Fate of rising methane bubbles in stratified waters: How much methane reaches the atmosphere?

There is growing concern about the transfer of methane originating from water bodies to the atmosphere. Methane from sediments can reach the atmosphere directly via bubbles or indirectly via vertical turbulent transport. This work quantifies methane gas bubble dissolution using a combination of bubble modeling and acoustic observations of rising bubbles to determine what fraction of the methane transported by bubbles will reach the atmosphere. The bubble model predicts the evolving bubble size, gas composition, and rise distance and is suitable for almost all aquatic environments. The model was validated using methane and argon bubble dissolution measurements obtained from the literature for deep, oxic, saline water with excellent results. Methane bubbles from within the hydrate stability zone (typically below ∼500 m water depth in the ocean) are believed to form an outer hydrate rim. To explain the subsequent slow dissolution, a model calibration was performed using bubble dissolution data from the literature measured within the hydrate stability zone. The calibrated model explains the impressively tall flares (>1300 m) observed in the hydrate stability zone of the Black Sea. This study suggests that only a small amount of methane reaches the surface at active seep sites in the Black Sea, and this only from very shallow water areas (<100 m). Clearly, the Black Sea and the ocean are rather effective barriers against the transfer of bubble methane to the atmosphere, although substantial amounts of methane may reach the surface in shallow lakes and reservoirs

Target strength of skipjack tuna (Katsuwanus pelamis) associated with fish aggregating devices (FADs)

[EN] This paper presents measures of target strength (TS; dB re 1 m(2)) and models of TS vs. fork length (L; cm), i.e. TS = 20log(L) + b(20), for skip-jack tuna associated with fish aggregating devices (FADs) in the Central Pacific Ocean. Measurements were made using 38-, 120-, and 200-kHz split-beam echosounders on a purse-seine workboat during fishing operations. To mitigate potential bias due to unresolved targets, TS measurements were rejected if they were not simultaneously detected with multiple echosounder frequencies in approximately the same location. The filtered TS and concomitantly sampled L data were used to estimate b(20) = -76, -71, and -70.5 dB for 38, 120, and 200 kHz, respectively, using the method of least squares. For comparison, quasi-independent estimates of TS and b(20) were calculated from acoustic echo-integration and catch data representing entire aggregations around the FADs. The results differed by <= 1 dB for all three frequencies. The sensitivities of these results to variations in fish morphology and behaviour were explored using a simulation of TS for fish without swimbladders. The utility of the results on acoustic properties of skipjack tuna and next research steps to achieve selective fishing at FADs are discussed.We thank the following organizations and people for their support of this work: the governments of Kiribati, Tuvalu, and Tokelau which permitted this research in their EEZs; Albacora for allowing this work aboard F/V ALBATUN TRES; Fishing Master Euken Mujika; the captain and crew; the scientists and divers J. Filmalter and F. Forget are thanked for invaluable insight about fish behaviour, vertical stratification and non-target species composition at FADs; Hector Pena for providing instruction on the sonar setup and analysis; Yolanda Lacalle for the illustration in Figure 2; and Andres Uriarte for advice concerning transmission of statistical errors. The research reported in the present document was funded by the International Seafood Sustainability Foundation (ISSF) and conducted independently by the authors. The report and its results, professional opinions and conclusions are solely the work of the authors. This paper is contribution 843 from AZTI (Marine or Food Research).Boyra, G..; Moreno, G.; Sobradillo, B.; Pérez Arjona, I.; Sancristóbal, I.; Demer, D. (2018). Target strength of skipjack tuna (Katsuwanus pelamis) associated with fish aggregating devices (FADs). ICES Journal of Marine Science. 75(5):1790-1802. https://doi.org/10.1093/icesjms/fsy041S1790180275