Contact Force and Scanning Velocity during Active Roughness Perception

Haptic perception is bidirectionally related to exploratory movements, which means that exploration influences perception, but perception also influences exploration. We can optimize or change exploratory movements according to the perception and/or the task, consciously or unconsciously. This paper presents a psychophysical experiment on active roughness perception to investigate movement changes as the haptic task changes. Exerted normal force and scanning velocity are measured in different perceptual tasks (discrimination or identification) using rough and smooth stimuli. The results show that humans use a greater variation in contact force for the smooth stimuli than for the rough stimuli. Moreover, they use higher scanning velocities and shorter break times between stimuli in the discrimination task than in the identification task. Thus, in roughness perception humans spontaneously use different strategies that seem effective for the perceptual task and the stimuli. A control task, in which the participants just explore the stimuli without any perceptual objective, shows that humans use a smaller contact force and a lower scanning velocity for the rough stimuli than for the smooth stimuli. Possibly, these strategies are related to aversiveness while exploring stimuli

First-principles extrapolation method for accurate CO adsorption energies on metal surfaces

We show that a simple first-principles correction based on the difference between the singlet-triplet CO excitation energy values obtained by DFT and high-level quantum chemistry methods yields accurate CO adsorption properties on a variety of metal surfaces. We demonstrate a linear relationship between the CO adsorption energy and the CO singlet-triplet splitting, similar to the linear dependence of CO adsorption energy on the energy of the CO 2$\pi$* orbital found recently {[Kresse {\em et al.}, Physical Review B {\bf 68}, 073401 (2003)]}. Converged DFT calculations underestimate the CO singlet-triplet excitation energy $\Delta E_{\rm S-T}$, whereas coupled-cluster and CI calculations reproduce the experimental $\Delta E_{\rm S-T}$. The dependence of $E_{\rm chem}$ on $\Delta E_{\rm S-T}$ is used to extrapolate $E_{\rm chem}$ for the top, bridge and hollow sites for the (100) and (111) surfaces of Pt, Rh, Pd and Cu to the values that correspond to the coupled-cluster and CI $\Delta E_{\rm S-T}$ value. The correction reproduces experimental adsorption site preference for all cases and obtains $E_{\rm chem}$ in excellent agreement with experimental results.Comment: Table sent as table1.eps. 3 figure

Measurement and structural invariance of the US version of the Birth Satisfaction Scale-Revised (BSS-R) in a large sample

Background: The 10-item Birth Satisfaction Scale-Revised (BSS-R) is being increasingly used internationally. The use of the measure and the concept has gathered traction in the United States following the development of a US version of the tool. A limitation of previous studies of the measurement characteristics of the BSS-R is modest sample size. Unplanned pregnancy is recognised as being associated with a range of negative birth outcomes, but the relationship to birth satisfaction has received little attention, despite the importance of birth satisfaction to a range of postnatal outcomes. Aim: The current investigation sought to evaluate the measurement characteristics of the BSS-R in a large postpartum sample. Methods: Multiple Groups Confirmatory Factor Analysis (MGCFA) was used to evaluate a series of measurement and structural models of the BSS-R to evaluate fundamental invariance characteristics using planned/unplanned pregnancy status to differentiate groups.Findings: Complete data from N=2116 women revealed that the US version of the BSS-R offers an excellent fit to data and demonstrates full measurement and structural invariance. Little difference was observed between women on the basis of planned/unplanned pregnancy stratification on measures of birth satisfaction. Discussion: The established relationship between unplanned pregnancy and negative perinatal outcomes was not found to extend to birth satisfaction in the current study. The BSS-R demonstrated exemplary measurement and structural invariance characteristics. Conclusion: The current study strongly supports the use of the US version of the BSS-R to compare birth satisfaction across different groups of women with theoretical and measurement confidence

The Birth Satisfaction Scale – Revised (BSS-R): should the subscale scores or the total score be used?

Objective and background: The 10-item Birth Satisfaction Scale-Revised (BSS-R) is increasingly being used internationally as the instrument of choice for the assessment of birth satisfaction. There remains conjecture over the most appropriate way to score the instrument, the choices being, sub-scale score totals, the overall total score, or adopting both approaches. The current study sought to clarify this issue by examining the measurement characteristics of the United States version of the BSS-R from a large dataset. Methods: A secondary analysis of a data matrix derived from a large sample United States BSS-R validation study (N=2116) using structural equation modelling and bi-factor model evaluation.Results: The bi-factor model revealed an excellent fit to data (?2(df=25) = 208.21,

The Spatial Origin of a Perceptual Transition in Binocular Rivalry

When the left and the right eye are simultaneously presented with incompatible images at overlapping retinal locations, an observer typically reports perceiving only one of the two images at a time. This phenomenon is called binocular rivalry. Perception during binocular rivalry is not stable; one of the images is perceptually dominant for a certain duration (typically in the order of a few seconds) after which perception switches towards the other image. This alternation between perceptual dominance and suppression will continue for as long the images are presented. A characteristic of binocular rivalry is that a perceptual transition from one image to the other generally occurs in a gradual manner: the image that was temporarily suppressed will regain perceptual dominance at isolated locations within the perceived image, after which its visibility spreads throughout the whole image. These gradual transitions from perceptual suppression to perceptual dominance have been labeled as traveling waves of perceptual dominance. In this study we investigate whether stimulus parameters affect the location at which a traveling wave starts. We varied the contrast, spatial frequency or motion speed in one of the rivaling images, while keeping the same parameter constant in the other image. We used a flash-suppression paradigm to force one of the rival images into perceptual suppression. Observers waited until the suppressed image became perceptually dominant again, and indicated the position at which this breakthrough from suppression occurred. Our results show that the starting point of a traveling wave during binocular rivalry is highly dependent on local stimulus parameters. More specifically, a traveling wave most likely started at the location where the contrast of the suppressed image was higher than that of the dominant one, the spatial frequency of the suppressed image was lower than that of the dominant one, and the motion speed of the suppressed image was higher than that of the dominant one. We suggest that a breakthrough from suppression to dominance occurs at the location where salience (the degree to which a stimulus element stands out relative to neighboring elements) of the suppressed image is higher than that of the dominant one. Our results further show that stimulus parameters affecting the temporal dynamics during continuous viewing of rival images described in other studies, also affect the spatial origin of traveling waves during binocular rivalry

3D imaging of colorectal cancer organoids identifies responses to Tankyrase inhibitors

Aberrant activation of the Wnt signalling pathway is required for tumour initiation and survival in the majority of colorectal cancers. The development of inhibitors of Wnt signalling has been the focus of multiple drug discovery programs targeting colorectal cancer and other malignancies associated with aberrant pathway activation. However, progression of new clinical entities targeting the Wnt pathway has been slow. One challenge lies with the limited predictive power of 2D cancer cell lines because they fail to fully recapitulate intratumoural phenotypic heterogeneity. In particular, the relationship between 2D cancer cell biology and cancer stem cell function is poorly understood. By contrast, 3D tumour organoids provide a platform in which complex cell-cell interactions can be studied. However, complex 3D models provide a challenging platform for the quantitative analysis of drug responses of therapies that have differential effects on tumour cell subpopulations. Here, we generated tumour organoids from colorectal cancer patients and tested their responses to inhibitors of Tankyrase (TNKSi) which are known to modulate Wnt signalling. Using compounds with 3 orders of magnitude difference in cellular mechanistic potency together with image-based assays, we demonstrate that morphometric analyses can capture subtle alterations in organoid responses to Wnt inhibitors that are consistent with activity against a cancer stem cell subpopulation. Overall our study highlights the value of phenotypic readouts as a quantitative method to asses drug-induced effects in a relevant preclinical model

Standalone vertex finding in the ATLAS muon spectrometer

A dedicated reconstruction algorithm to find decay vertices in the ATLAS muon spectrometer is presented. The algorithm searches the region just upstream of or inside the muon spectrometer volume for multi-particle vertices that originate from the decay of particles with long decay paths. The performance of the algorithm is evaluated using both a sample of simulated Higgs boson events, in which the Higgs boson decays to long-lived neutral particles that in turn decay to bbar b final states, and pp collision data at √s = 7 TeV collected with the ATLAS detector at the LHC during 2011

Measurements of Higgs boson production and couplings in diboson final states with the ATLAS detector at the LHC

Measurements are presented of production properties and couplings of the recently discovered Higgs boson using the decays into boson pairs, H →γ γ, H → Z Z∗ →4l and H →W W∗ →lνlν. The results are based on the complete pp collision data sample recorded by the ATLAS experiment at the CERN Large Hadron Collider at centre-of-mass energies of √s = 7 TeV and √s = 8 TeV, corresponding to an integrated luminosity of about 25 fb−1. Evidence for Higgs boson production through vector-boson fusion is reported. Results of combined fits probing Higgs boson couplings to fermions and bosons, as well as anomalous contributions to loop-induced production and decay modes, are presented. All measurements are consistent with expectations for the Standard Model Higgs boson