Phylogenetic definitions for 25 higher-level clade names of birds

Knowledge of the higher-level phylogenetic relationships of birds has grown substantially during the past two decades due to the application of genomic data. However, the nomenclature of higher-level taxa has not become more stable, due to the lack of regulation of taxon names above the level of superfamily by the ICZN, and the usage of rank-based nomenclature, which is not tied to clades in a phylogeny. Lack of regulation and the instability of rank-based nomenclature impede effective communication among systematists. Here we review support for higher-level avian clades using a set of 10 phylogenomic data sets, and identify clades that are supported by congruency of at least four of these. We provide formal definitions of the names of these clades based on the rules of the recently published PhyloCode. The names of 25 clades are here defined using minimum-crown-clade (n = 23), minimum-clade (n = 1) and maximum-crown-clade (n = 1) definitions. Four new names are introduced here: Dinocrypturi, Pteroclimesites, Musophagotides and Pelecanes. We also review diagnostic apomorphies of the relevant clades, and identify known synonyms and homonyms. By establishing a formal link between higher-level taxon names and well-supported phylogenetic hypotheses, our phylogenetic definitions will provide a solid basis for the stabilization of avian higher-level nomenclature

Open ended microwave oven for flip-chip assembly

A novel open-ended waveguide cavity resonator for the microwave curing of bumps, underfills and encapsulants is described. The open oven has the potential to provide fast alignment of devices during flip-chip assembly, direct chip attach, surface mount assembly or wafer-scale level packaging. The prototype microwave oven was designed to operate at X-band for ease of testing, although a higher frequency version is planned. The device described in the paper takes the form of a waveguide cavity resonator. It is approximately square in cross-section and is filled with a low-loss dielectric with a relative permittivity of 6. It is excited by end-fed probes in order to couple power preferentially into the TM3,3,k mode with the object of forming nine 'hot-spots' in the open end. Low power tests using heat sensitive film demonstrate clearly that selective heating in multiple locations in the open end of the oven is achievabl

Ion Thermal Decoupling and Species Separation in Shock-Driven Implosions

Anomalous reduction of the fusion yields by 50% and anomalous scaling of the burn-averaged ion temperatures with the ion-species fraction has been observed for the first time in D[superscript 3]He-filled shock-driven inertial confinement fusion implosions. Two ion kinetic mechanisms are used to explain the anomalous observations: thermal decoupling of the D and [superscript 3]He populations and diffusive species separation. The observed insensitivity of ion temperature to a varying deuterium fraction is shown to be a signature of ion thermal decoupling in shock-heated plasmas. The burn-averaged deuterium fraction calculated from the experimental data demonstrates a reduction in the average core deuterium density, as predicted by simulations that use a diffusion model. Accounting for each of these effects in simulations reproduces the observed yield trends.United States. National Nuclear Security Administration (Grant DE-NA0001857)University of Rochester. Fusion Science Center (Grant 415023-G)National Laser User’s Facility (Grant DE-NA0002035)University of Rochester. Laboratory for Laser Energetics (Grant 415935-G)Lawrence Livermore National Laboratory (Grant B600100

Exploration of the Transition from the Hydrodynamiclike to the Strongly Kinetic Regime in Shock-Driven Implosions

Clear evidence of the transition from hydrodynamiclike to strongly kinetic shock-driven implosions is, for the first time, revealed and quantitatively assessed. Implosions with a range of initial equimolar D[superscript 3]He gas densities show that as the density is decreased, hydrodynamic simulations strongly diverge from and increasingly overpredict the observed nuclear yields, from a factor of ∼2 at 3.1  mg/cm[superscript 3] to a factor of 100 at 0.14  mg/cm[superscript 3]. (The corresponding Knudsen number, the ratio of ion mean-free path to minimum shell radius, varied from 0.3 to 9; similarly, the ratio of fusion burn duration to ion diffusion time, another figure of merit of kinetic effects, varied from 0.3 to 14.) This result is shown to be unrelated to the effects of hydrodynamic mix. As a first step to garner insight into this transition, a reduced ion kinetic (RIK) model that includes gradient-diffusion and loss-term approximations to several transport processes was implemented within the framework of a one-dimensional radiation-transport code. After empirical calibration, the RIK simulations reproduce the observed yield trends, largely as a result of ion diffusion and the depletion of the reacting tail ions.United States. Dept. of Energy (Grant DE-NA0001857)United States. Dept. of Energy (Grant DE-FC52-08NA28752)University of Rochester. Fusion Science Center (5-24431)National Laser User’s Facility (DE-NA0002035)University of Rochester. Laboratory for Laser Energetics (415935-G)Lawrence Livermore National Laboratory (B597367

A review of photovoltaic module technologies for increased performance in tropical climate

The global adoption and use of photovoltaic modules (PVMs) as the main source of energy is the key to realising the UN Millennium Development Goals on Green Energy. The technology – projected to contribute about 20% of world energy supply by 2050, over 60% by 2100 and leading to 50% reduction in global CO2 emissions – is threatened by its poor performance in tropical climate. Such performance discourages its regional acceptance. The magnitude of crucial module performance influencing factors (cell temperature, wind speed and relative humidity) reach critical values of 90 °C, 0.2 m/s and 85%, respectively in tropical climates which negatively impact module performance indices which include power output (PO), power conversion efficiency (PCE) and energy payback time (EPBT). This investigation reviews PVM technologies which include cell, contact and interconnection technologies. It identifies critical technology route(s) with potential to increase operational reliability of PVMs in the tropics when adopted. The cell performance is measured by PO, PCE and EPBT while contacts and interconnections performance is measured by the degree of recombination, shading losses and also the rate of thermo-mechanical degradation. It is found that the mono-crystalline cell has the best PCE of 25% while the Cadmium Telluride (CdTe) cell has the lowest EPBT of 8-months. Results show that the poly-crystalline cell has the largest market share amounting to 54%. The CdTe cell exhibits 0% drop in PCE at high-temperatures and low irradiance operations – demonstrating least affected PO by the conditions. Further results establish that back contacts and back-to-back interconnection technologies produce the least recombination losses and demonstrate absence of shading in addition to possessing longest interconnection fatigue life. Based on these findings, the authors propose a PVM comprising CdTe cell, back contacts and back-to-back interconnection technologies as the technology with latent capacity to produce improved performance in tropical climates

Effects of antiplatelet therapy on stroke risk by brain imaging features of intracerebral haemorrhage and cerebral small vessel diseases: subgroup analyses of the RESTART randomised, open-label trial

Background Findings from the RESTART trial suggest that starting antiplatelet therapy might reduce the risk of recurrent symptomatic intracerebral haemorrhage compared with avoiding antiplatelet therapy. Brain imaging features of intracerebral haemorrhage and cerebral small vessel diseases (such as cerebral microbleeds) are associated with greater risks of recurrent intracerebral haemorrhage. We did subgroup analyses of the RESTART trial to explore whether these brain imaging features modify the effects of antiplatelet therapy

Initial antibodies binding to HIV-1 gp41 in acutely infected subjects are polyreactive and highly mutated

Many HIV-1 envelope-reactive antibodies shortly after HIV-1 transmission may arise from crow-reactive memory B cells previously stimulated by non-HIV-1 host or microbial antigen

A population-based lifestyle intervention to promote healthy weight and physical activity in people with cardiac disease: The PANACHE (Physical Activity, Nutrition And Cardiac HEalth) study protocol

<p>Abstract</p> <p>Background</p> <p>Maintaining a healthy weight and undertaking regular physical activity are important for the secondary prevention of cardiovascular disease (CVD). However, many people with CVD are overweight and insufficiently active. In addition, in Australia only 20-30% of people requiring cardiac rehabilitation (CR) for CVD actually attend. To improve outcomes of and access to CR the efficacy, effectiveness and cost-effectiveness of alternative approaches to CR need to be established.</p> <p>This research will determine the efficacy of a telephone-delivered lifestyle intervention, promoting healthy weight and physical activity, in people with CVD in urban and rural settings. The control group will also act as a replication study of a previously proven physical activity intervention, to establish whether those findings can be repeated in different urban and rural locations. The cost-effectiveness and acceptability of the intervention to CR staff and participants will also be determined.</p> <p>Methods/Design</p> <p>This study is a randomised controlled trial. People referred for CR at two urban and two rural Australian hospitals will be invited to participate. The intervention (healthy weight) group will participate in four telephone delivered behavioural coaching and goal setting sessions over eight weeks. The coaching sessions will be on weight, nutrition and physical activity and will be supported by written materials, a pedometer and two follow-up booster telephone calls. The control (physical activity) group will participate in a six week intervention previously shown to increase physical activity, consisting of two telephone delivered behavioural coaching and goal setting sessions on physical activity, supported by written materials, a pedometer and two booster phone calls. Data will be collected at baseline, eight weeks and eight months for the intervention group (baseline, six weeks and six months for the control group). The primary outcome is weight change. Secondary outcomes include physical activity, sedentary time and nutrition habits. Costs will be compared with outcomes to determine the relative cost-effectiveness of the healthy weight and physical activity interventions.</p> <p>Discussion</p> <p>This study addresses a significant gap in public health practice by providing evidence for the efficacy and cost-effectiveness of a low cost, low contact, high reach intervention promoting healthy weight and physical activity among people with CVD in rural and urban areas in Australia. The replication arm of the study, undertaken by the control group, will demonstrate whether the findings of the previously proven physical activity intervention can be generalised to new settings. This population-based approach could potentially improve access to and outcomes of secondary prevention programs, particularly for rural or disadvantaged communities.</p> <p>Trial Registration</p> <p>ACTRN12610000102077</p

Taxonomy based on science is necessary for global conservation

Peer reviewe