Central Higgs Production at LHC from Single-Pomeron-Exchange

Contrary to common perceptions about systems produced in Single-Pomeron-Exchange (SPE) pp interactions, the hard diffractive process discovered at the CERN SPS-Collider leads to dominant central production of Higgs bosons at the LHC. The rate for SPE production of Higgs bosons is calculated to be 7-9 % of the total inclusive Higgs rate. In addition, an SPE measurement program of dijet events is outlined for the early days of LHC running which should answer many fundamental questions about the Pomeron structure and its effective flux factor in the proton.Comment: 14 pages, 7 Encapsulated Postscript figures, LaTex, submitted to European Phisical Journal

Evidence for xi- and t-dependent damping of the Pomeron Flux in the proton

We show that a triple-Regge parametrization of inclusive single diffraction agrees with the data in the following two domains: (a) xi > 0.03 at all t, (b) |t| > 1 GeV^2 at all xi. Since the triple-Regge parametrization fails when applied to the full xi-t range of the total single-diffractive cross section, we conclude that damping occurs only at low-xi and low-|t|. We give a (``toy'') parametrization of the damping factor, D(xi), valid at low-|t|, which describes the diffractive differential cross-section (dsig/dt) data at the ISR and roughly accounts for the observed s-dependence of diffractive total cross-section up to Tevatron energies. However, an effective damping factor calculated for the CDF fitted function for dsig/dxidt at sqrt(s} = 1800 GeV and |t| = 0.05 GeV^2, suggests that, at fixed-xi, damping increases as s increases. We conjecture that, in the regions where the triple-Regge formalism describes the data and there is no evidence of damping, factorization is valid and the Pomeron-flux-factor may be universal. With the assumption that the observed damping is due to multi-Pomeron exchange, our results imply that the recent UA8 demonstration that the effective Pomeron trajectory flattens for |t| > 1 GeV$^2 is evidence for the onset of the perturbative 2-gluon pomeron. Our damping results may also shed some light on the self-consistency of recent measurements of hard-diffractive jet production cross sections in the UA8, CDF and ZEUS experiments.Comment: 19 pages, 7 Encapsulated Postscript figures, LaTex, Phys. Lett. B (in press - 1998

R & D for collider beauty physics at the LHC

We propose an R&D program for the development of a Beauty trigger and innovative elements of the associated spectrometer. A series of short test runs is proposed at the SPS p-pbar Collider with the minimal spectrometer which will allow a credible B signal to be obtained in an invariant mass spectrum of reconstructed B mesons. The program builds on the success of the recent collider run of the P238 Collaboration, in which clean signals from beam-beam interactions were observed in a large silicon strip microvertex detector running 1.5 mm from the circulating beams. A continuing successful R&D program of the type proposed could ultimately lead to a collider experiment at the LHC to study CP Violation and rare B decays

Alignment of the CMS tracker with LHC and cosmic ray data

© CERN 2014 for the benefit of the CMS collaboration, published under the terms of the Creative Commons Attribution 3.0 License by IOP Publishing Ltd and Sissa Medialab srl. Any further distribution of this work must maintain attribution to the author(s) and the published article's title, journal citation and DOI.The central component of the CMS detector is the largest silicon tracker ever built. The precise alignment of this complex device is a formidable challenge, and only achievable with a significant extension of the technologies routinely used for tracking detectors in the past. This article describes the full-scale alignment procedure as it is used during LHC operations. Among the specific features of the method are the simultaneous determination of up to 200 000 alignment parameters with tracks, the measurement of individual sensor curvature parameters, the control of systematic misalignment effects, and the implementation of the whole procedure in a multi-processor environment for high execution speed. Overall, the achieved statistical accuracy on the module alignment is found to be significantly better than 10μm

The QCD transition temperature: results with physical masses in the continuum limit II.

We extend our previous study [Phys. Lett. B643 (2006) 46] of the cross-over temperatures (T_c) of QCD. We improve our zero temperature analysis by using physical quark masses and finer lattices. In addition to the kaon decay constant used for scale setting we determine four quantities (masses of the \Omega baryon, K^*(892) and \phi(1020) mesons and the pion decay constant) which are found to agree with experiment. This implies that --independently of which of these quantities is used to set the overall scale-- the same results are obtained within a few percent. At finite temperature we use finer lattices down to a <= 0.1 fm (N_t=12 and N_t=16 at one point). Our new results confirm completely our previous findings. We compare the results with those of the 'hotQCD' collaboration.Comment: 19 pages, 8 figures, 3 table

Penilaian Kinerja Keuangan Koperasi di Kabupaten Pelalawan

This paper describe development and financial performance of cooperative in District Pelalawan among 2007 - 2008. Studies on primary and secondary cooperative in 12 sub-districts. Method in this stady use performance measuring of productivity, efficiency, growth, liquidity, and solvability of cooperative. Productivity of cooperative in Pelalawan was highly but efficiency still low. Profit and income were highly, even liquidity of cooperative very high, and solvability was good

Juxtaposing BTE and ATE – on the role of the European insurance industry in funding civil litigation

One of the ways in which legal services are financed, and indeed shaped, is through private insurance arrangement. Two contrasting types of legal expenses insurance contracts (LEI) seem to dominate in Europe: before the event (BTE) and after the event (ATE) legal expenses insurance. Notwithstanding institutional differences between different legal systems, BTE and ATE insurance arrangements may be instrumental if government policy is geared towards strengthening a market-oriented system of financing access to justice for individuals and business. At the same time, emphasizing the role of a private industry as a keeper of the gates to justice raises issues of accountability and transparency, not readily reconcilable with demands of competition. Moreover, multiple actors (clients, lawyers, courts, insurers) are involved, causing behavioural dynamics which are not easily predicted or influenced. Against this background, this paper looks into BTE and ATE arrangements by analysing the particularities of BTE and ATE arrangements currently available in some European jurisdictions and by painting a picture of their respective markets and legal contexts. This allows for some reflection on the performance of BTE and ATE providers as both financiers and keepers. Two issues emerge from the analysis that are worthy of some further reflection. Firstly, there is the problematic long-term sustainability of some ATE products. Secondly, the challenges faced by policymakers that would like to nudge consumers into voluntarily taking out BTE LEI