Utilisation of High Energy Propellant Waste in Manufacturing of Fired Clay Bricks to Enhance the Acoustic Properties

The disposal and waste management of solid high energy propellant (HEP) is a considerate conservational problem. HEP waste is currently disposed in open or confined burning which may cause environmental hazards. In this paper, we examined and discussed results on recycling of HEP waste into fired clay bricks baked in different orientation. HEP modified bricks with 1.5%, 3% and 5 wt. % HEP waste content were manufactured and tested, and then compared against virgin clay bricks without HEP content. The effect of directional orientation of bricks baked with varying HEP content on acoustic properties were experimented and discussed. The sound transmission loss decreases with increase in HEP waste due to formation of independently closed directional pores. The transmission loss of horizontally baked during firing of bricks is nearly 5dB lower than vertically baked bricks. Results of the experimental studies indicate that HEP waste can be utilised in fired clay bricks and different orientation baking further enhances the acoustic properties

Development of carp fish culture practice under different stocking densities in mid hills of Uttarakhand, India

The present study was undertaken in order to standardise the stocking density values of carps fishes for sustainable fisheries development in mid hills and enhancing the fish production. The paper deals with growth performance of 3 exotic fish species in low stocking density i.e. 3 fish/m3 over high stocking density of 5 fish/m3 and 10 fish/m3 in the control pond. The net production was 12.6% higher with stocking density of 3 fish/m3. Among the both tested density, the combination of 30: 40: 30 was superior (45.6%) in terms of growth and production in comparison to the other combinations and control. In present study, the highest production as 57.13kg/100m2 (5713 kg/ha.) was achieved in the stocking ratio of 30:40:30 with stocking density of 3 fish/m3. It is 4.7% higher of the combination of 40:30:30 and 4% higher than the combination of 30: 30: 40. It is 12.6% higher than the stocking density of 5 fish/m3 and 48.5% higher than the stocking density of 10 fish /m3. The growth pattern reflected the slow growth during the winter months, reflected the direct negative effect of water temperature on the growth. The production level of existing practice of the farmers may be enhanced up to 1.5 times with proper stocking density i.e. 3 fish/m3 and perfect species combination i.e. 30: 40: 30 for silver carp, grass carp and common carp respectively

INFORMATION MANAGEMENT SYSTEM FOR FACULTY AND STUDENTS

Information Management System for Faculty and Students is a system developed using PHP that provides a number of operations such as uploading, editing, deleting etc. The users of the system will be the college staff (including the admin, HOD and examiner) and students. Information Management System deals with all kind of student details, academic related reports, college details, course details, curriculum, batch details, placement details, assignment list, syllabus, lesson plans, test papers and experiment lists. It tracks all the details of a student from the day one to the end of the course which can be used for reporting purpose, tracking of attendance, progress in the course, completed semesters, years, final exam result and all these will be available through a secure, online interface embedded in the college’s website. It will also have faculty details, batch execution details, students’ details, the various academic notifications to the staff and students updated by the college administration. It also allows them to explore all the activities happening in the college. This program accelerates reaction time and improves accuracy. The objective of our project is to develop an application which will automate the process of managing all the details required for all the educational institutes. DOI: 10.17762/ijritcc2321-8169.15022

Approximate solution of the Duffin-Kemmer-Petiau equation for a vector Yukawa potential with arbitrary total angular momenta

The usual approximation scheme is used to study the solution of the Duffin-Kemmer-Petiau (DKP) equation for a vector Yukawa potential in the framework of the parametric Nikiforov-Uvarov (NU) method. The approximate energy eigenvalue equation and the corresponding wave function spinor components are calculated for arbitrary total angular momentum in closed form. Further, the approximate energy equation and wave function spinor components are also given for case. A set of parameter values is used to obtain the numerical values for the energy states with various values of quantum levelsComment: 17 pages; Communications in Theoretical Physics (2012). arXiv admin note: substantial text overlap with arXiv:1205.0938, and with arXiv:quant-ph/0410159 by other author

Mapping geographical inequalities in childhood diarrhoeal morbidity and mortality in low-income and middle-income countries, 2000–17 : analysis for the Global Burden of Disease Study 2017

Background Across low-income and middle-income countries (LMICs), one in ten deaths in children younger than 5 years is attributable to diarrhoea. The substantial between-country variation in both diarrhoea incidence and mortality is attributable to interventions that protect children, prevent infection, and treat disease. Identifying subnational regions with the highest burden and mapping associated risk factors can aid in reducing preventable childhood diarrhoea. Methods We used Bayesian model-based geostatistics and a geolocated dataset comprising 15 072 746 children younger than 5 years from 466 surveys in 94 LMICs, in combination with findings of the Global Burden of Diseases, Injuries, and Risk Factors Study (GBD) 2017, to estimate posterior distributions of diarrhoea prevalence, incidence, and mortality from 2000 to 2017. From these data, we estimated the burden of diarrhoea at varying subnational levels (termed units) by spatially aggregating draws, and we investigated the drivers of subnational patterns by creating aggregated risk factor estimates. Findings The greatest declines in diarrhoeal mortality were seen in south and southeast Asia and South America, where 54·0% (95% uncertainty interval [UI] 38·1–65·8), 17·4% (7·7–28·4), and 59·5% (34·2–86·9) of units, respectively, recorded decreases in deaths from diarrhoea greater than 10%. Although children in much of Africa remain at high risk of death due to diarrhoea, regions with the most deaths were outside Africa, with the highest mortality units located in Pakistan. Indonesia showed the greatest within-country geographical inequality; some regions had mortality rates nearly four times the average country rate. Reductions in mortality were correlated to improvements in water, sanitation, and hygiene (WASH) or reductions in child growth failure (CGF). Similarly, most high-risk areas had poor WASH, high CGF, or low oral rehydration therapy coverage. Interpretation By co-analysing geospatial trends in diarrhoeal burden and its key risk factors, we could assess candidate drivers of subnational death reduction. Further, by doing a counterfactual analysis of the remaining disease burden using key risk factors, we identified potential intervention strategies for vulnerable populations. In view of the demands for limited resources in LMICs, accurately quantifying the burden of diarrhoea and its drivers is important for precision public health

Anemia prevalence in women of reproductive age in low- and middle-income countries between 2000 and 2018

Anemia is a globally widespread condition in women and is associated with reduced economic productivity and increased mortality worldwide. Here we map annual 2000–2018 geospatial estimates of anemia prevalence in women of reproductive age (15–49 years) across 82 low- and middle-income countries (LMICs), stratify anemia by severity and aggregate results to policy-relevant administrative and national levels. Additionally, we provide subnational disparity analyses to provide a comprehensive overview of anemia prevalence inequalities within these countries and predict progress toward the World Health Organization’s Global Nutrition Target (WHO GNT) to reduce anemia by half by 2030. Our results demonstrate widespread moderate improvements in overall anemia prevalence but identify only three LMICs with a high probability of achieving the WHO GNT by 2030 at a national scale, and no LMIC is expected to achieve the target in all their subnational administrative units. Our maps show where large within-country disparities occur, as well as areas likely to fall short of the WHO GNT, offering precision public health tools so that adequate resource allocation and subsequent interventions can be targeted to the most vulnerable populations.Peer reviewe

Measurement of the azimuthal anisotropy of Y(1S) and Y(2S) mesons in PbPb collisions at √S^{S}NN = 5.02 TeV

The second-order Fourier coefficients (υ$_{2}$) characterizing the azimuthal distributions of Υ(1S) and Υ(2S) mesons produced in PbPb collisions at $\sqrt{s_{NN}}$ = 5.02 TeV are studied. The Υmesons are reconstructed in their dimuon decay channel, as measured by the CMS detector. The collected data set corresponds to an integrated luminosity of 1.7 nb$^{-1}$. The scalar product method is used to extract the υ$_{2}$ coefficients of the azimuthal distributions. Results are reported for the rapidity range |y| < 2.4, in the transverse momentum interval 0 < p$_{T}$ < 50 GeV/c, and in three centrality ranges of 10–30%, 30–50% and 50–90%. In contrast to the J/ψ mesons, the measured υ$_{2}$ values for the Υ mesons are found to be consistent with zero

Measurement of prompt D0^{0} and D‾\overline{D}0^{0} meson azimuthal anisotropy and search for strong electric fields in PbPb collisions at root SNN\sqrt{S_{NN}} = 5.02 TeV

The strong Coulomb field created in ultrarelativistic heavy ion collisions is expected to produce a rapiditydependent difference (Av2) in the second Fourier coefficient of the azimuthal distribution (elliptic flow, v2) between D0 (uc) and D0 (uc) mesons. Motivated by the search for evidence of this field, the CMS detector at the LHC is used to perform the first measurement of Av2. The rapidity-averaged value is found to be (Av2) = 0.001 ? 0.001 (stat)? 0.003 (syst) in PbPb collisions at ?sNN = 5.02 TeV. In addition, the influence of the collision geometry is explored by measuring the D0 and D0mesons v2 and triangular flow coefficient (v3) as functions of rapidity, transverse momentum (pT), and event centrality (a measure of the overlap of the two Pb nuclei). A clear centrality dependence of prompt D0 meson v2 values is observed, while the v3 is largely independent of centrality. These trends are consistent with expectations of flow driven by the initial-state geometry. ? 2021 The Author. Published by Elsevier B.V. This is an open access article under the CC BY licens

Performance of the CMS Level-1 trigger in proton-proton collisions at √s = 13 TeV

At the start of Run 2 in 2015, the LHC delivered proton-proton collisions at a center-of-mass energy of 13\TeV. During Run 2 (years 2015–2018) the LHC eventually reached a luminosity of 2.1× 10$^{34}$ cm$^{-2}$s$^{-1}$, almost three times that reached during Run 1 (2009–2013) and a factor of two larger than the LHC design value, leading to events with up to a mean of about 50 simultaneous inelastic proton-proton collisions per bunch crossing (pileup). The CMS Level-1 trigger was upgraded prior to 2016 to improve the selection of physics events in the challenging conditions posed by the second run of the LHC. This paper describes the performance of the CMS Level-1 trigger upgrade during the data taking period of 2016–2018. The upgraded trigger implements pattern recognition and boosted decision tree regression techniques for muon reconstruction, includes pileup subtraction for jets and energy sums, and incorporates pileup-dependent isolation requirements for electrons and tau leptons. In addition, the new trigger calculates high-level quantities such as the invariant mass of pairs of reconstructed particles. The upgrade reduces the trigger rate from background processes and improves the trigger efficiency for a wide variety of physics signals