115 research outputs found

    Dynamic Nuclear Polarization of Silicon Carbide Micro- and Nanoparticles

    Get PDF
    [Image: see text] Two dominant crystalline phases of silicon carbide (SiC): α-SiC and β-SiC, differing in size and chemical composition, were investigated regarding their potential for dynamic nuclear polarization (DNP). (29)Si nuclei in α-SiC micro- and nanoparticles with sizes ranging from 650 nm to 2.2 μm and minimal oxidation were successfully hyperpolarized without the use of free radicals, while β-SiC samples did not display appreciable degrees of polarization under the same polarization conditions. Long T(1) relaxation times in α-SiC of up to 1600 s (∼27 min) were recorded for the (29)Si nuclei after 1 h of polarization at a temperature of 4 K. Interestingly, these promising α-SiC particles allowed for direct hyperpolarization of both (29)Si and (13)C nuclei, resulting in comparably strong signal amplifications. Moreover, the T(1) relaxation time of (13)C nuclei in 750 nm-sized α-SiC particles was over 33 min, which far exceeds T(1) times of conventional (13)C DNP probes with values in the order of 1–2 min. The present work demonstrates the feasibility of DNP on SiC micro- and nanoparticles and highlights their potential as hyperpolarized magnetic resonance imaging agents

    Anatomic reconstruction or temporary screw stabilization of chronic symptomatic anterolateral proximal tibiofibular joint instability

    Get PDF
    The paper describes the new concept Tensairity which can be used to significantly improve the load bearing capacity of inflatable wings. The basic principle of Tensairity is to use an inflatable structure to stabilize conventional compression and tension elements. So far, Tensairity has been mainly used in civil engineering application like roof structures and bridges. In this work, considerations to apply Tensairity to wing structures are given and the construction of two wing-like Tensairity kite prototypes is described. Test results on the Tensairity structure used in these kites are presented and compared to purely air inflated structures. Finally, the advantages of Tensairity wings are discussed and some application areas of these wings are suggested.Aerospace Design, Integration and OperationsAerospace Engineerin

    Crosswind Kite Control - A Benchmark Problem for Advanced Control and Dynamic Optimization

    Get PDF
    This article presents a kite control and optimization problem intended as a benchmark problem for advanced control and optimization. We provide an entry point to this exciting renewable energy system for researchers in control and optimization methods looking for a realistic test bench, and/or a useful application case for their theory. The benchmark problem in this paper can be studied in simulation, and a complete Simulink model is provided to facilitate this. The simulated scenario, which reproduces many of the challenges presented by a real system, is based on experimental studies from the literature, industrial data and the first author’s own experience in experimental kite control. In par- ticular, an experimentally validated wind turbulence model is included, which subjects the kite to realistic disturbances. The benchmark problem is that of controlling a kite such that the average line tension is maximized. Two different models are provided: A more comprehensive one is used to simulate the ’plant’, while a simpler ’model’ is used to design and implement control and optimization strategies. This way, uncertainty is present in the form of plant-model mismatch. The outputs of the plant are corrupted by measurement noise. The maximum achievable average line tension for the plant is calculated, which should facilitate the performance comparison of different algorithms. A simple control strategy is implemented on the plant and found to be quite suboptimal, even if the free parameters of the algorithm are well tuned. An open question is whether or not more advanced control algorithms could do better

    Introduction of Heated Cow's Milk Protein in Challenge-Proven Cow's Milk Allergic Children:The iAGE Study

    Get PDF
    The introduction of baked milk products in cow's milk (CM) allergic children has previously been shown to accelerate induction tolerance in a selected group of children. However, there is no standardized baked milk product on the market. Recently, a new standardized, heated and glycated cow's milk protein (HP) product was developed. The aim of this study was to measure safety and tolerability of a new, well characterized heated CM protein (HP) product in cow's milk allergic (CMA) children between the age of 3 and 36 months. The children were recruited from seven clinics throughout The Netherlands. The HP product was introduced in six incremental doses under clinical supervision. Symptoms were registered after introduction of the HP product. Several questionnaires were filled out by parents of the children. Skin prick tests were performed with CM and HP product, sIgE to CM and α-lactalbumin (Bos d4), β-lactoglobulin (Bos d5), serum albumin (Bos d 6), lactoferrin (Bos d7) and casein (Bos d8). Whereas 72% percent (18 out of 25) of the children tolerated the HP product, seven children experienced adverse events. Risk factors for intolerance to the HP product were higher skin prick test (SPT) histamine equivalent index (HEP) results with CM and the HP product, higher specific IgE levels against Bos d4 and Bos d8 levels and Bos d5 levels. In conclusion, the HP product was tolerated by 72% of the CM allergic children. Outcomes of SPT with CM and the HP product, as well as values of sIgE against caseins, α-lactalbumin, and β-lactoglobulin may predict the tolerability of the HP product. Larger studies are needed to confirm these conclusions.</p

    High Affinity Antibodies to Plasmodium falciparum Merozoite Antigens Are Associated with Protection from Malaria

    Get PDF
    Malaria kills almost 1 million people every year, but the mechanisms behind protective immunity against the disease are still largely unknown. In this study, surface plasmon resonance technology was used to evaluate the affinity (measured as k(d)) of naturally acquired antibodies to the Plasmodium falciparum antigens MSP2 and AMA1. Antibodies in serum samples from residents in endemic areas bound with higher affinities to AMA1 than to MSP2, and with higher affinities to the 3D7 allele of MSP2-3D7 than to the FC27 allele. The affinities against AMA1 and MSP2-3D7 increased with age, and were usually within similar range as the affinities for the monoclonal antibodies also examined in this study. The finding of MSP2-3D7 type parasites in the blood was associated with a tendency for higher affinity antibodies to both forms of MSP2 and AMA1, but this was significant only when analyzing antibodies against MSP2-FC27, and individuals infected with both allelic forms of MSP2 at the same time showed the highest affinities. Individuals with the highest antibody affinities for MSP2-3D7 at baseline had a prolonged time to clinical malaria during 40 weeks of follow-up, and among individuals who were parasite positive at baseline higher antibody affinities to all antigens were seen in the individuals that did not experience febrile malaria during follow up. This study contributes important information for understanding how immunity against malaria arises. The findings suggest that antibody affinity plays an important role in protection against disease, and differs between antigens. In light of this information, antibody affinity measurements would be a key assessment in future evaluation of malaria vaccine formulations

    Applications of isothermal titration calorimetry - the research and technical developments from 2011 to 2015

    Get PDF
    Isothermal titration calorimetry is a widely used biophysical technique for studying the formation or dissociation of molecular complexes. Over the last 5years, much work has been published on the interpretation of isothermal titration calorimetry (ITC) data for single binding and multiple binding sites. As over 80% of ITC papers are on macromolecules of biological origin, this interpretation is challenging. Some researchers have attempted to link the thermodynamics constants to events at the molecular level. This review highlights work carried out using binding sites characterized using x-ray crystallography techniques that allow speculation about individual bond formation and the displacement of individual water molecules during ligand binding and link these events to the thermodynamic constants for binding. The review also considers research conducted with synthetic binding partners where specific binding events like anion-π and π-π interactions were studied. The revival of assays that enable both thermodynamic and kinetic information to be collected from ITC data is highlighted. Lastly, published criticism of ITC research from a physical chemistry perspective is appraised and practical advice provided for researchers unfamiliar with thermodynamics and its interpretation

    Identification of regulatory variants associated with genetic susceptibility to meningococcal disease.

    Get PDF
    Non-coding genetic variants play an important role in driving susceptibility to complex diseases but their characterization remains challenging. Here, we employed a novel approach to interrogate the genetic risk of such polymorphisms in a more systematic way by targeting specific regulatory regions relevant for the phenotype studied. We applied this method to meningococcal disease susceptibility, using the DNA binding pattern of RELA - a NF-kB subunit, master regulator of the response to infection - under bacterial stimuli in nasopharyngeal epithelial cells. We designed a custom panel to cover these RELA binding sites and used it for targeted sequencing in cases and controls. Variant calling and association analysis were performed followed by validation of candidate polymorphisms by genotyping in three independent cohorts. We identified two new polymorphisms, rs4823231 and rs11913168, showing signs of association with meningococcal disease susceptibility. In addition, using our genomic data as well as publicly available resources, we found evidences for these SNPs to have potential regulatory effects on ATXN10 and LIF genes respectively. The variants and related candidate genes are relevant for infectious diseases and may have important contribution for meningococcal disease pathology. Finally, we described a novel genetic association approach that could be applied to other phenotypes

    Plasma lipid profiles discriminate bacterial from viral infection in febrile children

    Get PDF
    Fever is the most common reason that children present to Emergency Departments. Clinical signs and symptoms suggestive of bacterial infection are often non-specific, and there is no definitive test for the accurate diagnosis of infection. The 'omics' approaches to identifying biomarkers from the host-response to bacterial infection are promising. In this study, lipidomic analysis was carried out with plasma samples obtained from febrile children with confirmed bacterial infection (n = 20) and confirmed viral infection (n = 20). We show for the first time that bacterial and viral infection produces distinct profile in the host lipidome. Some species of glycerophosphoinositol, sphingomyelin, lysophosphatidylcholine and cholesterol sulfate were higher in the confirmed virus infected group, while some species of fatty acids, glycerophosphocholine, glycerophosphoserine, lactosylceramide and bilirubin were lower in the confirmed virus infected group when compared with confirmed bacterial infected group. A combination of three lipids achieved an area under the receiver operating characteristic (ROC) curve of 0.911 (95% CI 0.81 to 0.98). This pilot study demonstrates the potential of metabolic biomarkers to assist clinicians in distinguishing bacterial from viral infection in febrile children, to facilitate effective clinical management and to the limit inappropriate use of antibiotics
    corecore