566 research outputs found

    W-Band Cavity-backed Folded-slot Antenna Using GaAs Integrated Passive Device Technology

    Get PDF
    A W-band cavity-backed folded-slot antenna based on GaAs integrated passive device technology is proposed in this paper for the first time. A via-cavity is formed to produce TE120 mode resonance and suppress surface waves, and an offset folded slot is designed to match the high impedance of the cavity. The simulated and measured S11 and the simulated radiation patterns are presented, which demonstrate that the antenna can operate from 97.8 GHz to 98.6 GHz with a maximum gain of 2.5 dBi while consuming a small area of only 0.84 mm× 1.325 mm. The proposed antenna is suitable for system-on-chip millimeter-wave applications where front-end modules and the antenna are built on the same chip for minimal signal transfer loss

    3D Chip-level Broadband Measurement Technique for Radiated EM Emission

    Get PDF
    This paper proposes a novel broadband 3D chip-level radiated EM emission measurement technique. Two different test carriers with the embedded CPW and coil conductors respectively are designed and realized by the integrated passive device (IPD) process, which allow collecting the EM emission via near-field coupling. Using an in-house designed 0.18-μm CMOS VCO as the DUT, the emission spectrum obtained using the CPW conductor demonstrates a broadband characteristic up to above 20 GHz with an excellent agreement of the direct measurements. Compared to the traditional IEC standard approaches typically limited below 3 GHz, the proposed high sensitivity and broadband technique is suitable for evaluating EM interference of high-frequency ICs in advanced 3D packaging

    Mining Medical Data: A Case Study of Endometriosis

    Get PDF
    [[abstract]]Ultrasound guided aspiration of ovarian endometrioma had been tried as an alternative therapeutic modality in patients whose desire to avoid surgery or surgical approach is contraindicated since 1991. Cyst puncture can reduce tumor volume and destruct the cyst wall, alleviate sticking circumstances and enhance the chance of recovery. But simple aspiration without other treatments results in high recurrence rate (28.5 % to 100 %). In order to reduce recurrence after aspiration, ultrasound-guided aspiration with instillation of tetracycline, methotrexate, and recombinant interleukin-2 has been combined and proven to be effective with the recurrence rates of 46.9 %, 18.1 %, and 40 % respectively. Noma et al. (2001) reported that conduct of ethanol instillation for more than 10 min particularly for a case with a single endometrial cyst is considered most effective from the standpoint of recurrence (14.9 %). Our goal is to analyze patients with recurrent pelvic cyst who underwent surgical intervention. The research data are based on clinical diagnosis, symptoms and medical intervention classification, and the cyst numbers are defined as forecast project target. The decision tree, methodology of data mining technology, is used to find the meaningful characteristic as well as each other mutually connection. The experimental result can help the clinical faculty doctors to better diagnose and provide treatment reference for future patients.[[notice]]補正完畢[[incitationindex]]SCI[[booktype]]紙

    Direct Semi-Synthesis of the Anticancer Lead-Drug Protoapigenone from Apigenin, and Synthesis of Further New Cytotoxic Protoflavone Derivatives

    Get PDF
    Protoapigenone, a natural flavonoid possessing an unusual p-quinol moiety on its B-ring, is a novel prospective anticancer agent with low toxicity that is currently in development. The first economical, one-step synthesis of protoapigenone from apigenin is described on up to gram scale. 13 new 1′-O-alkylflavone analogs were also synthesized, either from apigenin or β-naphthoflavone. The in vitro cytotoxic activity of each compound was tested on six human cancer cell lines (HepG2, Hep3B, Ca9-22, A549, MCF-7 and MDA-MB-231). In the case of 1′-O-alkyl-protoapigenone derivatives, structure-activity relationships were found depending on the side-chain, and protoapigenone 1′-O-butyl ether was found to exert significantly stronger activity against three of the cell lines (Hep3B, MCF-7 and MDA-MB-231) than its non-substituted analog, protoapigenone itself. In contrast to this, all β-naphthoflavone derivatives bearing the same pharmacophore on their B-ring showed decreased cytotoxic activities when substituted with an O-alkyl side-chain at position 1′, comparing to that of the non-substituted compound

    Electrodeposited lead dioxide coatings

    No full text
    Lead dioxide coatings on inert substrates such as titanium and carbon now offer new opportunities for a material known for 150 years. It is now recognised that electrodeposition allows the preparation of stable coatings with different phase structures and a wide range of surface morphologies. In addition, substantial modification to the physical properties and catalytic activities of the coatings are possible through doping and the fabrication of nanostructured deposits or composites. In addition to applications as a cheap anode material in electrochemical technology, lead dioxide coatings provide unique possibilities for probing the dependence of catalytic activity on layer composition and structure (critical review, 256 references)

    Vision-Based Finger Detection, Tracking, and Event Identification Techniques for Multi-Touch Sensing and Display Systems

    Get PDF
    This study presents efficient vision-based finger detection, tracking, and event identification techniques and a low-cost hardware framework for multi-touch sensing and display applications. The proposed approach uses a fast bright-blob segmentation process based on automatic multilevel histogram thresholding to extract the pixels of touch blobs obtained from scattered infrared lights captured by a video camera. The advantage of this automatic multilevel thresholding approach is its robustness and adaptability when dealing with various ambient lighting conditions and spurious infrared noises. To extract the connected components of these touch blobs, a connected-component analysis procedure is applied to the bright pixels acquired by the previous stage. After extracting the touch blobs from each of the captured image frames, a blob tracking and event recognition process analyzes the spatial and temporal information of these touch blobs from consecutive frames to determine the possible touch events and actions performed by users. This process also refines the detection results and corrects for errors and occlusions caused by noise and errors during the blob extraction process. The proposed blob tracking and touch event recognition process includes two phases. First, the phase of blob tracking associates the motion correspondence of blobs in succeeding frames by analyzing their spatial and temporal features. The touch event recognition process can identify meaningful touch events based on the motion information of touch blobs, such as finger moving, rotating, pressing, hovering, and clicking actions. Experimental results demonstrate that the proposed vision-based finger detection, tracking, and event identification system is feasible and effective for multi-touch sensing applications in various operational environments and conditions

    Lepton Flavor Non-Conservation

    Full text link
    In the present work we review the most prominent lepton flavor violating processes (\mu \ra e\gamma, \mu \ra 3e, (μ,e)(\mu , e) conversion, MMˉM-\bar M oscillations etc), in the context of unified gauge theories. Many currently fashionable extensions of the standard model are considered, such as: {\it i)} extensions of the fermion sector (right-handed neutrino); {\it ii)} minimal extensions involving additional Higgs scalars (more than one isodoublets, singly and doubly charged isosinglets, isotriplets with doubly charged members etc.); {\it iii)} supersymmetric or superstring inspired unified models emphasizing the implications of the renormalization group equations in the leptonic sector. Special attention is given to the experimentaly most interesting (μe)(\mu - e) conversion in the presence of nuclei. The relevant nuclear aspects of the amplitudes are discussed in a number of fashionable nuclear models. The main features of the relevant experiments are also discussed, and detailed predictions of the above models are compared to the present experimental limits.Comment: (IOA-300/93, review article, 83p, 6 epsf figures , available upon request from [email protected])
    corecore