Characterisation of the VELO High Voltage System

The high voltage system supplies the bias voltage to the 88 silicon sensors which comprise the LHCb Vertex Locator (VELO). This note describes the results of the tests which have been performed on the hardware of the high voltage system of the VELO. Each individual test detailed in this note corresponds to a specific requirement of the system. These requirements arise primarily from ensuring the safety of the silicon sensors and the quality of the data taken from the VELO modules. The tests performed are in four categories: normal operation of the high voltage system; verification of its stability under operation; discussion of its behaviour in failure modes; and details of operation at low voltage. Noteworthy issues, identified through the tests, include the behaviour of the high voltage modules at voltages below 9V, the current limit that can be applied during ramping of the voltage, and the speed with which the voltage is cut during failures of the system. The results of these tests provide high confidence that the high voltage system can be safely used and demonstrate that low noise is produced by the power supplies

The VELO High Voltage System Control Software

This note describes the VELO high voltage control software. The implementation of its structure as a PVSS Finite State Machine is emphasized. The main error conditions that may occur during operation is also discussed. The VELO HV software conforms to the specification of the VELO

Performance of the LHCb vertex locator

The Vertex Locator (VELO) is a silicon microstrip detector that surrounds the proton-proton interaction region in the LHCb experiment. The performance of the detector during the first years of its physics operation is reviewed. The system is operated in vacuum, uses a bi-phase CO2 cooling system, and the sensors are moved to 7 mm from the LHC beam for physics data taking. The performance and stability of these characteristic features of the detector are described, and details of the material budget are given. The calibration of the timing and the data processing algorithms that are implemented in FPGAs are described. The system performance is fully characterised. The sensors have a signal to noise ratio of approximately 20 and a best hit resolution of 4 μm is achieved at the optimal track angle. The typical detector occupancy for minimum bias events in standard operating conditions in 2011 is around 0.5%, and the detector has less than 1% of faulty strips. The proximity of the detector to the beam means that the inner regions of the n+-on-n sensors have undergone space-charge sign inversion due to radiation damage. The VELO performance parameters that drive the experiment's physics sensitivity are also given. The track finding efficiency of the VELO is typically above 98% and the modules have been aligned to a precision of 1 μm for translations in the plane transverse to the beam. A primary vertex resolution of 13 μm in the transverse plane and 71 μm along the beam axis is achieved for vertices with 25 tracks. An impact parameter resolution of less than 35 μm is achieved for particles with transverse momentum greater than 1 GeV/c

Precision luminosity measurements at LHCb

Measuring cross-sections at the LHC requires the luminosity to be determined accurately at each centre-of-mass energy √s. In this paper results are reported from the luminosity calibrations carried out at the LHC interaction point 8 with the LHCb detector for √s = 2.76, 7 and 8 TeV (proton-proton collisions) and for √sNN = 5 TeV (proton-lead collisions). Both the "van der Meer scan" and "beam-gas imaging" luminosity calibration methods were employed. It is observed that the beam density profile cannot always be described by a function that is factorizable in the two transverse coordinates. The introduction of a two-dimensional description of the beams improves significantly the consistency of the results. For proton-proton interactions at √s = 8 TeV a relative precision of the luminosity calibration of 1.47% is obtained using van der Meer scans and 1.43% using beam-gas imaging, resulting in a combined precision of 1.12%. Applying the calibration to the full data set determines the luminosity with a precision of 1.16%. This represents the most precise luminosity measurement achieved so far at a bunched-beam hadron collider

Quantum numbers of the X(3872)X(3872) state and orbital angular momentum in its ρ0Jψ\rho^0 J\psi decay

Angular correlations in $B^+\to X(3872) K^+$ decays, with $X(3872)\to \rho^0 J/\psi$, $\rho^0\to\pi^+\pi^-$ and $J/\psi \to\mu^+\mu^-$, are used to measure orbital angular momentum contributions and to determine the $J^{PC}$ value of the $X(3872)$ meson. The data correspond to an integrated luminosity of 3.0 fb$^{-1}$ of proton-proton collisions collected with the LHCb detector. This determination, for the first time performed without assuming a value for the orbital angular momentum, confirms the quantum numbers to be $J^{PC}=1^{++}$. The $X(3872)$ is found to decay predominantly through S wave and an upper limit of $4\%$ at $95\%$ C.L. is set on the fraction of D wave.Comment: 16 pages, 4 figure

Observation of two new Ξb−\Xi_b^- baryon resonances

Two structures are observed close to the kinematic threshold in the $\Xi_b^0 \pi^-$ mass spectrum in a sample of proton-proton collision data, corresponding to an integrated luminosity of 3.0 fb$^{-1}$ recorded by the LHCb experiment. In the quark model, two baryonic resonances with quark content $bds$ are expected in this mass region: the spin-parity $J^P = \frac{1}{2}^+$ and $J^P=\frac{3}{2}^+$ states, denoted $\Xi_b^{\prime -}$ and $\Xi_b^{*-}$. Interpreting the structures as these resonances, we measure the mass differences and the width of the heavier state to be $m(\Xi_b^{\prime -}) - m(\Xi_b^0) - m(\pi^{-}) = 3.653 \pm 0.018 \pm 0.006$ MeV$/c^2$, $m(\Xi_b^{*-}) - m(\Xi_b^0) - m(\pi^{-}) = 23.96 \pm 0.12 \pm 0.06$ MeV$/c^2$, $\Gamma(\Xi_b^{*-}) = 1.65 \pm 0.31 \pm 0.10$ MeV, where the first and second uncertainties are statistical and systematic, respectively. The width of the lighter state is consistent with zero, and we place an upper limit of $\Gamma(\Xi_b^{\prime -}) < 0.08$ MeV at 95% confidence level. Relative production rates of these states are also reported.Comment: 17 pages, 2 figure

Measurement of the CP-violating phase \phi s in Bs->J/\psi\pi+\pi- decays

Measurement of the mixing-induced CP-violating phase phi_s in Bs decays is of prime importance in probing new physics. Here 7421 +/- 105 signal events from the dominantly CP-odd final state J/\psi pi+ pi- are selected in 1/fb of pp collision data collected at sqrt{s} = 7 TeV with the LHCb detector. A time-dependent fit to the data yields a value of phi_s=-0.019^{+0.173+0.004}_{-0.174-0.003} rad, consistent with the Standard Model expectation. No evidence of direct CP violation is found.Comment: 15 pages, 10 figures; minor revisions on May 23, 201

Observation of the decay Bc→J/ψK+K−π+B_c \rightarrow J/\psi K^+ K^- \pi^+

The decay $B_c\rightarrow J/\psi K^+ K^- \pi^+$ is observed for the first time, using proton-proton collisions collected with the LHCb detector corresponding to an integrated luminosity of 3fb$^{-1}$. A signal yield of $78\pm14$ decays is reported with a significance of 6.2 standard deviations. The ratio of the branching fraction of \B_c \rightarrow J/\psi K^+ K^- \pi^+ decays to that of $B_c \rightarrow J/\psi \pi^+$ decays is measured to be $0.53\pm 0.10\pm0.05$, where the first uncertainty is statistical and the second is systematic.Comment: 18 pages, 2 figure

Observation of associated production of a ZZ boson with a DD meson in the~forward region

A search for associated production of a $Z$ boson with an open charm meson is presented using a data sample, corresponding to an integrated luminosity of $1.0\,\mathrm{fb}^{-`}$ of proton--proton collisions at a centre-of-mass energy of 7\,TeV, collected by the LHCb experiment. %% Seven candidate events for associated production of a $Z$ boson with a $D^0$ meson and four candidate events for a $Z$ boson with a $D^+$ meson are observed with a combined significance of 5.1standard deviations. The production cross-sections in the forward region are measured to be $$\sigma_{Z\rightarrow\mu^+\mu^-\!,D^0} = 2.50\pm1.12\pm0.22pb$$ $$\sigma_{Z\rightarrow\mu^+\mu^-\!,D^+} = 0.44\pm0.23\pm0.03pb,$$ where the first uncertainty is statistical and the second systematic.Comment: 18 pages, 2 figure

Differential branching fraction and angular analysis of the decay B0→K∗0μ+μ−

The angular distribution and differential branching fraction of the decay B 0→ K ∗0 μ + μ − are studied using a data sample, collected by the LHCb experiment in pp collisions at s√=7 TeV, corresponding to an integrated luminosity of 1.0 fb−1. Several angular observables are measured in bins of the dimuon invariant mass squared, q 2. A first measurement of the zero-crossing point of the forward-backward asymmetry of the dimuon system is also presented. The zero-crossing point is measured to be q20=4.9±0.9GeV2/c4 , where the uncertainty is the sum of statistical and systematic uncertainties. The results are consistent with the Standard Model predictions