Gravitational Lensing at Millimeter Wavelengths

With today's millimeter and submillimeter instruments observers use gravitational lensing mostly as a tool to boost the sensitivity when observing distant objects. This is evident through the dominance of gravitationally lensed objects among those detected in CO rotational lines at z>1. It is also evident in the use of lensing magnification by galaxy clusters in order to reach faint submm/mm continuum sources. There are, however, a few cases where millimeter lines have been directly involved in understanding lensing configurations. Future mm/submm instruments, such as the ALMA interferometer, will have both the sensitivity and the angular resolution to allow detailed observations of gravitational lenses. The almost constant sensitivity to dust emission over the redshift range z=1-10 means that the likelihood for strong lensing of dust continuum sources is much higher than for optically selected sources. A large number of new strong lenses are therefore likely to be discovered with ALMA, allowing a direct assessment of cosmological parameters through lens statistics. Combined with an angular resolution <0.1", ALMA will also be efficient for probing the gravitational potential of galaxy clusters, where we will be able to study both the sources and the lenses themselves, free of obscuration and extinction corrections, derive rotation curves for the lenses, their orientation and, thus, greatly constrain lens models.Comment: 69 pages, Review on quasar lensing. Part of a LNP Topical Volume on "Dark matter and gravitational lensing", eds. F. Courbin, D. Minniti. To be published by Springer-Verlag 2002. Paper with full resolution figures can be found at ftp://oden.oso.chalmers.se/pub/tommy/mmviews.ps.g

Constraining the neutrino emission of gravitationally lensed Flat-Spectrum Radio Quasars with ANTARES data

This paper proposes to exploit gravitational lensing effects to improve the sensitivity of neutrino telescopes to the intrinsic neutrino emission of distant blazar populations. This strategy is illustrated with a search for cosmic neutrinos in the direction of four distant and gravitationally lensed Flat-Spectrum Radio Quasars. The magnification factor is estimated for each system assuming a singular isothermal profile for the lens. Based on data collected from 2007 to 2012 by the ANTARES neutrino telescope, the strongest constraint is obtained from the lensed quasar B0218+357, providing a limit on the total neutrino luminosity of this source of 1.08 x 10(46) erg s(-1) This limit is about one order of magnitude lower than those previously obtained in the ANTARES standard point source searches with non-lensed Flat-Spectrum Radio Quasars

Helium identification with LHCb

The identification of helium nuclei at LHCb is achieved using a method based on measurements of ionisation losses in the silicon sensors and timing measurements in the Outer Tracker drift tubes. The background from photon conversions is reduced using the RICH detectors and an isolation requirement. The method is developed using pp collision data at √(s) = 13 TeV recorded by the LHCb experiment in the years 2016 to 2018, corresponding to an integrated luminosity of 5.5 fb-1. A total of around 105 helium and antihelium candidates are identified with negligible background contamination. The helium identification efficiency is estimated to be approximately 50% with a corresponding background rejection rate of up to O(10^12). These results demonstrate the feasibility of a rich programme of measurements of QCD and astrophysics interest involving light nuclei

Momentum scale calibration of the LHCb spectrometer

For accurate determination of particle masses accurate knowledge of the momentum scale of the detectors is crucial. The procedure used to calibrate the momentum scale of the LHCb spectrometer is described and illustrated using the performance obtained with an integrated luminosity of 1.6 fb-1 collected during 2016 in pp running. The procedure uses large samples of J/ψ → μ + μ - and B+ → J/ψ K + decays and leads to a relative accuracy of 3 × 10-4 on the momentum scale

Curvature-bias corrections using a pseudomass method

Momentum measurements for very high momentum charged particles, such as muons from electroweak vector boson decays, are particularly susceptible to charge-dependent curvature biases that arise from misalignments of tracking detectors. Low momentum charged particles used in alignment procedures have limited sensitivity to coherent displacements of such detectors, and therefore are unable to fully constrain these misalignments to the precision necessary for studies of electroweak physics. Additional approaches are therefore required to understand and correct for these effects. In this paper the curvature biases present at the LHCb detector are studied using the pseudomass method in proton-proton collision data recorded at centre of mass energy √(s)=13 TeV during 2016, 2017 and 2018. The biases are determined using Z→μ + μ - decays in intervals defined by the data-taking period, magnet polarity and muon direction. Correcting for these biases, which are typically at the 10-4 GeV-1 level, improves the Z→μ + μ - mass resolution by roughly 18% and eliminates several pathological trends in the kinematic-dependence of the mean dimuon invariant mass

Measurement of CP asymmetries and branching fraction ratios of B− decays to two charm mesons

The $CP$ asymmetries of seven $B^-$ decays to two charm mesons are measured using data corresponding to an integrated luminosity of $9\text{fb}^{-1}$ of proton-proton collisions collected by the LHCb experiment. Decays involving a $D^{*0}$ or $D^{*-}_s$ meson are analysed by reconstructing only the $D^0$ or $D^-_s$ decay products. This paper presents the first measurement of $\mathcal{A}^{CP}(B^- \rightarrow D^{*-}_s D^0)$ and $\mathcal{A}^{CP}(B^- \rightarrow D^{-}_s D^{*0})$, and the most precise measurement of the other five $CP$ asymmetries. There is no evidence of $CP$ violation in any of the analysed decays. Additionally, two ratios between branching fractions of selected decays are measured.The CP asymmetries of seven B$^{−}$ decays to two charm mesons are measured using data corresponding to an integrated luminosity of 9 fb$^{−1}$ of proton-proton collisions collected by the LHCb experiment. Decays involving a D$^{*0}$ or ${D}_s^{\ast -}$ meson are analysed by reconstructing only the D$^{0}$ or ${D}_s^{-}$ decay products. This paper presents the first measurement of $\mathcal{A} ^{CP}$(B$^{−}$→${D}_s^{\ast -}$D$^{0}$) and $\mathcal{A} ^{CP}$(B$^{−}$→${D}_s^{-}$D$^{∗0}$), and the most precise measurement of the other five CP asymmetries. There is no evidence of CP violation in any of the analysed decays. Additionally, two ratios between branching fractions of selected decays are measured.[graphic not available: see fulltext]The $CP$ asymmetries of seven $B^-$ decays to two charm mesons are measured using data corresponding to an integrated luminosity of $9\text{ fb}^{-1}$ of proton-proton collisions collected by the LHCb experiment. Decays involving a $D^{*0}$ or $D^{*-}_s$ meson are analysed by reconstructing only the $D^0$ or $D^-_s$ decay products. This paper presents the first measurement of $\mathcal{A}^{CP}(B^- \rightarrow D^{*-}_s D^0)$ and $\mathcal{A}^{CP}(B^- \rightarrow D^{-}_s D^{*0})$, and the most precise measurement of the other five $CP$ asymmetries. There is no evidence of $CP$ violation in any of the analysed decays. Additionally, two ratios between branching fractions of selected decays are measured

The LHCb upgrade I

The LHCb upgrade represents a major change of the experiment. The detectors have been almost completely renewed to allow running at an instantaneous luminosity five times larger than that of the previous running periods. Readout of all detectors into an all-software trigger is central to the new design, facilitating the reconstruction of events at the maximum LHC interaction rate, and their selection in real time. The experiment's tracking system has been completely upgraded with a new pixel vertex detector, a silicon tracker upstream of the dipole magnet and three scintillating fibre tracking stations downstream of the magnet. The whole photon detection system of the RICH detectors has been renewed and the readout electronics of the calorimeter and muon systems have been fully overhauled. The first stage of the all-software trigger is implemented on a GPU farm. The output of the trigger provides a combination of totally reconstructed physics objects, such as tracks and vertices, ready for final analysis, and of entire events which need further offline reprocessing. This scheme required a complete revision of the computing model and rewriting of the experiment's software