426 research outputs found

    Studio di fattibilità della ricostruzione del decadimento D0→K−μ+νμD^0\to K^-\mu^+\nu_{\mu} ad LHCb

    Get PDF
    Il Modello Standard delle particelle elementari prevede l’universalità del sapore leptonico, cioè l’uguaglianza della probabilità di accoppiamento dei bosoni di gauge carichi dell’interazione debole con tutti i leptoni. Recentemente, le Collaborazioni LHCb, BaBar e Belle, misurando il rapporto tra i branching ratio dei decadimenti B0→D∗−τ+ντeB^0\to D^{∗− }\tau^+\nu_{\tau} e B^0 →D^{∗−}\mu^+\nu_{\mu}, hanno osservato una deviazione dai valori previsti dal Modello Standard di 3.9 deviazioni standard. Questo interessante risultato, se confermato, indicherebbe l’esistenza di nuove particelle, come per esempio il bosone di Higgs carico. Analogamente ai decadimenti del mesone B0B^0 , è possibile cercare effetti analoghi anche nel rapporto di branching ratio dei decadimenti D0→K−μ+νμD^0\to K^ −\mu^+\nu_{\mu} e D0→K−e+νeD^0\to K^−e^+\nu_e . In questo lavoro di tesi è stato realizzato uno studio preliminare di questa misura. In particolare, è stato studiata, tramite simulazioni Monte Carlo, la ricostruzione del processo D∗±→D0(→K−μ+νμ)πs±D^{*\pm}\to D^0 (\to K^− \mu+\nu_{\mu})\pi_s^{\pm} nell’esperimento LHCb. Questo canale ha la particolarità di avere una particella invisibile, il neutrino, al rivelatore LHCb. Tuttavia, mediante vincoli cinematici e topologici, è possibile ricavare le componenti dell’impulso del neutrino, con risoluzioni non paragonabili a quelle di una particella visibile, ma comunque accettabili. In questa tesi sono riportati i calcoli che permettono di ottenere queste informazioni ed è stata studiata la risoluzione sulla massa invariante del D∗±D^{∗\pm} . La tesi è organizzata nel seguente modo: il primo capitolo riporta le motivazioni della misura dei rapporti dei branching ratio e l’attuale stato sperimentale; il secondo capitolo contiene una breve descrizione del rivelatore LHCb; il terzo capitolo, infine, descrive lo studio di fattibilità della ricostruzione del decadimento $D^0\to K^-\mu^+\nu_{\mu}

    Quantitative analysis of fentanyl, several analogues and metabolites in urine by parallel artificial liquid membrane extraction and liquid chromatography tandem mass spectrometry analysis

    Get PDF
    The rapid introduction of new psychoactive substances (NPS) has definitively changed the drug market. Among the several NPS that were identified in the last decades, fentanyl and its analogues deserve special attention. These are synthetic opioids with high potency and are associated with increasing number of deaths; for this reason, forensic toxicologists are paying close attention to these analytes and sensitive analytical methods for their detection in biological samples of drug users are needed. The aim of this study was the development of a LC–MS/MS method for the determination of fentanyl, 23 analogues and metabolites in urine by exploiting parallel artificial liquid membrane extraction (PALME). This technique was shown to be particularly suitable for fentanyl extraction and allowed to obtain a high enrichment factor by using a few microliters of organic solvent (1-octanol) immobilized into a polyvinylidene fluoride (PVDF) membrane. The extraction was carried out on a 96 well plate providing high laboratory throughput. The applied strategy allowed to measure concentrations ranging from 0.1 ng mL − 1 for fentanyl and most analogues to 5 ng mL − 1 for metabolites, by using an entry level mass spectrometer. Because of the different concentration levels generally found in real samples, linearity was studied in different ranges i.e. LOQ to 50 ng mL − 1 for parent drugs and LOQ to 200 ng mL − 1 for metabolites. All the validation parameters were found within the imposed limits, and notably matrix effect was not significant for all the analytes, showing the selectivity achieved by PALME extraction

    Blindness and glaucoma: A multicenter data review from 7 academic eye clinics

    Get PDF
    Purpose To evaluate frequency, conversion rate, and risk factors for blindness in glaucoma patients treated in European Universities. Methods This multicenter retrospective study included 2402 consecutive patients with glaucoma in at least one eye. Medical charts were inspected and patients were divided into those blind and the remainder (''controls''). Blindness was defined as visual acuity-0.05 and/or visual field loss to less than 10°. Results Unilateral and bilateral blindness were respectively 11.0% and 1.6%at the beginning, and 15.5%and 3.6% at the end of the observation period (7.5¹5.5 years, range:1-25 years)//conversion to blindness (at least unilateral) was 1.1%/year. 134 eyes (97 patients) developed blindness by POAG during the study. At the first access to study centre, they had mean deviation (MD) of -17.1¹8.3 dB and treated intraocular pressure (IOP) of 17.1¹6.6 mmHg. During follow-up the IOP decreased by 14%in these eyes but MD deteriorated by 1.1¹3.5 dB/year, which was 5-fold higher than controls (0.2¹1.6 dB/year). In a multivariate model, the best predictors for blindness by glaucoma were initial MD (p<0.001), initial IOP (p<0.001), older age at the beginning of follow-up (p<0.001), whereas final IOP was found to be protective (p<0.05). Conclusions In this series of patients, blindness occurred in about 20%. Blindness by glaucoma had 2 characteristics: late diagnosis and/or late referral, and progression of the disease despite in most cases IOP was within the range of normality and target IOP was achieved//it could be predicted by high initial MD, high initial IOP, and old age

    Observation of channeling for 6500 GeV/c protons in the crystal assisted collimation setup for LHC

    Get PDF
    Two high-accuracy goniometers equipped with two bent silicon crystals were installed in the betatron cleaning insertion of the CERN Large Hadron Collider (LHC) during its long shutdown. First beam tests were recently performed at the LHC with 450 GeV/c and 6500 GeV/c stored proton beams to investigate the feasibility of beam halo collimation assisted by bent crystals. For the first time channeling of 6500 GeV/c protons was observed in a particle accelerator. A strong reduction of beam losses due to nuclear inelastic interactions in the aligned crystal in comparison with its amorphous orientation was detected. The loss reduction value was about 24. Thus, the results show that deflection of particles by a bent crystal due to channeling is effective for this record particle energy.peer-reviewe

    Strong reduction of the off-momentum halo in crystal assisted collimation of the SPS beam

    Get PDF
    A study of crystal assisted collimation has been continued at the CERN SPS for different energies of stored beams using 120 GeV/. c and 270 GeV/. c protons and Pb ions with 270 GeV/. c per charge. A bent silicon crystal used as a primary collimator deflected halo particles using channeling and directing them into the tungsten absorber. A strong correlation of the beam losses in the crystal and off-momentum halo intensity measured in the first high dispersion (HD) area downstream was observed. In channeling conditions, the beam loss rate induced by inelastic interactions of particles with nuclei is significantly reduced in comparison with the non-oriented crystal. A maximal reduction of beam losses in the crystal larger than 20 was observed with 270 GeV/. c protons. The off-momentum halo intensity measured in the HD area was also strongly reduced in channeling conditions. The reduction coefficient was larger than 7 for the case of Pb ions. A strong loss reduction was also detected in regions of the SPS ring far from the collimation area. It was shown by simulations that the miscut angle between the crystal surface and its crystallographic planes doubled the beam losses in the aligned crystal.peer-reviewe

    Comparative results on collimation of the SPS beam of protons and Pb ions with bent crystals

    Get PDF
    New experiments on crystal assisted collimation have been carried out at the CERN SPS with stored beams of 120 GeV/. c protons and Pb ions. Bent silicon crystals of 2 mm long with about 170 Îźrad bend angle and a small residual torsion were used as primary collimators. In channeling conditions, the beam loss rate induced by inelastic interactions of particles with the crystal nuclei is minimal. The loss reduction was about 6 for protons and about 3 for Pb ions. Lower reduction value for Pb ions can be explained by their considerably larger ionization losses in the crystal. In one of the crystals, the measured fraction of the Pb ion beam halo deflected in channeling conditions was 74%, a value very close to that for protons. The intensity of the off-momentum halo leaking out from the collimation station was measured in the first high dispersion area downstream. The particle population in the shadow of the secondary collimator-absorber was considerably smaller in channeling conditions than for amorphous orientations of the crystal. The corresponding reduction was in the range of 2-5 for both protons and Pb ions.peer-reviewe

    Jet energy measurement with the ATLAS detector in proton-proton collisions at root s=7 TeV

    Get PDF
    The jet energy scale and its systematic uncertainty are determined for jets measured with the ATLAS detector at the LHC in proton-proton collision data at a centre-of-mass energy of √s = 7TeV corresponding to an integrated luminosity of 38 pb-1. Jets are reconstructed with the anti-kt algorithm with distance parameters R=0. 4 or R=0. 6. Jet energy and angle corrections are determined from Monte Carlo simulations to calibrate jets with transverse momenta pT≥20 GeV and pseudorapidities {pipe}η{pipe}<4. 5. The jet energy systematic uncertainty is estimated using the single isolated hadron response measured in situ and in test-beams, exploiting the transverse momentum balance between central and forward jets in events with dijet topologies and studying systematic variations in Monte Carlo simulations. The jet energy uncertainty is less than 2. 5 % in the central calorimeter region ({pipe}η{pipe}<0. 8) for jets with 60≤pT<800 GeV, and is maximally 14 % for pT<30 GeV in the most forward region 3. 2≤{pipe}η{pipe}<4. 5. The jet energy is validated for jet transverse momenta up to 1 TeV to the level of a few percent using several in situ techniques by comparing a well-known reference such as the recoiling photon pT, the sum of the transverse momenta of tracks associated to the jet, or a system of low-pT jets recoiling against a high-pT jet. More sophisticated jet calibration schemes are presented based on calorimeter cell energy density weighting or hadronic properties of jets, aiming for an improved jet energy resolution and a reduced flavour dependence of the jet response. The systematic uncertainty of the jet energy determined from a combination of in situ techniques is consistent with the one derived from single hadron response measurements over a wide kinematic range. The nominal corrections and uncertainties are derived for isolated jets in an inclusive sample of high-pT jets. Special cases such as event topologies with close-by jets, or selections of samples with an enhanced content of jets originating from light quarks, heavy quarks or gluons are also discussed and the corresponding uncertainties are determined. © 2013 CERN for the benefit of the ATLAS collaboration

    Measurement of the inclusive and dijet cross-sections of b-jets in pp collisions at sqrt(s) = 7 TeV with the ATLAS detector

    Get PDF
    The inclusive and dijet production cross-sections have been measured for jets containing b-hadrons (b-jets) in proton-proton collisions at a centre-of-mass energy of sqrt(s) = 7 TeV, using the ATLAS detector at the LHC. The measurements use data corresponding to an integrated luminosity of 34 pb^-1. The b-jets are identified using either a lifetime-based method, where secondary decay vertices of b-hadrons in jets are reconstructed using information from the tracking detectors, or a muon-based method where the presence of a muon is used to identify semileptonic decays of b-hadrons inside jets. The inclusive b-jet cross-section is measured as a function of transverse momentum in the range 20 < pT < 400 GeV and rapidity in the range |y| < 2.1. The bbbar-dijet cross-section is measured as a function of the dijet invariant mass in the range 110 < m_jj < 760 GeV, the azimuthal angle difference between the two jets and the angular variable chi in two dijet mass regions. The results are compared with next-to-leading-order QCD predictions. Good agreement is observed between the measured cross-sections and the predictions obtained using POWHEG + Pythia. MC@NLO + Herwig shows good agreement with the measured bbbar-dijet cross-section. However, it does not reproduce the measured inclusive cross-section well, particularly for central b-jets with large transverse momenta.Comment: 10 pages plus author list (21 pages total), 8 figures, 1 table, final version published in European Physical Journal

    Standalone vertex nding in the ATLAS muon spectrometer

    Get PDF
    A dedicated reconstruction algorithm to find decay vertices in the ATLAS muon spectrometer is presented. The algorithm searches the region just upstream of or inside the muon spectrometer volume for multi-particle vertices that originate from the decay of particles with long decay paths. The performance of the algorithm is evaluated using both a sample of simulated Higgs boson events, in which the Higgs boson decays to long-lived neutral particles that in turn decay to bbar b final states, and pp collision data at √s = 7 TeV collected with the ATLAS detector at the LHC during 2011

    Measurements of Higgs boson production and couplings in diboson final states with the ATLAS detector at the LHC

    Get PDF
    Measurements are presented of production properties and couplings of the recently discovered Higgs boson using the decays into boson pairs, H →γ γ, H → Z Z∗ →4l and H →W W∗ →lνlν. The results are based on the complete pp collision data sample recorded by the ATLAS experiment at the CERN Large Hadron Collider at centre-of-mass energies of √s = 7 TeV and √s = 8 TeV, corresponding to an integrated luminosity of about 25 fb−1. Evidence for Higgs boson production through vector-boson fusion is reported. Results of combined fits probing Higgs boson couplings to fermions and bosons, as well as anomalous contributions to loop-induced production and decay modes, are presented. All measurements are consistent with expectations for the Standard Model Higgs boson
    • …
    corecore