Influence of Anodizing by Electro-Chemical Oxidation on Fatigue and Wear Resistance of the EV31A-T6 Cast Magnesium Alloy

In the last decades, several anodizing processes for Mg alloys have been proposed to achieve a good wear and corrosion resistance combination. In particular, Electro-Chemical Oxidation (ECO) showed an improved dense and compact anodized layer compared to other anodizing processes carried out above the dielectric breakdown voltage, such as Plasma Electrolytic Oxidation (PEO). However, the influence of the ECO treatment on the tribological behavior and cyclic mechanical performance of Mg alloys has not been investigated yet. This paper reports on the influence of ECO on dry sliding behavior (vs. 100Cr6 bearing steel (block-on-ring contact geometry)) and rotating bending fatigue performance of the rare earth (RE)-containing Mg alloy EV31A-T6, comparing it with both untreated EV31A-T6 and PEO-treated EV31A-T6, used as benchmarks. The ECO-treated alloy showed improved tribological behavior (critical load for coating failure one order of magnitude higher and coefficient of friction 40% lower than for PEO) and fatigue strength (no decrease for ECO-treated samples compared to the untreated alloy, while PEO-treated samples induced a 15% decrease) due to the increased compactness and lower defectivity of the anodized layer, induced by the minimization of destructive arc discharges during coating growth. In addition, the ECO treatment significantly improved wear resistance compared to the untreated alloy, avoiding, at the same time, the decrease in fatigue strength, which typically occurs after PEO. Therefore, the ECO process can be applied to improve wear resistance without decreasing the fatigue strength of high-performance components

Inverted loss engineering in functional material covered waveguides

Optical waveguides, covered with thin films, which transmittance can be controlled by external action, are widely used in various applications from optical modulators to saturable absorbers. It is natural to suggest that the waveguide losses will be proportional to the covering material absorption. We demonstrate that under certain conditions this simple assumption fails. Instead, we observe the reduction of the film material absorption can lead to an increase in the waveguide propagation losses. For this, we use a side polished fiber covered with a single-walled carbon nanotube thin film whose absorption is attenuated either due to saturable absorption or electrochemical gating. For the films thicker than 50 nm, we observe saturable absorption to turn into light induced absorption with nonmonotonic dependence on the incident power. With a numerical simulation and analytical approach, we identify that this nontrivial behavior comes from mode reshaping and predict required parameters for its observation.Comment: 7 pages, 3 figure

Crossover critical behavior of Ga1-xMnxAs

The critical behavior of Ga1-xMnxAs in a close vicinity of the Curie temperature was experimentally studied by using the thermal diffusivity measurements. Taking into account that the inverse of the thermal diffusivity has the same critical behavior as the specific heat, the critical exponent {\alpha} for the samples investigated has been determined. With approaching close to the critical temperature, the crossover from the mean-field-like to the Ising-like critical behavior has been observed. From the crossover behavior the values of the Ginzburg number and the exchange interaction length in Ga1-xMnxAs with different concentrations of Mn were determined.Comment: 17 pages, 5 figure

Chemical characterization and anti-inflammatory effect of rauvolfian, a pectic polysaccharide of Rauvolfia callus

The pectic polysaccharide named rauvolfian RS was obtained from the dried callus of Rauvolfia serpentina L. by extraction with 0.7% aqueous ammonium oxalate. Crude rauvolfian RS was purified using membrane ultrafiltration to yield the purified rauvolfian RSP in addition to glucan as admixture from the callus, with molecular weights 300 and 100-300 kD, respectively. A peroral pretreatment of mice with the crude and purified samples of rauvolfian (RS and RSP) was found to decrease colonic macroscopic scores, the total area of damage, and tissue myelope roxidase activity in colons as compared with a colitis group. RS and RSP were shown to stimulate production of mucus by colons of the colitis mice. RSP appeared to be an active constituent of the parent RS. The glucan failed to possess anti-inflammatory activity. © 2007 Pleiades Publishing, Ltd

Shock pressure induced by 0.44 [mu]m laser radiation on aluminum targets

Shock pressure generated in aluminum targets due to the interaction of 0.44 μm (3 ω of iodine laser) laser radiation has been studied. The laser intensity profile was smoothed using phase zone plates. Aluminum step targets were irradiated at an intensity I ≈ 1014 W/cm2. Shock velocity in the aluminum target was estimated by detecting the shock luminosity from the target rear using a streak camera to infer the shock pressure. Experimental results show a good agreement with the theoretical model based on the delocalized laser absorption approximation. In the present report, we explicitly discuss the importance of target thickness on the shock pressure scaling

Pectobacterium atrosepticum exopolysaccharides: Identification, molecular structure, formation under stress and in planta conditions

© The Author 2017. Published by Oxford University Press. All rights reserved. In the present study, we identified exopolysaccharides of the harmful phytopathogenic bacterium Pectobacterium atrosepticum SCRI1043 and characterized the molecular structure of these polymers. The synthesis of the target polysaccharides was shown to be induced under starvation conditions. Moreover, intensive accumulation of exopolysaccharides occurred during the colonization by bacteria of the xylem vessels of infected plants, where microorganisms formed specific 3D "multicellular" structures-bacterial emboli. Thus, the identified polymers are likely to be involved in the adaptation and virulence of bacteria of Pectobacterium genus

Ozone observations and a model of marine boundary layer photochemistry during SAGA 3

A major purpose of the third joint Soviet‐American Gases and Aerosols (SAGA 3) oceanographic cruise was to examine remote tropical marine O3 and photochemical cycles in detail. On leg 1, which took place between Hilo, Hawaii, and Pago‐Pago, American Samoa, in February and March 1990, shipboard measurements were made of O3, CO, CH4, nonmethane hydrocarbons (NMHC), NO, dimethyl sulfide (DMS), H2S, H2O2, organic peroxides, and total column O3. Postcruise analysis was performed for alkyl nitrates and a second set of nonmethane hydrocarbons. A latitudinal gradient in O3 was observed on SAGA 3, with O3 north of the intertropical convergence zone (ITCZ) at 15–20 parts per billion by volume (ppbv) and less than 12 ppbv south of the ITCZ but never ≤3 ppbv as observed on some previous equatorial Pacific cruises (Piotrowicz et al., 1986; Johnson et al., 1990). Total column O3 (230–250 Dobson units (DU)) measured from the Akademik Korolev was within 8% of the corresponding total ozone mapping spectrometer (TOMS) satellite observations and confirmed the equatorial Pacific as a low O3 region. In terms of number of constituents measured, SAGA 3 may be the most photochemically complete at‐sea experiment to date. A one‐dimensional photochemical model gives a self‐consistent picture of O3‐NO‐CO‐hydrocarbon interactions taking place during SAGA 3. At typical equatorial conditions, mean O3 is 10 ppbv with a 10–15% diurnal variation and maximum near sunrise. Measurements of O3, CO, CH4, NMHC, and H2O constrain model‐calculated OH to 9 × 105 cm−3 for 10 ppbv O3 at the equator. For DMS (300–400 parts per trillion by volume (pptv)) this OH abundance requires a sea‐to‐air flux of 6–8 × 109 cm−2 s−1, which is within the uncertainty range of the flux deduced from SAGA 3 measurements of DMS in seawater (Bates et al., this issue). The concentrations of alkyl nitrates on SAGA 3 (5–15 pptv total alkyl nitrates) were up to 6 times higher than expected from currently accepted kinetics, suggesting a largely continental source for these species. However, maxima in isopropyl nitrate and bromoform near the equator (Atlas et al., this issue) as well as for nitric oxide (Torres and Thompson, this issue) may signify photochemical and biological sources of these species

Global data on earthworm abundance, biomass, diversity and corresponding environmental properties

14 p.Earthworms are an important soil taxon as ecosystem engineers, providing a variety of crucial ecosystem functions and services. Little is known about their diversity and distribution at large spatial scales, despite the availability of considerable amounts of local-scale data. Earthworm diversity data, obtained from the primary literature or provided directly by authors, were collated with information on site locations, including coordinates, habitat cover, and soil properties. Datasets were required, at a minimum, to include abundance or biomass of earthworms at a site. Where possible, site-level species lists were included, as well as the abundance and biomass of individual species and ecological groups. This global dataset contains 10,840 sites, with 184 species, from 60 countries and all continents except Antarctica. The data were obtained from 182 published articles, published between 1973 and 2017, and 17 unpublished datasets. Amalgamating data into a single global database will assist researchers in investigating and answering a wide variety of pressing questions, for example, jointly assessing aboveground and belowground biodiversity distributions and drivers of biodiversity change

Global data on earthworm abundance, biomass, diversity and corresponding environmental properties

Publisher Copyright: © 2021, The Author(s).Earthworms are an important soil taxon as ecosystem engineers, providing a variety of crucial ecosystem functions and services. Little is known about their diversity and distribution at large spatial scales, despite the availability of considerable amounts of local-scale data. Earthworm diversity data, obtained from the primary literature or provided directly by authors, were collated with information on site locations, including coordinates, habitat cover, and soil properties. Datasets were required, at a minimum, to include abundance or biomass of earthworms at a site. Where possible, site-level species lists were included, as well as the abundance and biomass of individual species and ecological groups. This global dataset contains 10,840 sites, with 184 species, from 60 countries and all continents except Antarctica. The data were obtained from 182 published articles, published between 1973 and 2017, and 17 unpublished datasets. Amalgamating data into a single global database will assist researchers in investigating and answering a wide variety of pressing questions, for example, jointly assessing aboveground and belowground biodiversity distributions and drivers of biodiversity change.Peer reviewe