Low threshold linear cavity mode-locked fiber laser using microfiber-based carbon nanotube saturable absorber

In this work, we demonstrate a linear cavity mode-locked erbium-doped fiber laser in C-band wavelength region. The passive mode-locking is achieved using a microfiber-based carbon nanotube saturable absorber. The carbon nanotube saturable absorber has low saturation fluence of 0.98 µJ/cm2. Together with the linear cavity architecture, the fiber laser starts to produce soliton pulses at low pump power of 22.6 mW. The proposed fiber laser generates fundamental soliton pulses with a center wavelength, pulse width, and repetition rate of 1557.1 nm, 820 fs, and 5.41 MHz, respectively. This mode-locked laser scheme presents a viable option in the development of low threshold ultrashort pulse system for deployment as a seed laser

Low threshold L-band mode-locked ultrafast fiber laser assisted by microfiber-based single wall carbon nanotube saturable absorber

We demonstrate a passively mode-locked erbium-doped fiber laser in L-band wavelength region with low mode-locking threshold employing a 1425 nm pump wavelength. The mode-locking regime is generated by microfiber-based saturable absorber using carbon nanotube-polymer composite in a ring cavity. This carbon nanotube saturable absorber shows saturation intensity of 9 MW/cm². In this work, mode-locking laser threshold is observed at 36.4 mW pump power. At the maximum pump power of 107.6 mW, we obtain pulse duration at full-width half-maximum point of 490 fs and time bandwidth product of 0.33, which corresponds to 3-dB spectral bandwidth of 5.8 nm. The pulse repetition rate remains constant throughout the experiment at 5.8 MHz due to fixed cavity length of 35.5 m. Average output power and pulse energy of 10.8 mW and 1.92 nJ are attained respectively through a 30% laser output extracted from the mode-locked cavity. This work highlights the feasibility of attaining a low threshold mode-locked laser source to be employed as seed laser in L-band wavelength region

Synthesis and characterization of thin film composite membranes made of PSF-TiO2/GO nanocomposite substrate for forward osmosis applications

Support layer of thin film composite (TFC) membrane plays an important role in forward osmosis (FO) performance. A new type of support layer or nanocomposite substrate was developed by incorporating titanium dioxide (TiO2)/graphene oxide (GO) into polysulfone (PSF) matrix. Prior to performance evaluation, the developed substrates were characterized with respect to surface chemistry, roughness and cross-sectional morphology. The results showed that both surface hydrophilicity and roughness of PSF-based substrates were increased upon incorporation of nanomaterials. Substrates with long finger-like voids extended from the top to the bottom could be developed upon incorporation of TiO2 (SubstrateTiO2) or TiO2/GO mixture (SubstrateTiO2/GO). The improved surface hydrophilicity and favorable structure formed are the main factors leading to higher water flux of nanocomposite substrate. Moreover, the water flux of FO using TFC membranes could be enhanced using this nanocomposite substrate. Comparing to the control TFC membrane, the TFC membranes made of SubstrateTiO2 and SubstrateTiO2/GO exhibited greater water flux with minimum increase in reverse draw solute flux. Based on the results obtained

Comparative study on membrane distillation application between raw POME and POMSE

The palm oil industry is considered the traditional pillar of Malaysian industry that plays a key role in the domestic economy. In addition to the high incomes generated by this industry, it generates large quantities of effluent. To solve this problem, the purpose of this work is to introduce membrane distillation (MD) technology for the effluent treatment system. Polyvinylidene fluoride (PVDF) -bentonite hollow fiber membranes were tested in an MD system using raw palm oil mill effluent (POME) and palm oil mill secondary effluent (POMSE). Preliminary test was carried out using deionized water to evaluate the maximum permeate flux achievable in the absence of fouling problem before continuing with POME and POMSE as the feed solution. Membrane performance was evaluated in terms of permeate flux and rejection rate of several water quality parameters. The average permeate flux obtained while using raw POME is much lower than that obtained in the POMSE test which was recorded as 1.41 ± 0.62 kg/m2.hr and 3.45 ± 0.51 kg/m2.hr respectively. The membrane tested for POME experienced a significant decrease in flux relative to POMSE due to the excessive amounts of biological compounds blocking the membrane pores. In terms of removal efficiency of the PVDF-bentonite membrane, the membranes were able to achieve more than 95% removal efficiency for chemical oxygen demand, nitrate nitrogen, total suspended solids, total dissolved solids, color and turbidity. The results proved that the DCMD system was able to eliminate almost all pollutants in the effluent from oil palm industry. However, raw POME without pre-treatment is not suitable to be used directly in the DCMD process because it will cause a serious fouling problem. In conclusion, it can be said that MD has shown excellent performance in the treatment of palm oil wastewater and can be applied to other types of oil industries

The state-of-the-art development of photocatalysts for degrading of persistent herbicides in aqueous environment

Herbicides are one of the most recurring pollutants in the aquatic system due to their widespread usage in the agriculture sector for weed control. Semiconductor-based photocatalysts have gained recognition due to their ability to degrade and mineralize pollutants into harmless by-products completely. Lately, many studies have been done to design photocatalysts with efficient separation of photogenerated charge carriers and enhanced light absorption. Photocatalyst engineering through doping with metal and non-metal elements and the formation of heterojunction are proven effective for minimizing the recombination of electron-hole pairs and enlarging the absorption in the visible light region. This review focuses on discussing and evaluating the recent progress in the types of photocatalysts and their performance in the remediation of herbicides in wastewater. The development of innovative hybrid technologies is also highlighted. The limitations and challenges of photocatalysis technology in the present literature have been identified, and future studies are recommended

PREPARATION AND CHARACTERIZATION OF LAFEO3 USING DUAL-COMPLEXING AGENTS FOR PHOTODEGRADATION OF HUMIC ACID

Humic Acid (HA) is considered as one of the major components that represents a major fraction of dissolved in natural water. Complex mixture of organic compounds on HA lead to the problematic issue for municipal wastewater treatment plants such as undesirable taste, colour to drinking water and fouling in pipe line. The reaction of HA with chlorine during disinfection processes would produce carcinogenic by-products like trihalomethanes. In this study, for the first time, LaFeO3 photocatalyst was successfully synthesized via gel-combustion method using combined glucose/citric acid as chelating agents and was further calcined at 400°C. The photocatalytic activity of samples was investigated by degradation of Humic Acid (HA) in water under visible light irradiation. Results proved that the photocatalytic degradation of HA is dependent on the catalyst dosage, initial concentration of HA, and oxygen availability in the aeration. The photocatalytic degradation also was enhanced by high surface area of synthesized LaFeO3 obtained by amorphous structure. Overall, the percentage removal of HA by varying the catalyst dosage are in the order of 88%, 90%, 98% and 97% for 0.6 g/L, 0.8 g/L, 1.0 g/L, and 1.2 g/L respectively for an irradiation period of 120 minutes. Next, the removal of HA by manipulating its initial concentration are 98%, 90%, 85% and 86% with respect to 10 g/L, 20 g/L, 30 g/L and 40 g/L taken for 120 minutes. Overall, the optimal operational parameters for the removal of HA of catalyst dosage is 1.0 g/L performing at 98%, for initial concentration of HA which was removed efficiently at 97% is 10 g/L and via aeration in this study was about 93%, after 120 min of irradiation times

Search for displaced vertices arising from decays of new heavy particles in 7 TeV pp collisions at ATLAS

We present the results of a search for new, heavy particles that decay at a significant distance from their production point into a final state containing charged hadrons in association with a high-momentum muon. The search is conducted in a pp-collision data sample with a center-of-mass energy of 7 TeV and an integrated luminosity of 33 pb^-1 collected in 2010 by the ATLAS detector operating at the Large Hadron Collider. Production of such particles is expected in various scenarios of physics beyond the standard model. We observe no signal and place limits on the production cross-section of supersymmetric particles in an R-parity-violating scenario as a function of the neutralino lifetime. Limits are presented for different squark and neutralino masses, enabling extension of the limits to a variety of other models.Comment: 8 pages plus author list (20 pages total), 8 figures, 1 table, final version to appear in Physics Letters

Measurement of the polarisation of W bosons produced with large transverse momentum in pp collisions at sqrt(s) = 7 TeV with the ATLAS experiment

This paper describes an analysis of the angular distribution of W->enu and W->munu decays, using data from pp collisions at sqrt(s) = 7 TeV recorded with the ATLAS detector at the LHC in 2010, corresponding to an integrated luminosity of about 35 pb^-1. Using the decay lepton transverse momentum and the missing transverse energy, the W decay angular distribution projected onto the transverse plane is obtained and analysed in terms of helicity fractions f0, fL and fR over two ranges of W transverse momentum (ptw): 35 < ptw < 50 GeV and ptw > 50 GeV. Good agreement is found with theoretical predictions. For ptw > 50 GeV, the values of f0 and fL-fR, averaged over charge and lepton flavour, are measured to be : f0 = 0.127 +/- 0.030 +/- 0.108 and fL-fR = 0.252 +/- 0.017 +/- 0.030, where the first uncertainties are statistical, and the second include all systematic effects.Comment: 19 pages plus author list (34 pages total), 9 figures, 11 tables, revised author list, matches European Journal of Physics C versio

Observation of a new chi_b state in radiative transitions to Upsilon(1S) and Upsilon(2S) at ATLAS

The chi_b(nP) quarkonium states are produced in proton-proton collisions at the Large Hadron Collider (LHC) at sqrt(s) = 7 TeV and recorded by the ATLAS detector. Using a data sample corresponding to an integrated luminosity of 4.4 fb^-1, these states are reconstructed through their radiative decays to Upsilon(1S,2S) with Upsilon->mu+mu-. In addition to the mass peaks corresponding to the decay modes chi_b(1P,2P)->Upsilon(1S)gamma, a new structure centered at a mass of 10.530+/-0.005 (stat.)+/-0.009 (syst.) GeV is also observed, in both the Upsilon(1S)gamma and Upsilon(2S)gamma decay modes. This is interpreted as the chi_b(3P) system.Comment: 5 pages plus author list (18 pages total), 2 figures, 1 table, corrected author list, matches final version in Physical Review Letter

Measurement of the inclusive isolated prompt photon cross-section in pp collisions at sqrt(s)= 7 TeV using 35 pb-1 of ATLAS data

A measurement of the differential cross-section for the inclusive production of isolated prompt photons in pp collisions at a center-of-mass energy sqrt(s) = 7 TeV is presented. The measurement covers the pseudorapidity ranges |eta|<1.37 and 1.52<=|eta|<2.37 in the transverse energy range 45<=E_T<400GeV. The results are based on an integrated luminosity of 35 pb-1, collected with the ATLAS detector at the LHC. The yields of the signal photons are measured using a data-driven technique, based on the observed distribution of the hadronic energy in a narrow cone around the photon candidate and the photon selection criteria. The results are compared with next-to-leading order perturbative QCD calculations and found to be in good agreement over four orders of magnitude in cross-section.Comment: 7 pages plus author list (18 pages total), 2 figures, 4 tables, final version published in Physics Letters