Limits for Monge-Kantorovich mass transport problems

In this paper we study the limit of Monge-Kantorovich mass transfer problems when the involved measures are supported in a small strip near the boundary of a bounded smooth domain, Ω. Given two absolutely continues measures (with respect to the surface measure) supported on the boundary ∂Ω, by performing a suitable extension of the measures to a strip of width ε near the boundary of the domain Ω we consider the mass transfer problem for the extensions. Then we study the limit as ε goes to zero of the Kantorovich potentials for the extensions and obtain that it coincides with a solution of the original mass transfer problem. Moreover we look for the possible approximations of these problems by solutions to equations involving the p-Laplacian for large values of p.Fil:Rossi, J.D. Universidad de Buenos Aires. Facultad de Ciencias Exactas y Naturales; Argentina

Refined asymptotics for the infinite heat equation with homogeneous Dirichlet boundary conditions

The nonnegative viscosity solutions to the infinite heat equation with homogeneous Dirichlet boundary conditions are shown to converge as time increases to infinity to a uniquely determined limit after a suitable time rescaling. The proof relies on the half-relaxed limits technique as well as interior positivity estimates and boundary estimates. The expansion of the support is also studied

Diffeomorphic approximation of Sobolev homeomorphisms

Every homeomorphism h : X -> Y between planar open sets that belongs to the Sobolev class W^{1,p}(X,Y), 1<p<\infty, can be approximated in the Sobolev norm by diffeomorphisms.Comment: 21 pages, 5 figure

Field Measurements of Terrestrial and Martian Dust Devils

Surface-based measurements of terrestrial and martian dust devils/convective vortices provided from mobile and stationary platforms are discussed. Imaging of terrestrial dust devils has quantified their rotational and vertical wind speeds, translation speeds, dimensions, dust load, and frequency of occurrence. Imaging of martian dust devils has provided translation speeds and constraints on dimensions, but only limited constraints on vertical motion within a vortex. The longer mission durations on Mars afforded by long operating robotic landers and rovers have provided statistical quantification of vortex occurrence (time-of-sol, and recently seasonal) that has until recently not been a primary outcome of more temporally limited terrestrial dust devil measurement campaigns. Terrestrial measurement campaigns have included a more extensive range of measured vortex parameters (pressure, wind, morphology, etc.) than have martian opportunities, with electric field and direct measure of dust abundance not yet obtained on Mars. No martian robotic mission has yet provided contemporaneous high frequency wind and pressure measurements. Comparison of measured terrestrial and martian dust devil characteristics suggests that martian dust devils are larger and possess faster maximum rotational wind speeds, that the absolute magnitude of the pressure deficit within a terrestrial dust devil is an order of magnitude greater than a martian dust devil, and that the time-of-day variation in vortex frequency is similar. Recent terrestrial investigations have demonstrated the presence of diagnostic dust devil signals within seismic and infrasound measurements; an upcoming Mars robotic mission will obtain similar measurement types

Measurement of the B0-anti-B0-Oscillation Frequency with Inclusive Dilepton Events

The $B^0$-$\bar B^0$ oscillation frequency has been measured with a sample of 23 million \B\bar B pairs collected with the BABAR detector at the PEP-II asymmetric B Factory at SLAC. In this sample, we select events in which both B mesons decay semileptonically and use the charge of the leptons to identify the flavor of each B meson. A simultaneous fit to the decay time difference distributions for opposite- and same-sign dilepton events gives $\Delta m_d = 0.493 \pm 0.012{(stat)}\pm 0.009{(syst)}$ ps$^{-1}$.Comment: 7 pages, 1 figure, submitted to Physical Review Letter

A search for the decay B+→K+ννˉB^+ \to K^+ \nu \bar{\nu}

We search for the rare flavor-changing neutral-current decay $B^+ \to K^+ \nu \bar{\nu}$ in a data sample of 82 fb$^{-1}$ collected with the {\sl BABAR} detector at the PEP-II B-factory. Signal events are selected by examining the properties of the system recoiling against either a reconstructed hadronic or semileptonic charged-B decay. Using these two independent samples we obtain a combined limit of ${\mathcal B}(B^+ \to K^+ \nu \bar{\nu})<5.2 \times 10^{-5}$ at the 90% confidence level. In addition, by selecting for pions rather than kaons, we obtain a limit of ${\mathcal B}(B^+ \to \pi^+ \nu \bar{\nu})<1.0 \times 10^{-4}$ using only the hadronic B reconstruction method.Comment: 7 pages, 8 postscript figures, submitted to Phys. Rev. Let

High-reflectivity broadband distributed Bragg reflector lattice matched to ZnTe

We report on the realization of a high quality distributed Bragg reflector with both high and low refractive index layers lattice matched to ZnTe. Our structure is grown by molecular beam epitaxy and is based on binary compounds only. The high refractive index layer is made of ZnTe, while the low index material is made of a short period triple superlattice containing MgSe, MgTe, and ZnTe. The high refractive index step of Delta_n=0.5 in the structure results in a broad stopband and the reflectivity coefficient exceeding 99% for only 15 Bragg pairs.Comment: 4 pages, 3 figure

Measurement of the CP-Violating Asymmetry Amplitude sin2β\beta

We present results on time-dependent CP-violating asymmetries in neutral B decays to several CP eigenstates. The measurements use a data sample of about 88 million Y(4S) --> B Bbar decays collected between 1999 and 2002 with the BABAR detector at the PEP-II asymmetric-energy B Factory at SLAC. We study events in which one neutral B meson is fully reconstructed in a final state containing a charmonium meson and the other B meson is determined to be either a B0 or B0bar from its decay products. The amplitude of the CP-violating asymmetry, which in the Standard Model is proportional to sin2beta, is derived from the decay-time distributions in such events. We measure sin2beta = 0.741 +/- 0.067 (stat) +/- 0.033 (syst) and |lambda| = 0.948 +/- 0.051 (stat) +/- 0.017 (syst). The magnitude of lambda is consistent with unity, in agreement with the Standard Model expectation of no direct CP violation in these modes

Measurement of the muon flux from 400 GeV/c protons interacting in a thick molybdenum/tungsten target

The SHiP experiment is proposed to search for very weakly interacting particles beyond the Standard Model which are produced in a 400 GeV/c proton beam dump at the CERN SPS. About 1011 muons per spill will be produced in the dump. To design the experiment such that the muon-induced background is minimized, a precise knowledge of the muon spectrum is required. To validate the muon flux generated by our Pythia and GEANT4 based Monte Carlo simulation (FairShip), we have measured the muon flux emanating from a SHiP-like target at the SPS. This target, consisting of 13 interaction lengths of slabs of molybdenum and tungsten, followed by a 2.4 m iron hadron absorber was placed in the H4 400 GeV/c proton beam line. To identify muons and to measure the momentum spectrum, a spectrometer instrumented with drift tubes and a muon tagger were used. During a 3-week period a dataset for analysis corresponding to (3.27±0.07) × 1011 protons on target was recorded. This amounts to approximatively 1% of a SHiP spill

Track reconstruction and matching between emulsion and silicon pixel detectors for the SHiP-charm experiment

In July 2018 an optimization run for the proposed charm cross section measurement for SHiP was performed at the CERN SPS. A heavy, moving target instrumented with nuclear emulsion films followed by a silicon pixel tracker was installed in front of the Goliath magnet at the H4 proton beam-line. Behind the magnet, scintillating-fibre, drift-tube and RPC detectors were placed. The purpose of this run was to validate the measurement's feasibility, to develop the required analysis tools and fine-tune the detector layout. In this paper, we present the track reconstruction in the pixel tracker and the track matching with the moving emulsion detector. The pixel detector performed as expected and it is shown that, after proper alignment, a vertex matching rate of 87% is achieved