1,187 research outputs found
Charge collection properties of prototype sensors for the LHCb VELO upgrade
An extensive sensor testing campaign is presented, dedicated to measuring the
charge collection properties of prototype candidates for the Vertex Locator
(VELO) detector for the upgraded LHCb experiment. The charge collection is
measured with sensors exposed to fluences of up to , as well as with nonirradiated prototypes. The results are
discussed, including the influence of different levels of irradiation and bias
voltage on the charge collection properties. Charge multiplication is observed
on some sensors that were nonuniformly irradiated with 24 GeV protons, to the
highest fluence levels. An analysis of the charge collection near the guard
ring region is also presented, revealing significant differences between the
sensor prototypes. All tested sensor variants succeed in collecting the minimum
required charge of 6000 electrons after the exposure to the maximum fluence
The LHCb VELO Upgrade module construction
The LHCb detector has undergone a major upgrade for LHC Run 3. This Upgrade I detector facilitates operation at higher luminosity and utilises full-detector information at the LHC collision rate, critically including the use of vertex information. A new vertex locator system, the VELO Upgrade, has been constructed. The core element of the new VELO are the double-sided pixelated hybrid silicon detector modules which operate in vacuum close to the LHC beam in a high radiation environment. The construction and quality assurance tests of these modules are described in this paper. The modules incorporate 200 μm thick, n-on-p silicon sensors bump-bonded to 130 nm technology ASICs. These are attached with high precision to a silicon microchannel substrate that uses evaporative CO2 cooling. The ASICs are controlled and read out with flexible printed circuits that are glued to the substrate and wire-bonded to the chips. The mechanical support of the module is given by a carbon fibre plate, two carbon fibre rods and an aluminium plate. The sensor attachment was achieved with an average precision of 21 μm, more than 99.5% of all pixels are fully functional, and a thermal figure of merit of 3 Kcm2W-1 was achieved. The production of the modules was successfully completed in 2021, with the final assembly and installation completed in time for data taking in 2022
Observation of an Excited Bc+ State
Using pp collision data corresponding to an integrated luminosity of 8.5 fb-1 recorded by the LHCb experiment at center-of-mass energies of s=7, 8, and 13 TeV, the observation of an excited Bc+ state in the Bc+π+π- invariant-mass spectrum is reported. The observed peak has a mass of 6841.2±0.6(stat)±0.1(syst)±0.8(Bc+) MeV/c2, where the last uncertainty is due to the limited knowledge of the Bc+ mass. It is consistent with expectations of the Bc∗(2S31)+ state reconstructed without the low-energy photon from the Bc∗(1S31)+→Bc+γ decay following Bc∗(2S31)+→Bc∗(1S31)+π+π-. A second state is seen with a global (local) statistical significance of 2.2σ (3.2σ) and a mass of 6872.1±1.3(stat)±0.1(syst)±0.8(Bc+) MeV/c2, and is consistent with the Bc(2S10)+ state. These mass measurements are the most precise to date
Bose-Einstein correlations of same-sign charged pions in the forward region in pp collisions at √s=7 TeV
Bose-Einstein correlations of same-sign charged pions, produced in protonproton collisions at a 7 TeV centre-of-mass energy, are studied using a data sample collected
by the LHCb experiment. The signature for Bose-Einstein correlations is observed in the
form of an enhancement of pairs of like-sign charged pions with small four-momentum
difference squared. The charged-particle multiplicity dependence of the Bose-Einstein correlation parameters describing the correlation strength and the size of the emitting source
is investigated, determining both the correlation radius and the chaoticity parameter. The
measured correlation radius is found to increase as a function of increasing charged-particle
multiplicity, while the chaoticity parameter is seen to decreas
Measurement of the inelastic pp cross-section at a centre-of-mass energy of 13TeV
The cross-section for inelastic proton-proton collisions at a centre-of-mass energy of 13TeV is measured with the LHCb detector. The fiducial cross-section for inelastic interactions producing at least one prompt long-lived charged particle with momentum p > 2 GeV/c in the pseudorapidity range 2 < η < 5 is determined to be ϭ acc = 62:2 ± 0:2 ± 2:5mb. The first uncertainty is the intrinsic systematic uncertainty of the measurement, the second is due to the uncertainty on the integrated luminosity. The statistical uncertainty is negligible. Extrapolation to full phase space yields the total inelastic proton-proton cross-section ϭ inel = 75:4 ± 3:0 ± 4:5mb, where the first uncertainty is experimental and the second due to the extrapolation. An updated value of the inelastic cross-section at a centre-of-mass energy of 7TeV is also reported
The HEV Ventilator Proposal
We propose the design of a ventilator which can be easily manufactured and
integrated into the hospital environment to support COVID-19 patients. The unit
is designed to support standard ventilator modes of operation, most importantly
PRVC (Pressure Regulated Volume Control) and SIMV-PC (Synchronised Intermittent
Mandatory Ventilation) modes. The unit is not yet an approved medical device
and is in the concept and prototyping stage. It is presented here to invite
fast feedback for development and deployment in the face of the COVID-19
pandemic.Comment: 14 pages, 5 figure
The HEV Ventilator
HEV is a low-cost, versatile, high-quality ventilator, which has been
designed in response to the COVID-19 pandemic. The ventilator is intended to be
used both in and out of hospital intensive care units, and for both invasive
and non-invasive ventilation. The hardware can be complemented with an external
turbine for use in regions where compressed air supplies are not reliably
available. The standard modes provided include PC-A/C(Pressure Assist
Control),PC-A/C-PRVC(Pressure Regulated Volume Control), PC-PSV (Pressure
Support Ventilation) and CPAP (Continuous Positive airway pressure). HEV is
designed to support remote training and post market surveillance via a web
interface and data logging to complement the standard touch screen operation,
making it suitable for a wide range of geographical deployment. The HEV design
places emphasis on the quality of the pressure curves and the reactivity of the
trigger, delivering a global performance which will be applicable to ventilator
needs beyond theCOVID-19 pandemic. This article describes the conceptual design
and presents the prototype units together with their performance evaluation.Comment: 34 pages, 18 figures, Extended version of the article submitted to
PNA
Updated Determination of D⁰–D¯⁰Mixing and CP Violation Parameters with D⁰→K⁺π⁻ Decays
We report measurements of charm-mixing parameters based on the decay-time-dependent ratio of D⁰→K⁺π⁻ to D⁰→K⁻π⁺ rates. The analysis uses a data sample of proton-proton collisions corresponding to an integrated luminosity of 5.0 fb⁻¹ recorded by the LHCb experiment from 2011 through 2016. Assuming charge-parity (CP) symmetry, the mixing parameters are determined to be x′²=(3.9±2.7)×10⁻⁵, y′=(5.28±0.52)×10⁻³, and R[subscript D]=(3.454±0.031)×10⁻³. Without this assumption, the measurement is performed separately for D⁰ and D[over ¯]⁰ mesons, yielding a direct CP-violating asymmetry A[subscript D]=(-0.1±9.1)×10⁻³, and magnitude of the ratio of mixing parameters 1.00<|q/p|<1.35 at the 68.3% confidence level. All results include statistical and systematic uncertainties and improve significantly upon previous single-measurement determinations. No evidence for CP violation in charm mixing is observed
Observation of D⁰ Meson Decays to Π⁺π⁻μ⁺μ⁻ and K⁺K⁻μ⁺μ⁻ Final States
The first observation of the D⁰→π⁺π⁻μ⁺μ⁻ and D⁰→K⁺K⁻μ⁺μ⁻ decays is reported using a sample of proton-proton collisions collected by LHCb at a center-of-mass energy of 8 TeV, and corresponding to 2 fb⁻¹ of integrated luminosity. The corresponding branching fractions are measured using as normalization the decay D⁰→K⁻π⁺[μ⁺μ⁻][subscript ρ⁰/ω], where the two muons are consistent with coming from the decay of a ρ⁰ or ω meson. The results are B(D⁰→π⁺π⁻μ⁺μ⁻)=(9.64±0.48±0.51±0.97)×10⁻⁷ and B(D⁰→K⁺K⁻μ⁺μ⁻)=(1.54±0.27±0.09±0.16)×10⁻⁷, where the uncertainties are statistical, systematic, and due to the limited knowledge of the normalization branching fraction. The dependence of the branching fraction on the dimuon mass is also investigated
- …