Electron-phonon renormalization of the absorption edge of the cuprous halides

Compared to most tetrahedral semiconductors, the temperature dependence of the absorption edges of the cuprous halides (CuCl, CuBr, CuI) is very small. CuCl and CuBr show a small increase of the gap $E_0$ with increasing temperature, with a change in the slope of $E_0$ vs. $T$ at around 150 K: above this temperature, the variation of $E_0$ with $T$ becomes even smaller. This unusual behavior has been clarified for CuCl by measurements of the low temperature gap vs. the isotopic masses of both constituents, yielding an anomalous negative shift with increasing copper mass. Here we report the isotope effects of Cu and Br on the gap of CuBr, and that of Cu on the gap of CuI. The measured isotope effects allow us to understand the corresponding temperature dependences, which we also report, to our knowledge for the first time, in the case of CuI. These results enable us to develop a more quantitative understanding of the phenomena mentioned for the three halides, and to interpret other anomalies reported for the temperature dependence of the absorption gap in copper and silver chalcogenides; similarities to the behavior observed for the copper chalcopyrites are also pointed out.Comment: 14 pages, 5 figures, submitted to Phys. Rev.

Study of Operating Characteristics of Pyrotechnic Reserve Power Source Based on Magnesium and Zinс

This paper presents the results of studies of operating parameters of pyrotechnic reserve power source (PRPS). This battery was activated by the pyrotechnic compositions contained in the electrodes. Once the ignition impulse worked, the pyrotechnic compositions took fire immediately and melted the electrolyte. Then the rest pyrotechnic compositions served as anode and cathode. The battery began to discharge. The following characteristics of PRPS were evaluated during the study: release time to operating regime of the electric current, the duration of the PRPS work and initiation temperature of PRPS. A detailed evaluation of the Mg/LiF/PbF2 electrochemical system and Zn/LiF/PbF2 one is undertaken. Test results show that the electric current value using powder of zinc and granular zinc in these experiments was 0.179 A and 0.1 A, respectively, and the operating time at these values of elecrtic current was 40 and 151 sec, respectively

Single hadron response measurement and calorimeter jet energy scale uncertainty with the ATLAS detector at the LHC

The uncertainty on the calorimeter energy response to jets of particles is derived for the ATLAS experiment at the Large Hadron Collider (LHC). First, the calorimeter response to single isolated charged hadrons is measured and compared to the Monte Carlo simulation using proton-proton collisions at centre-of-mass energies of sqrt(s) = 900 GeV and 7 TeV collected during 2009 and 2010. Then, using the decay of K_s and Lambda particles, the calorimeter response to specific types of particles (positively and negatively charged pions, protons, and anti-protons) is measured and compared to the Monte Carlo predictions. Finally, the jet energy scale uncertainty is determined by propagating the response uncertainty for single charged and neutral particles to jets. The response uncertainty is 2-5% for central isolated hadrons and 1-3% for the final calorimeter jet energy scale.Comment: 24 pages plus author list (36 pages total), 23 figures, 1 table, submitted to European Physical Journal

Technological Aspects of Introduction Crocus Alatavicus According to GACP Requirements

According to the forecasts of the World Health Organization, the share of herbal medicines in the global pharmaceutical market is more than 40%. The pronounced growth trend of phytopreparations can lead to depletion of stocks of medicinal plants and the introduction of medicinal plants into the culture is a suitable solution to the problem. In order to ensure the quality of medicinal plants, in 2003 the World Health Organization (WHO) issued guidelines on Good cultivation and harvesting practices (GACP) medicinal plants. This article presents the results of the introduction of the Crocus alatavicus plant by seeds. The aim of the study is to develop a technology for the introduction of Crocus alatavicus by the method of seed propagation according to the principles of GACP. The development of the introduction technology according to the principles of GACP guarantees the provision of domestic pharmaceutical production with high-quality plant raw materials. The introduction was carried out at the pilot production plantation of "Phytoleum" LLP. The results of the study showed that during seed propagation, autumn sowing of Crocus alatavicus seeds is preferable. The introduction of organic fertilizer of vermicompost before sowing seeds has a positive effect on the germination of seeds and the survival of seedlings. The plant in the fourth year of vegetation goes into the generative period and the fruit will form. The results of the introduction of Crocus alatavicus by seeds in the period from 2018 to 2022 showed good seed germination and high survival of seedlings, which makes it possible to recommend the plant for introduction into culture. It is important to emphasize that the ability to cultivate C. alatavicus from seeds creates new opportunities for use as domestic raw materials for the purpose of further rational use in scientific and practical medicine, preserving this species in culture

Standalone vertex finding in the ATLAS muon spectrometer

A dedicated reconstruction algorithm to find decay vertices in the ATLAS muon spectrometer is presented. The algorithm searches the region just upstream of or inside the muon spectrometer volume for multi-particle vertices that originate from the decay of particles with long decay paths. The performance of the algorithm is evaluated using both a sample of simulated Higgs boson events, in which the Higgs boson decays to long-lived neutral particles that in turn decay to bbar b final states, and pp collision data at √s = 7 TeV collected with the ATLAS detector at the LHC during 2011

Measurements of Higgs boson production and couplings in diboson final states with the ATLAS detector at the LHC

Measurements are presented of production properties and couplings of the recently discovered Higgs boson using the decays into boson pairs, H →γ γ, H → Z Z∗ →4l and H →W W∗ →lνlν. The results are based on the complete pp collision data sample recorded by the ATLAS experiment at the CERN Large Hadron Collider at centre-of-mass energies of √s = 7 TeV and √s = 8 TeV, corresponding to an integrated luminosity of about 25 fb−1. Evidence for Higgs boson production through vector-boson fusion is reported. Results of combined fits probing Higgs boson couplings to fermions and bosons, as well as anomalous contributions to loop-induced production and decay modes, are presented. All measurements are consistent with expectations for the Standard Model Higgs boson

Measurement of the top quark pair cross section with ATLAS in pp collisions at √s=7 TeV using final states with an electron or a muon and a hadronically decaying τ lepton

A measurement of the cross section of top quark pair production in proton-proton collisions recorded with the ATLAS detector at the Large Hadron Collider at a centre-of-mass energy of 7 TeV is reported. The data sample used corresponds to an integrated luminosity of 2.05 fb -1. Events with an isolated electron or muon and a τ lepton decaying hadronically are used. In addition, a large missing transverse momentum and two or more energetic jets are required. At least one of the jets must be identified as originating from a b quark. The measured cross section, σtt-=186±13(stat.)±20(syst.)±7(lumi.) pb, is in good agreement with the Standard Model prediction

Measurement of the top quark-pair production cross section with ATLAS in pp collisions at \sqrt{s}=7\TeV

A measurement of the production cross-section for top quark pairs(\ttbar) in $pp$ collisions at \sqrt{s}=7 \TeV is presented using data recorded with the ATLAS detector at the Large Hadron Collider. Events are selected in two different topologies: single lepton (electron $e$ or muon $\mu$) with large missing transverse energy and at least four jets, and dilepton ($ee$, $\mu\mu$ or $e\mu$) with large missing transverse energy and at least two jets. In a data sample of 2.9 pb-1, 37 candidate events are observed in the single-lepton topology and 9 events in the dilepton topology. The corresponding expected backgrounds from non-\ttbar Standard Model processes are estimated using data-driven methods and determined to be $12.2 \pm 3.9$ events and $2.5 \pm 0.6$ events, respectively. The kinematic properties of the selected events are consistent with SM \ttbar production. The inclusive top quark pair production cross-section is measured to be \sigmattbar=145 \pm 31 ^{+42}_{-27} pb where the first uncertainty is statistical and the second systematic. The measurement agrees with perturbative QCD calculations.Comment: 30 pages plus author list (50 pages total), 9 figures, 11 tables, CERN-PH number and final journal adde

Expected Performance of the ATLAS Experiment - Detector, Trigger and Physics

A detailed study is presented of the expected performance of the ATLAS detector. The reconstruction of tracks, leptons, photons, missing energy and jets is investigated, together with the performance of b-tagging and the trigger. The physics potential for a variety of interesting physics processes, within the Standard Model and beyond, is examined. The study comprises a series of notes based on simulations of the detector and physics processes, with particular emphasis given to the data expected from the first years of operation of the LHC at CERN