783 research outputs found
Phenomenological modelling of damage in polymer blends
To describe the constitutive behaviour of a certain class of polymer blends an elastoperfectly-viscoplastic and creep damageable material characterization is proposed. For a composite of 80 % Polystyrene and 20 % Ethylene Propylene Diene Monomer rubber (PSIEPDM) the specific parameters are determined from tensile tests in a particular range of strain velocities. To investigate the applicability of the model, the results of a finite element analysis for a laterally loaded thin plate (plane stress) with a circular hole are compared to measurements. Numerically calculated values are in reasonable agreement with reality; discrepancies can be ascribed to noise in experimental data. The finite element approach is evaluated with respect to the occurrence of mesh-dependence. Mesh-refinement shows convergence of solutions, attributable to the stabilizing influence of the viscous contribution in the constitutive equations
Practical considerations of the use of cross-weld and compact tension specimens creep data
This article gives an overview of the use of cross-weld and compact tension specimen modelling and analyses data to characterise creep behaviour of the high-temperature components. Cross-weld and compact tension specimens are used to describe creep crack growth in heterogeneous material structures, such as welds, and a number of factors that affect the creep behaviour of the structure, associated with this heterogeneity, have been identified. Creep data obtained from cross-weld specimen modelling are substantially affected by the material model used (e.g. Norton power law, Liu-Murakami), stress singularities that arise at the material interfaces and in between the columnar and equiaxed zones of the weld material, residual stresses which arise through the thickness of a multi-pass weld and the extraction orientation of the specimen relative to the welding direction. Creep crack growth data obtained from compact tension specimen testing and analyses are strongly dependent on the material models used (isotropic hardening models, Norton creep law, Liu/Murakami model, etc.), the path dependence of the C*-contour integral fracture parameter for certain heterogeneous material configurations and the accurate computation of material constants for damage mechanics models and the agreement between loading state to the actual stress state of the component to which the compact tension specimen creep data are applied to. This study examines typical results and observations from cross-weld specimen and compact tension specimen creep analyses, identifying the advantages, disadvantages and limitations of each specimen procedure
A Damage Mechanics Approach to Life Prediction for a Salt Structure
Excavated rooms in natural bedded salt formations are being considered for use as repositories for nuclear waste. It is presumed that deformation of the rooms by creep will lead to loss of structural integrity and affect room life history and seal efficiency. At projected repository temperatures, two possible fracture mechanisms in salt are creep-induced microcracking in triaxial compression and cleavage in tension. Thus, an accurate prediction of room life and seal degradation requires a reliable description of the creep and damage processes. While several constitutive models that treat either creep or fracture in salt are available in the literature, very few models have considered creep and damage in a coupled manner. Previously, Munson and Dawson formulated a set of creep equations for salt based on the consideration of dislocation mechanisms in the creep process. This set of creep equations has been generalized to include continuum, isotropic damage as a fully coupled variable in the response equation. The extended model has been referred to as the Multimechanism Deformation Coupled Fracture (MDCF) model. A set of material constants for the creep and damage terms was deduced based on test data for both clean and argillaceous salt. In this paper, the use of the MDCF model for establishing the failure criteria and for analyzing the creep response of a salt structure is demonstrated. The paper is divided into three parts. A summary of the MDCF model is presented first, which is followed by an evaluation of the MDCF model against laboratory data. Finally, finite-element calculations of the creep and damage response of a salt structure are presented and compared against in-situ field measurements
Performance of CMS muon reconstruction in pp collision events at sqrt(s) = 7 TeV
The performance of muon reconstruction, identification, and triggering in CMS
has been studied using 40 inverse picobarns of data collected in pp collisions
at sqrt(s) = 7 TeV at the LHC in 2010. A few benchmark sets of selection
criteria covering a wide range of physics analysis needs have been examined.
For all considered selections, the efficiency to reconstruct and identify a
muon with a transverse momentum pT larger than a few GeV is above 95% over the
whole region of pseudorapidity covered by the CMS muon system, abs(eta) < 2.4,
while the probability to misidentify a hadron as a muon is well below 1%. The
efficiency to trigger on single muons with pT above a few GeV is higher than
90% over the full eta range, and typically substantially better. The overall
momentum scale is measured to a precision of 0.2% with muons from Z decays. The
transverse momentum resolution varies from 1% to 6% depending on pseudorapidity
for muons with pT below 100 GeV and, using cosmic rays, it is shown to be
better than 10% in the central region up to pT = 1 TeV. Observed distributions
of all quantities are well reproduced by the Monte Carlo simulation.Comment: Replaced with published version. Added journal reference and DO
Performance of CMS muon reconstruction in pp collision events at sqrt(s) = 7 TeV
The performance of muon reconstruction, identification, and triggering in CMS
has been studied using 40 inverse picobarns of data collected in pp collisions
at sqrt(s) = 7 TeV at the LHC in 2010. A few benchmark sets of selection
criteria covering a wide range of physics analysis needs have been examined.
For all considered selections, the efficiency to reconstruct and identify a
muon with a transverse momentum pT larger than a few GeV is above 95% over the
whole region of pseudorapidity covered by the CMS muon system, abs(eta) < 2.4,
while the probability to misidentify a hadron as a muon is well below 1%. The
efficiency to trigger on single muons with pT above a few GeV is higher than
90% over the full eta range, and typically substantially better. The overall
momentum scale is measured to a precision of 0.2% with muons from Z decays. The
transverse momentum resolution varies from 1% to 6% depending on pseudorapidity
for muons with pT below 100 GeV and, using cosmic rays, it is shown to be
better than 10% in the central region up to pT = 1 TeV. Observed distributions
of all quantities are well reproduced by the Monte Carlo simulation.Comment: Replaced with published version. Added journal reference and DO
X-ray emission from the Sombrero galaxy: discrete sources
We present a study of discrete X-ray sources in and around the
bulge-dominated, massive Sa galaxy, Sombrero (M104), based on new and archival
Chandra observations with a total exposure of ~200 ks. With a detection limit
of L_X = 1E37 erg/s and a field of view covering a galactocentric radius of ~30
kpc (11.5 arcminute), 383 sources are detected. Cross-correlation with Spitler
et al.'s catalogue of Sombrero globular clusters (GCs) identified from HST/ACS
observations reveals 41 X-rays sources in GCs, presumably low-mass X-ray
binaries (LMXBs). We quantify the differential luminosity functions (LFs) for
both the detected GC and field LMXBs, whose power-low indices (~1.1 for the
GC-LF and ~1.6 for field-LF) are consistent with previous studies for
elliptical galaxies. With precise sky positions of the GCs without a detected
X-ray source, we further quantify, through a fluctuation analysis, the GC LF at
fainter luminosities down to 1E35 erg/s. The derived index rules out a
faint-end slope flatter than 1.1 at a 2 sigma significance, contrary to recent
findings in several elliptical galaxies and the bulge of M31. On the other
hand, the 2-6 keV unresolved emission places a tight constraint on the field
LF, implying a flattened index of ~1.0 below 1E37 erg/s. We also detect 101
sources in the halo of Sombrero. The presence of these sources cannot be
interpreted as galactic LMXBs whose spatial distribution empirically follows
the starlight. Their number is also higher than the expected number of cosmic
AGNs (52+/-11 [1 sigma]) whose surface density is constrained by deep X-ray
surveys. We suggest that either the cosmic X-ray background is unusually high
in the direction of Sombrero, or a distinct population of X-ray sources is
present in the halo of Sombrero.Comment: 11 figures, 5 tables, ApJ in pres
Azimuthal anisotropy of charged particles at high transverse momenta in PbPb collisions at sqrt(s[NN]) = 2.76 TeV
The azimuthal anisotropy of charged particles in PbPb collisions at
nucleon-nucleon center-of-mass energy of 2.76 TeV is measured with the CMS
detector at the LHC over an extended transverse momentum (pt) range up to
approximately 60 GeV. The data cover both the low-pt region associated with
hydrodynamic flow phenomena and the high-pt region where the anisotropies may
reflect the path-length dependence of parton energy loss in the created medium.
The anisotropy parameter (v2) of the particles is extracted by correlating
charged tracks with respect to the event-plane reconstructed by using the
energy deposited in forward-angle calorimeters. For the six bins of collision
centrality studied, spanning the range of 0-60% most-central events, the
observed v2 values are found to first increase with pt, reaching a maximum
around pt = 3 GeV, and then to gradually decrease to almost zero, with the
decline persisting up to at least pt = 40 GeV over the full centrality range
measured.Comment: Replaced with published version. Added journal reference and DO
Search for new physics with same-sign isolated dilepton events with jets and missing transverse energy
A search for new physics is performed in events with two same-sign isolated
leptons, hadronic jets, and missing transverse energy in the final state. The
analysis is based on a data sample corresponding to an integrated luminosity of
4.98 inverse femtobarns produced in pp collisions at a center-of-mass energy of
7 TeV collected by the CMS experiment at the LHC. This constitutes a factor of
140 increase in integrated luminosity over previously published results. The
observed yields agree with the standard model predictions and thus no evidence
for new physics is found. The observations are used to set upper limits on
possible new physics contributions and to constrain supersymmetric models. To
facilitate the interpretation of the data in a broader range of new physics
scenarios, information on the event selection, detector response, and
efficiencies is provided.Comment: Published in Physical Review Letter
- …