16 research outputs found
Magnetostriction of single crystal and polycrystalline Tb0.60Dy0.40 at cryogenic temperatures
At cryogenic temperatures, single crystals of TbDy alloys exhibit giant magnetostrictions of nearly 9000 ppm, making these materials promising for engineering service in cryogenic actuators, valves, and positioners. The preparation of single crystals is difficult and costly. Preliminary results on the magnetostriction of textured polycrystalline materials are presented here. For instance, polycrystalline Tb0.60Dy0.40, plane-rolled (one direction of applied stress) to induce crystallographic texture, has shown magnetostrictions at 77 K of 3000 ppm for an applied field of 4.5 kOe and an applied load of 23 MPa, or 48% that of a single crystal under similar conditions. Comparisons are presented between the magnetostrictive response of plane- and form-rolled (two orthogonal directions of applied stress) polycrystalline Tb0.60Dy0.40 at 10 and 77 K. It is reported that at 10 K plane-rolled Tb0.60Dy0.40 exhibits 1600 ppm magnetostriction at an applied field of 4.4 kOe with a minimal applied load of 0.28 MPa. An observed restoration of the initial unstrained state may be a useful feature of polycrystalline materials for engineering service. Finally it is reported that thermal expansion measurements provide a measure of crystallographic texture for comparison with the magnetostriction
The Frequency Dependence of Critical-velocity Behavior in Oscillatory Flow of Superfluid Helium-4 Through a 2-micrometer by 2-micrometer Aperture in a Thin Foil
The critical-velocity behavior of oscillatory superfluid Helium-4 flow
through a 2-micrometer by 2-micrometer aperture in a 0.1-micrometer-thick foil
has been studied from 0.36 K to 2.10 K at frequencies from less than 50 Hz up
to above 1880 Hz. The pressure remained less than 0.5 bar. In early runs during
which the frequency remained below 400 Hz, the critical velocity was a
nearly-linearly decreasing function of increasing temperature throughout the
region of temperature studied. In runs at the lowest frequencies, isolated 2 Pi
phase slips could be observed at the onset of dissipation. In runs with
frequencies higher than 400 Hz, downward curvature was observed in the decrease
of critical velocity with increasing temperature. In addition, above 500 Hz an
alteration in supercritical behavior was seen at the lower temperatures,
involving the appearance of large energy-loss events. These irregular events
typically lasted a few tens of half-cycles of oscillation and could involve
hundreds of times more energy loss than would have occurred in a single
complete 2 Pi phase slip at maximum flow. The temperatures at which this
altered behavior was observed rose with frequency, from ~ 0.6 K and below, at
500 Hz, to ~ 1.0 K and below, at 1880 Hz.Comment: 35 pages, 13 figures, prequel to cond-mat/050203
Identifying the rotation rate and the presence of dynamic weather on extrasolar Earth-like planets from photometric observations
With the recent discoveries of hundreds of extrasolar planets, the search for
planets like Earth and life in the universe, is quickly gaining momentum. In
the future, large space observatories could directly detect the light scattered
from rocky planets, but they would not be able to spatially resolve a planet's
surface. Using reflectance models and real cloud data from satellite
observations, here we show that, despite Earth's dynamic weather patterns, the
light scattered by the Earth to a hypothetical distant observer as a function
of time contains sufficient information to accurately measure Earth's rotation
period. This is because ocean currents and continents result in relatively
stable averaged global cloud patterns. The accuracy of these measurements will
vary with the viewing geometry and other observational constraints. If the
rotation period can be measured with accuracy, data spanning several months
could be coherently combined to obtain spectroscopic information about
individual regions of the planetary surface. Moreover, deviations from a
periodic signal can be used to infer the presence of relatively short-live
structures in its atmosphere (i.e., clouds). This could provide a useful
technique for recognizing exoplanets that have active weather systems, changing
on a timescale comparable to their rotation. Such variability is likely to be
related to the atmospheric temperature and pressure being near a phase
transition and could support the possibility of liquid water on the planet's
surface
Simulations of Vortex Evolution and Phase Slip in Oscillatory Potential Flow of the Superfluid Component of Helium-4 Through an Aperture
The evolution of semicircular quantum vortex loops in oscillating potential
flow emerging from an aperture is simulated in some highly symmetrical cases.
As the frequency of potential flow oscillation increases, vortex loops that are
evolving so as eventually to cross all of the streamlines of potential flow are
drawn back toward the aperture when the flow reverses. As a result, the escape
size of the vortex loops, and hence the net energy transferred from potential
flow to vortex flow in such 2 Pi phase-slip events, decreases as the
oscillation frequency increases. Above some aperture-dependent and
flow-dependent threshold frequency, vortex loops are drawn back into the
aperture. Simulations are preformed using both radial potential flow and
oblate-spheroidal potential flow.Comment: 18 pages, 6 figures, sequel to cond-mat/050203
Results from SIM's Thermo-Opto-Mechanical (TOM3) Testbed
Future space-based optical interferometers, such as the Space Interferometer Mission Planet Quest (SIM), require thermal stability of the optical wavefront to the level of picometers in order to produce astrometric data at the micro-arc-second level. In SIM, the internal path of the interferometer will be measured with a small metrology beam whereas the starlight fringe position is estimated from a large concentric annular beam. To achieve the micro-arc-second observation goal for SIM, it is necessary to maintain the optical path difference between the central and the outer annulus portions of the wavefront of the front-end telescope optics to a few tens of picometers. The Thermo-Opto-Mecha nical testbed (TOM3) was developed at the Jet Propulsion Laboratory to measure thermally induced optical deformations of a full-size flight-like beam compressor and siderostat, the two largest optics on SIM, in flight-like thermal environments. A Common Path Heterodyne Interferometer (COPHI) developed at JPL was used for the fine optical path difference measurement as the metrology sensor. The system was integrated inside a large vacuum chamber in order to mitigate the atmospheric and thermal disturbances. The siderostat was installed in a temperature-controlled thermal shroud inside the vacuum chamber, creating a flight-like thermal environment. Detailed thermal and structural models of the test articles (siderostat and compressor) were also developed for model prediction and correlation of the thermal deformations. Experimental data shows SIM required thermal stability of the test articles and good agreement with the model predictions