Comparison of different techniques to study the nanostructure and the microstructure of cementitious materials with and without superabsorbent polymers

It is difficult to study the microstructural porosity in time without destroying the samples and stopping hydration. Current techniques mainly involve mercury intrusion porosimetry and microscopic analysis. These destructive techniques are able to give information on the microstructure, but the nanostructure is affected due to sample preparation. Dynamic vapour sorption is a technique which is not often used to study the nanostructure of cementitious materials and requires the application of different models. Furthermore, nuclear magnetic resonance can be applied to non-destructive study not only the total water content but also the pore size distribution by comparing the T2 relaxation times, and can be combined with cryoporometry. In this paper, these different measuring techniques are compared and linked to each other. The obtained nano- and microstructures are compared to different models found in literature. Pore sizes in the range of 1.5–2 nm and of 8–12 nm are found, reflecting the gel pores. In addition, some bigger capillary pores are found. The measuring techniques are complementary to each other as they study different pore size ranges and are based on different phenomena.</p

The formation of meta-stable sodium sulphate heptahydrate during drying as studied by NMR

Salt weathering is a major cause of deterioration of porous building materials. Of the salts responsible, especially sodium sulfate is seen as very damaging. However many questions arise concerning which sodium sulfate phase will crystallize out during salt weathering. In this study we focused on the crystallization during isothermal drying of a sample saturated with a sodium sulfate solution. As the material is drying moisture will leave and hence the salt concentration will rise until the maximum solubility is reached. From that point on crystals will be formed. Using NMR we have measured quasi simultaneously both the moisture and Na profiles during drying. These experiments have been performed at various temperatures and concentrations. In our NMR experiments we observe the formation of a metastable phase of sodium sulfate, the heptahydrate crystals

The formation of meta-stable sodium sulphate heptahydrate during drying as studied by NMR

Salt weathering is a major cause of deterioration of porous building materials. Of the salts responsible, especially sodium sulfate is seen as very damaging. However many questions arise concerning which sodium sulfate phase will crystallize out during salt weathering. In this study we focused on the crystallization during isothermal drying of a sample saturated with a sodium sulfate solution. As the material is drying moisture will leave and hence the salt concentration will rise until the maximum solubility is reached. From that point on crystals will be formed. Using NMR we have measured quasi simultaneously both the moisture and Na profiles during drying. These experiments have been performed at various temperatures and concentrations. In our NMR experiments we observe the formation of a metastable phase of sodium sulfate, the heptahydrate crystals

A new volumetric strain-based method for determining the crack initiation threshold of rocks under compression

The crack initiation stress threshold ( ci) is an essential parameter in the brittle failure process of rocks. In this paper, a volumetric strain response method (VSRM) is proposed to determine the σci based on two new concepts, i.e., the dilatancy resistance state index ( ci) and the maximum value of the dilatancy resistance state index difference (| ci|), which represent the state of dilatancy resistance of the rock and the shear sliding resistance capacity of the crack-like pores during the compressive period, respectively. The deviatoric stress corresponding to the maximum | ci| is taken as the ci . We then examine the feasibility and validity of the VSRM using the experimental results. The results from the VSRM are also compared with those calculated by other strain-based methods, including the volumetric strain method (VSM), crack volumetric strain method (CVSM), lateral strain method (LSM) and lateral strain response method (LSRM). Compared with the other methods, the VSRM is effective and reduces subjectivity when determining the ci . Finally, with the help of the proposed VSRM, influences from chemical corrosion and confining stress on the ci and ci of the carbonate rock are analyzed. This study provides a subjective and practical method for determining σci . Moreover, it sheds light on the effects of confinement and chemical corrosion on σci

Paradoxical drying due to salt crystallization

We investigated how salt crystallization inside a porous building material influences the formation of a receding drying front. Nuclear Magnetic Resonance (NMR) is used to measure non-destructively both hydrogen and dissolved sodium ions simultaneously during drying experiments. In this study we focused on the influence of NaCl on the drying. The results show that salt changes the drying process. At low relative humidities (RH ~ 0%), the drying rate of a brick saturated with NaCl solution is much lower than the drying rate of water saturated brick. Moreover, the presence of salt suppresses the development of a receding front. In this case homogenous drying of the material continues till very low saturation values. This is due to salt crystallization near the surface of the brick that causes blockage of the pores. This blockage reduces evaporation rate at the surface and allows maintaining a continuous hydraulic connection between the surface of the porous medium and the liquid present inside the material till low saturation values. Increasing the relative humidity at 55% and 70% RH with the brick saturated with the salt solution leads to a paradoxical situation with evaporation rates greater than for 0% RH. The paradox is explained by the impact of evaporation rate on the efflorescence microstructure, leading to the formation of a blocking crust for sufficiently high evaporation rates and non-blocking efflorescence for sufficiently low evaporation rates. The fundamental difference between the two types of efflorescence is demonstrated from a simple imbibition experiment. Using a simple continuum scale model of drying, critical moisture content was determined and all the essential features of the experimental results are validated. It is shown that critical moisture content can be very low in case of fired-clay brick due to the low threshold of the pore space, which is consistent with the relatively large pore size distribution of the fired-clay brick

Search for CP violation in D+→ϕπ+ and D+s→K0Sπ+ decays

A search for CP violation in D + → ϕπ + decays is performed using data collected in 2011 by the LHCb experiment corresponding to an integrated luminosity of 1.0 fb−1 at a centre of mass energy of 7 TeV. The CP -violating asymmetry is measured to be (−0.04 ± 0.14 ± 0.14)% for candidates with K − K + mass within 20 MeV/c 2 of the ϕ meson mass. A search for a CP -violating asymmetry that varies across the ϕ mass region of the D + → K − K + π + Dalitz plot is also performed, and no evidence for CP violation is found. In addition, the CP asymmetry in the D+s→K0Sπ+ decay is measured to be (0.61 ± 0.83 ± 0.14)%

Proteomic Analysis of the Secretory Response of Aspergillus niger to D-Maltose and D-Xylose

Fungi utilize polysaccharide substrates through extracellular digestion catalyzed by secreted enzymes. Thus far, protein secretion by the filamentous fungus Aspergillus niger has mainly been studied at the level of individual proteins and by genome and transcriptome analyses. To extend these studies, a complementary proteomics approach was applied with the aim to investigate the changes in secretome and microsomal protein composition resulting from a shift to a high level secretion condition. During growth of A. niger on d-sorbitol, small amounts of d-maltose or d-xylose were used as inducers of the extracellular amylolytic and xylanolytic enzymes. Upon induction, protein compositions in the extracellular broth as well as in enriched secretory organelle (microsomal) fractions were analyzed using a shotgun proteomics approach. In total 102 secreted proteins and 1,126 microsomal proteins were identified in this study. Induction by d-maltose or d-xylose resulted in the increase in specific extracellular enzymes, such as glucoamylase A on d-maltose and β-xylosidase D on d-xylose, as well as of microsomal proteins. This reflects the differential expression of selected genes coding for dedicated extracellular enzymes. As expected, the addition of extra d-sorbitol had no effect on the expression of carbohydrate-active enzymes, compared to addition of d-xylose or d-maltose. Furthermore, d-maltose induction caused an increase in microsomal proteins related to translation (e.g., Rpl15) and vesicular transport (e.g., the endosomal-cargo receptor Erv14). Millimolar amounts of the inducers d-maltose and d-xylose are sufficient to cause a direct response in specific protein expression levels. Also, after induction by d-maltose or d-xylose, the induced enzymes were found in microsomes and extracellular. In agreement with our previous findings for d-xylose induction, d-maltose induction leads to recruitment of proteins involved in proteasome-mediated degradation

Proteomics of industrial fungi: trends and insights for biotechnology

Filamentous fungi are widely known for their industrial applications, namely, the production of food-processing enzymes and metabolites such as antibiotics and organic acids. In the past decade, the full genome sequencing of filamentous fungi increased the potential to predict encoded proteins enormously, namely, hydrolytic enzymes or proteins involved in the biosynthesis of metabolites of interest. The integration of genome sequence information with possible phenotypes requires, however, the knowledge of all the proteins in the cell in a system-wise manner, given by proteomics. This review summarises the progress of proteomics and its importance for the study of biotechnological processes in filamentous fungi. A major step forward in proteomics was to couple protein separation with high-resolution mass spectrometry, allowing accurate protein quantification. Despite the fact that most fungal proteomic studies have been focused on proteins from mycelial extracts, many proteins are related to processes which are compartmentalised in the fungal cell, e.g. β-lactam antibiotic production in the microbody. For the study of such processes, a targeted approach is required, e.g. by organelle proteomics. Typical workflows for sample preparation in fungal organelle proteomics are discussed, including homogenisation and sub-cellular fractionation. Finally, examples are presented of fungal organelle proteomic studies, which have enlarged the knowledge on areas of interest to biotechnology, such as protein secretion, energy production or antibiotic biosynthesis