246 research outputs found

    Review of methods for deriving areal reduction factors

    Get PDF
    The design of hydraulic structures requires knowledge of how much rain is likely to fall within a certain amount of time, and over a specific area. Point rainfalls are only representative for a very limited area, and for larger areas the areal average rainfall depth is likely to be much smaller than at the point of maximum observed depth. The estimation of areal reduction factors is concerned with the relationship between the point and areal rainfalls. This relationship has been found to vary with, for example, predominant weather type, season and return period. Methods for estimation of areal reduction factors include empirical and analytical methods. The current design guidelines in the United Kingdom are based on an empirical method, but since they were issued in 1975, several new analytical methods have been proposed. These methods are discussed, and recommendations for an update suitable for United Kingdom conditions are made

    Genetics of tension-type headache

    Get PDF
    The objective of this study was to investigate the importance of genetics in tension-type headache. A MEDLINE search from 1966 to December 2006 was performed for “tension-type headache and prevalence” and “tension-type headache and genetics” The prevalence of tensiontype headache varies from 11 to 93%, with a slight female preponderance. Co-occurrence of migraine increases the frequency of tension-type headache. A family study of chronic tension-type headache suggests that genetic factors are important. A twin study analysing tension-type headache in migraineurs found that genetic factors play a minor role in episodic tension-type headache. Another twin study analysing twin pairs without co-occurrence of migraine showed a significantly higher concordance rate among monozygotic than same-gender dizygotic twin pairs with no or frequent episodic tension-type headache, while the difference was minor in twin pairs with infrequent episodic tensiontype headache. Frequent episodic and chronic tension-type headache is caused by a combination of genetic and environmental factors, while infrequent episodic tensiontype headache is caused primarily by environmental factors

    On the mechanisms governing gas penetration into a tokamak plasma during a massive gas injection

    Get PDF
    A new 1D radial fluid code, IMAGINE, is used to simulate the penetration of gas into a tokamak plasma during a massive gas injection (MGI). The main result is that the gas is in general strongly braked as it reaches the plasma, due to mechanisms related to charge exchange and (to a smaller extent) recombination. As a result, only a fraction of the gas penetrates into the plasma. Also, a shock wave is created in the gas which propagates away from the plasma, braking and compressing the incoming gas. Simulation results are quantitatively consistent, at least in terms of orders of magnitude, with experimental data for a D 2 MGI into a JET Ohmic plasma. Simulations of MGI into the background plasma surrounding a runaway electron beam show that if the background electron density is too high, the gas may not penetrate, suggesting a possible explanation for the recent results of Reux et al in JET (2015 Nucl. Fusion 55 093013)

    Towards a new image processing system at Wendelstein 7-X: From spatial calibration to characterization of thermal events

    Get PDF
    Wendelstein 7-X (W7-X) is the most advanced fusion experiment in the stellarator line and is aimed at proving that the stellarator concept is suitable for a fusion reactor. One of the most important issues for fusion reactors is the monitoring of plasma facing components when exposed to very high heat loads, through the use of visible and infrared (IR) cameras. In this paper, a new image processing system for the analysis of the strike lines on the inboard limiters from the first W7-X experimental campaign is presented. This system builds a model of the IR cameras through the use of spatial calibration techniques, helping to characterize the strike lines by using the information given by real spatial coordinates of each pixel. The characterization of the strike lines is made in terms of position, size, and shape, after projecting the camera image in a 2D grid which tries to preserve the curvilinear surface distances between points. The description of the strike-line shape is made by means of the Fourier Descriptors

    Forward modeling of collective Thomson scattering for Wendelstein 7-X plasmas: Electrostatic approximation

    Get PDF
    In this paper, we present a method for numerical computation of collective Thomson scattering (CTS). We developed a forward model, eCTS, in the electrostatic approximation and benchmarked it against a full electromagnetic model. Differences between the electrostatic and the electromagnetic models are discussed. The sensitivity of the results to the ion temperature and the plasma composition is demonstrated. We integrated the model into the Bayesian data analysis framework Minerva and used it for the analysis of noisy synthetic data sets produced by a full electromagnetic model. It is shown that eCTS can be used for the inference of the bulk ion temperature. The model has been used to infer the bulk ion temperature from the first CTS measurements on Wendelstein 7-X

    Velocity-space sensitivity of the time-of-flight neutron spectrometer at JET

    Get PDF
    The velocity-space sensitivities of fast-ion diagnostics are often described by so-called weight functions. Recently, we formulated weight functions showing the velocity-space sensitivity of the often dominant beam-target part of neutron energy spectra. These weight functions for neutron emission spectrometry (NES) are independent of the particular NES diagnostic. Here we apply these NES weight functions to the time-of-flight spectrometer TOFOR at JET. By taking the instrumental response function of TOFOR into account, we calculate time-of-flight NES weight functions that enable us to directly determine the velocity-space sensitivity of a given part of a measured time-of-flight spectrum from TOFOR

    Relationship of edge localized mode burst times with divertor flux loop signal phase in JET

    Get PDF
    A phase relationship is identified between sequential edge localized modes (ELMs) occurrence times in a set of H-mode tokamak plasmas to the voltage measured in full flux azimuthal loops in the divertor region. We focus on plasmas in the Joint European Torus where a steady H-mode is sustained over several seconds, during which ELMs are observed in the Be II emission at the divertor. The ELMs analysed arise from intrinsic ELMing, in that there is no deliberate intent to control the ELMing process by external means. We use ELM timings derived from the Be II signal to perform direct time domain analysis of the full flux loop VLD2 and VLD3 signals, which provide a high cadence global measurement proportional to the voltage induced by changes in poloidal magnetic flux. Specifically, we examine how the time interval between pairs of successive ELMs is linked to the time-evolving phase of the full flux loop signals. Each ELM produces a clear early pulse in the full flux loop signals, whose peak time is used to condition our analysis. The arrival time of the following ELM, relative to this pulse, is found to fall into one of two categories: (i) prompt ELMs, which are directly paced by the initial response seen in the flux loop signals; and (ii) all other ELMs, which occur after the initial response of the full flux loop signals has decayed in amplitude. The times at which ELMs in category (ii) occur, relative to the first ELM of the pair, are clustered at times when the instantaneous phase of the full flux loop signal is close to its value at the time of the first ELM

    Experimental progress in positronium laser physics

    Get PDF

    Processos de democracia direta: sim ou não? Os argumentos clássicos à luz da teoria e da prática

    Get PDF
    Regularmente surgem controvérsias sobre os processos de democracia direta, dos quais os mecanismos mais frequentes são a iniciativa popular, o plebiscito e o referendo. Por um lado, há autores que defendem a posição de que essas instituições tornam o jogo político mais lento, caro, confuso e ilegítimo; outros defendem a posição contrária e argumentam que processos de democracia direta são fundamentais para os cidadãos e a qualidade da democracia. O presente estudo analisa esse tema em torno de sete questões, baseadas em considerações teóricas e pesquisas empíricas: 1. A questão entre o minimalismo e o maximalismo democrático; 2. A concorrência entre maioria e minoria; 3. A concorrência entre as instituições representativas e os processos de democracia direta; 4. A questão da competência dos cidadãos; 5. A questão dos efeitos colaterais dos processos de democracia direta; 6. A questão do tamanho do eleitorado; 7. A questão dos custos dos processos de democracia direta. As sete questões são analisadas a partir de uma revisão bibliográfica que considera tanto fontes nacionais como internacionais. O estudo mostra que os processos de democracia direta podem ser um complemento para as instituições representativas em um sistema democrático. O bom desempenho dos plebiscitos, referendos e iniciativas populares depende tanto da regulamentação destes como também do desempenho das outras instituições políticas e da situação socioeconômica de um país. O estudo permite ampliar e aprofundar o debate sobre processos de democracia direta no Brasil

    Experimental confirmation of efficient island divertor operation and successful neoclassical transport optimization in Wendelstein 7-X

    Get PDF
    We present recent highlights from the most recent operation phases of Wendelstein 7-X, the most advanced stellarator in the world. Stable detachment with good particle exhaust, low impurity content, and energy confinement times exceeding 100 ms, have been maintained for tens of seconds. Pellet fueling allows for plasma phases with reduced ion-temperature-gradient turbulence, and during such phases, the overall confinement is so good (energy confinement times often exceeding 200 ms) that the attained density and temperature profiles would not have been possible in less optimized devices, since they would have had neoclassical transport losses exceeding the heating applied in W7-X. This provides proof that the reduction of neoclassical transport through magnetic field optimization is successful. W7-X plasmas generally show good impurity screening and high plasma purity, but there is evidence of longer impurity confinement times during turbulence-suppressed phases.EC/H2020/633053/EU/Implementation of activities described in the Roadmap to Fusion during Horizon 2020 through a Joint programme of the members of the EUROfusion consortium/ EUROfusio
    corecore