67 research outputs found
Search for dark matter produced in association with bottom or top quarks in √s = 13 TeV pp collisions with the ATLAS detector
A search for weakly interacting massive particle dark matter produced in association with bottom or top quarks is presented. Final states containing third-generation quarks and miss- ing transverse momentum are considered. The analysis uses 36.1 fb−1 of proton–proton collision data recorded by the ATLAS experiment at √s = 13 TeV in 2015 and 2016. No significant excess of events above the estimated backgrounds is observed. The results are in- terpreted in the framework of simplified models of spin-0 dark-matter mediators. For colour- neutral spin-0 mediators produced in association with top quarks and decaying into a pair of dark-matter particles, mediator masses below 50 GeV are excluded assuming a dark-matter candidate mass of 1 GeV and unitary couplings. For scalar and pseudoscalar mediators produced in association with bottom quarks, the search sets limits on the production cross- section of 300 times the predicted rate for mediators with masses between 10 and 50 GeV and assuming a dark-matter mass of 1 GeV and unitary coupling. Constraints on colour- charged scalar simplified models are also presented. Assuming a dark-matter particle mass of 35 GeV, mediator particles with mass below 1.1 TeV are excluded for couplings yielding a dark-matter relic density consistent with measurements
Retrospective evaluation of whole exome and genome mutation calls in 746 cancer samples
Funder: NCI U24CA211006Abstract: The Cancer Genome Atlas (TCGA) and International Cancer Genome Consortium (ICGC) curated consensus somatic mutation calls using whole exome sequencing (WES) and whole genome sequencing (WGS), respectively. Here, as part of the ICGC/TCGA Pan-Cancer Analysis of Whole Genomes (PCAWG) Consortium, which aggregated whole genome sequencing data from 2,658 cancers across 38 tumour types, we compare WES and WGS side-by-side from 746 TCGA samples, finding that ~80% of mutations overlap in covered exonic regions. We estimate that low variant allele fraction (VAF < 15%) and clonal heterogeneity contribute up to 68% of private WGS mutations and 71% of private WES mutations. We observe that ~30% of private WGS mutations trace to mutations identified by a single variant caller in WES consensus efforts. WGS captures both ~50% more variation in exonic regions and un-observed mutations in loci with variable GC-content. Together, our analysis highlights technological divergences between two reproducible somatic variant detection efforts
Electrokinetic thickening of mature fine oil sands tailings
Mature fine oil sands tailings (MFT) are the fine parts of oil sands tailings that remain suspended in tailings disposal pond for decades because of the low sedimentation/consolidation rate. This study applies electrokinetics to thicken, that is, to increase the solid content, of the MFT suspension. The geotechnical properties of MFT solids and chemical analysis of tailings pore water are measured, followed by electrokinetic (EK) tests. The results of this study indicate that EK thickening is very effective for the settling of MFT suspensions under an applied voltage of 219 V/m, the final solid content of the sediment reached 18·75% from an initial 5% after 7 h. The EK treatment is also very effective in clarifying the supernatant. The final turbidity of the supernatant is 30·6 NTU under 219 V/m applied voltage gradient. Regression models are developed using statistical software MINITAB 15 in coded and uncoded units to relate the final solid content of the sediment with the initial solid content and applied voltage gradient. The models and the independent variables are statistically significant at 95% confidence level based on F test and t test results, respectively
Coagulation enhanced electrokinetic settling of mature fine oil sands tailings
The mature fine oil sand tailings (MFT) remain as slurry in the tailings pond for long time. The dewatering and consolidation of MFT for sustainable management is an important task for the mining industry. The objective of this study is to accelerate electrokinetic settling of MFT solids in suspensions in presence of optimal coagulant. In the first phase, optimal coagulant and coagulant dosage for settling of suspension are identified, i.e., ferric chloride at 350 mg/L. It is found that the chemical treatment is not much effective; the final solid content of the sediment is only 6.48% from an initial of 5%. In the second phase, combined coagulation and electrokinetic treatment is carried out to enhance the settling effect. The direct electric current is applied in continuous and intermittent modes on MFT suspensions placed in electrokinetic cell. The results show the final solid content reaches 23.74% under the combined application of 350 mg/L ferric chloride and 218.75 V/m applied voltage gradient in the continuous mode. The intermittent current mode with 40% save in power consumption produces a settled sediment having 20.84% final solid content. Keywords: Electrokinetics, Electrophoresis, Coagulation, Settling, Voltage gradient, MF
Complex Permittivity to Detect Lead in Soil with Various Salt Forms and Combinations
The response of soil-water systems to an external electric field can be described as polarization and conduction. Polarization represents the electric charges stored in a material, whereas conduction is the ability of a material to conduct free charges. The combined effects of polarization and conduction can be expressed in terms of complex permittivity. Since the complex permittivity of a soil-water system is a function of soil properties, this research was undertaken to detect soil contamination using the complex permittivity measurements. The system used in this investigation to measure the complex permittivity of a lead contaminated soil consisted of an Automatic Network Analyzer (ANA), a set of coaxial cables, a personal computer (PC) for data processing and a coaxial sample holder. Two sample holders were first used: long holder and short holder. It was found that the short holder can give reliable and close measurement to the long holder. The short holder was later adopted. Soil samples were prepared in the lab and mixed with lead nitrate solutions and with hybrid blend of lead nitrate and lead chloride solutions. The relationship between the complex permittivity and lead concentration was investigated. A chemical analysis of the pore fluids for all lead contaminated soil samples was conducted to trace the presence of lead in soil. It was found that the complex permittivity is affected by lead concentration in soil, as the real part decreased and the imaginary part increased with an increase in lead concentration. Lead was not detected in the soil pore water for the soil tested, which suggested that lead was immobilized by precipitation and the adsorption mechanism
Micropore Structure of Cement-Stabilized Gold Mine Tailings
Mine tailings have often to be stabilized by mixing them with cementing agents. In this study, the pore structure of gold tailings stabilized with Portland cement was evaluated by means of mercury intrusion porosimetry. The investigation was conducted on samples prepared with different fractions of tailings and cement as well as on samples activated with elevated temperature curing and chemical (CaCl2) addition. It was observed that all mixed samples exhibit a mono-modal pore size distribution, indicating that the cement-stabilized tailings are characterized by a single-porosity structure. The results also showed that the higher fraction of tailings and cement leads to a dense and finer pore structure. The total porosity of mixture samples decreases with increasing curing temperature and CaCl2 concentration due to the acceleration of hydration reaction
Complex Permittivity to Detect Lead in Soil with Various Salt Forms and Combinations
The response of soil-water systems to an external electric field can be described as polarization and conduction. Polarization represents the electric charges stored in a material, whereas conduction is the ability of a material to conduct free charges. The combined effects of polarization and conduction can be expressed in terms of complex permittivity. Since the complex permittivity of a soil-water system is a function of soil properties, this research was undertaken to detect soil contamination using the complex permittivity measurements. The system used in this investigation to measure the complex permittivity of a lead contaminated soil consisted of an Automatic Network Analyzer (ANA), a set of coaxial cables, a personal computer (PC) for data processing and a coaxial sample holder. Two sample holders were first used: long holder and short holder. It was found that the short holder can give reliable and close measurement to the long holder. The short holder was later adopted. Soil samples were prepared in the lab and mixed with lead nitrate solutions and with hybrid blend of lead nitrate and lead chloride solutions. The relationship between the complex permittivity and lead concentration was investigated. A chemical analysis of the pore fluids for all lead contaminated soil samples was conducted to trace the presence of lead in soil. It was found that the complex permittivity is affected by lead concentration in soil, as the real part decreased and the imaginary part increased with an increase in lead concentration. Lead was not detected in the soil pore water for the soil tested, which suggested that lead was immobilized by precipitation and the adsorption mechanism
Evolution of thermal and mechanical properties of mine tailings and fly ash mixtures during curing period
Electrophoresis and its applications in oil sand tailings management
Oil sands mines generate tailings during the extraction process, which are a mixture of water, clay, sand and residual bitumen. When the tailings are released to tailings ponds, the coarse solids settle quickly, whereas fine solids containing clay minerals, namely mature fine tailings (MFT), remain suspended for years, even decades. A study is carried out to assess the suitability of electrokinetic (EK) sedimentation to accelerate sedimentation of MFT. A series of laboratory-scale column experiments are carried out to examine the effects of electrophoresis during settling processes. The investigation focuses on the effects of EK sedimentation as related to the initial solid content of the tailings suspension, applied electric field intensity, water pH, and the use of an optimized coagulant FeCl. Based on the experimental data, an electric field intensity of 150 V/m along with an initial tailings solid content of no > 5% are the optimum condition for EK sedimentation of MFT, in terms of reducing the overall sedimentation time and increasing the final solid content. The results show that the current density of EK sedimentation for MFT should not be > 20 A/m to control the bubble effect and reduce power consumption
- …