The Factors that Influence Knowledge Sharing in Educational Institutions

The objective of the study is to identify the elements which have an impact on sharing of knowledge at Cihan University in Erbil. Although previous studies have identified a range of elements affecting knowledge sharing, further research is needed to understand the factors driving knowledge sharing, particularly among higher educational institutions in Iraq. Since there are few studies about the sharing of knowledge among Iraqi higher education institutions' staff and there is no current model that has all of the elements required to examine the sharing of knowledge, the researchers investigated the effects of organizational, individual, and technological variables on academics' knowledge sharing behavior. Cihan University staff in Iraq's Kurdistan Region completed a total of 78 validated questionnaires. The data were evaluated with the use of a structural equation model (PLS-SEM). According to the findings of the study, organizational and technological factors are important indicators of knowledge sharing in educational institutions

Studies on pathogenicity effect of Aeromonas hydrophila infection in juvenile red hybrid tilapia Oreochromis sp.

This study was conducted to evaluate the ability of motile Aeromonas species (MAS) to induce clinical symptoms and some pathological changes in juvenile red hybrid tilapia. A standard dose of infection was selected based on predetermined LD50. Infected fish were observed for any clinical sign and symptom for 96 hours. Samples of liver, spleen and kidney were collected for histopatological changes due to Aeromonas hydrophila infection. Clinical signs of fish included abnormal swimming behaviour and loss of balance. Most of infected fish suffered from haemorrhagic eyes and lesions on the body surface. Some of the them also developed bilateral exophthalmia. Histopathological changes were observed in kidney, liver and spleen. The infected liver showed severe congestion of hepatic veins and vacuoles formation while anterior kidney manifested degeneration of excretory tubules and glomeruli followed by severe haemorrhages and hyaline droplets degeneration. Spleen on the other hand showed tissues degeneration and vacuoles formation. All targated tissues also showed deposition of haemosiderin pigments followed by proliferation of melanomacrphage centres. Development of such symptoms was associated with the infection with Aeromonas hydrophila. The current study has shown that MAS could serve as the primary cause of severe infection not only in red hybrid tilapia but may also infected other freshwater fish species.The results of histological analysis of various tissues indicates a direct correlation between disease infection and histopathological disorders observed in the tissues

Analysis of cod-liver oil adulteration using Fourier Transform Infrared (FTIR) spectroscopy.

Analysis of the adulteration of cod-liver oil with much cheaper oil-like animal fats has become attractive in recent years. This study highlights an application of Fourier transform infrared (FTIR) spectroscopy as a nondestructive and fast technique for the determination of adulterants in cod-liver oil. Attenuated total reflectance measurements were made on pure cod-liver oil and cod-liver oil adulterated with different concentrations of lard (0.5–50% v/v in cod-liver oil). A chemometrics partial least squares (PLS) calibration model was developed for quantitative measurement of the adulterant. Discriminant analysis method was used to classify cod-liver oil samples from common animal fats (beef, chicken, mutton, and lard) based on their infrared spectra. Discriminant analysis carried out using seven principal components was able to classify the samples as pure or adulterated cod-liver oil based on their FTIR spectra at the selected fingerprint regions (1,500–1,030 cm−1)

Optimisation of pH of cadmium chloride post-growth-treatment in processing CDS/CDTE based thin film solar cells

The role of Chlorine-based activation in the production of high quality CdS/CdTe photovoltaic have been well discussed and explored with an overlook of the effect of Cadmium chloride (CdCl2) post-growth treatment acidity on the property of the fabricated devices. This work focuses on the optimisation of CdCl2 post-growth treatment pH as it affects both the material and fabricated device properties of all-electrodeposited multilayer glass/FTO/n-CdS/n-CdTe/p-CdTe configuration. CdCl2 treatments with acidity ranging from pH1 to pH4 were explored. The properties of the ensued CdTe layer were explored using optical, morphological, compositional structural and electrical property analysis, while, the effect on fabricated multilayer glass/FTO/n-CdS/n-CdTe/p-CdTe configuration were also explored using both I-V and C-V measurements. Highest improvements in the optical, morphological, compositional and structural were observed at pH2 CdCl2 post-growth treatment with an improvement in absorption edge, grain size, crystallinity and crystallite size. Conductivity type conversions from n-CdTe to p-CdTe, increase in pin-hole density and collapse of the absorption edge were observed after pH1 CdCl2 treatment. The highest fabricated solar cell efficiency of 13% was achieved using pH2 CdCl2 treatment as compared to other pH values explored

Surface resistivity and ultrasonic pulse velocity evaluation of reinforced opc concrete and reinforced geopolymer concrete in marine environment

The concrete structures that are built along the seaside often suffer from reduced service life due to inadequate durability against deterioration. This research reports the findings of concrete resistivity and quality using two Non-Destructive Testing (NDT) measures applied to Reinforced Geopolymer and Ordinary Portland Cement (OPC) concrete in the marine environment. In addition, the relationship between Reinforced Geopolymer and Reinforced OPC concrete was statistically discussed in-terms of strength and direction. The testing was carried out using a Proceeq Resipod Wenner 4-probe to measure Surface Resistivity (SR) and Ultrasonic Pulse Velocity (UPV), respectively. The testings were carried out on beam shaped samples of OPC and Geopolymer concrete that were immersed in seawater over a period of 90 days with similar curing condition. It was found from the present investigation that the maximum SR and maximum UPV values acquired for both the Reinforced OPC and Reinforced Geopolymer concrete are 2.73 kΩcm and 2.07 kΩcm, as well as 4.18 km/s and 4.05 km/s, respectively. It is apparent from the study that both concrete is comparable in terms of quality and surface resistivity

Regiospecific analysis of Mono and Diglycerides in Glycerolysis products by GC x GC TOF-MS.

Comprehensive bidimensional gas chromatography coupled with time-of-flight mass spectrometry (GC × GC-TOF-MS) was used for the characterization of regiospecific mono- and diglycerides (MG-DG) content in the glycerolysis products derived from five different lipids included lard (LA), sun flower seed oil (SF), corn oil (CO), butter (BU), and palm oil (PA). The combination of fast and high temperature non-orthogonal column set namely DB17ht (6 m × 0.10 mm × 0.10 μm) as the primary column and SLB-5 ms (60 cm × 0.10 mm × 0.10 μm) as the secondary column was applied in this work. System configuration involved high oven ramp temperature to obtain precise mass spectral identification and highest effluent’s resolution. 3-Monopalmitoyl-sn-glycerol (MG 3-C16) was the highest concentration in LA, BU and PA while monostearoyl-sn-glycerol (MG C18) in CO and 1,3-dilinoleol-rac-glycerol (DG C18:2c) in SF. Principal component analysis accounted 82% of variance using combination of PC1 and PC2. The presence of monostearoyl-sn-glycerol (MG C18), 3-Monopalmitoyl-sn-glycerol (MG 3-C16), 1,3-dilinoleol-rac-glycerol (DG C18:2c), 1,3-dipalmitoyl-glycerol (DG 1,3-C16), and 1,3-dielaidin (DG C18:1t) caused differentiation of the samples tested

Effects of deposition time and post-deposition annealing on the physical and chemical properties of electrodeposited CdS thin films for solar cell application

CdS thin films were cathodically electrodeposited by means of a two-electrode deposition system for different durations. The films were characterised for their structural, optical, morphological and compositional properties using x-ray diffraction (XRD), spectrophotometry, scanning electron microscopy (SEM) and energy dispersive x-ray (EDX) respectively. The results obtained show that the physical and chemical properties of these films are significantly influenced by the deposition time and post-deposition annealing. This influence manifests more in the as-deposited materials than in the annealed ones. XRD results show that the crystallite sizes of the different films are in the range (9.4 – 65.8) nm and (16.4 – 66.0) nm in the as-deposited and annealed forms respectively. Optical measurements show that the absorption coefficients are in the range (2.7×104 – 6.7×104) cm-1 and (4.3×104 – 7.2×104) cm-1 respectively for as-deposited and annealed films. The refractive index is in the range (2.40 – 2.60) for as-deposited films and come to the value of 2.37 after annealing. The extinction coefficient varies in the range (0.1 – 0.3) in asdeposited films and becomes 0.1 in annealed films. The estimated energy bandgap of the films is in the range (2.48 – 2.50) eV for as-deposited films and becomes 2.42 eV for all annealed films. EDX results show that all the films are S-rich in chemical composition with fairly uniform Cd/S ratio after annealing. The results show that annealing improves the qualities of the films and deposition time can be used to control the film thickness. Keywords: Electrodeposition; two-electrode system; CdS; annealing; deposition time; thin-film

Electrodeposition and characterisation of CdS thin films using thiourea precursor for application in solar cells

CdS thin films have been successfully electrodeposited on glass/FTO substrates using acidic and aqueous solution of CdCl2.xH2O and thiourea (SC(NH2)2). The electrodeposition of CdS thin films were carried out potentiostatically using a 2-electrode system. The prepared films were characterised using X-ray diffraction (XRD), Raman spectroscopy, Scanning electron microscopy (SEM), Atomic force microscopy (AFM), Photoelectrochemical (PEC) cell measurements, Electrical resistivity measurements and UV-Vis spectrophotometry to study their structural, compositional, morphological, electrical and optical properties, respectively. The structural studies show that the as-deposited and annealed CdS layers are polycrystalline with hexagonal crystal structure and preferentially oriented along (200) planes. The optical studies indicate that the ED-CdS layers have direct bandgaps in the range (2.53-2.58) eV for the as-deposited and (2.42-2.48) eV after annealing at 400oC for 20 minutes in air. The morphological studies show the good coverage of the FTO surface by the CdS grains. The average grain sizes for the as-deposited and annealed layers were in the range (60-225) nm. These grains or clusters are made out of smaller nano crystallites with the sizes in the range ~(11-33) nm. The electrical resistivity shows reduction as thickness increases. The resistivity values for the as-deposited and annealed layers were in the range (0.82-4.92)×105 Ωcm. The optimum growth voltage for the CdS thin films was found to be at the cathodic potential of 797 mV with respect to the graphite anode. No visible precipitations of elemental S or CdS particles were observed in the deposition electrolyte showing a stable bath using thiourea during the growth

Assessing the carcinogenic potential of low-dose exposures to chemical mixtures in the environment: the challenge ahead.

Lifestyle factors are responsible for a considerable portion of cancer incidence worldwide, but credible estimates from the World Health Organization and the International Agency for Research on Cancer (IARC) suggest that the fraction of cancers attributable to toxic environmental exposures is between 7% and 19%. To explore the hypothesis that low-dose exposures to mixtures of chemicals in the environment may be combining to contribute to environmental carcinogenesis, we reviewed 11 hallmark phenotypes of cancer, multiple priority target sites for disruption in each area and prototypical chemical disruptors for all targets, this included dose-response characterizations, evidence of low-dose effects and cross-hallmark effects for all targets and chemicals. In total, 85 examples of chemicals were reviewed for actions on key pathways/mechanisms related to carcinogenesis. Only 15% (13/85) were found to have evidence of a dose-response threshold, whereas 59% (50/85) exerted low-dose effects. No dose-response information was found for the remaining 26% (22/85). Our analysis suggests that the cumulative effects of individual (non-carcinogenic) chemicals acting on different pathways, and a variety of related systems, organs, tissues and cells could plausibly conspire to produce carcinogenic synergies. Additional basic research on carcinogenesis and research focused on low-dose effects of chemical mixtures needs to be rigorously pursued before the merits of this hypothesis can be further advanced. However, the structure of the World Health Organization International Programme on Chemical Safety 'Mode of Action' framework should be revisited as it has inherent weaknesses that are not fully aligned with our current understanding of cancer biology