigate the technology under different fields of interest: daylight, lighting energy, cooling and heating needs, and thermo-hygrometric comfort. The case study chosen is an existing building, a student dormitory belonging to the University of Athens. It is subject to a deep energy renovation to conform to the “nearly Zero Energy Building” target, in the frame of a European research project called Pro-GET-onE (G.A No. 723747). By means of the calibrated numerical model of this HVAC-building system, ten different configurations of light shelves have been investigated. The best solution is given by the application of an internal horizontal light shelf placed at 50 cm from the top of the window with a depth of 90 or 60 cm. It has been found that despite the reduction in electricity demand for lighting, the variation in heating and cooling needs does not always lead to a benefit. © 2021 by the authors. Licensee MDPI, Basel, Switzerland