443 research outputs found
Measurement And Modeling Of Short Copper Cables For Ultra-wideband Communication
High-speed communication using the copper network, originally installed for telephony, is one of the dominant Internet access techniques. Several variants of a technology referred to as digital subscriber line (DSL) have been developed, standardized and installed during the last two decades. Essentially, DSL achieves high rates by exploiting wide bands of the copper cable channel. The shorter the cable, the wider the band that can be used efficiently for communication. Current DSL standards foresee the use of bands up to 30MHz. Cable properties have been studied by means of measurements, characterization and modeling up to frequencies of 30MHz. Recent investigations have shown that it is feasible both from technical and from economical point of view to exploit very short cables (up to 200m) even further and use bands above 30MHz. A prerequisite for further evaluation and the design of such ultra-wideband copper (UWBC) systems is the extension of existing cable models to higher frequencies. This paper presents wideband measurement results of insertion loss and crosstalk coupling in a 10-pair cable of various length values for frequencies up to 200MHz. We compare the results with extrapolations of cable models that are established in the 30MHz-range.6390Chen, W.Y., (1998) DSL: Simulation Techniques and Standards Development for Digital Subscriber Line Systems, , Macmillan Technical Publishing, ISBN 1-57870-017-5G.selt: Updated issues list for G.selt (2004) ITU-T Temporary Document SS U09, , ITU-TAsymmetric digital subscriber line (ADSL) transceivers (1999) ITU Recommendation G.992.1, , ITU-T, JuneAsymmetric digital subscriber line (ADSL) transceivers (1999) ITU Recommendation G.992.2, , ITU-T, JuneAsymmetric digital subscriber line (ADSL) extended bandwidth (ADSL2+) (2005) ITU Recommendation G.992.5, , ITU-TStarr, T., Cioffi, J.M., Silverman, P., (1998) Understanding Digital Subscriber Line Technology, , Prentice Hall, Englewood CliffsDedieu, H., The copper channel - Loop charactersitics and models (2005) Fundamentals of DSL Technology, , ch. ISBN 0849319137, AUERBACHVan Der Brink, R.F.M., (1998) Cable Reference Models for Simulating Metallic Access Networks, , Permanent Document TM6(97), ETSI STC TM6, Luleå, Sweden, JunePaul, C.R., (1994) Analysis of Multiconductor Transmission Lines, , Wiley, ISBN 0-471-02080-XCook, J.W., (1996) Parametric Modelling of Twisted Pair Cables for VDSL, , Temporary Document TD22, ETSI STC TM6, Vienna, Austria, MarVan Der Brink, R.F.M., (1997) Measurements and Models on Dutch Cables, , Temporary Document TD15, ETSI STC TM6, Tel Aviv, Israel, MarPollakowski, M., (1996) DTAG Cables Transmission Characteristics, , Temporary Document TD40, ETSI STC TM6, Vienna, Austria, MarPythoud, F., (1998) Model of Swiss Access Network Cables, , Temporary Document TD48, ETSI STC TM6, Madrid, Spain, JanHeylen, L., Musson, J., (1999) Cable Models Predict Physically Impossible Behavior in Time Domain, , Temporary Document TD08, ETSI STC TM6, Amsterdam, Netherlands, NovMusson, J., (1998) Maximum Likelihood Estimation of the Primary Parameters of Twisted Pair Cables, , Temporary Document TD06, ETSI STC TM6, Madrid, Spain, SeptBoets, P., Zekri, M., Van Biesen, L., Bostoen, T., Pollet, T., On the identification of cables for metallic access networks (2001) 18th IEEE Instrumentation and Measurement Technology Conference IMTC2001, 2, pp. 1348-1353. , Budapest, Hungary, MayBostoen, T., Boets, P., Zekri, M., Van Biesen, L., Pollet, T., Rabijns, D., Estimation of the transfer function of the access network by means of one-port scattering parameter measurements at the central office (2002) IEEE Journal on Selected Areas in Communication, 20, pp. 936-948. , JuneVery-high-bit-rate Digital Subscriber Line (VDSL) metallic interface part 1: Functional requirement and common specification (2001) T1E1.4/2000-009R3, , ANSI T1E1.4, FebVan Der Brink, R.F.M., (2001) Laboratory Performance Tests for XDSL Systems, , Permanent Document TM6(98)10, ETSI STC TM6, Sophia Antipolis, France, FebValenti, C., NEXT and FEXT models for twisted-pair North American loop plant (2002) IEEE Journal on Selected Areas in Communication, 20, pp. 893-900. , JuneNedev, N.H., McLaughlin, S., Cook, J.W., Wideband UTP cable measurements and modelling for MIMO systems (2004) Proc. European Signal Processing Conf. EUSIPCO 2004, , (Vienna, Austria), SeptMagesacher, T., Henkel, W., Tauböck, G., Nordström, T., Cable measurements supporting xDSL technologies (2002) Journal E&i Elektrotechnik und Informationstechnik, 199, pp. 37-43. , FebMagesacher, T., Ödling, P., Börjesson, P.O., Henkel, W., Nordström, T., Zukunft, R., Haar, S., On the capacity of the copper cable channel using the common mode (2002) Proc. IEEE Global Telecommun. Conf. GLOBECOM 2002, , (Taipei, Taiwan), NovTomita, N., Ohmura, M., Low-frequency crosstalk loss characteristics of balanced cables (1989) Electron. Commun. Japan, Part 1, 72 (3), pp. 95-105Goedbloed, J.J., Aspects of EMC at the equipment level (1997) Proc. 12th Intl. Symp. Electromagn. Compat., pp. 23-38. , (Zurich, Switzerland), FebWerner, J.J., The HDSL environment (1991) IEEE Journal on Selected Areas in Communication, 9, pp. 785-800. , AugConte, R.A., A crosstalk model for balanced digital transmission in multipair cables (1986) AT&T Tech. J., 65, pp. 41-59. , May-JunSchutt-Aine, J.E., High-frequency characterization of twisted-pair cables (2001) IEEE Trans. on Commun., 49, pp. 598-601. , AprGresh, P.A., Physical and transmission characteristics of customer loop plant (1969) The Bell System Technical Journal, 48, pp. 3337-3385. , DecManhire, L.M., Physical and transmission characteristics of customer loop plant (1978) The Bell System Technical Journal, 57, pp. 35-39. , JanPierce, S.B., Crosstalk in twisted pair circuits (1986) Proc. Intl. Wire and Cable Symp., pp. 349-354Fung, A., Lee, L.S., Falconer, D.D., A facility for near end crosstalk measurements on ISDN subscriber loops (1989) Proc. IEEE Global Telecommun. Conf, , paper 54.
Developmental Symbiosis Facilitates The Multiple Origins Of Herbivory
Developmental bias toward particular evolutionary trajectories can be facilitated through symbiosis. Organisms are holobionts, consisting of zygote‐derived cells and a consortia of microbes, and the development, physiology, and immunity of animals are properties of complex interactions between the zygote‐derived cells and microbial symbionts. Such symbionts can be agents of developmental plasticity, allowing an organism to develop in particular directions. This plasticity can lead to genetic assimilation either through the incorporation of microbial genes into host genomes or through the direct maternal transmission of the microbes. Such plasticity can lead to niche construction, enabling the microbes to remodel host anatomy and/or physiology. In this article, I will focus on the ability of symbionts to bias development toward the evolution of herbivory. I will posit that the behavioral and morphological manifestations of herbivorous phenotypes must be preceded by the successful establishment of a community of symbiotic microbes that can digest cell walls and detoxify plant poisons. The ability of holobionts to digest plant materials can range from being a plastic trait, dependent on the transient incorporation of environmental microbes, to becoming a heritable trait of the holobiont organism, transmitted through the maternal propagation of symbionts or their genes
Hexagonal Si-Ge Class of Semiconducting Alloys Prepared Using Pressure and Temperature
Multi-anvil and laser-heated diamond anvil methods have been used to subject Ge and Si mixtures to pressures and temperatures of between 12 and 17 GPa and 1500–1800 K, respectively. Synchrotron angle dispersive X-ray diffraction, precession electron diffraction and chemical analysis using electron microscopy, reveal recovery atambient pressure of hexagonal Ge-Si solid solutions (P6/mmc). Taken together, the multi-anvil and diamond anvil results reveal that hexagonal solid solutions can be preparedfor all Ge-Si compositions. This hexagonal class of solid solutions constitutes a significant expansion of the bulk Ge-Sisolid solution family, and is of interest for optoelectronic applications
Hierarchy Theory of Evolution and the Extended Evolutionary Synthesis: Some Epistemic Bridges, Some Conceptual Rifts
Contemporary evolutionary biology comprises a plural landscape of multiple co-existent conceptual frameworks and strenuous voices that disagree on the nature and scope of evolutionary theory. Since the mid-eighties, some of these conceptual frameworks have denounced the ontologies of the Modern Synthesis and of the updated Standard Theory of Evolution as unfinished or even flawed. In this paper, we analyze and compare two of those conceptual frameworks, namely Niles Eldredge’s Hierarchy Theory of Evolution (with its extended ontology of evolutionary entities) and the Extended Evolutionary Synthesis (with its proposal of an extended ontology of evolutionary processes), in an attempt to map some epistemic bridges (e.g. compatible views of causation; niche construction) and some conceptual rifts (e.g. extra-genetic inheritance; different perspectives on macroevolution; contrasting standpoints held in the “externalism–internalism” debate) that exist between them. This paper seeks to encourage theoretical, philosophical and historiographical discussions about pluralism or the possible unification of contemporary evolutionary biology
Inherited biotic protection in a Neotropical pioneer plant
Chelonanthus alatus is a bat-pollinated, pioneer Gentianaceae that clusters in patches where still-standing, dried-out stems are interspersed among live individuals. Flowers bear circum-floral nectaries (CFNs) that are attractive to ants, and seed dispersal is both barochorous and anemochorous. Although, in this study, live individuals never sheltered ant colonies, dried-out hollow stems - that can remain standing for 2 years - did. Workers from species nesting in dried-out stems as well as from ground-nesting species exploited the CFNs of live C. alatus individuals in the same patches during the daytime, but were absent at night (when bat pollination occurs) on 60.5% of the plants. By visiting the CFNs, the ants indirectly protect the flowers - but not the plant foliage - from herbivorous insects. We show that this protection is provided mostly by species nesting in dried-out stems, predominantly Pseudomyrmex gracilis. That dried-out stems remain standing for years and are regularly replaced results in an opportunistic, but stable association where colonies are sheltered by one generation of dead C. alatus while the live individuals nearby, belonging to the next generation, provide them with nectar; in turn, the ants protect their flowers from herbivores. We suggest that the investment in wood by C. alatus individuals permitting stillstanding, dried-out stems to shelter ant colonies constitutes an extended phenotype because foraging workers protect the flowers of live individuals in the same patch. Also, through this process these dried-out stems indirectly favor the reproduction (and so the fitness) of the next generation including both their own offspring and that of their siblings, alladding up to a potential case of inclusive fitness in plants
- …