Geant4 Simulation of a filtered X-ray Source for Radiation Damage Studies

Geant4 low energy extensions have been used to simulate the X-ray spectra of industrial X-ray tubes with filters for removing the uncertain low energy part of the spectrum in a controlled way. The results are compared with precisely measured X-ray spectra using a silicon drift detector. Furthermore, this paper shows how the different dose rates in silicon and silicon dioxide layers of an electronic device can be deduced from the simulations

Spatio-temporal patterns of beaked whale echolocation signals in the North Pacific.

At least ten species of beaked whales inhabit the North Pacific, but little is known about their abundance, ecology, and behavior, as they are elusive and difficult to distinguish visually at sea. Six of these species produce known species-specific frequency modulated (FM) echolocation pulses: Baird's, Blainville's, Cuvier's, Deraniyagala's, Longman's, and Stejneger's beaked whales. Additionally, one described FM pulse (BWC) from Cross Seamount, Hawai'i, and three unknown FM pulse types (BW40, BW43, BW70) have been identified from almost 11 cumulative years of autonomous recordings at 24 sites throughout the North Pacific. Most sites had a dominant FM pulse type with other types being either absent or limited. There was not a strong seasonal influence on the occurrence of these signals at any site, but longer time series may reveal smaller, consistent fluctuations. Only the species producing BWC signals, detected throughout the Pacific Islands region, consistently showed a diel cycle with nocturnal foraging. By comparing stranding and sighting information with acoustic findings, we hypothesize that BWC signals are produced by ginkgo-toothed beaked whales. BW43 signal encounters were restricted to Southern California and may be produced by Perrin's beaked whale, known only from Californian waters. BW70 signals were detected in the southern Gulf of California, which is prime habitat for Pygmy beaked whales. Hubb's beaked whale may have produced the BW40 signals encountered off central and southern California; however, these signals were also recorded off Pearl and Hermes Reef and Wake Atoll, which are well south of their known range

The potential and challenges of monitoring-supported energy efficiency improvement strategies in existing buildings

The ongoing EU-supported CAMPUS 21 explores the energy efficiency potential of integrated security, control, and building management software. The main objective of the project is to compare the energy and indoor-environmental performance of a number of existing facilities before and after real or virtual implementation of monitoring-based control improvement measures

Ground-State Electromagnetic Moments of Calcium Isotopes

High-resolution bunched-beam collinear laser spectroscopy was used to measure the optical hyperfine spectra of the $^{43-51}$Ca isotopes. The ground state magnetic moments of $^{49,51}$Ca and quadrupole moments of $^{47,49,51}$Ca were measured for the first time, and the $^{51}$Ca ground state spin $I=3/2$ was determined in a model-independent way. Our results provide a critical test of modern nuclear theories based on shell-model calculations using phenomenological as well as microscopic interactions. The results for the neutron-rich isotopes are in excellent agreement with predictions using interactions derived from chiral effective field theory including three-nucleon forces, while lighter isotopes illustrate the presence of particle-hole excitations of the $^{40}$Ca core in their ground state.Comment: Accepted as a Rapid Communication in Physical Review

Construction and Performance of a Micro-Pattern Stereo Detector with Two Gas Electron Multipliers

The construction of a micro-pattern gas detector of dimensions 40x10 cm**2 is described. Two gas electron multiplier foils (GEM) provide the internal amplification stages. A two-layer readout structure was used, manufactured in the same technology as the GEM foils. The strips of each layer cross at an effective crossing angle of 6.7 degrees and have a 406 um pitch. The performance of the detector has been evaluated in a muon beam at CERN using a silicon telescope as reference system. The position resolutions of two orthogonal coordinates are measured to be 50 um and 1 mm, respectively. The muon detection efficiency for two-dimensional space points reaches 96%.Comment: 21 pages, 17 figure

Optimal General Matchings

Given a graph $G=(V,E)$ and for each vertex $v \in V$ a subset $B(v)$ of the set $\{0,1,\ldots, d_G(v)\}$, where $d_G(v)$ denotes the degree of vertex $v$ in the graph $G$, a $B$-factor of $G$ is any set $F \subseteq E$ such that $d_F(v) \in B(v)$ for each vertex $v$, where $d_F(v)$ denotes the number of edges of $F$ incident to $v$. The general factor problem asks the existence of a $B$-factor in a given graph. A set $B(v)$ is said to have a {\em gap of length} $p$ if there exists a natural number $k \in B(v)$ such that $k+1, \ldots, k+p \notin B(v)$ and $k+p+1 \in B(v)$. Without any restrictions the general factor problem is NP-complete. However, if no set $B(v)$ contains a gap of length greater than $1$, then the problem can be solved in polynomial time and Cornuejols \cite{Cor} presented an algorithm for finding a $B$-factor, if it exists. In this paper we consider a weighted version of the general factor problem, in which each edge has a nonnegative weight and we are interested in finding a $B$-factor of maximum (or minimum) weight. In particular, this version comprises the minimum/maximum cardinality variant of the general factor problem, where we want to find a $B$-factor having a minimum/maximum number of edges. We present an algorithm for the maximum/minimum weight $B$-factor for the case when no set $B(v)$ contains a gap of length greater than $1$. This also yields the first polynomial time algorithm for the maximum/minimum cardinality $B$-factor for this case

Internal Jugular Vein Geometry Under Multiple Inclination Angles with 3D Low-Field MRI in Healthy Volunteers

BACKGROUND: Cerebral venous pathways are subjected to geometrical and patency changes due to body position. The internal jugular veins (IJVs) are the main venous drainage pathway in supine position. Their patency and geometry should be evaluated under different body inclination angles over a three‐dimensional (3D) volume in the healthy situation to better understand pathological cases. PURPOSE: To investigate whether positional changes in the body can affect the geometrical properties and patency of the venous system. STUDY TYPE: Prospective. POPULATION: 15 healthy volunteers, of which seven males and median age 22 years in a range of 19–59. FIELD STRENGTH/SEQUENCE: A 0.25‐T tiltable MRI system was used to scan volunteers in 90° (sitting position), 69°, 45°, 21°, and 0° (supine position) in the transverse plane with the top at vertebra C2. A gradient echo sequence was used. ASSESSMENT: Three observers assessed IJVs on patency and created automatic centerlines from which diameter and patency were analysed perpendicular to the vessel at every 4 mm starting at the level of C2. STATISTICAL TESTS: A Student's t test was used to find statistical difference (p < 0.05) in average IJV diameters per inclination angle. RESULTS: The amount of fully collapsed IJVs increased from 33% to 93% (left IJV) and 14% to 80% (right IJV) when increasing the inclination angle from 0° to 90°. In both IJVs, the mean diameter (±SD) of the open vessels was significantly higher at 0° than 90° with 6.3 ± 0.5 mm vs. 4.4 ± 0.1 mm (left IJV) and 6.6 ± 0.6 mm vs. 4.3 ± 0.4 mm (right IJV). DATA CONCLUSION: Tiltable low‐field MRI can be used to assess IJV geometry and its associated venous pathways in 3D under multiple inclination angles. Next to a higher amount of collapsed vessels, the average diameter of noncollapsed vessels decreases with increasing inclination angles for both left and right IJVs. LEVEL OF EVIDENCE: 2 TECHNICAL EFFICACY STAGE:

Recent Developments in Speeding up Prostate MRI

The increasing incidence of prostate cancer cases worldwide has led to a tremendous demand for multiparametric MRI (mpMRI). In order to relieve the pressure on healthcare, reducing mpMRI scan time is necessary. This review focuses on recent techniques proposed for faster mpMRI acquisition, specifically shortening T2W and DWI sequences while adhering to the PI-RADS (Prostate Imaging Reporting and Data System) guidelines. Speeding up techniques in the reviewed studies rely on more efficient sampling of data, ranging from the acquisition of fewer averages or b-values to adjustment of the pulse sequence. Novel acquisition methods based on undersampling techniques are often followed by suitable reconstruction methods typically incorporating synthetic priori information. These reconstruction methods often use artificial intelligence for various tasks such as denoising, artifact correction, improvement of image quality, and in the case of DWI, for the generation of synthetic high b-value images or apparent diffusion coefficient maps. Reduction of mpMRI scan time is possible, but it is crucial to maintain diagnostic quality, confirmed through radiological evaluation, to integrate the proposed methods into the standard mpMRI protocol. Additionally, before clinical integration, prospective studies are recommended to validate undersampling techniques to avoid potentially inaccurate results demonstrated by retrospective analysis. This review provides an overview of recently proposed techniques, discussing their implementation, advantages, disadvantages, and diagnostic performance according to PI-RADS guidelines compared to conventional methods. Level of Evidence: 3. Technical Efficacy: Stage 3.</p

'Swer (single wire earth return) systems user applications – optimising the use of this cost–effective electrification tool with suitable end-user applications' – the Ugandan case

The impact of SWER (Single Wire Earth Return) systems on any rural electrification programThe access to electricity is becoming a major demand in all societies in the developing countries. The declared aim of Uganda’s Ministry of Energy and Mineral Development to increase the access to electricity to 10% of Uganda’s population implies the electrification of 40,000 rural household per year, bringing ‘power to the people’. Access to electricity is directly associated with higher levels of living conditions. Individual households, (rural and urban) when provided with electricity have better conditions of cleanliness, health and self-empowerment. Key institutions in society (private, governmental, non-governmental, parastatal) also require electricity to enhance the effectiveness and efficiency of their operations and programmes. The introduction of SWER (Single Wire Earth Return) technology has significant merits regarding cost effectiveness to supply electricity to remote areas. This is especially the case where a strong backbone reticulation system is in place to supply high load centres (such as mines and larger towns, water pumping installations). Additional rural settlements and low demand settlements with clinics, schools, hostels, small borehole pumping installations can be adequately supplied with SWER (Single Wire Earth Return) technology.The access to electricity is becoming a major demand in all societies in the developing countries. The declared aim of Uganda’s Ministry of Energy and Mineral Development to increase the access to electricity to 10% of Uganda’s population implies the electrification of 40,000 rural household per year, bringing ‘power to the people’. Access to electricity is directly associated with higher levels of living conditions. Individual households, (rural and urban) when provided with electricity have better conditions of cleanliness, health and self-empowerment. Key institutions in society (private, governmental, non-governmental, parastatal) also require electricity to enhance the effectiveness and efficiency of their operations and programmes. The introduction of SWER (Single Wire Earth Return) technology has significant merits regarding cost effectiveness to supply electricity to remote areas. This is especially the case where a strong backbone reticulation system is in place to supply high load centres (such as mines and larger towns, water pumping installations). Additional rural settlements and low demand settlements with clinics, schools, hostels, small borehole pumping installations can be adequately supplied with SWER (Single Wire Earth Return) technology

Theoretical analysis of the role of chromatin interactions in long-range action of enhancers and insulators

Long-distance regulatory interactions between enhancers and their target genes are commonplace in higher eukaryotes. Interposed boundaries or insulators are able to block these long distance regulatory interactions. The mechanistic basis for insulator activity and how it relates to enhancer action-at-a-distance remains unclear. Here we explore the idea that topological loops could simultaneously account for regulatory interactions of distal enhancers and the insulating activity of boundary elements. We show that while loop formation is not in itself sufficient to explain action at a distance, incorporating transient non-specific and moderate attractive interactions between the chromatin fibers strongly enhances long-distance regulatory interactions and is sufficient to generate a euchromatin-like state. Under these same conditions, the subdivision of the loop into two topologically independent loops by insulators inhibits inter-domain interactions. The underlying cause of this effect is a suppression of crossings in the contact map at intermediate distances. Thus our model simultaneously accounts for regulatory interactions at a distance and the insulator activity of boundary elements. This unified model of the regulatory roles of chromatin loops makes several testable predictions that could be confronted with \emph{in vitro} experiments, as well as genomic chromatin conformation capture and fluorescent microscopic approaches.Comment: 10 pages, originally submitted to an (undisclosed) journal in May 201