523 research outputs found

    Large probe arrays for measuring mean and time dependent local oil volume fraction and local oil velocity component distributions in inclined oil-in-water flows

    Get PDF
    Arrays of dual-sensor and four-sensor needle conductance probes have been used to measure the mean and time dependent local properties of upward inclined, bubbly oil-in-water flows (also known as dispersed oil-in-water flows) in a 153mm diameter pipe. The flow properties that were measured were (i) the local in-situ oil volume fraction ; (ii) the local oil velocity in the axial direction of the pipe (the direction); and (iii) the local oil velocity in the direction from the lower side of the inclined pipe to its upper side (the direction). Oil velocities in the direction (orthogonal to the and directions) were found to be negligible. For all of the flow conditions investigated it was found that the mean value of varied from a maximum value at the upper side of the inclined pipe to a minimum value at the lower side, and that the rate of decrease of this mean value of with distance in the direction became greater as the pipe inclination angle from the vertical was increased. It was also found that the mean value of was greatest at the upper side of the inclined pipe and decreased towards the lower side of the inclined pipe, the rate of decrease with distance in the direction again becoming greater as was increased. For , a water volumetric flow rate , an oil volumetric flow rate and using a sampling period over a total time interval of , it was found that at the upper side of the inclined pipe the standard deviation in was 31.6% of the mean value of . Furthermore for , , and it was found that the standard deviation in the cross-pipe oil velocity component was approximately equal to the standard deviation in the axial velocity component . These large temporal variations in the local flow properties have been attributed to the presence of large scale Kelvin-Helmholtz waves which intermittently appear in the flow. It is believed that the techniques outlined in this paper for measuring the standard deviation of local flow properties as a function of the sampling period will be of considerable value in validating mathematical models of time dependent oil-water flows. It should be noted that the principal focus of this paper is on the measurement techniques that were used and the methods of data analysis rather than the presentation of exhaustive experimental results at numerous different flow conditions

    Experimental and theoretical study of the gas–water two phase flow through a conductance multiphase Venturi meter in vertical annular (wet gas) flow

    Get PDF
    Annular gas–liquid two phase flow widely occurs in nuclear industry. Various combinations of techniques have been employed in annular gas–liquid two phase flows to measure the flow parameters (e.g. liquid film thickness, gas volume fraction and the phase flow rates). One of the most useful techniques which has proven attractive for many multiphase flow applications is the electrical conductance technique. This paper presents an advanced conductance multiphase Venturi meter (CMVM) which is capable of measuring the gas volume fractions at the inlet and the throat of the Venturi. A new model was investigated to measure the gas flow rate. This model is based on the measurement of the gas volume fractions at the inlet and the throat of the Venturi meter using a conductance technique rather than relying on prior knowledge of the mass flow quality x. We measure conductance using two ring electrodes flush with the inner surface of the Venturi throat and two ring electrodes flush with the inner surface of the Venturi inlet. The basic operation of the electrical conductance technique in a multiphase flow is that the conductance of the mixture depends on the gas volume fraction in the water. An electronic circuit was built and calibrated to give a dc voltage output which is proportional to the conductance of the mixture which can then be related to the water film thickness in annular flow (and hence to the gas volume fraction). It was inferred from the experimental results that the minimum average percentage error of the predicted gas mass flow rates (i.e. −0.0428%) can be achieved at the optimum gas discharge coefficient of 0.932

    Thermal ablation versus cryotherapy or loop excision to treat women positive for cervical precancer on visual inspection with acetic acid test: pilot phase of a randomised controlled trial

    Get PDF
    Background: Cryotherapy is standard practice for treating patients with cervical precancer in see-and-treat programmes in low-income and middle-income countries (LMICs). Because of logistical difficulties with cryotherapy (eg, the necessity, costs, and supply chain difficulties of refrigerant gas; equipment failure; and treatment duration >10 min), a battery-operated thermal ablator that is lightweight and portable has been developed. We aimed to compare thermal ablation using the new device with cryotherapy. Methods: We report the pilot phase of a randomised controlled trial in routine screen-and-treat clinics providing cervical screening using visual inspection with acetic acid (VIA) in Lusaka, Zambia. We recruited non-pregnant women, aged 25 years or older, who were eligible for ablative therapy. We randomly assigned participants (1:1:1) to thermal ablation, cryotherapy, or large loop excision of the transformation zone (LLETZ), using computer-generated allocation. The randomisation was concealed but the nurses providing treatment and the participants were unmasked. Thermal ablation was achieved using the Liger thermal ablator (using 1–5 overlapping applications of the probe heated to 100°C, each application lasting for 40 s), cryotherapy was carried out using the double-freeze technique (freeze for 3 min, thaw for 5 min, and freeze again for 3 min), and LLETZ (using a large loop driven by an electro-surgical unit to excise the transformation zone) was done under local anaesthesia. The primary endpoint was treatment success, defined as either human papillomavirus (HPV) type-specific clearance among participants who were positive for the same HPV type at baseline, or a negative VIA test at 6-month follow-up, if the baseline HPV test was negative. Per protocol analyses were done. Enrolment for the full trial is ongoing. Here, we present findings from a prespecified pilot phase of the full trial. The final analysis of the full trial will assess non-inferiority of the groups for the primary efficacy endpoint. The study is registered with ClinicalTrials.gov, number NCT02956239. Findings: Between Aug 2, 2017, and Jan 15, 2019, 750 participants were randomly assigned (250 per group). 206 (84%) participants in the cryotherapy group, 197 (81%) in the thermal ablation group, and 204 (84%) in the LLETZ group attended the 6-month follow-up examination. Treatment success was reported in 120 (60%) of 200 participants in the cryotherapy group, 123 (64%) of 192 in the thermal ablation group, and 134 (67%) of 199 in the LLETZ group (p=0·31). Few participants complained of moderate to severe pain in any group immediately after the procedure (six [2%] of 250 in the cryotherapy group, four [2%] of 250 in the thermal ablation group, and five [2%] of 250 in the LLETZ group) and 2 weeks after the procedure (one [<1%] of 241 in the cryotherapy group, none of 242 in the thermal ablation group, and two [<1%] of 237 in the LLETZ group). None of the participants reported any complication requiring medical consultation or admission to hospital. Interpretation: Results from this pilot study preliminarily suggest that thermal ablation has similar treatment success to cryotherapy, without the practical disadvantages of providing cryotherapy in an LMIC. However, the study was not powered to establish the similarity between the techniques, and results from the ongoing randomised controlled trial are need to confirm these results. Funding: US National Institutes of Health

    Developments in Structuring of Reformed Theology:The Synopsis Purioris Theologiae (1625) as Example

    Get PDF
    The Synopsis Purioris Theologiae (1625), an influential handbook of Reformeddogmatics, began as a cycle of disputations. A comparison of it with the cyclesthat were held previously in Leiden reveals some shifts in the structure of Reformeddogmatics. After introducing the Synopsis, this paper highlights thefunction of prolegomena, the place of predestination, and the relationship betweenthe magistrate and eschatology. It concludes that the choices made in theSynopsis illustrate tensions in Reformed theology. After the conflict with theRemonstrants it became urgent to carefully define the character of theology inthe prolegomena, to relate predestination to the person and work of Christ, andto connect the task of the magistrate to the doctrine of the church

    Evidence for a mixed mass composition at the `ankle' in the cosmic-ray spectrum

    Get PDF
    We report a first measurement for ultra-high energy cosmic rays of the correlation between the depth of shower maximum and the signal in the water Cherenkov stations of air-showers registered simultaneously by the fluorescence and the surface detectors of the Pierre Auger Observatory. Such a correlation measurement is a unique feature of a hybrid air-shower observatory with sensitivity to both the electromagnetic and muonic components. It allows an accurate determination of the spread of primary masses in the cosmic-ray flux. Up till now, constraints on the spread of primary masses have been dominated by systematic uncertainties. The present correlation measurement is not affected by systematics in the measurement of the depth of shower maximum or the signal in the water Cherenkov stations. The analysis relies on general characteristics of air showers and is thus robust also with respect to uncertainties in hadronic event generators. The observed correlation in the energy range around the `ankle' at lg(E/eV)=18.519.0\lg(E/{\rm eV})=18.5-19.0 differs significantly from expectations for pure primary cosmic-ray compositions. A light composition made up of proton and helium only is equally inconsistent with observations. The data are explained well by a mixed composition including nuclei with mass A>4A > 4. Scenarios such as the proton dip model, with almost pure compositions, are thus disfavoured as the sole explanation of the ultrahigh-energy cosmic-ray flux at Earth.Comment: Published version. Added journal reference and DOI. Added Report Numbe

    Measurement of the polarisation of W bosons produced with large transverse momentum in pp collisions at sqrt(s) = 7 TeV with the ATLAS experiment

    Get PDF
    This paper describes an analysis of the angular distribution of W->enu and W->munu decays, using data from pp collisions at sqrt(s) = 7 TeV recorded with the ATLAS detector at the LHC in 2010, corresponding to an integrated luminosity of about 35 pb^-1. Using the decay lepton transverse momentum and the missing transverse energy, the W decay angular distribution projected onto the transverse plane is obtained and analysed in terms of helicity fractions f0, fL and fR over two ranges of W transverse momentum (ptw): 35 < ptw < 50 GeV and ptw > 50 GeV. Good agreement is found with theoretical predictions. For ptw > 50 GeV, the values of f0 and fL-fR, averaged over charge and lepton flavour, are measured to be : f0 = 0.127 +/- 0.030 +/- 0.108 and fL-fR = 0.252 +/- 0.017 +/- 0.030, where the first uncertainties are statistical, and the second include all systematic effects.Comment: 19 pages plus author list (34 pages total), 9 figures, 11 tables, revised author list, matches European Journal of Physics C versio

    Observation of a new chi_b state in radiative transitions to Upsilon(1S) and Upsilon(2S) at ATLAS

    Get PDF
    The chi_b(nP) quarkonium states are produced in proton-proton collisions at the Large Hadron Collider (LHC) at sqrt(s) = 7 TeV and recorded by the ATLAS detector. Using a data sample corresponding to an integrated luminosity of 4.4 fb^-1, these states are reconstructed through their radiative decays to Upsilon(1S,2S) with Upsilon->mu+mu-. In addition to the mass peaks corresponding to the decay modes chi_b(1P,2P)->Upsilon(1S)gamma, a new structure centered at a mass of 10.530+/-0.005 (stat.)+/-0.009 (syst.) GeV is also observed, in both the Upsilon(1S)gamma and Upsilon(2S)gamma decay modes. This is interpreted as the chi_b(3P) system.Comment: 5 pages plus author list (18 pages total), 2 figures, 1 table, corrected author list, matches final version in Physical Review Letter

    Search for displaced vertices arising from decays of new heavy particles in 7 TeV pp collisions at ATLAS

    Get PDF
    We present the results of a search for new, heavy particles that decay at a significant distance from their production point into a final state containing charged hadrons in association with a high-momentum muon. The search is conducted in a pp-collision data sample with a center-of-mass energy of 7 TeV and an integrated luminosity of 33 pb^-1 collected in 2010 by the ATLAS detector operating at the Large Hadron Collider. Production of such particles is expected in various scenarios of physics beyond the standard model. We observe no signal and place limits on the production cross-section of supersymmetric particles in an R-parity-violating scenario as a function of the neutralino lifetime. Limits are presented for different squark and neutralino masses, enabling extension of the limits to a variety of other models.Comment: 8 pages plus author list (20 pages total), 8 figures, 1 table, final version to appear in Physics Letters

    Measurement of the inclusive isolated prompt photon cross-section in pp collisions at sqrt(s)= 7 TeV using 35 pb-1 of ATLAS data

    Get PDF
    A measurement of the differential cross-section for the inclusive production of isolated prompt photons in pp collisions at a center-of-mass energy sqrt(s) = 7 TeV is presented. The measurement covers the pseudorapidity ranges |eta|<1.37 and 1.52<=|eta|<2.37 in the transverse energy range 45<=E_T<400GeV. The results are based on an integrated luminosity of 35 pb-1, collected with the ATLAS detector at the LHC. The yields of the signal photons are measured using a data-driven technique, based on the observed distribution of the hadronic energy in a narrow cone around the photon candidate and the photon selection criteria. The results are compared with next-to-leading order perturbative QCD calculations and found to be in good agreement over four orders of magnitude in cross-section.Comment: 7 pages plus author list (18 pages total), 2 figures, 4 tables, final version published in Physics Letters

    Framing the concept of satellite remote sensing essential biodiversity variables: challenges and future directions

    Get PDF
    Although satellite-based variables have for long been expected to be key components to a unified and global biodiversity monitoring strategy, a definitive and agreed list of these variables still remains elusive. The growth of interest in biodiversity variables observable from space has been partly underpinned by the development of the essential biodiversity variable (EBV) framework by the Group on Earth Observations – Biodiversity Observation Network, which itself was guided by the process of identifying essential climate variables. This contribution aims to advance the development of a global biodiversity monitoring strategy by updating the previously published definition of EBV, providing a definition of satellite remote sensing (SRS) EBVs and introducing a set of principles that are believed to be necessary if ecologists and space agencies are to agree on a list of EBVs that can be routinely monitored from space. Progress toward the identification of SRS-EBVs will require a clear understanding of what makes a biodiversity variable essential, as well as agreement on who the users of the SRS-EBVs are. Technological and algorithmic developments are rapidly expanding the set of opportunities for SRS in monitoring biodiversity, and so the list of SRS-EBVs is likely to evolve over time. This means that a clear and common platform for data providers, ecologists, environmental managers, policy makers and remote sensing experts to interact and share ideas needs to be identified to support long-term coordinated actions
    corecore