259 research outputs found
The cementation technique for coating carbon fibres
The cementation technique is used in a modified form where glacial acetic acid is added to the salt solution as an activating agent so that the displaced metal can wet the carbon fiber better. The feasibility of the technique is demonstrated on three types of carbon fibers. Copper, nickel and cobalt are deposited onto the carbon fiber from the corresponding salt solutions using four displacing agents, Zn, Mg, Al and Fe. To obtain uniform, continuous and adherent coatings, the following parameters are investigated and optimized: the metal ion solution concentration, the activation treatment of the fibers, temperature of the solution, time of deposition, effect of the reducing agent, and particle size of the reducing agent. The characterization of the coating is made on the basis of metallographic examination and tensile properties of the coated fibers. It is shown that by controlling the size of the reducing agent, acid concentration, solution concentration and temperature, uniform and adherent coatings can be obtained. The coating fibers are introduced into an aluminum matrix by an infiltration technique and are uniformly distributed in the composit
The effects of stochastic resonance electrical stimulation and neoprene sleeve on knee proprioception
<p>Abstract</p> <p>Background</p> <p>A variety of knee injuries and pathologies may cause a deficit in knee proprioception which may increase the risk of reinjury or the progression of disease. Stochastic resonance stimulation is a new therapy which has potential benefits for improving proprioceptive function. The objective of this study was to determine if stochastic resonance (SR) stimulation applied with a neoprene sleeve could improve knee proprioception relative to a no-stimulation/no-sleeve condition (control) or a sleeve alone condition in the normal, healthy knee. We hypothesized that SR stimulation when applied with a sleeve would enhance proprioception relative to the control and sleeve alone conditions.</p> <p>Methods</p> <p>Using a cross-over within subject design, twenty-four healthy subjects were tested under four combinations of conditions: electrical stimulation/sleeve, no stimulation/sleeve, no stimulation/no sleeve, and stimulation/no sleeve. Joint position sense (proprioception) was measured as the absolute mean difference between a target knee joint angle and the knee angle reproduced by the subject. Testing was conducted during both partial-weight bearing (PWB) and non-weight bearing (NWB) tasks. Differences in joint position sense between the conditions were evaluated by repeated-measures analysis of variance testing.</p> <p>Results</p> <p>Joint position sense error during the stimulation/sleeve condition (2.48° ± 1.32°) was found to be more accurate (P < 0.05) relative to the control condition (3.35° ± 1.63°) in the PWB task. No difference in joint position sense error was found between stimulation/sleeve and sleeve alone conditions for the PWB task. Joint position sense error was not found to differ between any of the conditions for the NWB task.</p> <p>Conclusion</p> <p>These results suggest that SR electrical stimulation when combined with a neoprene sleeve is an effective modality for enhancement of joint proprioception in the PWB knee. We believe these results suggest the need for further study of the potential of SR stimulation to correct proprioceptive deficits in a clinical population with knee injury/pathology or in subjects at risk of injury because of a proprioceptive deficit.</p
Tribological Analysis of Copper-Coated Graphite Particle-Reinforced A359 Al/5 wt.% SiC Composites
[[abstract]]Copper-coated graphite particles can be mass-produced by the cementation process using simple equipment.
Graphite particulates that were coated with electroless copper and 5 wt.% SiC particulates were
introduced into an aluminum alloy by compocasting to make A359 Al/5 wt.% SiC(p) composite that
contained 2, 4, 6, and 8 wt.% graphite particulate composite. The effects of SiC particles, quantity of
graphite particles, normal loading, sliding speed and wear debris on the coefficient of friction, and the wear
rate were investigated. The results thus obtained indicate that the wear properties were improved by adding
small amounts of SiC and graphite particles into the A359 Al alloy. The coefficient of friction of the A359
Al/5 wt.% SiC(p) composite that contained 6.0 wt.% graphite particulates was reduced to 0.246 and the
amount of graphite film that was released on the worn surface increased with the graphite particulate
content. The coefficient of friction and the wear rate were insensitive to the variation in the sliding speed
and normal loading.[[notice]]補正完畢[[incitationindex]]SCI[[booktype]]紙本[[booktype]]電子
Surprisingly High Specificity of the PPD Skin Test for M. tuberculosis Infection from Recent Exposure in The Gambia
BACKGROUND: Options for intervention against Mycobacterium tuberculosis infection are limited by the diagnostic tools available. The Purified Protein Derivative (PPD) skin test is thought to be non-specific, especially in tropical settings. We compared the PPD skin test with an ELISPOT test in The Gambia. METHODOLOGY/PRINCIPAL FINDINGS: Household contacts over six months of age of sputum smear positive TB cases and community controls were recruited. They underwent a PPD skin test and an ELISPOT test for the T cell response to PPD and ESAT-6/CFP10 antigens. Responsiveness to M. tuberculosis exposure was analysed according to sleeping proximity to an index case using logistic regression. 615 household contacts and 105 community controls were recruited. All three tests assessed increased significantly in positivity with increasing M. tuberculosis exposure, the PPD skin test most dramatically (OR 15.7; 95% CI 6.6–35.3). While the PPD skin test positivity continued to trend downwards in the community with increasing distance from a known case (61.9% to 14.3%), the PPD and ESAT-6/CFP-10 ELISPOT positivity did not. The PPD skin test was more in agreement with ESAT-6/CFP-10 ELISPOT (75%, p = 0.01) than the PPD ELISPOT (53%, p<0.0001). With increasing M. tuberculosis exposure, the proportion of ESAT-6/CFP-10 positive contacts who were PPD skin test positive increased (p<0.0001), and the proportion of ESAT-6/CFP-10 negative contacts that were PPD skin test negative decreased (p<0.0001); the converse did not occur. CONCLUSIONS/SIGNIFICANCE: The PPD skin test has surprisingly high specificity for M. tuberculosis infection from recent exposure in The Gambia. In this setting, anti-tuberculous prophylaxis in PPD skin test positive individuals should be revisited
Diagnostic accuracy of cyst fluid amphiregulin in pancreatic cysts
<p>Abstract</p> <p>Background</p> <p>Accurate tests to diagnose adenocarcinoma and high-grade dysplasia among mucinous pancreatic cysts are clinically needed. This study evaluated the diagnostic utility of amphiregulin (AREG) as a pancreatic cyst fluid biomarker to differentiate non-mucinous, benign mucinous, and malignant mucinous cysts.</p> <p>Methods</p> <p>A single-center retrospective study to evaluate AREG levels in pancreatic cyst fluid by ELISA from 33 patients with a histological gold standard was performed.</p> <p>Results</p> <p>Among the cyst fluid samples, the median (IQR) AREG levels for non-mucinous (n = 6), benign mucinous (n = 15), and cancerous cysts (n = 15) were 85 pg/ml (47-168), 63 pg/ml (30-847), and 986 pg/ml (417-3160), respectively. A significant difference between benign mucinous and malignant mucinous cysts was observed (<it>p </it>= 0.025). AREG levels greater than 300 pg/ml possessed a diagnostic accuracy for cancer or high-grade dysplasia of 78% (sensitivity 83%, specificity 73%).</p> <p>Conclusion</p> <p>Cyst fluid AREG levels are significantly higher in cancerous and high-grade dysplastic cysts compared to benign mucinous cysts. Thus AREG exhibits potential clinical utility in the evaluation of pancreatic cysts.</p
Suppression of charged particle production at large transverse momentum in central Pb-Pb collisions at TeV
Inclusive transverse momentum spectra of primary charged particles in Pb-Pb
collisions at = 2.76 TeV have been measured by the ALICE
Collaboration at the LHC. The data are presented for central and peripheral
collisions, corresponding to 0-5% and 70-80% of the hadronic Pb-Pb cross
section. The measured charged particle spectra in and GeV/ are compared to the expectation in pp collisions at the same
, scaled by the number of underlying nucleon-nucleon
collisions. The comparison is expressed in terms of the nuclear modification
factor . The result indicates only weak medium effects ( 0.7) in peripheral collisions. In central collisions,
reaches a minimum of about 0.14 at -7GeV/ and increases
significantly at larger . The measured suppression of high- particles is stronger than that observed at lower collision energies,
indicating that a very dense medium is formed in central Pb-Pb collisions at
the LHC.Comment: 15 pages, 5 captioned figures, 3 tables, authors from page 10,
published version, figures at http://aliceinfo.cern.ch/ArtSubmission/node/98
Two-pion Bose-Einstein correlations in central Pb-Pb collisions at = 2.76 TeV
The first measurement of two-pion Bose-Einstein correlations in central Pb-Pb
collisions at TeV at the Large Hadron Collider is
presented. We observe a growing trend with energy now not only for the
longitudinal and the outward but also for the sideward pion source radius. The
pion homogeneity volume and the decoupling time are significantly larger than
those measured at RHIC.Comment: 17 pages, 5 captioned figures, 1 table, authors from page 12,
published version, figures at
http://aliceinfo.cern.ch/ArtSubmission/node/388
Targeting FGFR4 Inhibits Hepatocellular Carcinoma in Preclinical Mouse Models
The fibroblast growth factor (FGF)-FGF receptor (FGFR) signaling system plays critical roles in a variety of normal developmental and physiological processes. It is also well documented that dysregulation of FGF-FGFR signaling may have important roles in tumor development and progression. The FGFR4–FGF19 signaling axis has been implicated in the development of hepatocellular carcinomas (HCCs) in mice, and potentially in humans. In this study, we demonstrate that FGFR4 is required for hepatocarcinogenesis; the progeny of FGF19 transgenic mice, which have previously been shown to develop HCCs, bred with FGFR4 knockout mice fail to develop liver tumors. To further test the importance of FGFR4 in HCC, we developed a blocking anti-FGFR4 monoclonal antibody (LD1). LD1 inhibited: 1) FGF1 and FGF19 binding to FGFR4, 2) FGFR4–mediated signaling, colony formation, and proliferation in vitro, and 3) tumor growth in a preclinical model of liver cancer in vivo. Finally, we show that FGFR4 expression is elevated in several types of cancer, including liver cancer, as compared to normal tissues. These findings suggest a modulatory role for FGFR4 in the development and progression of hepatocellular carcinoma and that FGFR4 may be an important and novel therapeutic target in treating this disease
CONSORT 2010 statement: extension to randomised pilot and feasibility trials [on behalf of the PAFS consensus group*]
The Consolidated Standards of Reporting Trials (CONSORT) statement is a guideline designed to improve the transparency and quality of the reporting of randomised controlled trials (RCTs). In this article we present an extension to that statement for randomised pilot and feasibility trials conducted in advance of a future definitive RCT. The checklist applies to any randomised study in which a future definitive RCT, or part of it, is conducted on a smaller scale, regardless of its design (eg, cluster, factorial, crossover) or the terms used by authors to describe the study (eg, pilot, feasibility, trial, study). The extension does not directly apply to internal pilot studies built into the design of a main trial, non-randomised pilot and feasibility studies, or phase II studies, but these studies all have some similarities to randomised pilot and feasibility studies and so many of the principles might also apply.
The development of the extension was motivated by the growing number of studies described as feasibility or pilot studies and by research that has identified weaknesses in their reporting and conduct. We followed recommended good practice to develop the extension, including carrying out a Delphi survey, holding a consensus meeting and research team meetings, and piloting the checklist.
The aims and objectives of pilot and feasibility randomised studies differ from those of other randomised trials. Consequently, although much of the information to be reported in these trials is similar to those in randomised controlled trials (RCTs) assessing effectiveness and efficacy, there are some key differences in the type of information and in the appropriate interpretation of standard CONSORT reporting items. We have retained some of the original CONSORT statement items, but most have been adapted, some removed, and new items added. The new items cover how participants were identified and consent obtained; if applicable, the prespecified criteria used to judge whether or how to proceed with a future definitive RCT; if relevant, other important unintended consequences; implications for progression from pilot to future definitive RCT, including any proposed amendments; and ethical approval or approval by a research review committee confirmed with a reference number.
This article includes the 26 item checklist, a separate checklist for the abstract, a template for a CONSORT flowchart for these studies, and an explanation of the changes made and supporting examples. We believe that routine use of this proposed extension to the CONSORT statement will result in improvements in the reporting of pilot trials.
Editor’s note: In order to encourage its wide dissemination this article is freely accessible on the BMJ and Pilot and Feasibility Studies journal websites
- …