The incidence of injuries traveling to and from school by travel mode

Objective. To assess the absolute and relative risks of youth school-related travel using the New Zealand's no fault accident liability scheme and Census at School datasets. Methods. Injury risk associated with traveling to and from school was assessed by combining census data from the Accident Compensation Commission database, New Zealand's no fault liability accident scheme database and the Census at School survey. Population injury and cost was assessed for incidents during a 2-year period (1 July 2003 to 30 June 2005) and during normal school travel hours (7.30 a.m.–9.00 a.m., 3.00 p.m.–4.30 p.m., weekdays) for youth 5–17 years of age. Results. Overall, 7573 cases were identified as being school travel-related, representing 1.6% of total, and 11.4% school travel period injuries. Walking (30.7%), cycling (30.3%), and motor vehicles (27.7%) provided the majority of injuries. Risk of injury per million trips was highest for cycling (46.1), walking (10.3), and motor vehicle travel (6.1). Conclusion. These data provide the first comprehensive examination of absolute risk of travel to and from school and by transport mode, showing that school-related travel is a relatively safe activity contributing to a minority of all injuries sustained by youth

IMPACT TESTING OF 18 ADULT MOUTHGUARDS

Mouthguards are used by sports participants to reduce dental injuries, but there is limited evidence of effectiveness of mouthguards. This research compared biomechanical impact performance data from 18 adult mouthguards available in New Zealand. Repeated impact testing was conducted on the centre of each mouthguard mounted on a dental model. The best mouthguards when impact absorption scores were considered were Avaro International, Shock Doctor Power Hilo v4.5 (upper/lower), and Signature Proplus Gel Type 3; The worst mouthguards were Shock Tec Classic and Professional moulded 1 senior custom laminated. Our impact results seem in contrast to other studies which support the belief that custom mouthguards provide superior protection against injury than boil-and-bite mouthguards (which are all usually EVA low stiffness)

The On-Site Analysis of the Cherenkov Telescope Array

The Cherenkov Telescope Array (CTA) observatory will be one of the largest ground-based very high-energy gamma-ray observatories. The On-Site Analysis will be the first CTA scientific analysis of data acquired from the array of telescopes, in both northern and southern sites. The On-Site Analysis will have two pipelines: the Level-A pipeline (also known as Real-Time Analysis, RTA) and the level-B one. The RTA performs data quality monitoring and must be able to issue automated alerts on variable and transient astrophysical sources within 30 seconds from the last acquired Cherenkov event that contributes to the alert, with a sensitivity not worse than the one achieved by the final pipeline by more than a factor of 3. The Level-B Analysis has a better sensitivity (not be worse than the final one by a factor of 2) and the results should be available within 10 hours from the acquisition of the data: for this reason this analysis could be performed at the end of an observation or next morning. The latency (in particular for the RTA) and the sensitivity requirements are challenging because of the large data rate, a few GByte/s. The remote connection to the CTA candidate site with a rather limited network bandwidth makes the issue of the exported data size extremely critical and prevents any kind of processing in real-time of the data outside the site of the telescopes. For these reasons the analysis will be performed on-site with infrastructures co-located with the telescopes, with limited electrical power availability and with a reduced possibility of human intervention. This means, for example, that the on-site hardware infrastructure should have low-power consumption. A substantial effort towards the optimization of high-throughput computing service is envisioned to provide hardware and software solutions with high-throughput, low-power consumption at a low-cost.Comment: In Proceedings of the 34th International Cosmic Ray Conference (ICRC2015), The Hague, The Netherlands. All CTA contributions at arXiv:1508.0589

An exploration of agro-food chain distributive, procedural and interactional fairness in food products

Fairness and ethical values in agro-food chain lay at the center of the current debate on agro-food chain sustainability. The food labels may contain elements focused on agro-food chain management fairness practices. The objective of the present study is to explore what types of fairness agro-food companies value in the food products they commercialize, and if the characteristics of agro-food companies have a relationship with the type of fairness valued. The research study collected 226 commercialized food products containing information on the agro-food chain fairness practices companies adopted to produce the food products. Data elaboration included a cluster analysis to identify groups of fair products, and a multinomial logistic regression to explore the relationship between the identified clusters and fairness types, organic, nutritional and functional claims, and price. Results support that fairness-oriented products provide information on different types of fairness that is distributive, procedural, and interactional. Some products provide economic information on the distribution of price between upstream and downstream actors. Other products focus on procedural and interactional fairness practices, such as dignity, respect and transparent relationship in agro-food chain; technologies used in the production and distribution of the product; and ethical certifications that companies hold. Fairness-oriented information differ depending both on the type of chain actor commercializing the product, and on the type of brand, that is whether commercial brand or private label. The main conclusion is that companies convey fairness-related information to consumers differently according to company’s role in the agro-food chain. Yet, there is need to exploit further the potential role of fairness practices in defining effective business strategies to contribute to higher equity and sustainability in the agro-food system

Search for squarks and gluinos in events with isolated leptons, jets and missing transverse momentum at s√=8 TeV with the ATLAS detector

The results of a search for supersymmetry in final states containing at least one isolated lepton (electron or muon), jets and large missing transverse momentum with the ATLAS detector at the Large Hadron Collider are reported. The search is based on proton-proton collision data at a centre-of-mass energy s√=8 TeV collected in 2012, corresponding to an integrated luminosity of 20 fb−1. No significant excess above the Standard Model expectation is observed. Limits are set on supersymmetric particle masses for various supersymmetric models. Depending on the model, the search excludes gluino masses up to 1.32 TeV and squark masses up to 840 GeV. Limits are also set on the parameters of a minimal universal extra dimension model, excluding a compactification radius of 1/R c = 950 GeV for a cut-off scale times radius (ΛR c) of approximately 30

Evidence for the Higgs-boson Yukawa coupling to tau leptons with the ATLAS detector

Results of a search for H → τ τ decays are presented, based on the full set of proton-proton collision data recorded by the ATLAS experiment at the LHC during 2011 and 2012. The data correspond to integrated luminosities of 4.5 fb−1 and 20.3 fb−1 at centre-of-mass energies of √s = 7 TeV and √s = 8 TeV respectively. All combinations of leptonic (τ → `νν¯ with ` = e, µ) and hadronic (τ → hadrons ν) tau decays are considered. An excess of events over the expected background from other Standard Model processes is found with an observed (expected) significance of 4.5 (3.4) standard deviations. This excess provides evidence for the direct coupling of the recently discovered Higgs boson to fermions. The measured signal strength, normalised to the Standard Model expectation, of µ = 1.43 +0.43 −0.37 is consistent with the predicted Yukawa coupling strength in the Standard Model

Measurement of the top pair production cross section in 8 TeV proton-proton collisions using kinematic information in the lepton plus jets final state with ATLAS

A measurement is presented of the $t\bar{t}$ inclusive production cross-section in $pp$ collisions at a center-of-mass energy of $\sqrt{s}=8$ TeV using data collected by the ATLAS detector at the CERN Large Hadron Collider. The measurement was performed in the lepton+jets final state using a data set corresponding to an integrated luminosity of 20.3 fb$^{-1}$. The cross-section was obtained using a likelihood discriminant fit and $b$-jet identification was used to improve the signal-to-background ratio. The inclusive $t\bar{t}$ production cross-section was measured to be $260\pm 1{\textrm{(stat.)}} ^{+22}_{-23} {\textrm{(syst.)}}\pm 8{\textrm{(lumi.)}}\pm 4{\mathrm{(beam)}}$ pb assuming a top-quark mass of 172.5 GeV, in good agreement with the theoretical prediction of $253^{+13}_{-15}$ pb. The $t\bar{t}\to (e,\mu)+{\mathrm{jets}}$ production cross-section in the fiducial region determined by the detector acceptance is also reported.Comment: Published version, 19 pages plus author list (35 pages total), 3 figures, 2 tables, all figures including auxiliary figures are available at http://atlas.web.cern.ch/Atlas/GROUPS/PHYSICS/PAPERS/TOPQ-2013-06

Measurement of the charge asymmetry in dileptonic Decays of top quark pairs in pp collisions at √ s = 7 TeV using the ATLAS detector

A measurement of the top-antitop (tt) charge asymmetry is presented using data corresponding to an integrated luminosity of 4.6 fb −1 of LHC pp collisions at a centre- of-mass energy of 7 TeV collected by the ATLAS detector. Events with two charged leptons, at least two jets and large missing transverse momentum are selected. Two observables are studied: A tt/C, based on the reconstructed tt final state. The asymmetries are measured to be A ll/C = 0.024 +/- 0.015 (stat.) +/- 0.009 (syst.) Att/C = 0.021 +/- 0.025 (stat.) +/- 0.017 (syst.) The measured values are in agreement with the Standard Model predictions

Spectroscopic and computational insights on catalytic synergy in bimetallic aluminophosphate catalysts

A combined electronic structure computational and X-ray absorption spectroscopy study was used to investigate the nature of the active sites responsible for catalytic synergy in Co-Ti bimetallic nanoporous frameworks. Probing the nature of the molecular species at the atomic level has led to the identification of a unique Co-O-Ti bond, which serves as the loci for the superior performance of the bimetallic catalyst, when compared with its analogous monometallic counterpart. The structural and spectroscopic features associated with this active site have been characterized and contrasted, with a view to affording structure property relationships, in the wider context of designing sustainable catalytic oxidations with porous solids

A prototype for the real-time analysis of the Cherenkov Telescope Array

The Cherenkov Telescope Array (CTA) observatory will be one of the biggest ground-based very-high-energy (VHE) γ- ray observatory. CTA will achieve a factor of 10 improvement in sensitivity from some tens of GeV to beyond 100 TeV with respect to existing telescopes. The CTA observatory will be capable of issuing alerts on variable and transient sources to maximize the scientific return. To capture these phenomena during their evolution and for effective communication to the astrophysical community, speed is crucial. This requires a system with a reliable automated trigger that can issue alerts immediately upon detection of γ-ray flares. This will be accomplished by means of a Real-Time Analysis (RTA) pipeline, a key system of the CTA observatory. The latency and sensitivity requirements of the alarm system impose a challenge because of the anticipated large data rate, between 0.5 and 8 GB/s. As a consequence, substantial efforts toward the optimization of highthroughput computing service are envisioned. For these reasons our working group has started the development of a prototype of the Real-Time Analysis pipeline. The main goals of this prototype are to test: (i) a set of frameworks and design patterns useful for the inter-process communication between software processes running on memory; (ii) the sustainability of the foreseen CTA data rate in terms of data throughput with different hardware (e.g. accelerators) and software configurations, (iii) the reuse of nonreal- time algorithms or how much we need to simplify algorithms to be compliant with CTA requirements, (iv) interface issues between the different CTA systems. In this work we focus on goals (i) and (ii)