Highly efficient and selective extraction of uranium from aqueous solution by a magnetic device: succinyl-ß-cyclodextrin-APTES@maghemite nanoparticles

The removal of radio-elements, notably uranium, from waste-waters is crucial for public health and environmental remediation. To this end, succinyl-ß-cyclodextrin (SßCD) is grafted onto maghemite nanoparticles (NPs) synthesized by the polyol method. The nanocomposite was well characterized. The adsorption of U(VI) by SßCD-APTES@Fe2O3 is pH-dependent with a maximum at pH 6. Adsorption occurs mainly by complex formation and displays a very good selectivity for U(VI) compared to other cations such as Cs+, K+, Na+, Mg2+ and Al3+. The data were plotted according to the Langmuir, Freundlich, Elovich, Temkin and Halsey isotherms. The Langmuir isotherm maximum adsorption capacity (qmax) is 286 mg U g-1 and higher than for other reported sorbents. Moreover, Cs-corrected STEM visualizes the uranium on the NP surface, which is consistent with the Halsey isotherm model for multilayer adsorption. The U(VI) adsorbed on SßCD-APTES@Fe2O3 is easily recovered by magnetic sedimentation and desorption performed in a small volume in order to concentrate the extract. The nanocomposite can be regenerated and re-used at least tenfold

Atmospheric trace metal concentrations, solubility and deposition fluxes in remote marine air over the south-east Atlantic

Total and soluble trace metal concentrations were determined in atmospheric aerosol and rainwater samples collected during seven cruises in the south-east Atlantic. Back trajectories indicated the samples all represented remote marine air masses, consistent with climatological expectations. Aerosol trace metal loadings were similar to previous measurements in clean, marine air masses. Median total Fe, Al, Mn, V, Co and Zn concentrations were 206, 346, 5, 3, 0.7 and 11 pmol m-3 respectively. Solubility was operationally defined as the fraction extractable using a pH4.7 ammonium acetate leach. Median soluble Fe, Al, Mn, V, Co, Zn, Cu, Ni, Cd and Pb concentrations were 6, 55, 1, 0.7, 0.06, 24, 2, 1, 0.05 and 0.3 pmol m-3 respectively. Large ranges in fractional solubility were observed for all elements except Co; median solubility values for Fe, Al and Mn were below 20% while the median for Zn was 74%. Volume weighted mean rainwater concentrations were 704, 792, 32, 10, 3, 686, 25, 0.02, 0.3 and 10 nmol L-1 for Fe, Al, Mn, V, Co, Zn, Cu, Ni, Cd and Pb respectively (n = 6). Wet deposition fluxes calculated from these values suggest rain makes a significant contribution to total deposition in the study area for all elements except perhaps Ni

Effect of wind speed on aerosol optical depth over remote oceans, based on data from the Maritime Aerosol Network

The Maritime Aerosol Network (MAN) has been collecting data over the oceans since November 2006. The MAN archive provides a valuable resource for aerosol studies in maritime environments. In the current paper we investigate correlations between ship-borne aerosol optical depth (AOD) and near-surface wind speed, either measured (onboard or from satellite) or modeled (NCEP). According to our analysis, wind speed influences columnar aerosol optical depth, although the slope of the linear regression between AOD and wind speed is not steep (~0.004–0.005), even for strong winds over 10 m s−1. The relationships show significant scatter (correlation coefficients typically in the range 0.3–0.5); the majority of this scatter can be explained by the uncertainty on the input data. The various wind speed sources considered yield similar patterns. Results are in good agreement with the majority of previously published relationships between surface wind speed and ship-based or satellite-based AOD measurements. The basic relationships are similar for all the wind speed sources considered; however, the gradient of the relationship varies by around a factor of two depending on the wind data used

Maghemite nanoparticles bearing di(amidoxime) groups for the extraction of uranium from wastewaters

Polyamidoximes (pAMD) are known to have strong affinities for uranyl cations. Grafting pAMD onto the surface of functionalized maghemite nanoparticles (MNP) leads to a nanomaterial with high capacities in the extraction of uranium from wastewaters by magnetic sedimentation. A diamidoxime (dAMD) specifically synthesized for this purpose showed a strong affinity for uranyl: Ka = 105 M-1 as determined by Isothermal Titration Calorimetry (nano-ITC). The dAMD was grafted onto the surface of MNP and the obtained sorbent (MNP-dAMD) was characterized. The nanohybrids were afterward incubated with different concentrations of uranyl and the solid phase recovered by magnetic separation. This latter was characterized by zeta-potential measurements, X-Ray Photoelectron Spectroscopy (XPS) and X-Ray Fluorescence spectroscopy (XRF), whereas the supernatant was analyzed by Inductively Coupled Plasma coupled to Mass Spectrometry (ICP-MS). All the data fitted the models of Langmuir, Freundlich and Temkin isotherms very well. These isotherms allowed us to evaluate the efficiency of the adsorption of uranium by MNP-dAMD. The saturation sorption capacity (qmax) was determined. It indicates that MNP-dAMD is able to extract up to 120 mg of uranium per gram of sorbent. Spherical aberration (Cs)-corrected High-Resolution Scanning Transmission Electron Microscopy (HRSTEM) confirmed these results and clearly showed that uranium is confined at the surface of the sorbent. Thus, MNP-dAMD presents a strong potential for the extraction of uranium from wastewaters

New constraints on elemental and Pb and Nd isotope compositions of South American and Southern African aerosol sources to the South Atlantic Ocean

Improving the geochemical database available for characterising potential natural and anthropogenic aerosol sources from South America and Southern Africa is a critical precondition for studies aimed at understanding trace metal controls on the marine biogeochemical cycles of the South Atlantic Ocean. We here present new elemental and isotopic data for a wide range of sample types from South America and Southern Africa that are potentially important aerosol sources. This includes road dust from Buenos Aires and lichen samples from Johannesburg, soil dust from Patagonia, volcanic ash from the Andean volcanic belt, and aerosol samples from São Paulo. All samples were investigated for major (Al, Ca, Fe, Mg, Na, K, Mn) and trace element (Cd, Co, Cr, Cu, Ni, Pb, REE, Sc, Th, Y, V, Zn) concentrations and Nd and Pb isotopic compositions. We show that diagrams of 208Pb/207Pb vs. εNd, 208Pb/207Pb vs. Pb/Al, 1/[Pb], Zn/Al, Cd/Al, Cu/Al, and εNd vs. Pb/Al, and 1/[Nd] are best suited to separate South American and South African source regions as well as natural and anthropogenic sources. A subset of samples from Patagonia and the Andes was additionally subjected to separation of a fine (<5 μm) fraction and compared to the composition of the bulk sample. We show that differences in the geochemical signature of bulk samples between individual regions and source types are significantly larger than between grain sizes. Jointly, these findings present an important step forward towards a quantitative assessment of aeolian trace metal inputs to the South Atlantic Ocean

Methods for the sampling and analysis of marine aerosols: results from the 2008 GEOTRACES aerosol intercalibration experiment

Atmospheric deposition of trace elements and isotopes (TEI) is an important source of trace metals to the open ocean, impacting TEI budgets and distributions, stimulating oceanic primary productivity, and influencing biological community structure and function. Thus, accurate sampling of aerosol TEIs is a vital component of ongoing GEOTRACES cruises, and standardized aerosol TEI sampling and analysis procedures allow the comparison of data from different sites and investigators. Here, we report the results of an aerosol analysis intercalibration study by seventeen laboratories for select GEOTRACES-relevant aerosol species (Al, Fe, Ti, V, Zn, Pb, Hg, NO3-, and SO42-) for samples collected in September 2008. The collection equipment and filter substrates are appropriate for the GEOTRACES program, as evidenced by low blanks and detection limits relative to analyte concentrations. Analysis of bulk aerosol sample replicates were in better agreement when the processing protocol was constrained (+/- 9% RSD or better on replicate analyses by a single lab, n = 7) than when it was not (generally 20% RSD or worse among laboratories using different methodologies), suggesting that the observed variability was mainly due to methodological differences rather than sample heterogeneity. Much greater variability was observed for fractional solubility of aerosol trace elements and major anions, due to differing extraction methods. Accuracy is difficult to establish without an SRM representative of aerosols, and we are developing an SRM for this purpose. Based on these findings, we provide recommendations for the GEOTRACES program to and macro-nutrients to the open ocean (Okin et al. 2011) and is a key component of the international GEOTRACES program (GEOTRACES Planning Group 2006). A priority of the GEOTRACES program is to quantify both major and trace elements (e. g., Al, Fe, Ti, V, Zn, Pb, and Hg) and species such as nitrate and sulfate in marine aerosols. Therefore, marine aerosol samples collected during GEOTRACES cruises must follow sampling protocols that permit the collection and analysis of as many elements and compounds as possible, while meeting the constraints associated with basin-wide oceanographic cruises (e. g., space limitations, high-frequency sampling, etc.)

Atmospheric aerosols at the Pierre Auger Observatory and environmental implications

The Pierre Auger Observatory detects the highest energy cosmic rays. Calorimetric measurements of extensive air showers induced by cosmic rays are performed with a fluorescence detector. Thus, one of the main challenges is the atmospheric monitoring, especially for aerosols in suspension in the atmosphere. Several methods are described which have been developed to measure the aerosol optical depth profile and aerosol phase function, using lasers and other light sources as recorded by the fluorescence detector. The origin of atmospheric aerosols traveling through the Auger site is also presented, highlighting the effect of surrounding areas to atmospheric properties. In the aim to extend the Pierre Auger Observatory to an atmospheric research platform, a discussion about a collaborative project is presented.Comment: Regular Article, 16 pages, 12 figure

Effect of wind speed on aerosol optical depth over remote oceans, based on data from the Maritime Aerosol Network

The Maritime Aerosol Network (MAN) has been collecting data over the oceans since November 2006. The MAN archive provides a valuable resource for aerosol studies in maritime environments. In the current paper we investigate correlations between ship-borne aerosol optical depth (AOD) and near-surface wind speed, either measured (onboard or from satellite) or modeled (NCEP). According to our analysis, wind speed influences columnar aerosol optical depth, although the slope of the linear regression between AOD and wind speed is not steep (~0.004–0.005), even for strong winds over 10 m s&lt;sup&gt;−1&lt;/sup&gt;. The relationships show significant scatter (correlation coefficients typically in the range 0.3–0.5); the majority of this scatter can be explained by the uncertainty on the input data. The various wind speed sources considered yield similar patterns. Results are in good agreement with the majority of previously published relationships between surface wind speed and ship-based or satellite-based AOD measurements. The basic relationships are similar for all the wind speed sources considered; however, the gradient of the relationship varies by around a factor of two depending on the wind data used

Atmospheric deposition of soluble trace elements along the Atlantic Meridional Transect (AMT)

We briefly review the role of atmospheric deposition measurements within the Atlantic Meridional Transect (AMT) programme and then go on to present new data on the soluble concentrations of a range of trace metals (Fe, Al, Mn, Ti, Zn, V, Ni and Cu) and major ions in aerosols collected along the AMT transect. The results allow us to identify emission sources of the trace metals particularly in terms of the relative importance of anthropogenic versus crustal sources. We identify strong gradients in concentrations and deposition for both crustal and anthropogenically sourced metals with much higher inputs to the North Atlantic compared to the South Atlantic, reflecting stronger land based emission sources in the Northern Hemisphere. We suggest anthropogenic sources of Ni and V may include an important component from shipping. We consider the extent to which these gradients are reflected in surface water concentrations of these metals based on the GEOTRACES water column trace metal data. We find there is a clear difference in the concentrations of surface water dissolved Al and Fe between the north and south Atlantic gyres reflecting atmospheric inputs. However for Mn, V or Ni, higher inputs to the North Atlantic compared to the South Atlantic are not clearly reflected in their water column concentrations