Structure, morphology and magnetic properties of flowerlike gamma-Fe2O3@NiO core/shell nanocomposites synthesized from different precursor concentrations

The flowerlike gamma-Fe2O3@NiO core/shell nanocomposites are synthesized by the two-step method. Their structure and morphology can be controlled by tuning the precursor concentration. Microstructural analysis reveals that all the samples have distinct core/shell structure without impurities, and the NiO shells are built of many irregular nanosheets which enclose the surface of gamma-Fe2O3 core. As the precursor concentration decreases (i.e., more NiO content), the NiO grain grows significantly, and the thickness of NiO shells increases. Magnetic experiments are performed to analyze the influences of different microstructures on magnetic properties of samples and we have the following two results. First, at 5 K, along with increasing thickness of NiO shell, the saturation magnetization increases, while the residual magnetization decreases slightly. Second, the hysteresis loops under cooling field demonstrate that the value of exchange bias effect fluctuates between 13 Oe and 17 Oe. This is mainly because of the NiO shell that (i) is composed of irregular nanosheets with disordered orientations, and (ii) does not form a complete coating around gamma-Fe2O3 core

A Novel Control Strategy of DFIG Based on the Optimization of Transfer Trajectory at Operation Points in the Islanded Power System

A novel control strategy based on the optimization of transfer trajectory at operation points for DFIG is proposed. Aim of this control strategy is to reduce the mechanical fatigue of DFIG caused by the frequent adjustment of rotating speed and pitch angle when operating in the islanded power system. Firstly, the stability of DFIG at different operation points is analyzed. Then an optimization model of transfer trajectory at operation points is established, with the minimum synthetic adjustment amount of rotating speed and pitch angle as the objective function and with the balance of active power and the stability of operation points as the constraint conditions. Secondly, the wind speed estimator is designed, and the control strategy of pitch system is improved to cooperate with the indirect stator flux orientation control technology for rotor-side inverter control. Then by the coordination control of its rotating speed and pitch angle, an operation trajectory controller is established to ensure the islanded operation of DFIG along the optimal transfer trajectory. Finally, the simulation results show that the proposed control strategy is technical feasibility with good performance

Search for dark matter produced in association with bottom or top quarks in √s = 13 TeV pp collisions with the ATLAS detector

A search for weakly interacting massive particle dark matter produced in association with bottom or top quarks is presented. Final states containing third-generation quarks and miss- ing transverse momentum are considered. The analysis uses 36.1 fb−1 of proton–proton collision data recorded by the ATLAS experiment at √s = 13 TeV in 2015 and 2016. No significant excess of events above the estimated backgrounds is observed. The results are in- terpreted in the framework of simplified models of spin-0 dark-matter mediators. For colour- neutral spin-0 mediators produced in association with top quarks and decaying into a pair of dark-matter particles, mediator masses below 50 GeV are excluded assuming a dark-matter candidate mass of 1 GeV and unitary couplings. For scalar and pseudoscalar mediators produced in association with bottom quarks, the search sets limits on the production cross- section of 300 times the predicted rate for mediators with masses between 10 and 50 GeV and assuming a dark-matter mass of 1 GeV and unitary coupling. Constraints on colour- charged scalar simplified models are also presented. Assuming a dark-matter particle mass of 35 GeV, mediator particles with mass below 1.1 TeV are excluded for couplings yielding a dark-matter relic density consistent with measurements

Analysis of Lipids in Pitaya Seed Oil by Ultra-Performance Liquid Chromatography–Time-of-Flight Tandem Mass Spectrometry

Red pitaya (Hylocereus undatus) is an essential tropical fruit in China. To make more rational use of its processing, byproducts and fruit seeds, and the type, composition, and relative content of lipids in pitaya seed oil were analyzed by UPLC-TOF-MS/MS. The results showed that the main fatty acids in pitaya seed oil were linoleic acid 42.78%, oleic acid 27.29%, and palmitic acid 16.66%. The ratio of saturated fatty acids to unsaturated fatty acids to polyunsaturated fatty acids was close to 1:1.32:1.75. The mass spectrum behavior and fracture mechanism of four lipid components, TG 54:5|TG 18:1_18:2_18:2, were analyzed. In addition, lipids are an essential indicator for evaluating the quality of oils and fats, and 152 lipids were isolated and identified from pitaya seed oil for the first time, including 136 glycerides and 16 phospholipids. The main components of glyceride and phospholipids were triglycerides and phosphatidyl ethanol, providing essential data support for pitaya seed processing and functional product development

Characteristics of Unorganized Hydrogen Sulfide Dispersion for Industrial Building Layout Optimization

Hydrogen sulfide (H2S) is the main toxic pollutant emitted to the atmosphere from auto-coating wastewater. Its unorganized dispersion poses a health challenge for workers. Defining safe working distance, which transfers the H2S occupational exposure limit into industrial construction design regulation, would be a useful approach for reducing H2S exposure risk. Therefore, in this study, an H2S dispersion prediction, within 25 m, was performed by a computational fluid dynamics (CFD) method to explore the influence of temperature and wind speed on H2S dispersion. With the temperature changes from 288 K to 303 K, the H2S concentration at different observing points decreased. With wind speed changes from 2 m/s to 20 m/s, the plume layer structure was studied in the whole process. According to the H2S distribution characteristics, when the sedimentation tank treatment capacity is less than or equal to 10 m3/h, the safe working distance of H2S unorganized dispersion is 10 m. Hence, when there are workplaces within 10 m of the tank, closed measures should be taken for the sedimentation tank, or the manufacturer layout should be optimized to protect the environment and human health

Cytogenetics data in adult men involved in the recycling of electronic wastes

In this data article, 146 villagers (exposed group) were randomly selected from the workers who involved in the e-wastes recycling directly as a daily job in Tianjin. Control group, including 121 villagers, came from another town without e-waste disposal sites. Chromosomal aberrations (CA) and cytokinesis blocking micronucleus (CBMN) were performed to detect the cytogenetic effect for each subject. DNA damage was detected using comet assay; the DNA percentage in the comet tail (TDNA%), tail moment (TM), and Olive tail moment (OTM) were recorded to describe DNA damage to lymphocytes and spermatozoa. Routine semen analysis, spermatozoa motility and morphology were analyzed. The RT2Profiler PCR array was used to measure levels of expression of 84 genes related to quality of DNA. It showed significant relationships between CA, CBMN, DNA damage and exposure time in exposure subjects. The alteration of sperm motility rate, abnormality rate and total sperm counts had association with exposure time and age