Rare earthquake response spectra for typical site conditions in Hong Kong

Hong Kong is located in a region of low-to-moderate seismicity; the potential consequences in the event of a nearby major earthquake should not be underrated. In the past two decades, researchers have conducted many studies on this issue and it is now clear that design procedures should not be directly borrowed from other codes of practice without modifications. This paper aims at presenting the rare earthquake response spectra for typical rock and soil sites in Hong Kong, which form the basis of a seismic design procedure. The uniform hazard spectrum (UHS) for rock sites was obtained from seismic hazard assessment using probabilistic methods. Records from 16 boreholes, representing a wide range of local site conditions, were collected from different locations in Hong Kong. A site-specific response spectrum was then constructed based on the results of site response analyses. Moreover, the 16 site-specific response spectra have been grouped into four types based on the (initial) site natural periods, which allows convenient evaluation of the loading characteristics that are expected at different types of sites. Finally, the rare earthquake response spectra proposed for Hong Kong are compared with those constructed based on the Chinese code (GB) and the Eurocode (EC8).postprin

CHD pile performance, part II:Numerical modelling

In this paper, a set of simple modelling procedures are presented that can be used to estimate the load-settlement behaviour of Continuous Helical Displacement (CHD) piles in sands, in conjunction with the Finite Element Method (FEM). The approach makes use of a stress and strain dependent non-linear soil model that can be parameterised using basic soil data (principally relative density) that can be determined through routine site investigation (e.g. SPT, CPT). The procedures are validated against a database of 1-g physical model tests reported in the Companion Paper, where they are shown to be suitable for estimating the load-settlement behaviour of CHD piles within the serviceability range. In this way they are complimentary to the analytical method for estimating the ultimate capacity of a CHD pile which was developed in the Companion Paper. In the final part of the paper, the FEM and analytical model are applied to four historical field pile load tests on CHD piles conducted at three different sand sites where they are (i) further validated; and (ii) used to discuss potential savings in pile material and therefore cost due to additional confidence in performance determination at both ultimate and serviceability limiting states

Coveting thy neighbors fitness as a means to resolve social dilemmas

In spatial evolutionary games the fitness of each individual is traditionally determined by the payoffs it obtains upon playing the game with its neighbors. Since defection yields the highest individual benefits, the outlook for cooperators is gloomy. While network reciprocity promotes collaborative efforts, chances of averting the impending social decline are slim if the temptation to defect is strong. It is therefore of interest to identify viable mechanisms that provide additional support for the evolution of cooperation. Inspired by the fact that the environment may be just as important as inheritance for individual development, we introduce a simple switch that allows a player to either keep its original payoff or use the average payoff of all its neighbors. Depending on which payoff is higher, the influence of either option can be tuned by means of a single parameter. We show that, in general, taking into account the environment promotes cooperation. Yet coveting the fitness of one's neighbors too strongly is not optimal. In fact, cooperation thrives best only if the influence of payoffs obtained in the traditional way is equal to that of the average payoff of the neighborhood. We present results for the prisoner's dilemma and the snowdrift game, for different levels of uncertainty governing the strategy adoption process, and for different neighborhood sizes. Our approach outlines a viable route to increased levels of cooperative behavior in structured populations, but one that requires a thoughtful implementation.Comment: 10 two-column pages, 5 figures; accepted for publication in Journal of Theoretical Biolog

DEM of triaxial tests on crushable cemented sand

Using the discrete element method, triaxial simulations of cemented sand consisting of crushable particles are presented. The triaxial model used features a flexible membrane, allowing realistic deformation to occur, and cementation is modelled using inter-particle bonds. The effects of particle crushing are explored, as is the influence of cementation on the behaviour of the soil. An insight to the effects that cementation has on the degree of crushing is presented

DEM of triaxial tests on crushable sand

This paper presents simulations of high-pressure triaxial shear tests on a crushable sand. The discrete element method is used, featuring a large number of particles and avoiding the use of agglomerates. The triaxial model features a flexible membrane, therefore allowing realistic deformation, and a simple breakage mechanism is implemented using the octahedral shear stress induced in the particles. The simulations show that particle crushing is essential to replicate the realistic behaviour of sand (in particular the volumetric contraction) in high-pressure shear tests. The general effects of crushing during shear are explored, including its effects on critical states, and the influence of particle strength and confining pressure on the degree of crushing are discussed

Alternative low doses and routes of administering a prostaglandin F2α analogue to induce luteolysis in Nelore cows

The present study was conducted in order to verify the efficacy of lower doses and alternative routes of a prostaglandin F2α analogue, luprostiol (PGF), for the induction of luteolysis and the precipitation of estrus in nonlactating Nelore cows (Bos taurus indicus). A conventional dose (15 mg) of PGF was compared to doses lower than the conventional dose, which ranges from 10 to 50%, that were administered intramuscularly (IM), intravulvosubmucosally (IVSM), or in the Bai-hui acupuncture site located within the lumbosacral area. The cows were administered PGF 8 day after estrus in the presence of a corpus luteum, and randomly assigned to the following groups: G1 (positive control), 15 mg, IM (n = 23); G2, 7.5 mg, IM (n = 23); G3, 3.75 mg, IM (n = 24); G4, 7.5 mg, IVSM (n = 25); G5, 3.75 mg, Bai-hui acupoint (n = 24); and G6, 1.5 mg, Bai-hui acupoint (n = 25). The results indicated that 50% of a conventional dose of PGF (7.5 mg) resulted in a complete luteal regression (plasma progesterone <1 ng/ml) at Hour 48, and hastened estrus, regardless of whether or not PGF was administered IM or IVSM. Comparatively, 10 or 25% of the conventional dose, even when administered to the Bai-hui acupoint, resulted in an initial reduction in the concentration of progesterone at Hour 24, followed by an increase observed at Hour 48. In conclusion, 25% of a conventional PGF dose administered via the Bai-hui acupoint proved inadequate to induce a complete luteal regression, whereas 50% of a conventional dose administered IM or IVSM was found to be the minimal dose required to induce effectively a complete luteal regression, and to precipitate the onset of estrus in nonlactating Nelore cows

Messaging About Very Low Nicotine Cigarettes (VLNCs) to Influence Policy Attitudes, Harm Perceptions and Smoking Motivations: A Discrete Choice Experiment

Background To reduce smoking and the harms it causes, countries, including the USA, are considering policies to reduce nicotine in combustible tobacco to minimally addictive levels. Effective messages about very low nicotine cigarettes (VLNCs) and this policy are crucial in combating misperceptions threatening the policy’s effectiveness. Data and methods A discrete choice experiment assessed messages about VLNCs. Participants were 590 adults who smoked exclusively, 379 adults who both smoked and used e-cigarettes, 443 adults who formerly smoked and 351 young adults who never smoked (total n=1763). Seven message attributes were varied systematically (source, harm, chemicals, nicotine, satisfaction, addictiveness and quitting efficacy). Outcomes were selection of messages that generated the most positive attitude towards reduced nicotine policy, the greatest perceived harmfulness of VLNCs, and most strongly motivated quitting and initiating behaviour for VLNCs. Results Information about specific harms and chemicals of VLNCs had the largest effects on selection of messages as eliciting more negative attitudes towards VLNCs policy, increasing perceived VLNC harmfulness, increasing motivation to quit VLNCs and decreasing motivation to try VLNCs. Messages with information about quitting efficacy were selected as more motivating to quit among those who smoke, but also more motivating to try VLNCs among those who do not smoke. Conclusion Harm and chemical information can be prioritised to ensure VLNCs are not misperceived as less harmful than regular cigarettes. Messages about increased quitting efficacy and reduced addictiveness associated with VLNCs may backfire if presented to those who do not smoke

Influence of packing density and stress on the dynamic response of granular materials

Laboratory geophysics tests including bender elements and acoustic emission measure the speed of propagation of stress or sound waves in granular materials to derive elastic stiffness parameters. This contribution builds on earlier studies to assess whether the received signal characteristics can provide additional information about either the material’s behaviour or the nature of the material itself. Specifically it considers the maximum frequency that the material can transmit; it also assesses whether there is a simple link between the spectrum of the received signal and the natural frequencies of the sample. Discrete element method (DEM) simulations of planar compression wave propagation were performed to generate the data for the study. Restricting consideration to uniform (monodisperse) spheres, the material fabric was varied by considering face-centred cubic lattice packings as well as random configurations with different packing densities. Supplemental analyses, in addition to the DEM simulations, were used to develop a more comprehensive understanding of the system dynamics. The assembly stiffness and mass matrices were extracted from the DEM model and these data were used in an eigenmode analysis that provided significant insight into the observed overall dynamic response. The close agreement of the wave velocities estimated using eigenmode analysis with the DEM results confirms that DEM wave propagation simulations can reliably be used to extract material stiffness data. The data show that increasing either stress or density allows higher frequencies to propagate through the media, but the low-pass wavelength is a function of packing density rather than stress level. Prior research which had hypothesised that there is a simple link between the spectrum of the received signal and the natural sample frequencies was not substantiated