WPlYW GIElD sWIATOWYCH NA GloWNE INDEKSY GIElDOWE W POLSCE

Autor porownal 13 indeksow gieldowych rynku amerykanskiego, brytyjskiego oraz niemieckiego i okreslil ich wplyw na indeksy WIG i WIG20. Analiza pokazala, iz najwieksze znaczenie dla indeksow warszawskich mialy indeksy brytyjskie FTSE100 i FTSE250 oraz niemiecki DAX. Na relacje te wplynal tez kryzys rosyjski i amerykanski oraz wejscie Polski do UE.indeksy gieldowe, miedzynarodowy przeplyw kapitalu, globalizacja

Photoelectrolytic oxidation of organic species at mesoporous tungsten trioxide film electrodes under visible light illumination

Operation of a photoelectrolyser fitted with a semitransparent semiconducting WO3 film photoanode is described. Due to its band-gap energy of 2.5eV, the photoresponse of the WO3 electrode extends into the blue part of the visible spectrum up to 500nm. The WO3 photoanode exhibits particularly high incident photon-to-current efficiencies for the oxidation of several organic species with the maximum occurring at ca. 400nm. Experiments conducted under simulated AM 1.5 solar illumination demonstrated efficient photodegradation of a variety of organic chemicals including small organic molecules as well as EDTA and anthraquinonic Acid Blue 80 dye. Although, due to the inherent mass transport limitations, the described device appears best suited to the treatment of industrial wastewater containing from 100ppm to few gL−1 of impurities, almost complete removal of organic carbon was observed in several photoelectrolysis runs. This is apparently associated with the concomitant photooxidation of sulphate-based supporting electrolyte resulting in the formation of a powerful chemical oxidant-persulphat

Modification des polymères conducteurs avec de petites particules métalliques; propriétés des films de polypyrrole et de polyaniline platines

The properties of two π-conjugated conducting polymers, polypyrrole, and polyaniline, modified with small amounts of Pt, have been investigated. Both polymers were prepared by electrochemical (cyclic voltammetric) polymerization in the form of thin films (less than 1 μm for polypyrrole, ca. 50-μm thick for polyaniline). It is shown that incorporation, via electrodeposition, of small amount of dispersed Pt particles, inside the polymer film, leads to radical change of its properties. Thus, the polypyrrole film electrode containing ca. 200 μg · cm-2 of Pt exhibits remarkably stable electrocatalytic activity towards anodic oxidation of an important fuel cell reactant – CH3OH. In contrast with the bulk Pt metal or the Pt dispersed on other supports, a polypyrrole/Pt composite does apparently not undergo poisoning, even in the course of prolonged oxidation runs. We show also that the incorporation of Pt microparticles, into several tens of μm thick polyniline films, results in a large enhancement of their redox switching rate between isolating and conducting states and vice versa

Study of the synergistic effect of 2-methoxy-4-formylphenol and sodium molybdenum oxide on the corrosion inhibition of 3CR12 ferritic steel in dilute sulphuric acid

The synergistic effect of the corrosion inhibition properties of 2-methoxy-4-formylphenol and sodium molybdenum oxide on the electrochemical property of 3CR12 ferritic stainless steel in 2M H2SO4 acid solution was assessed through coupon analysis, potentiodynamic polarization technique, IR spectroscopy and micro-analytical technique. Experimental data showed the combined admixture effectively inhibited the steel corrosion at the concentrations analyzed with a maximum inhibition efficiency of 94.47% and 89.71% from coupon analysis and potentiodynamic polarization due to the electrochemical action and inhibition of the steel by the ionized molecules of the inhibiting compound which influenced the mechanism of the redox reactions responsible to corrosion and surface deterioration. Results from corrosion thermodynamic calculations showed chemisorption adsorption mechanism. Infrared spectroscopic images exposed the functional groups of the molecules involved for the corrosion inhibition reaction. Micro-analytical images showed sharp contrast in surface morphology between the inhibited and corroded test specimens under study. Cracks, intergranular and pitting corrosion in addition to severe surface deterioration was observed in the uninhibited samples. Inhibitor adsorption fits the Langmuir isotherm mode

The electronic structure of iridium oxide electrodes active in water splitting

Iridium oxide based electrodes are among the most promising candidates for electrocatalyzing the oxygen evolution reaction, making it imperative to understand their chemical/electronic structure. However, the complexity of iridium oxide's electronic structure makes it particularly difficult to experimentally determine the chemical state of the active surface species. To achieve an accurate understanding of the electronic structure of iridium oxide surfaces, we have combined synchrotron-based X-ray photoemission and absorption spectroscopies with ab initio calculations. Our investigation reveals a pre-edge feature in the O K-edge of highly catalytically active X-ray amorphous iridium oxides that we have identified as O 2p hole states forming in conjunction with IrIII. These electronic defects in the near-surface region of the anionic and cationic framework are likely critical for the enhanced activity of amorphous iridium oxides relative to their crystalline counterparts

Suspension high velocity oxy-fuel spraying of TiO2: a quantitative approach to phase composition

A range of coatings from a water based suspension of anatase has been prepared by suspension high velocity oxy-fuel spraying with the aim to study effects of heat power of the flame on phase composition, microstructure and surface topography. Three most commonly used approaches of quantitative phase analysis have been scrutinized with respect to their applicability and as some of the coatings showed presence of preferred orientation and it was argued that quantitative Rietveld refinement is the most accurate method for phase composition determination. Coatings had a layered duplex anatase/rutile microstructure with fraction of rutile increasing exponentially with heat power. Spraying at the lower heat power led to a lower surface roughness and higher power resulted in surfaces with pronounced humps, which were distributed homogeneously on the surface. The emergence of humps is related to an increase in macroscopic surface area of up to 30% with respect to the flat coating

Non-aqueous sol-gel synthesis through a low-temperature solvothermal process of anatase showing visible-light photocatalytic activity

A novel, facile method based on a non-aqueous sol-gel solvothermal process has been developed to synthesise spherical TiO2 nanoparticles (NPs) in one pot. The reaction between titanium(IV) tert-butoxide (Ti[OC(CH3)(3)](4)) and benzyl alcohol was a simple process, which resulted in the formation of highly crystalline titania NPs with a small size of only 6 nm, and with a correspondingly high surface area. The chemical formation mechanism of the metal oxide NPs has been proposed, and the degree of surface hydroxyls (-OH groups) has been examined. The products of the synthesis were characterised by X-ray powder diffraction (XRPD) using the advanced whole powder pattern modelling (WPPM) method, high-resolution transmission electron microscopy (HR-TEM), thermo-gravimetric analysis (TGA), UV-visible diffuse reflectance spectroscopy (DRS), Fourier transform infrared spectroscopy (FT-IR), and nuclear magnetic resonance (NMR) spectroscopy. The photocatalytic activity (PCA) was evaluated in both the liquid-solid phase, by monitoring the degradation of an organic dye (methylene blue (MB)) under UV-light irradiation, and in the gas-solid phase, by following the degradation of 2-propanol under UV and visible-light exposures. The synthesized titania powders not only exhibited excellent photocatalysis in the liquid-solid phase (under UV irradiation), but also possessed a superior PCA in the gas-solid phase under a visible-light exposure. The effects on the PCA of the very small crystalline domain size, surface composition and the presence of organic molecules due to the synthesis process of the TiO2 NPs were shown to account for this behaviour