Performance comparison between signal digitizers and low-cost digital oscilloscopes: spectroscopic, pulse shape discrimination and timing capabilities for nuclear detectors

Signal digitizers revolutionized the approach to the electronics readout of radiation detectors in Nuclear Physics. These highly specialized pieces of equipment are designed to acquire the signals that are characteristic of the detectors in nuclear physics experiments. The functions of the several modules that were once needed for signal acquisition, can now be substituted by a single digitizer. As suggested by the name, with such readout modules, signals are first digitized (i.e. the signal waveform is sampled and converted to a digital representation) and then either stored or analyzed on-the-fly. The performances can be comparable or better than the traditional analog counterparts, in terms of energy, time resolution, and acquisition rate. In this work, we investigate the use of general-purpose digital oscilloscopes as signal digitizers for nuclear detectors. In order to have a proper comparison, we employ a distributed data acquisition system (DAQ), that standardizes the interface between the hardware and the on-line data analysis. The signals, from a set of typical radiation detectors, are digitized and analyzed with the very same algorithms in order to avoid biases due to different software analysis. We compare two traditional signal digitizers (CAEN DT5725 and CAEN DT5751) to two low-cost digital oscilloscopes (Digilent Analog Discovery 2, and Red Pitaya STEMLab 125-14), in terms of their capabilities for spectroscopy (energy resolution), time resolution, pulse shape discrimination, and maximum acquisition rate.Comment: 17 pages, 8 figures, 4 tables, Prepared for submission to JINS

a distributed data acquisition system for nuclear detectors

Nowadays, many examples of data acquisition (DAQ) software for experimental nuclear physics are monolithic processes that run on a computer attached to the DAQ hardware. In this article we present a distributed DAQ system developed for the C-BORD project. With our system, we propose a novel approach, in which each task related to the different DAQ parts (acquisition, pre-process, analysis, etc.) runs in a separate process. In particular, the system is composed of a set of servers that exchange information through dedicated communication sockets. Therefore, with this architecture, an important advantage is the possibility to run the processes on different computers to distribute the computational load. The initial tests of the system have been giving excellent results, both in terms of performance (i.e., maximum acquisition rates) and stability. The project entitled "Effective container inspection at BORDer control points" (C-BORD) is funded by the European H2020 programme. Its aim is to develop a comprehensive set of technologies for the generalized non-intrusive inspection (NII) of containers and large-volume freight at the European Union border

Material recognition with a 252Cf source

Material recognition is studied by measuring simultaneously the transmission of neutron and gamma rays produced by a time-tagged 252Cf source. Light elements (C,N,O) are identified by using the measured transmission versus neutron time of flight. The yield of the transmitted gamma ray as a function of energy provides high precision identification of the atomic number of the sample up to Z=83 . A tomography system, currently under construction, is described

The effect of customer perceived value on customer satisfaction: a case study of Malay upscale restaurants

Stiff competition and increasingly high operating costs have driven many international and domestic players to introduce new outlet concepts. Malay fine dining, upscale restaurant segment is gaining popularity among Malaysian, especially in Kuala Lumpur. This study examined the effect of perceived value on customer satisfaction in Malay upscale restaurants in terms of emotional responses, monetary prices, behavioral price and reputation. Primary data were gathered from 170 questionnaires returned by respondents from five Malay upscale restaurants in Kuala Lumpur, and statistically analysed using SPSS version 21. The findings of this study revealed that monetary prices had a high positive relationship with customer satisfaction. In addition, the beta value for emotional responses (β=0.530, p<0.01), behavioral price (β=0.180, p<0.01) and reputation (β=0.168, p<0.01) also indicated the respective contributions made to customer satisfaction

NEW EXPERIMENTAL APPROACH FOR HEAVY AND SUPERHEAVY ELEMENT PRODUCTION

In this article we present a new experimental approach for production of heavy and superheavy elements (HE, SHE). Nuclear reactions at low incident energies induced by heavy ion (HI) projectiles on fissile target nuclei are investigated. Dedicated detection setup is presented and the preliminary results for the reaction 197Au(7.5 MeV /u) + 232Th, studied at the Cyclotron Institute of Texas A&M University, are given

A Proton Recoil Telescope for Neutron Spectroscopy

The N2P research program funded by the INFN committee for Experimental Nuclear Physics (CSNIII) has among his goals the construction of a Proton Recoil Telescope (PRT), a detector to measure neutron energy spectra. The interest in such a detector is primarily related to the SPES project for rare beams production at the Laboratori Nazionali di Legnaro. For the SPES project it is, in fact, of fundamental importance to have reliable information about energy spectra and yield for neutrons produced by d or p projectiles on thick light targets to model the ''conversion target'' in which the p or d are converted in neutrons. These neutrons, in a second stage, will induce the Uranium fission in the ''production target''. The fission products are subsequently extracted, selected and re-accelerated to produce the exotic beam. The neutron spectra and angular distribution are important parameters to define the final production of fission fragments. In addition, this detector can be used to measure neutron spectra in the field of cancer therapy (this topic is nowadays of particular interest to INFN, for the National Centre for Hadron therapy (CNAO) in Pavia) and space applications

Search for Heavy and Superheavy systems in 197Au + 232Th Collisions near the Coulomb Barrier

The reaction 197Au + 232Th at 7.5 AMeV was studied using the BigSol spectrometer at Texas A&M. Theoretical calculations suggest that this reaction could be used as an alternative method to produce heavy and superheavy elements. During the short interaction time, heavy systems of interacting nucleons are formed and, due to the strong energy dissipation, a large number nucleons can be transferred. The larger the lifetime of the decaying giant system, the larger the possible number of transferred nucleons. Moreover shell effects may help in the formation of heavy nuclei in the region of the island of stability. Reaction products emitted in an angular range from 6 to 16 degrees were collected at the entrance of the BigSol spectrometer and detected at the focal plane using a segmented ionization chamber. Four position sensitive PPAC detectors placed along the ion's flight path were used to track the product trajectories and measure the times of flight. The experimental results are presented and compared with theoretical calculations performed with the Constraint Molecular Dynamics code

Azimuthal anisotropy of charged jet production in root s(NN)=2.76 TeV Pb-Pb collisions

We present measurements of the azimuthal dependence of charged jet production in central and semi-central root s(NN) = 2.76 TeV Pb-Pb collisions with respect to the second harmonic event plane, quantified as nu(ch)(2) (jet). Jet finding is performed employing the anti-k(T) algorithm with a resolution parameter R = 0.2 using charged tracks from the ALICE tracking system. The contribution of the azimuthal anisotropy of the underlying event is taken into account event-by-event. The remaining (statistical) region-to-region fluctuations are removed on an ensemble basis by unfolding the jet spectra for different event plane orientations independently. Significant non-zero nu(ch)(2) (jet) is observed in semi-central collisions (30-50% centrality) for 20 <p(T)(ch) (jet) <90 GeV/c. The azimuthal dependence of the charged jet production is similar to the dependence observed for jets comprising both charged and neutral fragments, and compatible with measurements of the nu(2) of single charged particles at high p(T). Good agreement between the data and predictions from JEWEL, an event generator simulating parton shower evolution in the presence of a dense QCD medium, is found in semi-central collisions. (C) 2015 CERN for the benefit of the ALICE Collaboration. Published by Elsevier B.V. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/).Peer reviewe

Production of He-4 and (4) in Pb-Pb collisions at root(NN)-N-S=2.76 TeV at the LHC

Results on the production of He-4 and (4) nuclei in Pb-Pb collisions at root(NN)-N-S = 2.76 TeV in the rapidity range vertical bar y vertical bar <1, using the ALICE detector, are presented in this paper. The rapidity densities corresponding to 0-10% central events are found to be dN/dy4(He) = (0.8 +/- 0.4 (stat) +/- 0.3 (syst)) x 10(-6) and dN/dy4 = (1.1 +/- 0.4 (stat) +/- 0.2 (syst)) x 10(-6), respectively. This is in agreement with the statistical thermal model expectation assuming the same chemical freeze-out temperature (T-chem = 156 MeV) as for light hadrons. The measured ratio of (4)/He-4 is 1.4 +/- 0.8 (stat) +/- 0.5 (syst). (C) 2018 Published by Elsevier B.V.Peer reviewe