Femtosecond spectral and anisotropy study of excitation energy transfer between neighbouring α-80 and β-81 chromophores of allophycocyanin trimers

Polarization pump-probe femtosecond spectroscopy was used to investigate photoinduced optical density changes in allophycocyanin (APC) trimers at 635–690 nm after excitation with 230-fs pulses at 618 nm. The initial bleaching observed at λ < 645 nm is followed by subpicosecond absorption recovery corresponding to 430 ± 40 fs recovery kinetics measured at 615 nm with 70-fs pulses. Only the red part of the APC absorption band remains strongly bleached at 3 ps after excitation. The spectral and kinetic results can be described in terms of two different models of interaction between neighbouring α-80 and β-81 chromophores of APC trimers. According to the first one, the observed subpicosecond kinetics corresponds to relaxation between the levels of excitonically coupled, spectrally identical α-80 and β-81 chromophores. Excited state absorption to doubly excited excitonic state should in this case contribute to the measured difference spectra. According to the second one, the femtosecond excitation energy transfer in APC trimers takes place between a donor chromophore absorbing predominantly at 620 nm and an acceptor chromophore absorbing at 650 nm. The high anisotropy value observed at 615 nm during the first 1.2 ps is in good agreement with the donor-acceptor model. Anisotropy values calculated in the 635–675 nm spectral region at 3 ps after excitation are in the 0.1–0.25 range corresponding to an angle of 30°–45° between donor and acceptor transition dipole orientations. The high anisotropy obtained at 658 nm during the excitation is probably due to stimulated emission of the donor chromophore

Förster energy transfer between neighbouring chromophores in C-phycocyanin trimers

The excitation-energy transfer in C-phycocyanin (C-PC) trimers and monomers isolated from phycobilisomes of Mastigocladus laminosus has been studied by polarization femtosecond laser spectroscopy. Excitation with 70-fs pulses at 615 nm gave rise to a 500-fs energy-transfer process that was observed only in trimeric preparations. The rate of the process is in agreement with earlier calculated Förster energy transfer rates between neighbouring α-84 and β-84 chromophores of different monomeric subunits. This process is most clearly seen in the anisotropy decay kinetics. As a result of femtosecond excitation-energy transfer, the anisotropy relaxes from 0.4 to 0.23. The final anisotropy value is in fair agreement with the results of calculations based on the crystal structure and spectroscopic data of C-PC trimers. Our results support the conclusion that Förster energy transfer can occur between excitonically coupled chromophores

Alignment of the ALICE Inner Tracking System with cosmic-ray tracks

37 pages, 15 figures, revised version, accepted by JINSTALICE (A Large Ion Collider Experiment) is the LHC (Large Hadron Collider) experiment devoted to investigating the strongly interacting matter created in nucleus-nucleus collisions at the LHC energies. The ALICE ITS, Inner Tracking System, consists of six cylindrical layers of silicon detectors with three different technologies; in the outward direction: two layers of pixel detectors, two layers each of drift, and strip detectors. The number of parameters to be determined in the spatial alignment of the 2198 sensor modules of the ITS is about 13,000. The target alignment precision is well below 10 micron in some cases (pixels). The sources of alignment information include survey measurements, and the reconstructed tracks from cosmic rays and from proton-proton collisions. The main track-based alignment method uses the Millepede global approach. An iterative local method was developed and used as well. We present the results obtained for the ITS alignment using about 10^5 charged tracks from cosmic rays that have been collected during summer 2008, with the ALICE solenoidal magnet switched off.Peer reviewe

Transverse momentum spectra of charged particles in proton-proton collisions at s=900\sqrt{s} = 900 GeV with ALICE at the LHC

The inclusive charged particle transverse momentum distribution is measured in proton-proton collisions at $\sqrt{s} = 900$ GeV at the LHC using the ALICE detector. The measurement is performed in the central pseudorapidity region $(|\eta|<0.8)$ over the transverse momentum range $0.15<p_{\rm T}<10$ GeV/$c$. The correlation between transverse momentum and particle multiplicity is also studied. Results are presented for inelastic (INEL) and non-single-diffractive (NSD) events. The average transverse momentum for $|\eta|<0.8$ is $\left<p_{\rm T}\right>_{\rm INEL}=0.483\pm0.001$ (stat.) $\pm0.007$ (syst.) GeV/$c$ and \left_{\rm NSD}=0.489\pm0.001 (stat.) $\pm0.007$ (syst.) GeV/$c$, respectively. The data exhibit a slightly larger $\left<p_{\rm T}\right>$ than measurements in wider pseudorapidity intervals. The results are compared to simulations with the Monte Carlo event generators PYTHIA and PHOJET.Comment: 20 pages, 8 figures, 2 tables, published version, figures at http://aliceinfo.cern.ch/ArtSubmission/node/390

The ALICE experiment at the CERN LHC

ALICE (A Large Ion Collider Experiment) is a general-purpose, heavy-ion detector at the CERN LHC which focuses on QCD, the strong-interaction sector of the Standard Model. It is designed to address the physics of strongly interacting matter and the quark-gluon plasma at extreme values of energy density and temperature in nucleus-nucleus collisions. Besides running with Pb ions, the physics programme includes collisions with lighter ions, lower energy running and dedicated proton-nucleus runs. ALICE will also take data with proton beams at the top LHC energy to collect reference data for the heavy-ion programme and to address several QCD topics for which ALICE is complementary to the other LHC detectors. The ALICE detector has been built by a collaboration including currently over 1000 physicists and engineers from 105 Institutes in 30 countries. Its overall dimensions are 161626 m3 with a total weight of approximately 10 000 t. The experiment consists of 18 different detector systems each with its own specific technology choice and design constraints, driven both by the physics requirements and the experimental conditions expected at LHC. The most stringent design constraint is to cope with the extreme particle multiplicity anticipated in central Pb-Pb collisions. The different subsystems were optimized to provide high-momentum resolution as well as excellent Particle Identification (PID) over a broad range in momentum, up to the highest multiplicities predicted for LHC. This will allow for comprehensive studies of hadrons, electrons, muons, and photons produced in the collision of heavy nuclei. Most detector systems are scheduled to be installed and ready for data taking by mid-2008 when the LHC is scheduled to start operation, with the exception of parts of the Photon Spectrometer (PHOS), Transition Radiation Detector (TRD) and Electro Magnetic Calorimeter (EMCal). These detectors will be completed for the high-luminosity ion run expected in 2010. This paper describes in detail the detector components as installed for the first data taking in the summer of 2008

Periodic structures on liquid-phase smectic A, nematic and isotropic free surfaces

The free boundary of smectic A (SmA), nematic and isotropic liquid phases were studied using a polarized optical microscope, an interferometric surface structure analyzer (ISSA), an atomic force microscope (AFM) and a scanning near-field optical microscope (SNOM). Images of the SmA phase free surface obtained by the polarized microscope and ISSA are in good correlation and show a well-known focal domain structure. The new periodic stripe structure was observed by scanning near-field optical microscopy on the surface of the smectic A, nematic and isotropic phases. The properties of this periodic structure are similar to the charged liquid helium surface and can be explained by nonlinear electrostatic instabilities previously described

Scientific program of DERICA — prospective accelerator and storage ring facility for radioactive ion beam research

Studies of radioactive ions (RIs) are the most thriving field of low-energy nuclear physics. In this paper, the concept and the scientific agenda of the prospective accelerator and storage ring facility for RI beam (RIB) research are proposed for a large-scale international project based at the Flerov Laboratory of Nuclear Reactions of the Joint Institute for Nuclear Research. The motivation for the new facility is discussed and its characteristics are briefly presented and shown to be comparable to those of advanced world centers, the so-called "RIB factories". In the project, the emphasis is made on studies with short-lived RIBs in storage rings. Aunique feature of the project is the possibility of studying electron-RI interactions in a collider experiment to determine the fundamental properties of nuclear matter, in particular, electromagnetic form factors of exotic nuclei

ALICE: Physics Performance Report, Volume II

ALICE is a general-purpose heavy-ion experiment designed to study the physics of strongly interacting matter and the quark\u2013gluon plasma in nucleus\u2013nucleus collisions at the LHC. It currently involves more than 900 physicists and senior engineers, from both the nuclear and high-energy physics sectors, from over 90 institutions in about 30 countries. The ALICE detector is designed to cope with the highest particle multiplicities above those anticipated for Pb\u2013Pb collisions (dNch/dy up to 8000) and it will be operational at the start-up of the LHC. In addition to heavy systems, the ALICE Collaboration will study collisions of lower-mass ions, which are a means of varying the energy density, and protons (both pp and pA), which primarily provide reference data for the nucleus\u2013nucleus collisions. In addition, the pp data will allow for a number of genuine pp physics studies. The detailed design of the different detector systems has been laid down in a number of Technical Design Reports issued between mid-1998 and the end of 2004. The experiment is currently under construction and will be ready for data taking with both proton and heavy-ion beams at the start-up of the LHC. Since the comprehensive information on detector and physics performance was last published in the ALICE Technical Proposal in 1996, the detector, as well as simulation, reconstruction and analysis software have undergone significant development. The Physics Performance Report (PPR) provides an updated and comprehensive summary of the performance of the various ALICE subsystems, including updates to the Technical Design Reports, as appropriate. The PPR is divided into two volumes. Volume I, published in 2004 (CERN/LHCC 2003-049, ALICE Collaboration 2004 J. Phys. G: Nucl. Part. Phys. 30 1517\u20131763), contains in four chapters a short theoretical overview and an extensive reference list concerning the physics topics of interest to ALICE, the experimental conditions at the LHC, a short summary and update of the subsystem designs, and a description of the offline framework and Monte Carlo event generators. The present volume, Volume II, contains the majority of the information relevant to the physics performance in proton\u2013proton, proton\u2013nucleus, and nucleus\u2013nucleus collisions. Following an introductory overview, Chapter 5 describes the combined detector performance and the event reconstruction procedures, based on detailed simulations of the individual subsystems. Chapter 6 describes the analysis and physics reach for a representative sample of physics observables, from global event characteristics to hard processes

ALICE Electromagnetic Calorimeter Technical Design Report

The ALICE Electromagnetic Calorimeter technical design is reported