21 research outputs found

    A Wire-Based Methodology to Analyse the Nanometric Resolution of an RF Cavity BPM

    Get PDF
    Resonant Cavity Beam Position Monitors (RF-BPMs) are diagnostic instruments capable of achieving beam position resolutions down to the nanometre scale. To date, their nanometric resolution capabilities have been predicted by simulation and verified through beam-based measurements with particle beams. In the frame of the PACMAN project at CERN, an innovative methodology has been developed to directly observe signal variations corresponding to nanometric displacements of the BPM cavity with respect to a conductive stretched wire. The cavity BPM of this R&D study operates at the TM110 dipole mode frequency of 15GHz. The concepts and details of the RF stretched wire BPM testbench to achieve the best resolution results are presented, along with the required control hardware and software

    Methods and results of a search for gravitational waves associated with gamma-ray bursts using the GEO 600, LIGO, and Virgo detectors

    Get PDF
    Paper producido por "The LIGO Scientific Collaboration and the Virgo Collaboration". (En el registro se mencionan solo algunos autores de las decenas de personas que participan).In this paper we report on a search for short-duration gravitational wave bursts in the frequency range 64 Hz–1792 Hz associated with gamma-ray bursts (GRBs), using data from GEO 600 and one of the LIGO or Virgo detectors. We introduce the method of a linear search grid to analyze GRB events with large sky localization uncertainties, for example the localizations provided by the Fermi Gamma-ray Burst Monitor (GBM). Coherent searches for gravitational waves (GWs) can be computationally intensive when the GRB sky position is not well localized, due to the corrections required for the difference in arrival time between detectors. Using a linear search grid we are able to reduce the computational cost of the analysis by a factor of Oð10Þfor GBM events. Furthermore, we demonstrate that our analysis pipeline can improve upon the sky localization of GRBs detected by the GBM, if a high-frequency GW signal is observed in coincidence. We use the method of the linear grid in a search for GWs associated with 129 GRBs observed satellite-based gamma-ray experiments between 2006 and 2011. The GRBs in our sample had not been previously analyzed for GW counterparts. A fraction of our GRB events are analyzed using data from GEO 600 while the detector was using squeezed-light states to improve its sensitivity; this is the first search for GWs using data from a squeezed-light interferometric observatory. We find no evidence for GW signals, either with any individual GRB in this sample or with the population as a whole. For each GRB we place lower bounds on the distance to the progenitor, under an assumption of a fixed GWemission energy of 10−2M⊙c2, with a median exclusion distance of 0.8 Mpc for emission at 500 Hz and 0.3 Mpc at 1 kHz. The reduced computational cost associated with a linear search grid will enable rapid searches for GWs associated with Fermi GBM events once the advanced LIGO and Virgo detectors begin operation.http://journals.aps.org/prd/abstract/10.1103/PhysRevD.89.122004publishedVersionFil: Aasi, J. LIGO. California Institute of Technology; Estados Unidos de América.Fil: Domínguez, E. Argentinian Gravitational Wave Group; Argentina.Fil: Maglione, C. Argentinian Gravitational Wave Group; Argentina.Fil: Reula, O. Argentinian Gravitational Wave Group; Argentina.Fil: Ortega, W. Argentinian Gravitational Wave Group; Argentina.Fil: Wolovick, N. Argentinian Gravitational Wave Group; Argentina.Fil: Schilman, M. Argentinian Gravitational Wave Group; Argentina.Física de Partículas y Campo

    Multimessenger Search for Sources of Gravitational Waves and High-Energy Neutrinos: Results for Initial LIGO-Virgo and IceCube

    Get PDF
    We report the results of a multimessenger search for coincident signals from the LIGO and Virgo gravitational-wave observatories and the partially completed IceCube high-energy neutrino detector, including periods of joint operation between 2007-2010. These include parts of the 2005-2007 run and the 2009-2010 run for LIGO-Virgo, and IceCube's observation periods with 22, 59 and 79 strings. We find no significant coincident events, and use the search results to derive upper limits on the rate of joint sources for a range of source emission parameters. For the optimistic assumption of gravitational-wave emission energy of 10210^{-2}\,M_\odotc2^2 at 150\sim 150\,Hz with 60\sim 60\,ms duration, and high-energy neutrino emission of 105110^{51}\,erg comparable to the isotropic gamma-ray energy of gamma-ray bursts, we limit the source rate below 1.6×1021.6 \times 10^{-2}\,Mpc3^{-3}yr1^{-1}. We also examine how combining information from gravitational waves and neutrinos will aid discovery in the advanced gravitational-wave detector era

    Searches for continuous gravitational waves from nine young supernova remnants

    Get PDF
    We describe directed searches for continuous gravitational waves in data from the sixth LIGO science data run. The targets were nine young supernova remnants not associated with pulsars; eight of the remnants are associated with non-pulsing suspected neutron stars. One target's parameters are uncertain enough to warrant two searches, for a total of ten. Each search covered a broad band of frequencies and first and second frequency derivatives for a fixed sky direction. The searches coherently integrated data from the two LIGO interferometers over time spans from 5.3-25.3 days using the matched-filtering F-statistic. We found no credible gravitational-wave signals. We set 95% confidence upper limits as strong (low) as 4×10254\times10^{-25} on intrinsic strain, 2×1072\times10^{-7} on fiducial ellipticity, and 4×1054\times10^{-5} on r-mode amplitude. These beat the indirect limits from energy conservation and are within the range of theoretical predictions for neutron-star ellipticities and r-mode amplitudes.Comment: Science summary available at http://www.ligo.org/science/Publication-S6DirectedSNR/index.ph

    A directed search for gravitational waves from Scorpius X-1 with initial LIGO

    Get PDF
    19 pages, 8 figuresInternational audienceWe present results of a search for continuously-emitted gravitational radiation, directed at the brightest low-mass X-ray binary, Scorpius X-1. Our semi-coherent analysis covers 10 days of LIGO S5 data ranging from 50-550 Hz, and performs an incoherent sum of coherent F\mathcal{F}-statistic power distributed amongst frequency-modulated orbital sidebands. All candidates not removed at the veto stage were found to be consistent with noise at a 1% false alarm rate. We present Bayesian 95% confidence upper limits on gravitational-wave strain amplitude using two different prior distributions: a standard one, with no a priori assumptions about the orientation of Scorpius X-1; and an angle-restricted one, using a prior derived from electromagnetic observations. Median strain upper limits of 1.3e-24 and 8e-25 are reported at 150 Hz for the standard and angle-restricted searches respectively. This proof of principle analysis was limited to a short observation time by unknown effects of accretion on the intrinsic spin frequency of the neutron star, but improves upon previous upper limits by factors of ~1.4 for the standard, and 2.3 for the angle-restricted search at the sensitive region of the detector

    Vibration analysis and control of the LIGO observatories large chambers and support piers

    No full text
    The Laser Interferometer Gravitational wave Observatories (LIGO) host kilometers long vacuum equipment. At each site, five large chambers and support structures are used to store the detector’s core instrumentation. This article discusses the vibrations of these large vacuum chambers and equipment. It presents and summarizes transmissibility measurements performed at the LIGO test facilities and observatories. In addition, it presents detailed models and compares them with experiments and discusses vibration mitigation techniques and control options. It concludes with recommendations for future LIGO observatories

    Budgeting and control of the mechanical noise in the International Linear Collider Final Focus System

    Get PDF
    In this paper, we present a simplified vibration model of the silicon detector (SiD), where the final doublet (QD0) is captured inside the detector and the penultimate magnet (QF1) is inside the machine tunnel. Ground motion spectra measured at the detector hall at SLAC have been used together with a spectrum of the technical noise on the detector. The model predicts that the maximum level of rms (root mean square) vibration seen by QD0 is well below the capture range of the interaction point (IP) feedback system available in the ILC. With the addition of an active stabilization system on QD0, it is also possible to get closer to the stability requirements of the compact linear collider (CLIC). These results can have important implications for CLIC. ©2014 Published by the American Physical Society.SCOPUS: ar.jinfo:eu-repo/semantics/publishe
    corecore