Uncovering Suitable Reference Proteins for Expression Studies in Human Adipose Tissue with Relevance to Obesity

Protein expression studies based on the two major intra-abdominal human fat depots, the subcutaneous and the omental fat, can shed light into the mechanisms involved in obesity and its co-morbidities. Here we address, for the first time, the identification and validation of reference proteins for data standardization, which are essential for accurate comparison of protein levels in expression studies based on fat from obese and non-obese individuals.To uncover adipose tissue proteins equally expressed either in omental and subcutaneous fat depots (study 1) or in omental fat from non-obese and obese individuals (study 2), we have reanalyzed our previously published data based on two-dimensional fluorescence difference gel electrophoresis. Twenty-four proteins (12 in study 1 and 12 in study 2) with similar expression levels in all conditions tested were selected and identified by mass spectrometry. Immunoblotting analysis was used to confirm in adipose tissue the expression pattern of the potential reference proteins and three proteins were validated: PARK7, ENOA and FAA. Western Blot analysis was also used to test customary loading control proteins. ENOA, PARK7 and the customary loading control protein Beta-actin showed steady expression profiles in fat from non-obese and obese individuals, whilst FAA maintained steady expression levels across paired omental and subcutaneous fat samples.ENOA, PARK7 and Beta-actin are proper reference standards in obesity studies based on omental fat, whilst FAA is the best loading control for the comparative analysis of omental and subcutaneous adipose tissues either in obese and non-obese subjects. Neither customary loading control proteins GAPDH and TBB5 nor CALX are adequate standards in differential expression studies on adipose tissue. The use of the proposed reference proteins will facilitate the adequate analysis of proteins differentially expressed in the context of obesity, an aim difficult to achieve before this study

Factors related to the development of health-promoting community activities in Spanish primary healthcare: two case-control studies.

Objective Spanish primary healthcare teams have the responsibility of performing health-promoting community activities (CAs), although such activities are not widespread. Our aim was to identify the factors related to participation in those activities. Design Two case–control studies. setting Performed in primary care of ve Spanish regions. subjects In the rst study, cases were teams that performed health-promoting CAs and controls were those that did not. In the second study (on case teams from the rst study), cases were professionals who developed these activities and controls were those who did not. Main outcome measures Team, professional and community characteristics collected through questionnaires (team managers/professionals) and from secondary sources. results The rst study examined 203 teams (103 cases, 100 controls). Adjusted factors associated with performing CAs were percentage of nurses (OR 1.07, 95% CI 1.01 to 1.14), community socioeconomic status (higher vs lower OR 2.16, 95% CI 1.18 to 3.95) and performing undergraduate training (OR 0.44, 95% CI 0.21 to 0.93). In the second study, 597 professionals responded (254 cases, 343 controls). Adjusted factors were professional classi cation (physicians do fewer activities than nurses and social workers do more), training in CAs (OR 1.9, 95% CI 1.2 to 3.1), team support (OR 2.9, 95% CI 1.5 to 5.7), seniority (OR 1.06, 95% CI 1.03 to 1.09), nursing tutor (OR 2.0, 95% CI 1.1 to 3.5), motivation (OR 3.7, 95% CI 1.8 to 7.5), collaboration with non-governmental organisations (OR 1.9, 95% CI 1.2 to 3.1) and participation in neighbourhood activities (OR 3.1, 95% CI 1.9 to 5.1). Conclusions Professional personal characteristics, such as social sensitivity, profession, to feel team support or motivation, have in uence in performing health-promoting CAs. In contrast to the opinion expressed by many professionals, workload is not related to performance of health-promoting CAs

Developing country consumers’ acceptance of biofortified foods: a synthesis

The success of biofortified staple crops depends on whether they are accepted and consumed by target populations. In the past 8 years, several studies were undertaken to understand consumers’ acceptance of foods made with biofortified staple crops. Consumer acceptance is measured in terms of their sensory evaluation and economic valuation of biofortified varieties vis-à-vis conventional ones. These studies apply expert sensory panel and hedonic trait analyses methods adopted from food sciences literature, as well as various preference elicitation methods (including experimental auctions, revealed choice experiments, and stated choice experiments) adopted from experimental economics literature. These studies also test the impact of various levers on consumers’ evaluation and valuation for biofortified foods. These levers include (i) nutrition information and the media through which such information is conveyed; (ii) the length and content of nutrition information; (iii) different branding options; (iv) the nature (national or international) of the branding/certification agency that is endorsing the biofortified staple food; and (v) the nature (national or international) of the agency that is delivering the biofortified staple food. This paper brings together evidence on consumer acceptance of biofortified crops on 5 crops across 7 countries in Africa, Asia and Latin America. The results of these studies are expected to aid in the development of biofortified crops that consumers like, as well as in the development of appropriate marketing and consumer awareness or information campaigns to encourage the switch in consumption from traditional staples to biofortified ones

Characterization of Italian honeys (Marche Region) on the basis of their mineral content and some typical quality parameters

<p>Abstract</p> <p>Background</p> <p>The characterization of three types of Marche (Italy) honeys (Acacia, Multifloral, Honeydew) was carried out on the basis of the their quality parameters (pH, sugar content, humidity) and mineral content (Na, K, Ca, Mg, Cu, Fe, and Mn). Pattern recognition methods such as principal components analysis (PCA) and linear discriminant analysis (LDA) were performed in order to classify honey samples whose botanical origins were different, and identify the most discriminant parameters. Lastly, using ANOVA and correlations for all parameters, significant differences between diverse types of honey were examined.</p> <p>Results</p> <p>Most of the samples' water content showed good maturity (98%) whilst pH values were in the range 3.50 – 4.21 confirming the good quality of the honeys analysed. Potassium was quantitatively the most relevant mineral (mean = 643 ppm), accounting for 79% of the total mineral content. The Ca, Na and Mg contents account for 14, 3 and 3% of the total mineral content respectively, while other minerals (Cu, Mn, Fe) were present at very low levels. PCA explained 75% or more of the variance with the first two PC variables. The variables with higher discrimination power according to the multivariate statistical procedure were Mg and pH. On the other hand, all samples of acacia and honeydew, and more than 90% of samples of multifloral type have been correctly classified using the LDA. ANOVA shows significant differences between diverse floral origins for all variables except sugar, moisture and Fe.</p> <p>Conclusion</p> <p>In general, the analytical results obtained for the Marche honeys indicate the products' high quality. The determination of physicochemical parameters and mineral content in combination with modern statistical techniques can be a useful tool for honey classification.</p

Measurement of the relative rate of prompt χc0, χc1 and χc2 production at √s=7TeV

Prompt production of charmonium χc0, χc1 and χc2 mesons is studied using proton-proton collisions at the LHC at a centre-of-mass energy of √s=7TeV. The χc mesons are identified through their decay to J/ψγ, with J/ψ→μ+mu− using photons that converted in the detector. A data sample, corresponding to an integrated luminosity of 1.0fb−1 collected by the LHCb detector, is used to measure the relative prompt production rate of χc1 and χc2 in the rapidity range 2.0<y<4.5 as a function of the J/ψ transverse momentum from 3 to 20 GeV/c. First evidence for χc0 meson production at a hadron collider is also presented

Search for CP violation in D+→ϕπ+ and D+s→K0Sπ+ decays

A search for CP violation in D + → ϕπ + decays is performed using data collected in 2011 by the LHCb experiment corresponding to an integrated luminosity of 1.0 fb−1 at a centre of mass energy of 7 TeV. The CP -violating asymmetry is measured to be (−0.04 ± 0.14 ± 0.14)% for candidates with K − K + mass within 20 MeV/c 2 of the ϕ meson mass. A search for a CP -violating asymmetry that varies across the ϕ mass region of the D + → K − K + π + Dalitz plot is also performed, and no evidence for CP violation is found. In addition, the CP asymmetry in the D+s→K0Sπ+ decay is measured to be (0.61 ± 0.83 ± 0.14)%

Study of DJ meson decays to D+π−, D0π+ and D∗+π− final states in pp collisions

A study of D+π−, D0π+ and D∗+π− final states is performed using pp collision data, corresponding to an integrated luminosity of 1.0 fb−1, collected at a centre-of-mass energy of 7 TeV with the LHCb detector. The D1(2420)0 resonance is observed in the D∗+π− final state and the D∗2(2460) resonance is observed in the D+π−, D0π+ and D∗+π− final states. For both resonances, their properties and spin-parity assignments are obtained. In addition, two natural parity and two unnatural parity resonances are observed in the mass region between 2500 and 2800 MeV. Further structures in the region around 3000 MeV are observed in all the D∗+π−, D+π− and D0π+ final states

Searches for B0(s)→J/ψppˉ and B+→J/ψppˉπ+ decays

The results of searches for B0(s)→J/ψ pp¯ and B + → J/ψ p p¯ π+ decays are reported. The analysis is based on a data sample, corresponding to an integrated luminosity of 1.0 fb−1 of pp collisions, collected with the LHCb detector. An excess with 2.8 σ significance is seen for the decay B0s→J/ψ pp¯ and an upper limit on the branching fraction is set at the 90 % confidence level: B(B0s→J/ψ pp¯) < 4.8 × 10−6, which is the first such limit. No significant signals are seen for B0 → J/ψ pp¯ and B+ → J/ψ pp¯ π + decays, for which the corresponding limits are set: B(B0→J/ψ pp¯) < 5.2 × 10−7, which significantly improves the existing limit; and B(B+→J/ψ pp¯π+) < 5.0 × 10−7, which is the first limit on this branching fraction

Fungal endophytes from arid areas of Andalusia: high potential sources for antifungal and antitumoral agents

Native plant communities from arid areas present distinctive characteristics to survive in extreme conditions. The large number of poorly studied endemic plants represents a unique potential source for the discovery of novel fungal symbionts as well as host-specific endophytes not yet described. The addition of adsorptive polymeric resins in fungal fermentations has been seen to promote the production of new secondary metabolites and is a tool used consistently to generate new compounds with potential biological activities. A total of 349 fungal strains isolated from 63 selected plant species from arid ecosystems located in the southeast of the Iberian Peninsula, were characterized morphologically as well as based on their ITS/28S ribosomal gene sequences. The fungal community isolated was distributed among 19 orders including Basidiomycetes and Ascomycetes, being Pleosporales the most abundant order. In total, 107 different genera were identified being Neocamarosporium the genus most frequently isolated from these plants, followed by Preussia and Alternaria. Strains were grown in four different media in presence and absence of selected resins to promote chemical diversity generation of new secondary metabolites. Fermentation extracts were evaluated, looking for new antifungal activities against plant and human fungal pathogens, as well as, cytotoxic activities against the human liver cancer cell line HepG2. From the 349 isolates tested, 126 (36%) exhibited significant bioactivities including 58 strains with exclusive antifungal properties and 33 strains with exclusive activity against the HepG2 hepatocellular carcinoma cell line. After LCMS analysis, 68 known bioactive secondary metabolites could be identified as produced by 96 strains, and 12 likely unknown compounds were found in a subset of 14 fungal endophytes. The chemical profiles of the differential expression of induced activities were compared. As proof of concept, ten active secondary metabolites only produced in the presence of resins were purified and identified. The structures of three of these compounds were new and herein are elucidated.This work was supported by Fundación MEDINA and the Andalusian Government grant RNM-7987 ‘Sustainable use of plants and their fungal parasites from arid regions of Andalucía for new molecules useful for antifungals and neuroprotectors’