Construction and Performance of a Micro-Pattern Stereo Detector with Two Gas Electron Multipliers

The construction of a micro-pattern gas detector of dimensions 40x10 cm**2 is described. Two gas electron multiplier foils (GEM) provide the internal amplification stages. A two-layer readout structure was used, manufactured in the same technology as the GEM foils. The strips of each layer cross at an effective crossing angle of 6.7 degrees and have a 406 um pitch. The performance of the detector has been evaluated in a muon beam at CERN using a silicon telescope as reference system. The position resolutions of two orthogonal coordinates are measured to be 50 um and 1 mm, respectively. The muon detection efficiency for two-dimensional space points reaches 96%.Comment: 21 pages, 17 figure

Breakdown-induced negative charge in ultrathin SiO2 films measured by atomic force microscopy

Atomic-force-microscopy-based techniques have been used to investigate at a nanometer scale the dielectric breakdown (BD) of ultrathin (<6 nm) SiO2films of metal-oxide-semiconductordevices. The results show that BD leads to negative charge at the BD location and the amount of created charge has been estimated. Moreover, the comparison of the charge magnitude generated during current-limited stresses and stresses without current limit demonstrates that the observed BD induced negative charge is related to the structural damage created by the oxide BD

A high resolution search for the tensor glueball candidate [xi] (2230) Crystal Barrel Collaboration

We report results of a high resolution search for the tensor glueball candidate ξ(2230) in a p̄p formation experiment. π0π0 and ηη decay channels were measured in a scan of the mass region 2220 MeV to 2240 MeV. No evidence for the existence of ξ(2230) was found. 95% confidence upper limits for the possible existence of ξ are presented

Tracker Operation and Performance at the Magnet Test and Cosmic Challenge

During summer 2006 a fraction of the CMS silicon strip tracker was operated in a comprehensive slice test called the Magnet Test and Cosmic Challenge (MTCC). At the MTCC, cosmic rays detected in the muon chambers were used to trigger the readout of all CMS sub-detectors in the general data acquisition system and in the presence of the 4 T magnetic field produced by the CMS superconducting solenoid. This document describes the operation of the Tracker hardware and software prior, during and after data taking. The performance of the detector as resulting from the MTCC data analysis is also presented

Proton-Antiproton Annihilation and Meson Spectroscopy with the Crystal Barrel

This report reviews the achievements of the Crystal Barrel experiment at the Low Energy Antiproton Ring (LEAR) at CERN. During seven years of operation Crystal Barrel has collected very large statistical samples in pbarp annihilation, especially at rest and with emphasis on final states with high neutral multiplicity. The measured rates for annihilation into various two-body channels and for electromagnetic processes have been used to test simple models for the annihilation mechanism based on the quark internal structure of hadrons. From three-body annihilations three scalar mesons, a0(1450), f0(1370) and f0(1500) have been established in various decay modes. One of them, f0(1500), may be identified with the expected ground state scalar glueball.Comment: 64 pages, LATEX file, 36 figures are available as ps files at http://afuz01.cern.ch/claude/ Submitted to Reviews of Modern Physic

CMS physics technical design report : Addendum on high density QCD with heavy ions

Peer reviewe

Tracker Operation and Performance at the Magnet Test and Cosmic Challenge

During summer 2006 a fraction of the CMS silicon strip tracker was operated in a comprehensive slice test called the Magnet Test and Cosmic Challenge (MTCC). At the MTCC, cosmic rays detected in the muon chambers were used to trigger the readout of all CMS sub-detectors in the general data acquisition system and in the presence of the 4 T magnetic field produced by the CMS superconducting solenoid. This document describes the operation of the Tracker hardware and software prior, during and after data taking. The performance of the detector as resulting from the MTCC data analysis is also presented

Commissioning and performance of the CMS silicon strip tracker with cosmic ray muons

This is the Pre-print version of the Article. The official published version of the Paper can be accessed from the link below - Copyright @ 2010 IOPDuring autumn 2008, the Silicon Strip Tracker was operated with the full CMS experiment in a comprehensive test, in the presence of the 3.8 T magnetic field produced by the CMS superconducting solenoid. Cosmic ray muons were detected in the muon chambers and used to trigger the readout of all CMS sub-detectors. About 15 million events with a muon in the tracker were collected. The efficiency of hit and track reconstruction were measured to be higher than 99% and consistent with expectations from Monte Carlo simulation. This article details the commissioning and performance of the Silicon Strip Tracker with cosmic ray muons.This work is supported by FMSR (Austria); FNRS and FWO (Belgium); CNPq, CAPES, FAPERJ, and FAPESP (Brazil); MES (Bulgaria); CERN; CAS, MoST, and NSFC (China); COLCIENCIAS (Colombia); MSES (Croatia); RPF (Cyprus); Academy of Sciences and NICPB (Estonia); Academy of Finland, ME, and HIP (Finland); CEA and CNRS/IN2P3 (France); BMBF, DFG, and HGF (Germany); GSRT (Greece); OTKA and NKTH (Hungary); DAE and DST (India); IPM (Iran); SFI (Ireland); INFN (Italy); NRF (Korea); LAS (Lithuania); CINVESTAV, CONACYT, SEP, and UASLP-FAI (Mexico); PAEC (Pakistan); SCSR (Poland); FCT (Portugal); JINR (Armenia, Belarus, Georgia, Ukraine, Uzbekistan); MST and MAE (Russia); MSTDS (Serbia); MICINN and CPAN (Spain); Swiss Funding Agencies (Switzerland); NSC (Taipei); TUBITAK and TAEK (Turkey); STFC (United Kingdom); DOE and NSF (USA)

Reception Test of Petals for the End Cap TEC+ of the CMS Silicon Strip Tracker

The silicon strip tracker of the CMS experiment has been completed and was inserted into the CMS detector in late 2007. The largest sub system of the tracker are its end caps, comprising two large end caps (TEC) each containing 3200 silicon strip modules. To ease construction, the end caps feature a modular design: groups of about 20 silicon modules are placed on sub-assemblies called petals and these self-contained elements are then mounted onto the TEC support structures. Each end cap consists of 144 such petals, which were built and fully qualified by several institutes across Europe. Fro