91 research outputs found
An Investigation of Biodiesel Production from Wastes of Seafood Restaurants
This work illustrates a comparative study on the applicability of the basic heterogeneous calcium oxide catalyst prepared from waste mollusks and crabs shells (MS and CS, resp.) in the transesterification of waste cooking oil collected from seafood restaurants with methanol for production of biodiesel. Response surface methodology RSM based on D-optimal deign of experiments was employed to study the significance and interactive effect of methanol to oil M : O molar ratio, catalyst concentration, reaction time, and mixing rate on biodiesel yield. Second-order quadratic model equations were obtained describing the interrelationships between dependent and independent variables to maximize the response variable (biodiesel yield) and the validity of the predicted models were confirmed. The activity of the produced green catalysts was better than that of chemical CaO and immobilized enzyme Novozym 435. Fuel properties of the produced biodiesel were measured and compared with those of Egyptian petro-diesel and international biodiesel standards. The biodiesel produced using MS-CaO recorded higher quality than that produced using CS-CaO. The overall biodiesel characteristics were acceptable, encouraging application of CaO prepared from waste MS and CS for production of biodiesel as an efficient, environmentally friendly, sustainable, and low cost heterogeneous catalyst
Statistical optimization of alginate immobilization process of candida stauntonica strain MY1 for bioethanol production
In this study a new yeast strain was isolated from Egyptian sugarcane molasses for its high capability of bioethanol fermentation,under anaerobic conditions.It was identified on the basis of its 18S rDNA to be Candida stauntonica MY1 (Accession No.KM657091). The central composite face centered design CCFD matrix and response surface methodology were
applied in designing and optimizing the process of calcium-alginate immobilization of MY1 yeast cells to maximize its
bioethanol productivity from glucose and evaluate the influence and interactive effect of three critical immobilization parameters; bead size (diameter,mm),initial
inoculum size (g/L) and alginate concentration (g/L) on the bioethanol yield. Three quadratic model equations have
been predicted ending out how statistically significant the effects of these variables (factors) and their interactions are in practice. The validity of the predicted models was confirmed. The optimum conditions for cell immobilization were found to be 2.5mm, 2.5 g/L and 5.5g/L,respectively. That produced 4.4 g/L bioethanol,with actual yield of 41.9% i.e. YP/S0.42g ethanol/g glucose, which was about 2.3 fold higher than that produced with free cells batch fermentation operated under the same conditions;48 h, pH5.5,
30oC and 100rpm. The immobilized cells showed good stability, with long storage time 21d and can be used for four successive batches with maximum bioethanol productivity
Comparison and Optimization of ozone – Based Advanced Oxidation Processes in The Treatment of Stabilized Landfill Leachate
-Leachate pollution is one of the main problems in landfilling. Among the most problematic parameters in stabilized leachate are COD, ammonia, and color. The treatment technology that can be used may differ based on the type of leachate produced. Even after treatment, the effluent characteristics are always hard to comply with the discharge standard. Ozonation is one of the chemical processes that can be used in the treatment of landfill leachate. However, its performance when use alone is low; its effectiveness can be improved using advanced oxidants. To date, application of Fenton and persulfate reagents separately to improve ozonation process in one ozone reactor was not well established. The study aimed to evaluate and compare the performance of the three treatment processes, namely ozone, ozone/Fenton and ozone/persulfate in treating stabilized leachate separately at different experimental conditions. The performance of the three methods in the treating stabilized leachate was compared. According to the results, the performance of ozone alone was poor, and utilizing new advanced oxidation material during ozonation of such leachate was required to improve leachate treatability. Ozone/Fenton process is a viable choice for degrading and decolourizing stabilized leachate. Furthermore, ozone/persulfate process has higher performance in ammonia removal as well as it has good removal efficiency of COD and color from stabilized leachate. Suitable data for establishing fully stabilized leachate treatment plant using ozone/Fenton and ozone/persulfate was suggested. The final effluent of ozone/Fenton process complied with the discharge standard for COD and colour
Microplastic in the environment: identification, occurrencand mitigation measures
Microplastic is an emerging pollutant causing trouble worldwide due to its extensive distribution and potential hazards to the ecological system. Some fundamental questions about micro-plastics, such as their presence, source, and possible hazards, remain unanswered. These issues develop because of a lack of systematic and comprehensive microplastic analysis. As a result, we thoroughly evaluated current knowledge on microplastics, including detection, characterization, occurrence, source, and potential harm. Microplastics are found in seawater, soil, wetlands, and air matrices worldwide based on findings. Visual classification, which can be enhanced by com-bining it with additional tools, is one of the most used methods for identifying microplastics. As soon as is practicable, microplastics analytical methods ought to be standardized. New techniques for analyzing nano-plastics are urgently needed in the meantime. Numerous studies have shown that microplastics’ impacts on people and soil are significantly influenced by their size, shape, and surface physicochemical characteristics. Finally, this study suggests areas for future research based on the knowledge gaps in the area of microplastics. © 2022 Desalination Publications. All rights reserved
Biofuel production using cultivated algae: technologies, economics, and its environmental impacts
The process of looking for alternative energy sources is driven by the increasing demand for energy and environmental contamination caused by using fossil fuels. Recent investigations reported the efficiency of microalgae for biofuel production due to its low cost of production, high speed of growth, and ability to grow in harsh environments. In addition, many microalgae are photosynthetic, consuming CO2 and solar light to grow in biomass and providing a promising bioenergy source. This review presents the recent advances in the application of microalgae for biofuel production. In addition, cultivation and harvesting systems and environmental factors that affect microalgae cultivation for biofuel production have also been discussed. Moreover, lipid extraction and conversion technologies to biofuel are presented. The mixotrophic cultivation strategy is promising as it combines the advantages of heterotrophy and autotrophy. Green harvesting methods such as using bio-coagulants and flocculants are promising technologies to reduce the cost of microalgal biomass production. In the future, more investigations into co-cultivation systems, new green harvesting methods, high lipids extraction methods, and the optimization of lipid extraction and converting processes should be implemented to increase the sustainability of microalgae application for biofuel production
Application of Response Surface Methodology to Enhance Phenol Removal from Refinery Wastewater by Microwave Process
Thermal based remediation technologies for soil and groundwater: a review
Thermal remediation technologies are fast and effective tools for the remediation of contaminated soils and sediments. Nevertheless, the high energy consumption and the effect of high temperature on the soil properties may hinder the wide applications of thermal remediation methods. This review highlights the recent studies focused on thermal remediation. Eight types of thermal remediation processes are discussed, including incineration, thermal desorption, stream enhanced extraction, electrical resistance heating, microwave heating, smoldering, vitrification, and pyrol-ysis. In addition, the combination of thermal remediation with other remediation technologies is presented. Finally, thermal remediation sustainability is evaluated in terms of energy efficiency and their impact on soil properties. The developments of the past decade show that thermal-based technologies are quite effective in terms of contaminant removal but that these technologies are associated with high energy use and costs and can has an adverse impact on soil properties. Nonetheless, it is anticipated that continued research on thermally based technologies can increase their sustainability and expand their applications. Low temperature thermal desorption is a prom-ising remediation technology in terms of land use and energy cost as it has no adverse effect on soil function after treatment and low temperature is required. Overall, selecting the sustainable remediation technology depends on the contaminant properties, soil properties and predicted risk level. © 2022 Desalination Publications. All rights reserved
Antimicrobial resistance among migrants in Europe: a systematic review and meta-analysis
BACKGROUND: Rates of antimicrobial resistance (AMR) are rising globally and there is concern that increased migration is contributing to the burden of antibiotic resistance in Europe. However, the effect of migration on the burden of AMR in Europe has not yet been comprehensively examined. Therefore, we did a systematic review and meta-analysis to identify and synthesise data for AMR carriage or infection in migrants to Europe to examine differences in patterns of AMR across migrant groups and in different settings. METHODS: For this systematic review and meta-analysis, we searched MEDLINE, Embase, PubMed, and Scopus with no language restrictions from Jan 1, 2000, to Jan 18, 2017, for primary data from observational studies reporting antibacterial resistance in common bacterial pathogens among migrants to 21 European Union-15 and European Economic Area countries. To be eligible for inclusion, studies had to report data on carriage or infection with laboratory-confirmed antibiotic-resistant organisms in migrant populations. We extracted data from eligible studies and assessed quality using piloted, standardised forms. We did not examine drug resistance in tuberculosis and excluded articles solely reporting on this parameter. We also excluded articles in which migrant status was determined by ethnicity, country of birth of participants' parents, or was not defined, and articles in which data were not disaggregated by migrant status. Outcomes were carriage of or infection with antibiotic-resistant organisms. We used random-effects models to calculate the pooled prevalence of each outcome. The study protocol is registered with PROSPERO, number CRD42016043681. FINDINGS: We identified 2274 articles, of which 23 observational studies reporting on antibiotic resistance in 2319 migrants were included. The pooled prevalence of any AMR carriage or AMR infection in migrants was 25·4% (95% CI 19·1-31·8; I2 =98%), including meticillin-resistant Staphylococcus aureus (7·8%, 4·8-10·7; I2 =92%) and antibiotic-resistant Gram-negative bacteria (27·2%, 17·6-36·8; I2 =94%). The pooled prevalence of any AMR carriage or infection was higher in refugees and asylum seekers (33·0%, 18·3-47·6; I2 =98%) than in other migrant groups (6·6%, 1·8-11·3; I2 =92%). The pooled prevalence of antibiotic-resistant organisms was slightly higher in high-migrant community settings (33·1%, 11·1-55·1; I2 =96%) than in migrants in hospitals (24·3%, 16·1-32·6; I2 =98%). We did not find evidence of high rates of transmission of AMR from migrant to host populations. INTERPRETATION: Migrants are exposed to conditions favouring the emergence of drug resistance during transit and in host countries in Europe. Increased antibiotic resistance among refugees and asylum seekers and in high-migrant community settings (such as refugee camps and detention facilities) highlights the need for improved living conditions, access to health care, and initiatives to facilitate detection of and appropriate high-quality treatment for antibiotic-resistant infections during transit and in host countries. Protocols for the prevention and control of infection and for antibiotic surveillance need to be integrated in all aspects of health care, which should be accessible for all migrant groups, and should target determinants of AMR before, during, and after migration. FUNDING: UK National Institute for Health Research Imperial Biomedical Research Centre, Imperial College Healthcare Charity, the Wellcome Trust, and UK National Institute for Health Research Health Protection Research Unit in Healthcare-associated Infections and Antimictobial Resistance at Imperial College London
Burnout among surgeons before and during the SARS-CoV-2 pandemic: an international survey
Background: SARS-CoV-2 pandemic has had many significant impacts within the surgical realm, and surgeons have been obligated to reconsider almost every aspect of daily clinical practice. Methods: This is a cross-sectional study reported in compliance with the CHERRIES guidelines and conducted through an online platform from June 14th to July 15th, 2020. The primary outcome was the burden of burnout during the pandemic indicated by the validated Shirom-Melamed Burnout Measure. Results: Nine hundred fifty-four surgeons completed the survey. The median length of practice was 10 years; 78.2% included were male with a median age of 37 years old, 39.5% were consultants, 68.9% were general surgeons, and 55.7% were affiliated with an academic institution. Overall, there was a significant increase in the mean burnout score during the pandemic; longer years of practice and older age were significantly associated with less burnout. There were significant reductions in the median number of outpatient visits, operated cases, on-call hours, emergency visits, and research work, so, 48.2% of respondents felt that the training resources were insufficient. The majority (81.3%) of respondents reported that their hospitals were included in the management of COVID-19, 66.5% felt their roles had been minimized; 41% were asked to assist in non-surgical medical practices, and 37.6% of respondents were included in COVID-19 management. Conclusions: There was a significant burnout among trainees. Almost all aspects of clinical and research activities were affected with a significant reduction in the volume of research, outpatient clinic visits, surgical procedures, on-call hours, and emergency cases hindering the training. Trial registration: The study was registered on clicaltrials.gov "NCT04433286" on 16/06/2020
- …