86 research outputs found
Using the inertia of spacecraft during landing to penetrate regoliths of the Solar System
The high inertia, i.e. high mass and low speed, of a landing spacecraft has the potential to drive a penetrometer into the subsurface without the need for a dedicated deployment mechanism, e.g., during Huygens landing on Titan. Such a method could complement focused subsurface exploration missions, particularly in the low gravity environments of comets and asteroids, as it is conducive to conducting surveys and to the deployment of sensor networks. We make full-scale laboratory simulations of a landing spacecraft with a penetrometer attached to its base plate. The tip design is based on that used in terrestrial Cone Penetration Testing (CPT) with a large enough shaft diameter to house instruments for analysing pristine subsurface material. Penetrometer measurements are made in a variety of regolith analogue materials and target compaction states. For comparison a copy of the ACC-E penetrometer from the Huygens mission to Titan is used. A test rig at the Open University is used and is operated over a range of speeds from 0.9 to 3 m s−1 and under two gravitational accelerations.
The penetrometer was found to be sensitive to the target’s compaction state with a high degree of repeatability. The penetrometer measurements also produced unique pressure profile shapes for each material. Measurements in limestone powder produced an exponential increase in pressure with depth possibly due to increasing compaction with depth. Measurements in sand produced an almost linear increase in pressure with depth. Iron powder produced significantly higher pressures than sand presumably due to the rough surface of the grains increasing the grain-grain friction. Impacts into foamglas produced with both ACC-E and the large penetrometer produced an initial increase in pressure followed by a leveling off as expected in a consolidated material. Measurements in sand suggest that the pressure on the tip is not significantly dependent on speed over the range tested, which suggests bearing strength equations could be applied to impact penetrometry in sand-like regoliths.
In terms of performance we find the inertia of a landing spacecraft, with a mass of 100 kg, is adequate to penetrate regoliths expected on the surface of Solar System bodies. Limestone powder, an analogue for a dusty surface, offered very little resistance allowing full penetration of the target container. Both iron powder, representing a stronger coarse grained regolith, and foamglas, representing a consolidated comet crust, could be penetrated to similar depths of around two to three tip diameters. Speed tests suggest a linear dependence of penetration depth on impact speed
The Penetration of Solar Radiation into Carbon Dioxide Ice
Icy surfaces behave differently to rocky or regolith‐covered surfaces in response to irradiation. A key factor is the ability of visible light to penetrate partially into the subsurface. This results in the Solid‐State Greenhouse Effect (SSGE), as ices can be transparent or translucent to visible and shorter wavelengths, whilst opaque in the infrared. This can lead to significant differences in shallow sub‐surface temperature profiles when compared to rocky surfaces. Of particular significance for modelling the SSGE is the e‐folding scale, otherwise known as the absorption scale length, or penetration depth, of the ice. Whilst there have been measurements for water ice and snow, pure and with mixtures, to date there have been no such measurements published for carbon dioxide ice. After an extensive series of measurements we are able to constrain the e‐folding scale of CO2 ice for the cumulative wavelength range 300 nm to 1100 nm, which is a vital parameter in heat transfer models for the Martian surface, enabling us to better understand surface‐atmosphere interactions at Mars’ polar caps
Prelaunch performance evaluation of the cometary experiment MUPUS-TP
This paper discusses test results obtained in both laboratory and terrestrial environment conditions for the “Multipurpose Sensors for Surface and Sub-Surface Science” Thermal Probe (MUPUS-TP), which has been developed for the European Space Agency Rosetta cometary rendezvous mission. The probe is intended to provide in situ long-term observations of the thermal evolution of the comet nucleus and will measure a thermal conductivity profile with time in the top 30 cm of the comet nucleus. The basic operating principles of the probe are briefly described, including typical test results gathered in terrestrial snow and soil. The tests in snow provide verification of the probe as a useful tool for monitoring the metamorphism of snow on the Earth. The tests in soil are intended to demonstrate the probe's suitability as an alternative to other methods of energy measurement currently practiced in soil physics research. The tests of the probe in the natural environment of the Earth provide a demonstration of the behavior of the instrument in the presence of complex energy exchange processes before it is used on the comet
Light-induced disassembly of dusty bodies in inner protoplanetary discs: implications for the formation of planets
Laboratory experiments show that a solid-state greenhouse effect in
combination with thermophoresis can efficiently erode a dust bed in a
low-pressure gaseous environment. The surface of an illuminated, light
absorbing dusty body is cooler than the dust below the surface (solidstate
greenhouse effect). This temperature gradient leads to a directed momentum
transfer between gas and dust particles and the dust particles are subject to a
force towards the surface(thermophoresis). If the thermophoretic force is
stronger than gravity and cohesion, dust particles are ejected. Applied to
protoplanetary discs, dusty bodies smaller than several kilometres in size
which are closer to a star than about 0.4 au are subject to a rapid and
complete disassembly to submillimetre size dust aggregates by this process.
While an inward-drifting dusty body is destroyed, the generated dust is not
lost for the disc by sublimation or subsequent accretion on to the star but can
be reprocessed by photophoresis or radiation pressure. Planetesimals cannot
originate through aggregation of dust inside the erosion zone. If objects
larger than several kilometres already exist, they prevail and further grow by
collecting dust from disassembled smaller bodies. The pile-up of solids in a
confined inner region of the disc, in general, boosts the formation of planets.
Erosion is possible in even strongly gas-depleted inner regions as observed for
TW Hya. Reprocessing of dust through light-induced erosion offers one possible
explanation for growth of large cores of gas-poor giant planets in a
gas-starved region as recently found around HD 149026b
Computer modelling of a penetrator thermal sensor
The Philae lander is part of the Rosetta mission to investigate comet 67P/Churyumov-Gerasimenko. It will use a harpoon like device to anchor itself onto the surface. The anchor will perhaps reach depths of 1–2 m. In the anchor is a temperature sensor that will measure the boundary temperature as part of the MUPUS experiment. As the anchor attains thermal equilibrium with the comet ice it may be possible to extract the thermal properties of the surrounding ice, such as the thermal diffusivity, by using the temperature sensor data. The anchor is not an optimal shape for a thermal probe and application of analytical solutions to the heat equation is inappropriate. We prepare a numerical model to fit temperature sensor data and extract the thermal diffusivity. Penetrator probes mechanically compact the material immediately surrounding them as they enter the target. If the thermal properties, composition and dimensions of the penetrator are known, then the thermal properties of this pristine material may be recovered although this will be a challenging measurement. We report on investigations, using a numerical thermal model, to simulate a variety of scenarios that the anchor may encounter and how they will affect the measurement
Parametric analysis of energy harvesting pavements operated by air convection
In this paper, an energy harvesting pavement prototype using air as the operating fluid is described and analysed. The prototype harvests the thermal energy available in the pavement through pipes embedded in its structure, where air flows thanks to natural convection. The air is able to exit the system through an updraft chimney. A parametric analysis of the controllable parameters of interest is performed in this work in order to evaluate the variation in the performance of the energy harvesting prototype in different experimental setups.
This study shows that there exists a maximum value for the air speed in each configuration and that the energy harvesting efficiency depends on the height and the diameter of the chimney. Moreover, there is a minimum value of the chimney diameter that does not allow air movement and makes the whole system behave as if no pipes were embedded in the pavement structure
The HADES mission concept – Astrobiological survey of Jupiter's icy moon Europa
The HADES Europa mission concept aims to provide a framework for an astrobiological in-depth investigation of the Jupiter moon Europa, relying on existing technologies and feasibility. This mission study proposes a system consisting of an orbiter, lander and cryobot as a platform for detailed exploration of Europa. While the orbiter will investigate the presence of a liquid ocean and characterize Europa's internal structure, the lander will survey local dynamics of the ice layer and the surface environment. The lander releases a cryobot, that melts into the ice, will sample the pristine subsurface and is expected to provide data on organic and gaseous content and putative bio-signatures. In summary, we present the scientific objectives for an astrobiological investigation of Europa, resulting in a mission concept with a detailed evaluation of scientific instrumentation, mission sequences, basic design of the spacecraft, technology needs and cost estimations
The activity of Main Belt comets
Main Belt comets represent a recently discovered class of objects. They are
quite intriguing because, while having a Tisserand invariant value higher than
3, are showing cometary activity. We study the activity of the Main Belt comets
making the assumption that they are icy-bodies and that the activity has been
triggered by an impact. We determine the characteristics of this activity and
if the nowadays impact rate in the Main Asteroid Belt is compatible with the
hypothesis of an activity triggered by a recent impact. Due to the fact that
the Main Belt comets can be considered as a kind of comets, we apply a thermal
evolution model developed for icy bodies in order to simulate their activity.
We also apply a model to derive the impact rate, with respect to the size of
the impactor, in the Main Belt. We demonstrate that a stable activity can
result from a recent impact, able to expose ice-rich layers, and that the
impact rate in the Main Belt is compatible with this explanation.Comment: 9 pages, 7 figure
Multiple scattering of light in a spherical cometary atmosphere with an axisymmetric dust jet
We have developed a numerical solution for the anisotropic multiple scattering of light in a cometary atmosphere. The atmosphere is assumed to be a spherical shell illuminated by parallel solar rays. The spatial variation of dust in the coma is symmetric about the Sun-comet axis. Multiple scattering of photons is determined by lambda iteration.We study two model dust profiles: (1) a spherically symmetric profile and (2) an axisymmetric dust jet at the comet's subsolar point. Calculation is made of the flux of visible energy impinging on the nucleus surface, the mean intensity of visible light throughout the coma, and an approximate solution for the flux of thermal radiation at the comet surface due to emission from dust particles in the coma. We determine conditions under which single and multiple scattering each become significant. Under all conditions examined, at no point on the nucleus surface does the radiant flux exceed the visible flux at the subsolar point of a bare nucleus.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/29918/1/0000275.pd
- …