Solar dynamic power systems for space station

The Parabolic Offset Linearly Actuated Reflector (POLAR) solar dynamic module was selected as the baseline design for a solar dynamic power system aboard the space station. The POLAR concept was chosen over other candidate designs after extensive trade studies. The primary advantages of the POLAR concept are the low mass moment of inertia of the module about the transverse boom and the compactness of the stowed module which enables packaging of two complete modules in the Shuttle orbiter payload bay. The fine pointing control system required for the solar dynamic module has been studied and initial results indicate that if disturbances from the station are allowed to back drive the rotary alpha joint, pointing errors caused by transient loads on the space station can be minimized. This would allow pointing controls to operate in bandwidths near system structural frequencies. The incorporation of the fine pointing control system into the solar dynamic module is fairly straightforward for the three strut concentrator support structure. However, results of structural analyses indicate that this three strut support is not optimum. Incorporation of a vernier pointing system into the proposed six strut support structure is being studied

New Spray Bar System Installed in NASA Lewis' Icing Research Tunnel

NASA Lewis Research Center's Icing Research Tunnel (IRT) is the world's largest refrigerated wind tunnel dedicated to the study of aircraft icing. In the IRT, natural icing conditions are duplicated to test the effects of in-flight icing on actual aircraft components and on scale models of airplanes and helicopters. The IRT's ability to reproduce a natural icing cloud was significantly improved with the recent installation of a new spray bar system. It is the spray bar system that transforms the low-speed wind tunnel into an icing wind tunnel by producing microscopic droplets of water and injecting them into the wind tunnel air stream in order to accurately simulate cloud moisture

New Icing Cloud Simulation System at the NASA Glenn Research Center Icing Research Tunnel

A new spray bar system was designed, fabricated, and installed in the NASA Glenn Research Center's Icing Research Tunnel (IRT). This system is key to the IRT's ability to do aircraft in-flight icing cloud simulation. The performance goals and requirements levied on the design of the new spray bar system included increased size of the uniform icing cloud in the IRT test section, faster system response time, and increased coverage of icing conditions as defined in Appendix C of the Federal Aviation Regulation (FAR), Part 25 and Part 29. Through significant changes to the mechanical and electrical designs of the previous-generation spray bar system, the performance goals and requirements were realized. Postinstallation aerodynamic and icing cloud calibrations were performed to quantify the changes and improvements made to the IRT test section flow quality and icing cloud characteristics. The new and improved capability to simulate aircraft encounters with in-flight icing clouds ensures that the 1RT will continue to provide a satisfactory icing ground-test simulation method to the aeronautics community

Characterising cancer-associated fibroblast heterogeneity in non-small cell lung cancer: a systematic review and meta-analysis.

Cancer-associated fibroblasts (CAFs) are a key component of the tumour microenvironment with evidence suggesting they represent a heterogeneous population. This study summarises the prognostic role of all proteins characterised in CAFs with immunohistochemistry in non-small cell lung cancer thus far. The functions of these proteins in cellular processes crucial to CAFs are also analysed. Five databases were searched to extract survival outcomes from published studies and statistical techniques, including a novel method, used to capture missing values from the literature. A total of 26 proteins were identified, 21 of which were combined into 7 common cellular processes key to CAFs. Quality assessments for sensitivity analyses were carried out for each study using the REMARK criteria whilst publication bias was assessed using funnel plots. Random effects models consistently identified the expression of podoplanin (Overall Survival (OS)/Disease-specific Survival (DSS), univariate analysis HR 2.25, 95% CIs 1.80-2.82) and α-SMA (OS/DSS, univariate analysis HR 2.11, 95% CIs 1.18-3.77) in CAFs as highly prognostic regardless of outcome measure or analysis method. Moreover, proteins involved in maintaining and generating the CAF phenotype (α-SMA, TGF-β and p-Smad2) proved highly significant after sensitivity analysis (HR 2.74, 95% CIs 1.74-4.33) supporting attempts at targeting this pathway for therapeutic benefit

Assessing diverse evidence to improve conservation decision-making

Meeting the urgent need to protect and restore ecosystems requires effective decision‐making through wisely considering a range of evidence. However, weighing and assessing evidence to make complex decisions is challenging, particularly when evidence is of diverse types, subjects, and sources, and varies greatly in its quality and relevance. To tackle these challenges, we present the Balance Evidence Assessment Method (BEAM), an intuitive way to weigh and assess the evidence relating to the core assumptions underpinning the planning and implementation of conservation projects, strategies, and actions. Our method directly tackles the question of how to bring together diverse evidence whilst assessing its relevance, reliability, and strength of support for a given assumption, which can be mapped, for example to a Theory of Change. We consider how simple principles and safeguards in applying this method could help to respectfully, and equitably, include more local forms of knowledge when assessing assumptions, such as by ensuring diverse groups of individuals contribute and assess evidence. The method can be flexibly applied within existing decision‐making tools, platforms, and frameworks whenever assumptions (i.e., claims and hypotheses) are made. This method could greatly facilitate and improve the weighing of diverse evidence to make decisions in a range of situations, from local projects to global policy platforms

Exsolution of catalytically active iridium nanoparticles from strontium titanate

The search for new functional materials that combine high stability and efficiency with reasonable cost and ease of synthesis is critical for their use in renewable energy applications. Specifically in catalysis, nanoparticles, with their high surface-to-volume ratio, can overcome the cost implications associated with otherwise having to use large amounts of noble metals. However, commercialized materials, that is, catalytic nanoparticles deposited on oxide supports, often suffer from loss of activity because of coarsening and carbon deposition during operation. Exsolution has proven to be an interesting strategy to overcome such issues. Here, the controlled emergence, or exsolution, of faceted iridium nanoparticles from a doped SrTiO3 perovskite is reported and their growth preliminary probed by in situ electron microscopy. Upon reduction of SrIr0.005Ti0.995O3, the generated nanoparticles show embedding into the oxide support, therefore preventing agglomeration and subsequent catalyst degradation. The advantages of this approach are the extremely low noble metal amount employed (∼0.5% weight) and the catalytic activity reported during CO oxidation tests, where the performance of the exsolved SrIr0.005Ti0.995O3 is compared to the activity of a commercial catalyst with 1% loading (1% Ir/Al2O3). The high activity obtained with such low doping shows the possibility of scaling up this new catalyst, reducing the high cost associated with iridium-based materials.PostprintPostprintPeer reviewe

Production and stability of low amount fraction of formaldehyde in hydrogen gas standards

Formaldehyde is an intermediate of the steam methane reforming process for hydrogen production. According to International Standard ISO 14687-2 the amount fraction level of formaldehyde present in hydrogen supplied to fuel cell electric vehicles (FCEV) must not exceed 10 nmol mol−1. The development of formaldehyde standards in hydrogen is crucial to validate the analytical results and ensure measurement reliability for the FCEV industry. NPL demonstrated that these standards can be gravimetrically prepared and validated at 10 μmol mol−1 with a shelf-life of 8 weeks (stability uncertainty <10%; k = 1), but that formaldehyde degrades into methanol and dimethoxymethane, as measured by FTIR, GC-MS and SIFT-MS. The degradation kinetics is more rapid than predicted by thermodynamics, this may be due to the internal gas cylinder surface acting as a catalyst. The identification of by-products (methanol and dimethoxymethane) requires further investigation to establish any potential undesirable impacts to the FCEV

Estimating the incidence of acute infectious intestinal disease in the community in the UK:A retrospective telephone survey

Objectives: To estimate the burden of intestinal infectious disease (IID) in the UK and determine whether disease burden estimations using a retrospective study design differ from those using a prospective study design. Design/Setting: A retrospective telephone survey undertaken in each of the four countries comprising the United Kingdom. Participants were randomly asked about illness either in the past 7 or 28 days. Participants: 14,813 individuals for all of whom we had a legible recording of their agreement to participate Outcomes: Self-reported IID, defined as loose stools or clinically significant vomiting lasting less than two weeks, in the absence of a known non-infectious cause. Results: The rate of self-reported IID varied substantially depending on whether asked for illness in the previous 7 or 28 days. After standardising for age and sex, and adjusting for the number of interviews completed each month and the relative size of each UK country, the estimated rate of IID in the 7-day recall group was 1,530 cases per 1,000 person-years (95% CI: 1135 – 2113), while in the 28-day recall group it was 533 cases per 1,000 person-years (95% CI: 377 – 778). There was no significant variation in rates between the four countries. Rates in this study were also higher than in a related prospective study undertaken at the same time. Conclusions: The estimated burden of disease from IID varied dramatically depending on study design. Retrospective studies of IID give higher estimates of disease burden than prospective studies. Of retrospective studies longer recall periods give lower estimated rates than studies with short recall periods. Caution needs to be exercised when comparing studies of self-reported IID as small changes in study design or case definition can markedly affect estimated rates

Origin of volatiles in the Main Belt

We propose a scenario for the formation of the Main Belt in which asteroids incorporated icy particles formed in the outer Solar Nebula. We calculate the composition of icy planetesimals formed beyond a heliocentric distance of 5 AU in the nebula by assuming that the abundances of all elements, in particular that of oxygen, are solar. As a result, we show that ices formed in the outer Solar Nebula are composed of a mix of clathrate hydrates, hydrates formed above 50 K and pure condensates produced at lower temperatures. We then consider the inward migration of solids initially produced in the outer Solar Nebula and show that a significant fraction may have drifted to the current position of the Main Belt without encountering temperature and pressure conditions high enough to vaporize the ices they contain. We propose that, through the detection and identification of initially buried ices revealed by recent impacts on the surfaces of asteroids, it could be possible to infer the thermodynamic conditions that were present within the Solar Nebula during the accretion of these bodies, and during the inward migration of icy planetesimals. We also investigate the potential influence that the incorporation of ices in asteroids may have on their porosities and densities. In particular, we show how the presence of ices reduces the value of the bulk density of a given body, and consequently modifies its macro-porosity from that which would be expected from a given taxonomic type.Comment: Accepted for publication in MNRA

Centerscope

Centerscope, formerly Scope, was published by the Boston University Medical Center "to communicate the concern of the Medical Center for the development and maintenance of improved health care in contemporary society.