Nonlinear waves on the surface of a dielectric liquid in a strong tangential electric field

The nonlinear dynamics of the free surface of an ideal dielectric liquid in a strong electric field is studied. The equation for the evolution of surface electrohydrodynamic waves is derived in the approximation of small surface-slope angles. It is established that the equation can be solved for liquids with sufficiently high values of the permittivity. This makes it possible to describe the interaction of the counter-propagating waves.Comment: 10 pages. accepted to Phys. Lett.

Model Systems of Human Intestinal Flora, to Set Acceptable Daily Intakes of Antimicrobial Residues

The veterinary use of antimicrobial drugs in food producing animals may result in residues in food, that might modify the consumer gut flora. This review compares three model systems that maintain a complex flora of human origin: (i) human flora associated (HFA) continuous flow cultures in chemostats, (ii) HFA mice, and (iii) human volunteers. The "No Microbial Effect Level" of an antibiotic on human flora, measured in one of these models, is used to set the accept¬able daily intake (ADI) for human consumers. Human volunteers trials are most relevant to set microbio¬log¬ical ADI, and may be considered as the "gold standard". However, human trials are very expensive and unethical. HFA chemostats are controlled systems, but tetracycline ADI calculated from a chemostat study is far above result of a human study. HFA mice studies are less expensive and better controlled than human trials. The tetracycline ADI derived from HFA mice studies is close to the ADI directly obtained in human volunteers

A Mechanistic Study of Carbonic Anhydrase Enhanced Calcite Dissolution

Carbonic anhydrase (CA) has been shown to promote calcite dissolution (Liu, 2001, https://doi.org/10.1111/j.1755-6724.2001.tb00531.x; Subhas et al., 2017, https://doi.org/10.1073/pnas.1703604114), and understanding the catalytic mechanism will facilitate our understanding of the oceanic alkalinity cycle. We use atomic force microscopy (AFM) to directly observe calcite dissolution in CA‐bearing solution. CA is found to etch the calcite surface only when in extreme proximity (~1 nm) to the mineral. Subsequently, the CA‐induced etch pits create step edges that serve as active dissolution sites. The possible catalytic mechanism is through the adsorption of CA on the calcite surface, followed by proton transfer from the CA catalytic center to the calcite surface during CO2 hydration. This study shows that the accessibility of CA to particulate inorganic carbon (PIC) in the ocean is critical in properly estimating oceanic CaCO3 and alkalinity cycles

A Mechanistic Study of Carbonic Anhydrase Enhanced Calcite Dissolution

Carbonic anhydrase (CA) has been shown to promote calcite dissolution (Liu, 2001, https://doi.org/10.1111/j.1755-6724.2001.tb00531.x; Subhas et al., 2017, https://doi.org/10.1073/pnas.1703604114), and understanding the catalytic mechanism will facilitate our understanding of the oceanic alkalinity cycle. We use atomic force microscopy (AFM) to directly observe calcite dissolution in CA‐bearing solution. CA is found to etch the calcite surface only when in extreme proximity (~1 nm) to the mineral. Subsequently, the CA‐induced etch pits create step edges that serve as active dissolution sites. The possible catalytic mechanism is through the adsorption of CA on the calcite surface, followed by proton transfer from the CA catalytic center to the calcite surface during CO2 hydration. This study shows that the accessibility of CA to particulate inorganic carbon (PIC) in the ocean is critical in properly estimating oceanic CaCO3 and alkalinity cycles

An Atomic Force Microscopy Study of Calcite Dissolution in Seawater

We present the first examination of calcite dissolution in seawater using Atomic Force Microscopy (AFM). We quantify step retreat velocity and etch pit density to compare dissolution in seawater to low ionic strength water, and also to compare calcite dissolution under AFM conditions to those conducted in bulk solution experiments (e.g. Subhas et al., 2015, Dong et al., 2018). Bulk dissolution rates and step retreat velocities are slower at high and mid-saturation state (Ω) values and become comparable to low ionic strength water rates at low Ω. The onset of defect-assisted etch pit formation in seawater is at Ω ∼ 0.85 (defined as Ω_(critical)), higher than in low ionic strength water (Ω ∼ 0.54). There is an abrupt increase in etch pit density (from ∼10⁶ cm⁻² to ∼10⁸ cm⁻²) occurring when Ω falls below 0.7 in seawater, compared to Ω ∼ 0.1 in low ionic strength water, suggesting a transition from defect-assisted dissolution to homogeneous dissolution much closer to equilibrium in seawater. The step retreat velocity (v) does not scale linearly with undersaturation (1-Ω) across an Ω range of 0.4 to 0.9 in seawater, potentially indicating a high order correlation between kink rate and Ω for non-Kossel crystals such as calcite, or surface complexation processes during calcite dissolution in seawater

An Atomic Force Microscopy Study of Calcite Dissolution in Seawater

We present the first examination of calcite dissolution in seawater using Atomic Force Microscopy (AFM). We quantify step retreat velocity and etch pit density to compare dissolution in seawater to low ionic strength water, and also to compare calcite dissolution under AFM conditions to those conducted in bulk solution experiments (e.g. Subhas et al., 2015, Dong et al., 2018). Bulk dissolution rates and step retreat velocities are slower at high and mid-saturation state (Ω) values and become comparable to low ionic strength water rates at low Ω. The onset of defect-assisted etch pit formation in seawater is at Ω ∼ 0.85 (defined as Ω_(critical)), higher than in low ionic strength water (Ω ∼ 0.54). There is an abrupt increase in etch pit density (from ∼10⁶ cm⁻² to ∼10⁸ cm⁻²) occurring when Ω falls below 0.7 in seawater, compared to Ω ∼ 0.1 in low ionic strength water, suggesting a transition from defect-assisted dissolution to homogeneous dissolution much closer to equilibrium in seawater. The step retreat velocity (v) does not scale linearly with undersaturation (1-Ω) across an Ω range of 0.4 to 0.9 in seawater, potentially indicating a high order correlation between kink rate and Ω for non-Kossel crystals such as calcite, or surface complexation processes during calcite dissolution in seawater

Early pyloric stenosis: a case control study

Pyloric stenosis (PS) is rare in the first 2 weeks of life, often leading to delays in diagnosis and treatment. We conducted a case control study to delineate the characteristics of patients with early PS (EPS). In addition, we tested the hypothesis that patients with EPS present with a smaller pylorus than older patients. A database of all patients presenting with PS to a children’s hospital over a 5-year period (2002–2006) was obtained. Each patient admitted during the first 2 weeks of life (subject) was matched to a patient admitted after 4 weeks of age (control), with the same gender, electrolyte status, and treating surgeon. A single pediatric radiologist, blinded to patient age, reviewed all available ultrasounds retrospectively. Demographic, clinical, diagnostic, therapeutic, and outcome data were compared. During the study period, 278 pyloromyotomies were performed for PS. Sixteen patients (5.8%) presented with EPS between 2 and 14 days of life. EPS patients had a higher prevalence of positive family history (31 vs. 0%, P = 0.043), and breast milk feeding (75 vs. 31%, P = 0.045). Sonographic measurements showed a pylorus that was of significantly less length (17.1 ± 0.6 vs. 20.5 ± 0.9 mm, P = 0.006) and muscle thickness (3.5 ± 0.2 vs. 4.9 ± 0.2 mm, P < 0.001) in patients with EPS. Hospital stay was significantly longer for EPS patients (4.3 ± 0.9 vs. 2.0 ± 0.1 days, P = 0.19) Babies presenting with EPS are more likely to be breast fed and to have a positive family history. EPS is associated with a longer hospital stay. Use of sonographic diagnostic measurements specific to this age group may prevent delays in diagnosis and treatment, and improve outcomes

Nano-indentation of a room-temperature ionic liquid film on silica: a computational experiment

We investigate the structure of the [bmim][Tf2N]/silica interface by simulating the indentation of a thin (4 nm) [bmim][Tf2N] film by a hard nanometric tip. The ionic liquid/silica interface is represented in atomistic detail, while the tip is modelled by a spherical mesoscopic particle interacting via an effective short-range potential. Plots of the normal force (Fz) on the tip as a function of its distance from the silica surface highlight the effect of weak layering in the ionic liquid structure, as well as the progressive loss of fluidity in approaching the silica surface. The simulation results for Fz are in near-quantitative agreement with new AFM data measured on the same [bmim][Tf2N]/silica interface at comparable thermodynamic conditions.Comment: 24 pages, including 8 fig

Pathways of Association from Stress to Obesity in Early Childhood

Peer Reviewedhttps://deepblue.lib.umich.edu/bitstream/2027.42/144591/1/oby22155_am.pdfhttps://deepblue.lib.umich.edu/bitstream/2027.42/144591/2/oby22155.pd

Scoping prediction of re-radiated ground-borne noise and vibration near high speed rail lines with variable soils

This paper outlines a vibration prediction tool, ScopeRail, capable of predicting in-door noise and vibration, within structures in close proximity to high speed railway lines. The tool is designed to rapidly predict vibration levels over large track distances, while using historical soil information to increase accuracy. Model results are compared to an alternative, commonly used, scoping model and it is found that ScopeRail offers higher accuracy predictions. This increased accuracy can potentially reduce the cost of vibration environmental impact assessments for new high speed rail lines. To develop the tool, a three-dimensional finite element model is first outlined capable of simulating vibration generation and propagation from high speed rail lines. A vast array of model permutations are computed to assess the effect of each input parameter on absolute ground vibration levels. These relations are analysed using a machine learning approach, resulting in a model that can instantly predict ground vibration levels in the presence of different train speeds and soil profiles. Then a collection of empirical factors are coupled with the model to allow for the prediction of structural vibration and in-door noise in buildings located near high speed lines. Additional factors are also used to enable the prediction of vibrations in the presence of abatement measures (e.g. ballast mats and floating slab tracks) and additional excitation mechanisms (e.g. wheelflats and switches/crossings)