Photoprotection through ultrafast charge recombination in photochemical reaction centres under oxidizing conditions

Engineering natural photosynthesis to address predicted shortfalls in food and energy supply requires a detailed understanding of its molecular basis and the intrinsic photoprotective mechanisms that operate under fluctuating environmental conditions. Long-lived triplet or singlet excited electronic states have the potential to cause photodamage, particularly in the presence of oxygen, and so a variety of mechanisms exist to prevent formation of such states or safely dissipate their energy. Here, we report a dramatic difference in spectral evolution in fully reduced and partially oxidized Rhodobacter sphaeroides reaction centres (RCs) following excitation of the monomeric bacteriochlorophyll (BChl) cofactors at 805 nm. Three types of preparation were studied, including RCs purified as protein/lipid nanodiscs using the copolymer styrene maleic acid. In fully reduced RCs such excitation produces membrane-spanning charge separation. In preparations of partially oxidized RCs the spectroscopic signature of this charge separation is replaced by that of an energy dissipation process, including in the majority sub-population of reduced RCs. This process, which appears to take place on both cofactor branches, involves formation of a BChl(+)/bacteriopheophytin(-) radical pair that dissipates energy via recombination to a vibrationally hot ground state. The possible physiological role of this dissipative process under mildly oxidizing conditions is considered

The effectiveness of styrene-maleic acid (SMA) copolymers for solubilisation of integral membrane proteins from SMA-accessible and SMA-resistant membranes

Solubilisation of biological lipid bilayer membranes for analysis of their protein complement has traditionally been carried out using detergents, but there is increasing interest in the use of amphiphilic copolymers such as styrene maleic acid (SMA) for the solubilisation, purification and characterisation of integral membrane proteins in the form of protein/lipid nanodiscs. Here we survey the effectiveness of various commercially-available formulations of the SMA copolymer in solubilising Rhodobacter sphaeroides reaction centres (RCs) from photosynthetic membranes. We find that formulations of SMA with a 2:1 or 3:1 ratio of styrene to maleic acid are almost as effective as detergent in solubilising RCs, with the best solubilisation by short chain variants ( < 30 kDa weight average molecular weight). The effectiveness of 10 kDa 2:1 and 3:1 formulations of SMA to solubilise RCs gradually declined when genetically-encoded coiled-coil bundles were used to artificially tether normally monomeric RCs into dimeric, trimeric and tetrameric multimers. The ability of SMA to solubilise reaction centre-light harvesting 1 (RC-LH1) complexes from densely packed and highly ordered photosynthetic membranes was uniformly low, but could be increased through a variety of treatments to increase the lipid:protein ratio. However, proteins isolated from such membranes comprised clusters of complexes in small membrane patches rather than individual proteins. We conclude that short-chain 2:1 and 3:1 formulations of SMA are the most effective in solubilising integral membrane proteins, but that solubilisation efficiencies are strongly influenced by the size of the target protein and the density of packing of proteins in the membrane

On the mechanism of ubiquinone mediated photocurrent generation by a reaction center based photocathode

Upon photoexcitation, the reaction center (RC) pigment-proteins that facilitate natural photosynthesis achieve a metastable separation of electrical charge among the embedded cofactors. Because of the high quantum efficiency of this process, there is a growing interest in their incorporation into biohybrid materials for solar energy conversion, bioelectronics and biosensing. Multiple bioelectrochemical studies have shown that reaction centers from various photosynthetic organisms can be interfaced with diverse electrode materials for the generation of photocurrents, but many mechanistic aspects of native protein functionality in a non-native environment is unknown. In vivo, RC's catalyse ubiquinone-10 reduction, protonation and exchange with other lipid phase ubiquinone-10s via protein-controlled spatial orientation and protein rearrangement. In contrast, the mechanism of ubiquinone-0 reduction, used to facilitate fast RC turnover in an aqueous photoelectrochemical cell (PEC), may not proceed via the same pathway as the native cofactor. In this report we show truncation of the native isoprene tail results in larger RC turnover rates in a PEC despite the removal of the tail's purported role of ubiquinone headgroup orientation and binding. Through the use of reaction centers with single or double mutations, we also show the extent to which two-electron/two-proton ubiquinone chemistry that operates in vivo also underpins the ubiquinone-0 reduction by surface-adsorbed RCs in a PEC. This reveals that only the ubiquinone headgroup is critical to the fast turnover of the RC in a PEC and provides insight into design principles for the development of new biophotovoltaic cells and biosensors

Foot-and-mouth disease in red deer - experimental infection and test methods performance

The aim of this study was to evaluate a number of foot-and-mouth disease (FMD) test methods for use in red deer. Ten animals were intranasally inoculated with the FMD virus (FMDV) O UKG 11/2001, monitored for clinical signs, and samples taken regularly (blood, serum, oral swabs, nasal swabs, probang samples and lesion swabs, if present) over a 4-week period. Only one animal, deer 1103, developed clinical signs (lesions under the tongue and at the coronary band of the right hind hoof). It tested positive by 3D and IRES real-time reverse transcription polymerase chain reaction (rRT-PCR) in various swabs, lesion materials and serum. In a non-structural protein (NSP) in-house ELISA (NSP-ELISA-IH), one commercial ELISA (NSP-ELISA-PR) and a commercial antibody NSP pen side test, only deer 1103 showed positive results from day post-inoculation (dpi) 14 onwards. Two other NSP-ELISAs detected anti-NSP serum antibodies with lower sensitivity. It also showed rising antibody levels in the virus neutralization test (VNT), the in-house SPO-ELISA-IH and the commercial SPO-ELISA-PR at dpi 9, and in another two commercial SPO-ELISAs at dpi 12 (SPO-ELISA-IV) and dpi 19 (SPO-ELISA-IZ), respectively. Six of the red deer that had been rRT-PCR and antibody negative were re-inoculated intramuscularly with the same O-serotype FMDV at dpi 14. None of these animals became rRT-PCR or NSP-ELISA positive, but all six animals became positive in the VNT, the in-house SPO-ELISA-IH and the commercial SPO-ELISA-PR. Two other commercial SPO-ELISAs were less sensitive or failed to detect animals as positive. The rRT-PCRs and the four most sensitive commercial ELISAs that had been used for the experimentally inoculated deer were further evaluated for diagnostic specificity (DSP) using 950 serum samples and 200 nasal swabs from non-infected animals. DSPs were 100% for the rRT-PCRs and between 99.8 and 100% for the ELISAs

Examining the stability of membrane proteins within SMALPs

Amphipathic co-polymers such as styrene-maleic acid (SMA) have gained popularity over the last few years due to their ability and ease of use in solubilising and purifying membrane proteins in comparison to conventional methods of extraction such as detergents. SMA2000 is widely used for membrane protein studies and is considered as the optimal polymer for this technique. In this study a side-by-side comparison of SMA2000 with the polymer SZ30010 was carried out as both these polymers have similar styrene:maleic acid ratios and average molecular weights. Ability to solubilise, purify and stabilise membrane proteins was tested using three structurally different membrane proteins. Our results show that both polymers can be used to extract membrane proteins at a comparable efficiency to conventional detergent dodecylmaltoside (DDM). SZ30010 was found to give a similar protein yield and, SMALP disc size as SMA2000, and both polymers offered an increased purity and increased thermostability compared to DDM. Further investigation was conducted to investigate SMALP sensitivity to divalent cations. It was found that the sensitivity is polymer specific and not dependent on the protein encapsulated. Neither is it affected by the concentration of SMALPs. Larger divalent cations such as Co2+ and Zn2+ resulted in an increased sensitivity

Encapsulated membrane proteins: a simplified system for molecular simulation

Over the past 50 years there has been considerable progress in our understanding of biomolecular interactions at an atomic level. This in turn has allowed molecular simulation methods employing full atomistic modeling at ever larger scales to develop. However, some challenging areas still remain where there is either a lack of atomic resolution structures or where the simulation system is inherently complex. An area where both challenges are present is that of membranes containing membrane proteins. In this review we analyse a new practical approach to membrane protein study that offers a potential new route to high resolution structures and the possibility to simplify simulations. These new approaches collectively recognise that preservation of the interaction between the membrane protein and the lipid bilayer is often essential to maintain structure and function. The new methods preserve these interactions by producing nano-scale disc shaped particles that include bilayer and the chosen protein. Currently two approaches lead in this area: the MSP system that relies on peptides to stabilise the discs, and SMALPs where an amphipathic styrene maleic acid copolymer is used. Both methods greatly enable protein production and hence have the potential to accelerate atomic resolution structure determination as well as providing a simplified format for simulations of membrane protein dynamics

Cryo-EM structure of the spinach cytochrome b6 f complex at 3.6 Å resolution.

The cytochrome b6 f (cytb6 f ) complex has a central role in oxygenic photosynthesis, linking electron transfer between photosystems I and II and converting solar energy into a transmembrane proton gradient for ATP synthesis1-3. Electron transfer within cytb6 f occurs via the quinol (Q) cycle, which catalyses the oxidation of plastoquinol (PQH2) and the reduction of both plastocyanin (PC) and plastoquinone (PQ) at two separate sites via electron bifurcation2. In higher plants, cytb6 f also acts as a redox-sensing hub, pivotal to the regulation of light harvesting and cyclic electron transfer that protect against metabolic and environmental stresses3. Here we present a 3.6 Å resolution cryo-electron microscopy (cryo-EM) structure of the dimeric cytb6 f complex from spinach, which reveals the structural basis for operation of the Q cycle and its redox-sensing function. The complex contains up to three natively bound PQ molecules. The first, PQ1, is located in one cytb6 f monomer near the PQ oxidation site (Qp) adjacent to haem bp and chlorophyll a. Two conformations of the chlorophyll a phytyl tail were resolved, one that prevents access to the Qp site and another that permits it, supporting a gating function for the chlorophyll a involved in redox sensing. PQ2 straddles the intermonomer cavity, partially obstructing the PQ reduction site (Qn) on the PQ1 side and committing the electron transfer network to turnover at the occupied Qn site in the neighbouring monomer. A conformational switch involving the haem cn propionate promotes two-electron, two-proton reduction at the Qn site and avoids formation of the reactive intermediate semiquinone. The location of a tentatively assigned third PQ molecule is consistent with a transition between the Qp and Qn sites in opposite monomers during the Q cycle. The spinach cytb6 f structure therefore provides new insights into how the complex fulfils its catalytic and regulatory roles in photosynthesis

Membrane protein extraction and purification using styrene-maleic acid (SMA) co-polymer:effect of variations in polymer structure

The use of styrene maleic acid (SMA) co-polymers to extract and purify transmembrane proteins, whilst retaining their native bilayer environment, overcomes many of the disadvantages associated with conventional detergent based procedures. This approach has huge potential for the future of membrane protein structural and functional studies. In this investigation we have systematically tested a range of commercially available SMA polymers, varying in both the ratio of styrene to maleic acid and in total size, for the ability to extract, purify and stabilise transmembrane proteins. Three different membrane proteins (BmrA, LeuT and ZipA) which vary in size and shape were used. Our results show that several polymers can be used to extract membrane proteins comparably to conventional detergents. A styrene:maleic acid ratio of either 2:1 or 3:1, combined with a relatively small average molecular weight (7.5-10 kDa) is optimal for membrane extraction, and this appears to be independent of the protein size, shape or expression system. A subset of polymers were taken forward for purification, functional and stability tests. Following a one-step affinity purification SMA 2000 was found to be the best choice for yield, purity and function. However the other polymers offer subtle differences in size and sensitivity to divalent cations that may be useful for a variety of downstream applications